中国菌糠露天焚烧污染物排放时空分布特征

基于我国2000~2017年食用菌年产量数据,采用排放因子法估算了菌糠露天焚烧的污染物排放量,利用Mann-Kendall法和聚类分析法分析了排放量的时空分布特征,使用回归分析法预测了污染物的排放趋势.结果表明：（1）2000~2017年全国菌糠露天焚烧污染物排放量持续上升,PM_2.5、CO₂、CO、CH₄、NMVOCs、PAHs、NO_x、SO₂累积排放量分别为1.40×10⁶,3.48×10⁸,1.99×10⁷,8.43×10⁵,2.08×10⁶,3.00×10⁴,6.34×10⁵,8.29×10⁴t;（2）污染物排放量较高的省区包括山东、黑龙江、浙江、湖南、江苏、福建和河南,排放量较低的省区包括贵州、宁夏、天津、北京、新疆、重庆、甘肃;（3）预计2021年菌糠焚烧污染物总排放量高达4.25×10⁷t,其对生物质焚烧污染物总排放量的贡献率约为19.82%.我国菌糠露天焚烧污染物排放规模较大,应予以重点关注.     

HNO_3─KI─MIBK萃取／原子吸收光谱法测定固体废物浸提液中的微量银

采用选择性较好的ＨＮＯ３—ＫＩ—ＭＩＢＫ萃取体系对铋渣和尾矿渣浸出液中的痕量银进行预分离富集后，用火焰原子吸收法（ＡＡＳ）进行测定。此法不仅变异系数小（约为３．１％），而且检出限比直接火焰ＡＡＳ法降低两个数量级，达０．５ｎｇ／ｍｌ．另外，还就作品细度对银测定结果的影响原因做了初步探讨。     

乙烯废碱液综合治理技术探讨

分析了乙烯裂解气碱洗过程所排放废液的组成及性质，讨论了该废液的除油方法及综合治理和利用的途径。     

复合混凝剂处理印染废水

为了处理高浓度、高色度、高COD的印染废水，利用硫酸亚铁、工业废酸和金属下脚料自行配制了复合混凝剂，并将其与聚合双酸铝铁、聚合氯化铝铁、硫酸亚铁对印染废水的混凝效果进行对比。研究表明，复合混凝剂处理印染废水具有成本低、效果好的特点。当硫酸亚铁的投加量为200mg/L，复合混凝剂的投加量为1280mg／L，PAM的用量为2mg／L时，脱色率达94．9％，COD去除率达78．1％，悬浮固体（SS）去除率达90．9％。     

亚铵制浆黑液非无菌操作连续发酵生产酵母

从土壤中筛选出能在亚铵黑液中生长的毕赤酵母菌株（Ｐｉｃｈｉａ ｓｐ．Ｎｏ．１）经耐毒驯化后，可接种于酸析脱木素和汽提脱毒后的亚铵黑液中，在非无菌操作条件下连续发酵生产酵母菌体，该菌生产迅速，连续培养衡释率达０．２６ｈ＾－１，总糖的酵母得率为０．４８ｇ／ｇ（ＴＳ），ＣＯＤ去除２３％，菌体易絮凝，可自然沉降分离。     

浅析废烟气脱硝催化剂环境管理

随着"十二五"期间国家对氮氧化物排放的控制越来越严格,选择性催化还原(SCR)烟气脱硝技术被广泛应用于火电厂的脱硝工程。本文介绍我国目前废烟气脱硝催化剂的产生情况、存在的环境风险以及发达国家的管理经验,从而提出我国将废烟气脱硝催化剂纳入危险废物管理,推行危险废物经营许可证制度,加强产生和经营单位的日常监督管理,从而促进行业的健康可持续发展。     

