臭氧氧化处理页岩气钻井废水的机理与动力学

采用臭氧氧化法处理页岩气钻井废水经混凝沉淀后的出水(COD=759.63 mg/L),重点研究了废水中有机污染物的去除机理与反应动力学。实验结果表明:在废水pH为11.2、臭氧通入量为8 mg/min、反应时间为50 min的最佳工艺条件下,废水的COD去除率为42.51%;羟基自由基抑制剂CO_3~(2-)、HCO_3~-和叔丁醇的引入抑制了废水COD的臭氧氧化去除,尤其是叔丁醇的加入使COD去除率显著下降,说明废水中有机物的臭氧氧化去除过程遵循羟基自由基机理;臭氧氧化法对钻井废水中有机物的氧化去除过程符合表观二级反应动力学规律。     

Diffusion mechanism of lindane into wood charcoal

Abstract

The wood charcoal treated by 1N HNO₃ (WCT) was used to remove toxic chlorinated pesticide lindane (y‐HCH) residue from water by the sorption process. Using a simple first order reversible kinetics constants and half time equations, the film and pore diffusion coefficients were determined. Film diffusion was found to be rate limiting step in sorbing lindane by WCT. This was further authenticated by kinetics studies at different initial sorbate concentrations, different sorbent sizes, and different agitation speeds besides interruption test. A pore diffusion model was used to fit the data of kinetics in continuously mixed batch reactors (CMBR), and the tortuosity, external resistance, and surface diffusion effects on lindane sorption by WCT were noticed. The tortuosity values of 15 to 28 were obtained for WCT‐lindane system.     

Ionic dye adsorption by zinc oxide nanoparticles

The adsorption behaviour of Basic Red 12, Acid Orange 7 and Acid Blue 1 on zinc oxide nanoparticles (ZNP) has been investigated to understand the physicochemical process involved and to explore the possible use of nanoparticles in the treatment and management of textile waste matter. The dye removal capacity of ZNP towards Basic Red 12, Acid Orange 7 and Acid Blue 1 was found to be 15.64, 6.78 and 6.38 mg g^?1, respectively. The adsorption process was pH dependent and optimum pH values of 9.0, 2.0 and 4.0 were obtained for Basic Red 12, Acid Orange 7 and Acid Blue 1, respectively. Equilibrium was established after 1.0 h for all dyes. Langmuir, Freundlich and Temkin isotherm models were applied to the system. The adsorbent ZNP was characterised using scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffraction (XRD), Brunauer–Emmett–Teller (BET) and Fourier transform infrared (FTIR) techniques. SEM analysis revealed the noticeable nanoporous morphology of the material. The results of FTIR spectroscopy showed that the process is driven by an electrostatic complexation mechanism. XRD studies revealed the nanocrystalline structure of ZNP. BET surface area measurement suggested a high pore volume and large surface area for the adsorbent. The kinetic measurements suggested pseudo-second-order kinetic processes with high regression coefficients and smaller standard error of estimate values and lower residual sum of squares. The thermodynamic measurements suggested that all processes were exothermic and accompanied by negative values for Δ G⁰, Δ S⁰ and Δ H⁰.     

Sorption and desorption kinetics of diuron,fluometuron, prometryn and pyrithiobac sodium in soils

Abstract

The sorption and desorption characteristics of four herbicides (diuron, fluometuron, prometryn and pyrithiobac‐sodium) in three different cotton growing soils of Australia was investigated. Kinetics and equilibrium sorption and desorption isotherms were determined using the batch equilibrium technique. Sorption was rapid (> 80% in 2 h) and sorption equilibrium was achieved within a short period of time (ca 4 h) for all herbicides. Sorption isotherms of the four herbicides were described by Freundlich equation with an r² value > 0.98. The herbicide sorption as measured by the distribution coefficient (K_d) values ranged from 3.24 to 5.71 L/kg for diuron, 0.44 to 1.13 L/kg for fluometuron, 1.78 to 6.04 L/kg for prometryn and 0.22 to 0.59 L/kg for pyrithiobac‐sodium. Sorption of herbicides was higher in the Moree soil than in Narrabri and Wee Waa soils. When the K_d values were normalised to organic carbon content of the soils (K_oC), it suggested that the affinity of the herbicides to the organic carbon increased in the order: pyrithiobac‐sodium < fluometuron < prometryn < diuron. The desorption isotherms were also adequately described by the Freundlich equation. For desorption, all herbicides exhibited hysteresis and the hysteresis was stronger for highly sorbed herbicides (diuron and prometryn) than the weakly sorbed herbicides (fluometuron and pyrithiobac‐sodium). Hysteresis was also quantified as the percentage of sorbed herbicides which is not released during the desorption step ω = [n_ad / n_de ‐1] x 100). Soil type and initial concentration had significant effect on ω. The effect of sorption and desorption properties of these four herbicides on the off‐site transport to contaminate surface and groundwater are also discussed in this paper.     

