Promotional effect of cobalt doping on catalytic performance of cryptomelane-type manganese oxide in toluene oxidation

The cryptomelane-type manganese oxide (OMS-2)-supported Co (xCo/OMS-2; x = 5, 10, and 15 wt.%) catalysts were prepared via a pre-incorporation route. The as-prepared materials were used as catalysts for catalytic oxidation of toluene (2000 ppmV). Physical and chemical properties of the catalysts were measured using the X-ray diffraction (XRD), Fourier transform infrared spectroscopic (FT-IR), scanning electron microscopic (SEM), X-ray photoelectron spectroscopy (XPS), and hydrogen temperature-programmed reduction (H₂-TPR) techniques. Among all of the catalysts, 10Co/OMS-2 performed the best, with the T_90%, specific reaction rate at 245°C, and turnover frequency at 245°C (TOF_Co) being 245°C, 1.23 × 10⁻³ mol_toluene/(g_cat·sec), and 11.58 × 10⁻³ sec⁻¹ for toluene oxidation at a space velocity of 60,000 mL/(g·hr), respectively. The excellent catalytic performance of 10Co/OMS-2 were due to more oxygen vacancies, enhanced redox ability and oxygen mobility, and strong synergistic effect between Co species and OMS-2 support. Moreover, in the presence of poisoning gases CO₂, SO₂ or NH₃, the activity of 10Co/OMS-2 decreased for the carbonate, sulfate and ammonia species covered the active sites and oxygen vacancies, respectively. After the activation treatment, the catalytic activity was partly recovered. The good low-temperature reducibility of 10Co/OMS-2 could also facilitate the redox process accompanied by the consecutive electron transfer between the adsorbed O₂ and the cobalt or manganese ions. In the oxidation process of toluene, the benzoic and aldehydic intermediates were first generated, which were further oxidized to the benzoate intermediate that were eventually converted into H₂O and CO₂.     

长炼第二污水处理场氧化沟工艺运行小结

臭伯尔氧化沟池容大，停留时间长，运行稳定，对氧化沟污泥培养及开工运行进行了小结，并结合运行过程中的几个问题进行了分析和探讨。     

柴油汽车掺烧LPG降低黑烟排放技术

研究了柴油机掺烧液化石油气(LPG)以降低黑烟排放的技术方案，并开发出了一种以独特型板调节装置为特征的机械控制式柴油/LPG双燃料供给系统。发动机不改变原有结构加装该系统后即成为柴油/LPG双燃料发动机，可以同时燃烧柴油和LPG两种燃料，并且在整个工作范围内，随着工况变化能够按照预先优化设定的型板型线规律而自动调节柴油／LPG供给量比例，使烟度降低50％以上，同时满足经济性、动力性以及操作性能等要求，此外，也可以切换为单独燃烧柴油，而不改变发动机的原有性能。该系统结构简单、成本低廉，非常适合于改装城市在用公交车，降低其黑烟排放。     

Environmental assessment of supercritical water oxidation of sewage sludge

Environmental aspects of using supercritical water oxidation (SCWO) to treat sewage sludge were studied using a life cycle assessment (LCA) methodology. The system studied is the first commercial scale SCWO plant for sewage sludge in the world, treating sludge from the municipal wastewater treatment facility in Harlingen, TX, USA. The environmental impacts were evaluated using three specific environmental attributes: global warming potential (GWP), photo-oxidant creation potential (POCP) and resource depletion; as well as two single point indicators: EPS2000 and EcoIndicator99. The LCA results show that for the described process, gas-fired preheating of the sludge is the major contributor to environmental impacts, and emissions from generating electricity for pumping and for oxygen production are also important. Overall, SCWO processing of undigested sewage sludge is an environmentally attractive technology, particularly when heat is recovered from the process. Energy-conserving measures and recovery of excess oxygen from the SCWO process should be considered for improving the sustainability potential.     

