Enhancement of thermophilic anaerobic digestion of thickened waste activated sludge by combined microwave and alkaline pretreatment

Pretreatment of thickened waste activated sludge (TWAS) by combined microwave and alkaline pretreatment (MAP) was studied to improve thermophilic anaerobic digestion efficiency. Uniform design was applied to determine the combination of target temperature (110–210°C), microwave holding time (1–51 min), and NaOH dose (0–2.5 g NaOH/g suspended solids (SS)) in terms of their effect on volatile suspended solids (VSS) solubilization. Maximum solubilization ratio (85.1%) of VSS was observed at 210°C with 0.2 g-NaOH/g-SS and 35 min holding time. The effects of 12 different pretreatment methods were investigated in 28 thermophilic batch reactors by monitoring cumulative methane production (CMP). Improvements in methane production in the TWAS were directly related to the microwave and alkaline pretreatment of the sludge. The highest CMP was a 27% improvement over the control. In spite of the increase in soluble chemical oxygen demand concentration and the decrease in dewaterability of digested sludge, a semi-continuous thermophilic reactor fed with pretreated TWAS without neutralization (at 170°C with 1 min holding time and 0.05 g NaOH/g SS) was stable and functioned well, with volatile solid (VS) and total chemical oxygen demand (TCOD) reductions of 28% and 18%, respectively, which were higher than those of the control system. Additionally, methane yields (L@STP/g-CODadded, at standard temperature and pressure (STP) conditions of 0°C and 101.325 kPa) and (L@STP/g VSadded) increased by 17% and 13%, respectively, compared to the control reactor.     

天津市夏季蜂窝状溶蚀器涂层溶液浓度确定的实验研究

于2013年7月1日～8月31日,在天津市南开大学理化楼楼顶,采用蜂窝状溶蚀器进行了溶蚀器涂层溶液最适浓度的探究实验.结果表明,在天津夏季,蜂窝状溶蚀器的碳酸钠涂层溶液最适浓度为3%,柠檬酸涂层溶液最适浓度为6%.含有溶蚀器系统的颗粒物采样法与传统采样法对比发现,含蜂窝状溶蚀器的采样系统所得到的PM2.5样品浓度有86%低于传统方法所得到的PM2.5样品浓度,其原因主要为1酸/碱性气体被去除,使其无法与富集在采样膜上的颗粒物发生反应,也无法吸附到颗粒物上;2溶蚀器系统采样过程中,部分颗粒物被捕集到溶蚀器上;3酸/碱性气体被去除,导致气-粒平衡被打破,部分颗粒物组分向气态转化.     

浅析废烟气脱硝催化剂环境管理

随着"十二五"期间国家对氮氧化物排放的控制越来越严格,选择性催化还原(SCR)烟气脱硝技术被广泛应用于火电厂的脱硝工程。本文介绍我国目前废烟气脱硝催化剂的产生情况、存在的环境风险以及发达国家的管理经验,从而提出我国将废烟气脱硝催化剂纳入危险废物管理,推行危险废物经营许可证制度,加强产生和经营单位的日常监督管理,从而促进行业的健康可持续发展。     

赤泥碱性调控研究进展

赤泥是氧化铝工业生产过程产生的强碱性固体废弃物,资源化利用难、环境风险高,严重制约了氧化铝行业的可持续发展.赤泥土壤化是实现规模化处置赤泥的一种可行方法,而碱性调控则是赤泥土壤化的关键环节.论文在综述氧化铝生产过程碱性物质形成过程的基础上,从可溶性碱和化学结合碱角度分析了赤泥碱性物质的赋存状态,阐述了国内外化学调碱法和生物调碱法的研究进展和碱性转化机制,剖析了赤泥碱性调控方面存在的问题,提出了赤泥碱性调控研究的发展方向.这将为赤泥规模化处置和堆场生态重建、保障氧化铝工业的健康发展提供科学参考.     

废旧锌锰电池生物淋滤-水热法制备纳米锰锌铁氧体

以氧化硫硫杆菌(A.thiooxidans)和氧化亚铁钩端螺旋菌(L.ferrooxidans)为混合淋滤菌株对废旧锌锰电池进行了生物浸提,并以获取的淋滤液为前驱体,采用水热法制备出系列锰锌铁氧体软磁材料(Mn_(1-x)Zn_xFe_2O_4,x=0.2~0.8);结合X射线衍射(XRD)、扫描电镜-能谱(SEMEDX)、振动样品磁强计(VSM)、透射电镜(TEM)、红外光谱(FT-IR)、热重-差热分析(TG-DTA)等表征手段对制备材料的结构、形貌、磁学性能和稳定性进行分析.结果表明,在5%固液比(质量体积比,5 g/100 mL,以下均表述为"5%固液比")下,经过5 d的外源酸调控生物浸提,分别获得了84.5%、63.2%的Zn、Mn浸出效率;当Zn∶Mn∶Fe=0.4∶0.6∶2.0(物质的量比,即x=0.4)时,制备的纳米级Mn_(0.6)Zn_(0.4)Fe_2O_4性能最优,属纯相的立方尖晶石结构,颗粒分布均匀,饱和磁化强度(M_s)、剩余磁化强度(M_r)和矫顽力(H_c)分别为68.9 emu·g~(-1)、4.7 emu·g~(-1)和53.6 Oe,具有热稳定性和耐酸碱性,有望成为一种新型的水处理磁性材料.     