生化法处理含氨废水动力学研究

对生化法处理含氨废水过去中有重要影响的动力学因素进行了试验研究和分析，得出了利用高效微生物菌群废水中COD和NH3－N的动力学条件，温度为20－35℃，PH为7－8，DO大于2.6mg/L,MLSS大于2.6g/L，C／N小于3。在此条件下处理含氨废水，处理后的出水达到国家化肥行业一级排放标准。     

有机废气的臭氧化过程降解及其动力学

实验研究了有机废气中的1.1-二氧乙烯（CH2=CCl2）在101.3kPa和288～308K下气相臭氧化降解过程及其反应动力学。结果表明，总的反应级数是2级，相对于臭氧和二氯乙烯浓度均为1级。反应速率常数可用方程Arrhenius（k2=8.32exp[-389.7/T]）表示。     

Adsorption behavior of ammonium by a bioadsorbent - Boston ivy leaf powder

The adsorption behaviors of ammonium ions from aqueous solution by a novel bioadsorbent,the Boston ivy (Parthenocissus tricuspidata) leaf powder (BPTL) were investigated.The SEM images and FT-IR spectra were used to characterize BPTL.The mathematical models were used to analyze the adsorption kinetics and isotherms.The optimum pH range for ammonium adsorption by BPTL was found to be 5-10.The adsorption reached equilibrium at 14 hr,and the kinetic data were well fitted by the Logistic model.The intraparticle diffusion was the main rate-controlling step of the adsorption process.The high temperature was favorableto the ammonium adsorption by BPTL,indicating that the adsorption was endothermic.The adsorption equilibrium fitted well to both the Langrnuir model and Freundlich model,and the maximum monolayer adsorption capacities calculated from Langmuir model were 3.37,5.28 and 6.59 mg N/g at 15,25 and 35℃,respectively,which were comparable to those by reported minerals.Both the separation factor (RL) from the Langmuir model and Freundlich exponent (n) suggested that the ammonium adsorption by BPTL was favorable.Therefore,the Boston ivy leaf powder could be considered a novel bioadsorbent for ammonium removal from aqueous solution.     

固定化微生物吸附剂对Cr3+的吸附特性研究

从皮革铬鞣、复鞣污泥等处分离、纯化出4株菌株TP、XB、MY和TQ,采用海藻酸钠悬滴法并添加膨润土制成微生物固定化吸附剂,研究该吸附剂对低质量浓度Cr3+的吸附特性。结果表明,4种固定化颗粒对低质量浓度Cr3+有较好的吸附作用。实验室条件下,当吸附温度为30℃时,6 h后固定化吸附剂进入缓慢吸附和平衡吸附阶段。吸附等温曲线拟合研究表明,不同温度下吸附剂适合不同的等温模型。4种微生物吸附剂均与Lagrange拟二级动力学模型拟合最佳,且吸附量从高到低为TQ、TP、XB、MY。颗粒内扩散模型研究表明,20℃下XB和MY对Cr3+的吸附分为快速吸附和缓慢吸附阶段;30℃和40℃下固定化颗粒均呈现表面吸附—缓慢吸附—平衡吸附过程。热力学研究表明,吸附反应均属于自发进行的吸热过程,并且均是化学吸附。     

黄壤表面电场作用下Cu~(2+)与Zn~(2+)的吸附/解吸动力学研究

利用静态恒流法研究了黄壤表面电场作用下Cu2+与Zn2+的吸附/解吸动力学.结果发现:考虑黄壤表面电场作用下,Cu2+和Zn2+的吸附实验呈现初期强吸附作用下的零级动力学过程和一定时间之后弱吸附作用下的一级动力学过程,与理论预期一致;在Cu2+和Zn2+的解吸实验中,只有前期出现了弱吸附作用下的一级动力学过程,实验结果与理论预期存在差别,原因在于专性吸附的Cu2+、Zn2+很难被解吸下来;在交换/吸附实验中,Cu2+的吸附速率值和平衡吸附量均大于Zn2+,且Cu2+-K+体系的表面电化学参数φ0、σ0、E0均大于Zn2+-K+体系中的对应值,证明了黄壤颗粒表面对Cu2+的吸附作用强于Zn2+;在交换/解吸实验中,Zn2+的解吸速率值和平衡解吸量均大于Cu2+,Zn2+-K+体系的表面电化学参数φ0、σ0、E0均大于Cu2+-K+体系中的对应值,证明Zn2+-K+体系中Zn2+的解吸作用比Cu2+-K+体系中的Cu2+解吸作用强.     

The sorption of selenite from aqueous solutions by pyrite

Selenium (Se) is an essential trace nutrient for mammals; however, the range between deficit and toxic levels is narrow. In this study, the potential sorption of selenite onto pyrite particles from an aqueous solution was investigated. An intraparticle diffusion model was used to describe kinetic data of sorption, yielding diffusivity values of 5 × 10^?7 cm²/s. The Langmuir isotherm equation could be used to describe the experimental data. The fitting results indicated that b and {Se(IV)}_max have values of 0.37 L/mg and 3.49 mg/g, respectively. The sorption of selenite onto the surface of pyrite particles was dependent on a pH range of 2–12, and the quantity of sorption onto pyrite was negatively correlated with pH; that is, the amount of sorption onto pyrite increased with a decrease in pH. In addition, organic matter did not exert a significant effect on removal of selenite. With a reaction time greater than 1 week, sorption of selenite onto pyrite particles was found to partially reduce the amount of elemental Se.