Factors influencing Aerosol Characteristics over Urban Environment

Atmospheric aerosols are an important contributing factor to turbidity in urban areas besides having impact on health. Aerosol characteristics show a high degree of variability in space and time as anthropogenic share of total aerosol loading is quite substantial and is essential to monitor the aerosol features over long time scales. In the present study extensive observations of columnar aerosol optical depth (AOD), total columnar ozone (TCO) and precipitable water content (PWC) have been carried over a tropical urban city of Hyderabad, India. Significant variations of AOD have been observed during course of the day with low values of AOD during morning and evening hours and high values during afternoon hours. Spectral variation of AOD exhibits high AOD at smaller wavelengths and vice versa except a slight enhancement in AOD at 500 nm. Anomalies in AOD, particulate matter and black carbon concentrations have been observed during May, 2003. Back trajectory analysis of air mass during these episodes suggested variation in air mass trajectories. Analysis of the results suggests that air trajectories from land region north of study area cause high loading of atmospheric aerosols. The results are discussed in the paper.     

Air Pollution and Heat Exposure Study in the Workplace in a Glass Manufacturing Unit in India

Air pollution in the workplace environment due to industrial operation have been found to cause serious occupational health hazard. Similarly, heat stress is still most neglected occupational hazard in the tropical and subtropical countries like India. The hot climate augments the heat exposure close to sources like furnaces. In this study an attempt is made to assess air pollution and heat exposure levels to workers in the workplace environment in glass manufacturing unit located in the State of Gujarat, India. Samples for workplace air quality were collected for SPM, SO₂, NO₂ and CO₂ at eight locations. Results of workplace air quality showed 8-hourly average concentrations of SPM: 165–9118 μg/m³, SO₂: 6–9 μg/m³ and NO₂: 5–42 μg/m³, which were below the threshold limit values of workplace environment. The level of CO₂ in workplace air of the plant was found to be in the range 827–2886 μg/m³, which was below TLV but much higher than the normal concentration for CO₂ in the air (585 mg/m³). Indoor heat exposure was studied near the furnace and at various locations in an industrial complex for glass manufacturing. The heat exposure parameters including the air temperature, the wet bulb temperature, and the globe parameters were measured. The Wet Bulb Globe Temperature (WBGT), an indicator of heat, exceeded ACGIH TLVs limits most of the time at all the locations in workplace areas. The recommended duration of work and rest have also been estimated.     

Aerosol Scavenging: Model Application and Sensitivity Analysis in the Indian Context

Sulfate aerosols have been found to bethe major contributors to precipitation acidity. Thus,in view of the long-term ecological repercussions theyhave on aquatic ecosystems and their acidity-potential,the present analysis focuses on a case study applicationof the layer-averaged aerosol-scavenging model (Okita et al., 1996) for predicting values of the wet scavengingcoefficient and sulfate concentrations in precipitationsamples on the basis of the information available forsome selected Indian cities. Through sensitivityanalysis (Pandey et al., 1997) the scavengingcoefficient has been found to be very strongly dependenton precipitation intensity. Comparison of modelpredictions has been done with the measured values forDelhi, Mumbai, Calcutta and Chennai in India.     

Prediction of Leachate Level in Kimpo Metropolitan Landfill Site by Total Water Balance

Kimpo metropolitan landfill has received various kinds of wastessince January 1992. The leachate level was measured to be 10.3 m in May 1995 and the level increased to 12.2 m in August 1996. Therefore, to prove the reason for the increasing leachate level, we calibrated hydraulic conductivity of each waste andintermediate layer using the HELP (Hydrologic Evaluation ofLandfill Performance) model. The leachate generation data measured from February 1993 to October 1995 was used in the model calibration. As a result of a model calibration, we obtained anaverage infiltration ratio and used this in analysis of the total water balance to predict elevation of leachate level. Main causes of the elevation of the leachate level were the high water content of the waste and the degradation of the leachate-drainage system caused by the subsidence of a naturalbarrier layer.     

Monitoring of Seasonal Vegetables for Pesticide Residues

Market samples (60) of six seasonal vegetables were monitoredduring 1996–1997 to determine the magnitude of pesticidalcontamination. The estimation of insecticide residuesrepresenting four major chemical groups i.e. organochlorine,organophosphorous, synthetic pyrethroid and carbamate, was doneby adopting a multiresidue analytical technique employingGC-ECD and GC-NPD systems with capillary columns. The testedsamples showed 100% contamination with low but measurableamounts of residues. Among the four chemical groups, theorganophosphates were dominant followed by organochlorines,synthetic pyrethroids and carbamates. About 23% of the samplesshowed contamination with organophosphorous compounds abovetheir respective MRL values. More extensive studies coveringdifferent regions of Haryana state are suggested to get a clearidea of the magnitude of vegetable contamination with pesticideresidues.     

用工业废水排放量预测地面水CODMn灰色方法研究

ＧＰＭ（１）灰色生长曲线常被用于等距时序环境系统的分析建模、非等距摆动空间序列方面的应用尚未报道。本文研究提出了将非等距摆动空间序列经过等距化处理的ＧＰＭ（１）线性回归优化建模方法采用该方法所建的非等距ＧＰＭ（１）模型用于工业废水量预测地面水ＣＯＤＭｎ的实例表明，该方法简捷，方便、精度高于回归分析，有较大实用价值。     

博斯腾湖富营养化状态水平调查

通过水质特征和生物学特征的一个水文年规范化实地调查,采用Scirgesew参数分类标准和相关加权综合营养状态指数,对博斯腾湖水体富营养化状态水平进行了调查和评价。     

灰色系统模型GM（1,1）在大气环境浓度预测中的应用

运用灰色系统理论，结合实例详细介绍了ＧＭ（１，１）模型在大气环境浓度预测中的应用。     

浅谈GAM与GM（1,1）模型

对ＧＡＭ水环境预测模型提出了四点不同看法，与有关作者商榷，指出ＧＭ（１，１）模型与ＧＡＭ模型二者并无优劣之差，精度亦相当。     

Application of CFD Methods for Modelling in Air Pollution Problems: Possibilities and Gaps

Different urban air pollution problems deal with complex structure of air flows and turbulence. For such problems the Computer Fluid Dynamics (CFD) methods become widely used. However, this approach despite a number of advantages has some problems. Experience of use of CFD tools for development of models and suggestions of their applications for a local scale air pollution over a complex terrain and stable stratification are discussed in this paper, including: Topography and complex geometry: choose of the co-ordinate system and computer grid; Turbulence closure for air pollution modelling: modified k- model for stable stratified ABL; Boundary conditions for vertical profiles of velocity for stable-stratified atmosphere; Effects of the radiation and thermal budget of inclined surfaces to dispersion of pollutants; Artificial sources of air dynamics and circulation.Some examples of CFD applications for air pollution modelling for a flat terrain, mountainous area, mining open cast and indoor ventilation are discussed. Modified k- model for stably-stratified ABL is suggested. Due to the isotropic character of the k- model a combination of it in vertical with the sub-grid turbulence closure in horizontal can be more suitable for ABL. An effective scheme of boundary conditions for velocity profiles, based on the developed similarity theory for stable-stratified ABL, is suggested. Alongside with the common studies of atmospheric dispersion, the CFD methods have also demonstrated a good potential for studying anthropogenic and artificial-ventilation sources of air dynamic and circulation in local-scale processes of air pollution.