松嫩平原西部碱尘气溶胶的时段变化及其气候影响因素分析

利用耦合等离子体发射光谱测试技术(ICP-AES)对松嫩平原西部2003年7月到2004年5月间获得的大气总悬浮颗粒物(TSP)样品进行了元素分析,并结合气象资料和TSP质量浓度,初步确定了碱尘活动年际内的演变规律及其主要控制因素.结果表明,TSP质量浓度的高峰时段是早春,其元素总体浓度亦高于其它时段,其中Na元素浓度具有明显的高值,表明碱尘在该时段为TSP的主要成分;晚春时段区域沙尘影响加强,很难监测本地碱尘活动;夏季,碱尘的3种重要元素(Na、Ca、K)含量增加,表明夏季有碱尘活动,与TSP浓度偏高吻合;秋季,碱尘和区域沙尘的活动均减弱.影响碱尘活动的气候因子主要是风力、降水量、温度、日照和湿度,但不同时段其主导作用不同.     

Oxidative stress and DNA damages induced by cadmium accumulation

Experimental evidence shows that cadmium （Cd） could induce oxidative stress and then causes DNA damage in animal cells, however, whether such effect exists in plants is still unclear. In the present study, Vicia faba plants was exposed to 5 and 10 mg/L Cd for 4 d to investigate the distribution of Cd in plant, the metal effects on the cell lipids, antioxidative enzymes and DNA damages in leaves. Cd induced an increase in Cd concentrations in plants. An enhanced level of lipid peroxidation in leaves and an enhanced concentration of H2O2 in root tissues suggested that Cd caused oxidative stress in Vicia faba. Compared with control, Cd-induced enhancement in superoxide dismutase activity was significant at 5 mg/L than at 10 mg/kg in leaves, by contrast, catalase and peroxidaseactivities were significantly suppressed by Cd addition. DNA damage was detected by neutral/neutral, alkaline/neutral and alkaline/alkaline Comet assay. Increased levels of DNA damages induced by Cd occurred with reference to oxidative stress in leaves, therefore, oxidative stress induced by Cd accumulation in plants contributed to DNA damages and was possibly an important mechanism of Cd-phytotoxicity in Vicia faba plants.     

Characterization of coffee residues pellets and their performance in a residential combustor

Spent coffee grounds (SCG) and coffee husks (CH) were evaluated as biofuels, after densification, for energy production. CH represent a specific problem for the coffee industry due to a low calorific value, high ash content, and a very low bulk density. Hence, the energetic potential of SCG (95 wt%)/CH (5 wt%) blend and pure SCG (100%) were examined. The blend of SCG and CH was limited to 5 wt% of CH because of the low bulk density of CH. Therefore, physicochemical and energetic characterizations of the produced pellets were performed. Thermogravimetric analyses were performed under nitrogen and air atmospheres to evaluate the CH behavior in the blend. Characterization study shows that both produced pellets could reach the French Agropellets standard (AQI). Thermal degradation showed that the mean reactivity of the SCG/HC pellets was higher than pure SCG. Then, combustion experiments were performed in a domestic combustor, after modification of the boiler power in order to improve its energetic performances. The presence of CH led to a rise of CO, NOx, VOC’s, and particle emissions. Nevertheless, the performances of the biofuels are almost in agreement the NF EN 12809 standard.     

Application of 1D and 2D MFR reactor technology for the isolation of insecticidal and anti-microbial properties from pyrolysis bio-oils

Valuable chemicals can be separated from agricultural residues by chemical or thermochemical processes. The application of pyrolysis has already been demonstrated as an efficient means to produce a liquid with a high concentration of desired product. The objective of this study was to apply an insect and microorganism bioassay-guided approach to separate and isolate pesticidal compounds from bio-oil produced through biomass pyrolysis. Tobacco leaf (Nicotianata bacum), tomato plant (Solanum lycopersicum), and spent coffee (Coffea arabica) grounds were pyrolyzed at 10°C/min from ambient to 565°C using the mechanically fluidized reactor (MFR). With one-dimensional (1D) MFR pyrolysis, the composition of the product vapors varied as the reactor temperature was raised allowing for the selection of the temperature range that corresponds to vapors with a high concentration of pesticidal properties. Further product separation was performed in a fractional condensation train, or 2D MFR pyrolysis, thus allowing for the separation of vapor components according to their condensation temperature. The 300–400°C tobacco and tomato bio-oil cuts from the 1D MFR showed the highest insecticidal and anti-microbial activity compared to the other bio-oil cuts. The 300–350 and 350–400°C bio-oil cuts produced by 2D MFR had the highest insecticidal activity when the bio-oil was collected from the 210°C condenser. The tobacco and tomato bio-oil had similar insecticidal activity (LC₅₀ of 2.1 and 2.2 mg/mL) when the bio-oil was collected in the 210°C condenser from the 300–350°C reactor temperature gases. The 2D MFR does concentrate the pesticidal products compared to the 1D MFR and thus can reduce the need for further separation steps such as solvent extraction.     

Dechlorination of polyvinyl chloride in NaOH/ethylene glycol solution by microwave heating

This study investigated the dehydrochlorination of flexible polyvinyl chloride (PVC) containing 59.2% PVC, 29.7% dioctyl phthalate (DOP), and approximately 12% stabilizers. Flexible PVC was treated with NaOH/ethylene glycol (NaOH/EG) solutions at NaOH concentrations in the range 0.5–4 mol/l and was heated in a microwave heater at a temperature between 100° and 160°C for 0–30 min. All chlorides were completely eliminated by internal heating at 160°C using microwaves for 10 min in a 1 mol/l NaOH/EG solution, and the residue was made up of hydrocarbons. The weight loss rate reached a maximum of 74.7% at a temperature of 160°C. It was discovered that the use of microwaves significantly shortened the reaction time compared to using conventional electric heaters or other external heating systems and also allowed the use of lower concentrations of NaOH. Chemical Feedstock Recycling & Other Innovative Recycling Techniques 6