废旧锌锰电池生物淋滤-水热法制备纳米锰锌铁氧体

以氧化硫硫杆菌(A.thiooxidans)和氧化亚铁钩端螺旋菌(L.ferrooxidans)为混合淋滤菌株对废旧锌锰电池进行了生物浸提,并以获取的淋滤液为前驱体,采用水热法制备出系列锰锌铁氧体软磁材料(Mn_(1-x)Zn_xFe_2O_4,x=0.2~0.8);结合X射线衍射(XRD)、扫描电镜-能谱(SEMEDX)、振动样品磁强计(VSM)、透射电镜(TEM)、红外光谱(FT-IR)、热重-差热分析(TG-DTA)等表征手段对制备材料的结构、形貌、磁学性能和稳定性进行分析.结果表明,在5%固液比(质量体积比,5 g/100 mL,以下均表述为"5%固液比")下,经过5 d的外源酸调控生物浸提,分别获得了84.5%、63.2%的Zn、Mn浸出效率;当Zn∶Mn∶Fe=0.4∶0.6∶2.0(物质的量比,即x=0.4)时,制备的纳米级Mn_(0.6)Zn_(0.4)Fe_2O_4性能最优,属纯相的立方尖晶石结构,颗粒分布均匀,饱和磁化强度(M_s)、剩余磁化强度(M_r)和矫顽力(H_c)分别为68.9 emu·g~(-1)、4.7 emu·g~(-1)和53.6 Oe,具有热稳定性和耐酸碱性,有望成为一种新型的水处理磁性材料.     

湿式氧化法处理汽油碱渣和液态烃碱渣

介绍了湿式氧化法处理洛阳分公司汽油碱渣和液态烃碱渣的工艺原理和运行效果.     

Characterization of coffee residues pellets and their performance in a residential combustor

Spent coffee grounds (SCG) and coffee husks (CH) were evaluated as biofuels, after densification, for energy production. CH represent a specific problem for the coffee industry due to a low calorific value, high ash content, and a very low bulk density. Hence, the energetic potential of SCG (95 wt%)/CH (5 wt%) blend and pure SCG (100%) were examined. The blend of SCG and CH was limited to 5 wt% of CH because of the low bulk density of CH. Therefore, physicochemical and energetic characterizations of the produced pellets were performed. Thermogravimetric analyses were performed under nitrogen and air atmospheres to evaluate the CH behavior in the blend. Characterization study shows that both produced pellets could reach the French Agropellets standard (AQI). Thermal degradation showed that the mean reactivity of the SCG/HC pellets was higher than pure SCG. Then, combustion experiments were performed in a domestic combustor, after modification of the boiler power in order to improve its energetic performances. The presence of CH led to a rise of CO, NOx, VOC’s, and particle emissions. Nevertheless, the performances of the biofuels are almost in agreement the NF EN 12809 standard.     

Application of 1D and 2D MFR reactor technology for the isolation of insecticidal and anti-microbial properties from pyrolysis bio-oils

Valuable chemicals can be separated from agricultural residues by chemical or thermochemical processes. The application of pyrolysis has already been demonstrated as an efficient means to produce a liquid with a high concentration of desired product. The objective of this study was to apply an insect and microorganism bioassay-guided approach to separate and isolate pesticidal compounds from bio-oil produced through biomass pyrolysis. Tobacco leaf (Nicotianata bacum), tomato plant (Solanum lycopersicum), and spent coffee (Coffea arabica) grounds were pyrolyzed at 10°C/min from ambient to 565°C using the mechanically fluidized reactor (MFR). With one-dimensional (1D) MFR pyrolysis, the composition of the product vapors varied as the reactor temperature was raised allowing for the selection of the temperature range that corresponds to vapors with a high concentration of pesticidal properties. Further product separation was performed in a fractional condensation train, or 2D MFR pyrolysis, thus allowing for the separation of vapor components according to their condensation temperature. The 300–400°C tobacco and tomato bio-oil cuts from the 1D MFR showed the highest insecticidal and anti-microbial activity compared to the other bio-oil cuts. The 300–350 and 350–400°C bio-oil cuts produced by 2D MFR had the highest insecticidal activity when the bio-oil was collected from the 210°C condenser. The tobacco and tomato bio-oil had similar insecticidal activity (LC₅₀ of 2.1 and 2.2 mg/mL) when the bio-oil was collected in the 210°C condenser from the 300–350°C reactor temperature gases. The 2D MFR does concentrate the pesticidal products compared to the 1D MFR and thus can reduce the need for further separation steps such as solvent extraction.