A/A/O微曝氧化沟处理城市污水的工程设计

以某日处理量为80 000 m3城市污水处理厂为例,介绍了A/A/O微曝氧化沟工艺的设计思路及参数选择,能够满足设计要求,且可信度高,有实用参考价值.     

Oxidation of polycyclic aromatic hydrocarbons by fungal isolates from an oil contaminated refinery soil

BACKGROUND AND OBJECTIVE: Indigenous soil microorganisms are used for the biodegradation of petroleum hydrocarbons in oily waste residues from the petroleum refining industry. The objective of this investigation was to determine the potential of indigenous strains of fungi in soil contaminated with petroleum hydrocarbons to biodegrade polycyclic aromatic hydrocarbons (PAH). MATERIALS AND METHODS: Twenty one fungal strains were isolated from a soil used for land-farming of oily waste residues from the petrochemical refining industry in Singapore and identified to genus level using laboratory culture and morphological techniques. Isolates were incubated in the presence of 30 mg/L of phenanthrene over a period of 28 days at 30 degrees C. The most effective strain was further evaluated to determine its ability to oxidise a wider range of PAH compounds of various molecular weight i.e acenaphthene, fluorene, fluoranthene, chrysene, benzo(a)pyrene and dibenz(ah)anthracene RESULTS AND DISCUSSION: After 28 days of incubation, 18 of the 21 fungal cultures were capable of oxidising over 50% of the phenanthrene present in culture medium, relative to abiotic controls. Fungal isolate, Penicillium sp. 06, was able to oxidise 89% of the phenanthrene present. This isolate could also oxidise more than 75% of the acenaphthene, fluorene and fluoranthene after 30 days of incubation. However, the oxidation of high molecular weight PAH i.e. chrysene, benzo(a)pyrene and dibenz(ah)anthracene by the Penicillium sp. 06 isolate was limited, where the extent of oxidation was inversely proportional to PAH molecular weight. CONCLUSIONS: Fungal isolate, Penicillium sp. 06, was effective at oxidising a range of PAH in petroleum contaminated soils, but higher molecular weight PAH were more recalcitrant. RECOMMENDATIONS AND OUTLOOK: There is potential for the re-application of this fungal strain to soil for bioremediation purposes.     

催化超临界水氧化对氨基苯酚

采用CuO／γ-Al2O3和MnO2/γ-Al2O3为催化剂、H2O2为氧化剂，在一连续流固定床反应器中进行了超临界水氧化对氨基苯酚实验。实验结果表明，CuO和MnO2催化剂对于对氨基苯酚的氧化降解具有显著的促进作用。对氨基苯酚的去除率随反应温度和压力的升高、停留时间的延长而提高，在24～26MPa和400～450℃条件下，数秒钟内COD去除率可达到99％以上，催化剂CuO／γ-Al2O3的催化效果优于MnO2／γ-Al2O3。证明了催化超临界水氧化技术的高效性。     

高浓度难降解有机废水的催化氧化技术及其进展

根据催化剂的激活因子不同 ,本文将催化氧化法分为湿式催化氧化法 (WCO)、光催化氧化法 (PCO)和电催化氧化法 (ECO)三种 ,并阐述了各自的反应机理及应用研究状况 ,提出了今后需要加强的研究方向     

酶制剂废水处理的试验研究

采用直接混凝、直接水解 -接触氧化的生化处理以及混凝 -水解 -接触氧化 3种不同工艺对某酶制剂废水进行处理。结果表明 ,针对浓度为 6 2 0 0mg/L的原水 ,用本单位的混凝剂 4号进行直接的混凝处理 ,在加入量为 10 0mg/L时可以得到 6 6 %的CODCr处理率 ;同样浓度的原水直接进行水解 -接触氧化生化处理 ,在 34h的停留时间后可以达到国家二类二级排放标准 ;经过混凝处理后的出水进行的生化实验则表明 ,达到国家排放标准的生化停留时间可缩短至 2 2h。     

Geochemistry and acidity of sulphide-bearing postglacial sediments of western Finland