ClO2去除废水中石油类污染物的研究

就如何使用ClO2和O3对水中石油类污染物氧化去除进行了研究，确定了最佳反应时间、pH和氧化剂用量对去除率的影响。ClO2的最佳投加量应为有机物总量的1．5倍，反应时间可控制在20min上。ClO2处理pH5．0～6．5溶液时的去除效果最好。同时进行了O3的对照实验。分析了ClO2和O3在水处理应用中的优缺点。     

钯离子液相催化氧化低浓度磷化氢

采用Pd^2＋液相催化氧化低浓度PH3,考察了Pd^2＋浓度、O2体积分数、PH3质量浓度、混合气流量、反应温度等因素对Pd^2＋吸收液去除低浓度PH3效果的影响。实验结果表明,采用10mL Pd^2＋浓度为0．112mol／L的水溶液作为吸收液净化含低浓度PH3的混合气,在反应温度22℃、O2体积分数5％、PH3质量浓度850mg／m^3、混合气流量190mL／min的条件下,印min之内PH3去除率保持在90％以上。Pd^2＋浓度越高、O2体积分数越大、反应温度越高,PH3去除率越高;混合气流量越大,PH3去除率越低;反应温度越低、O2体积分数越大,PH3去除率的下降速率越小。     

树脂吸附-Fenton试剂氧化法处理水杨醛生产废水

采用树脂吸附-Fenton试剂氧化法处理水杨醛生产废水。XF-01树脂和XF-02树脂静态吸附水杨醛生产废水时,COD去除率均在85％以上,挥发酚去除率均高于90％。XF-02树脂对水杨醛生产废水的处理效果更佳。动态吸附随废水流量增大,吸附出水的COD和挥发酚质量浓度均增加。适宜的废水流量为15BV,树脂的最佳脱附温度为80℃。在连续4批的吸附-脱附实验中,吸附出水的平均COD约为1200mg／L,平均挥发酚质量浓度小于10mg／L。在Fenton试剂氧化中,铁屑和铁粉的催化效果差别很小,都好于FeSO4·7H2O。以铁屑为催化剂、H2O2溶液加入量为1％时,氧化出水的COD小于150mg／L,挥发酚质量浓度小于0．5mg／L。     

羊场湾大采高易自燃工作面CO分布规律研究

为探明羊场湾160205工作面上隅角CO体积分数超限明显的原因,沿工作面倾向和走向布置测点,测试早中晚三班开始前的CO体积分数,并在采空区布置束管,对不同位置气体进行取样分析,得出160205工作面CO体积分数分布。结合煤炭开采过程CO的主要来源与煤氧化产生CO的机理,分析得出羊场湾160205工作面CO主要来源。结果表明:CO体积分数沿工作面煤壁到架后采空区方向逐渐升高;采空区深度0～15 m和30～100 m处为高体积分数CO区域;160205工作面CO主要来源为采空区遗煤氧化,其次为顶煤氧化与割煤时煤体破碎产生,采空区深度30～100 m处的CO体积分数较高区域是判定采空区遗煤自燃状况的关键区域。     

Landfill leachate treatment methods: A review

Landfilling of municipal waste is still a major issue of the waste management system in Europe. The generated leachate must be appropriately treated before being discharged into the environment. Technologies meant for leachate treatment can be classified as follows (i) biological methods, (ii) chemical and physical methods. Here we review briefly the main processes currently used for the landfill leachates treatments.     

短程硝化—厌氧氨氧化组合工艺在脱氮领域的研究进展

基于全程硝化反硝化的传统生物脱氮工艺在硝化过程中需要大量氧气供应,反硝化过程需要有机物作为碳源,存在能耗与药耗过大的问题.为了降低废水脱氮的成本,短程硝化(PN)—厌氧氨氧化(ANAMMOX)组合工艺(PNA工艺)得到了高速发展.综述了PNA工艺的影响因素,重点介绍了4种基于PN与ANAMMOX原理开发的衍生PNA工艺...