SCOPE: The detection and investigation of metal ions bound in strong complexes in natural waters is a difficult task, due to low concentration of the metal ions themselves, and also of the strong ligands, which, moreover, are often not of a well-defined composition. Here, a method is proposed for the investigation of the speciation of metal ions in natural waters. OBJECTIVE AND METHOD: It is based on the sorption of metal ions on strongly sorbing ion exchange resins, i.e. complexing resins. For this reason the method is called Resin Titration. It has been shown in previous investigations that the concentration of metal ion totally sorbed by a particular resin, and its reaction coefficient in the solution phase in the presence of the resin, can be determined from the sorption data using a simple relationship. Here, a data treatment (the Ruzic linearization method) is proposed for also determining the concentration of the ligands responsible for the complex in equilibrium with the resin. RESULTS: The method was applied to data obtained by Resin Titration of a freshwater and a seawater. Copper(II) and aluminium(III) were considered, using Chelex 100 as a titrant, due to its strong sorbing properties towards these metal ions. The results were: the total metal concentration in equilibrium with the resin, the side reaction coefficients, and the concentration of ligands. In all these cases the ligands forming very strong complexes were found to be at concentration lower than that of the metals. CONCLUSION: The Ruzic linearization method allows the determination of the concentration of the ligands forming very strong complexes in equilibrium with Chelex 100. The reaction coefficient was better determined by the calculation method previously proposed for RT. The ligands responsible for the strong complexes were found to be at low concentration, often lower than that of the metal ions considered. The metal in the original sample is partly bound to these ligands, since the complexes are very strong. Only a part of the metal is linked to weaker ligands, or free. 相似文献
An analytical procedure involving a three-step sequential extraction was used to determine the chemical association of heavy metals (Zn, Cr, Mn and Fe) with the major phases (exchangable, reducible and oxidizable) in samples from a fishpond of estuarine sediments. The pond is located in the Capibaribe River estuary, within the boundaries of the city of Recife, in the State of Pernambuco in the northeast of Brazil. The total metal content was determined as well. All metals were extracted from the residual fraction at a percentage greater than 50%. 相似文献
Air pollution control devices (APCDs) are installed at coal-fired power plants for air pollutant regulation. Selective catalytic reduction
(SCR) and wet flue gas desulfurization (FGD) systems have the co-benefits of air pollutant and mercury removal. Configuration
and operational conditions of APCDs and mercury speciation a ect mercury removal e ciently at coal-fired utilities. The Ontario
Hydro Method (OHM) recommended by the U.S. Environmental Protection Agency (EPA) was used to determine mercury speciation
simultaneously at five sampling locations through SCR-ESP-FGD at a 190 MW unit. Chlorine in coal had been suggested as a factor
a ecting the mercury speciation in flue gas; and low-chlorine coal was purported to produce less oxidized mercury (Hg2+) and more
elemental mercury (Hg0) at the SCR inlet compared to higher chlorine coal. SCR could oxidize elemental mercury into oxidized
mercury when SCR was in service, and oxidation e ciency reached 71.0%. Therefore, oxidized mercury removal e ciency was
enhanced through a wet FGD system. In the non-ozone season, about 89.5%–96.8% of oxidized mercury was controlled, but only
54.9%–68.8% of the total mercury was captured through wet FGD. Oxidized mercury removal e ciency was 95.9%–98.0%, and there
was a big di erence in the total mercury removal e ciencies from 78.0% to 90.2% in the ozone season. Mercury mass balance was
evaluated to validate reliability of OHM testing data, and the ratio of mercury input in the coal to mercury output at the stack was from
0.84 to 1.08. 相似文献
Environmental safety data are presented for [S,S]-Ethylene Diamine Disuccinate ([S,S]EDDS), a new, biodegradable, strong transition metal chelator. An environmental risk assessment for its use in detergent applications, which takes into account the chelating properties of [S,S]-EDDS, is proposed.
A property of [S,S]-EDDS that distinguishes it from other strong transition metal chelators is its, “ready” and transparent (no recalcitrant metabolites) biodegradation profile. Because its sorption to activated sludge solids is low ( Kp of 40 1/kg), removal of [S,S]EDDS during sewage treatment, which is greater than 96% as determined by the Continuous Activated Sludge test , is mainly ascribed to biodegradation. At projected use volumes in detergent applications [S,S] - EDDS predicted steady-state concentration in rivers leaving the mixing zone will be below 5 pg/I due to rapid biodegradation. [S,S]-EDDS exhibits low toxicity to fish and Daphnia ( both EC50s> 1000 mg/l). By contrast, due to limitation of the algal test for chelators apparent toxicity was observed (EC50 = 0.290 mg/l, NOEC - No observable Effect Concentration = 0.125 mg/l). Schowanek et al. [1] demonstrated that this is not toxicity sensu stricto but a chelation effect of trace metals in the test medium and of resulting essential nutrients limitation. This requires specific attention when the results of algal toxicity are to be extrapolated to a field situation to perform realistic risk assessment. Metal speciation calculations, using MINEQL+, show that at the predicted environmental concentrations of [S,S] - EDDS (1–5 μg/l), such a chelation effect would be insignificant. These calculations allow to estimate the NOEC for chelation effects in the field to be in the range of 0.250-0.500 mg/l, depending on the background water chemistry. These values are well above the laboratory NOEC.
An environmental risk assessment was performed using the EUSES (1.0) program. EUSES is currently the EU recommended tool for conducting risk assessments (TGD 1995). It was applied to estimate the river water and soil concentrations from production, formulation and private use life stages. The estimated PEC/PNEC ratio in all relevant environmental compartments is smaller than 1, indicating “no immediate concern” at the anticipated usage level. 相似文献