The geochemistry, mineralogy, acidity and electric conductivity of sulphide-bearing postglacial sediments located on the coastal plains of western Finland were studied. Grain size and mineralogical analysis (eight samples studied) indicated that the sediments are silts dominated by primary minerals (quartz, feldspars), and that the clay fraction (<2µm), which made up less than one-third of the bulk samples, is enriched in phyllosilicates but depleted in quartz and feldspars, relative to bulk samples. As compared to the metal contents of the fine-fraction of glacial till (data of the Geological Survey of Finland), the fine sediments appear to be enriched in sulphur (median = 0.54%) and trace metals such as Ni (31 µg g^–1), Zn (90 µg g^–1), Co (13 µg g^–1), Cr (48 µg g^–1) and V (50 µg g^–1). Statistical analysis indicated that aluminosilicates are the principal carrier phases of trace metals, and that sulphides and organic matter only partially control the distribution of elements other than S and C. A 3-g portion of 232 samples was oxidised in the laboratory by atmospheric oxygen for a period of 1 year. After this period of oxidation, 15 ml of water was added, after which pH and electric conductivity of the suspensions (sediment:water, 1:5) were measured. The quantities of elements mobilised by the oxidation was calculated from the dissolved concentrations found in 3 g of oxidised sediment suspended in 30 ml of deionised water (eight samples studied). The results of the experiment showed that the impact of sulphide oxidation on the pH and conductivity of the sediments is large, and that a high proportion (>13%) of the aqua-regia extractable contents of several elements (Co, Mn, Ca, Ni, Zn, Sr, Na and B) are mobilised at oxidation. Because of the high quantities of acidity and metals liberated at oxidation, it is argued that stream-water quality, which is poor in the study area, will not improve unless artificial draining is restricted in areas of sulphide sediments.     

Limestone surfaces in built-up environment as indicators of atmospheric pollution

The concentration of sulphate on limestone surfaces of the external walls of churches in Malta is shown to be related to their position and distance from a power station, the main local point source of sulphur dioxide pollution. Limestone powder collected from these surfaces was examined for the presence of particles which, under low-power optical microscopy, appear as shiny black amorphous bodies which were interpreted as soot particles; the abundance of these bodies was expressed as a black particle count (BPC). The degree of sulphation and BPC were shown to be correlated with each other and both appeared to be strongly dependent on the prevailing wind. The BPC contour map indicated an important contribution to the parameter from vehicular traffic. It is suggested that the degree of sulphation and BPC of limestone surfaces from the built environment should function as environmental indicators of the relative air quality with respect to SO₂ and soot pollution. This data is possibly more accurately representative of the relative long-term air-quality status of different areas of habitation than that deduced from single or episodic measurements of atmospheric pollutant levels.     

Removal of the herbicide amitrole from water by anodic oxidation and electro-Fenton

Here we demonstrate that an aqueous solution of the herbicide amitrole can be completely depolluted at pH 3.0 by anodic oxidation and electro-Fenton process. Anodic oxidation gives faster degradation with a boron-doped diamond anode than with a Pt anode. Electro-Fenton with a Pt anode and 1 mmol l ^–1 Fe²⁺ as catalyst yields the quickest depollution. Amitrole decay always follows a pseudo first-order reaction. NO₃^– and NH₄⁺ are accumulated in the medium during mineralization, although volatile N-products are also formed. These environmentally friendly electrochemical treatments could be applied to the remediation of wastewaters containing amitrole.     

苯酚的超临界水氧化试验

以自建的一套连续式超临界水氧化装置的温度，压力，溶氧量和流量等参数的可控性进行了实验，并在此基础上进行了苯酚的超临界水氧化研究。结果表明：所建立的装置能比较精确控制各种条件参数，是可靠的超临界水氧化试验研究装置。在氧气过量的条件下，停留时间是影响苯酚在超临界水中氧化分解的主要因素，反应的温度和压力升高导致苯致苯酚去除率的增大，只要有足够的氧气，苯酚起始浓度的增加对苯酚的转化率影响不明显，在实验条件下，溶液中苯酚的去除动力学对苯酚是一级，氧气是零级。     

新型废水生物脱氮的微生物学研究进展

生物脱氮是含氮废水处理公认的最佳处理方式,随着对生物脱氮微生物学原理研究的不断深入,许多新的生物脱氮特殊菌株或菌群及微生物转化机制不断被发现.本文在传统生物脱氮过程机理上,结合最近国内外生物脱氮的新发现,就短程硝化反硝化、同时硝化反硝化、厌氧氨氧化的微生物学原理进行了阐述.图1表2参23