超滤技术处理造纸废水的研究与应用

介绍了超滤技术及其优点,其在制浆废液、漂白废水、纸机白水的处理中的研究应用进展;分析了超滤技术处理造纸废水中的膜污染;指出了影响超滤技术处理造纸废水应用的因素,最后提出了今后的研究方向。     

印制电路板酸性蚀刻废液的膜电解再生

高度精细化线路和高层数印制电路板产量的增加,导致酸性蚀刻废液的排放量越来越大,对环境的负荷也随之增大.介绍了酸性蚀刻废液膜电解再生的基本原理,进行了中试规模的应用研究,并与其他电解再生方法进行技术与经济比较分析.结果表明,在槽电压为5V、电解时间为2h的条件下,酸性蚀刻废液的氧化还原电位由480 mV升至540mV,所...     

Penetration analysis of elements and bioleaching treatment of spent refractory for recycling

Acidithiobacillus ferrooxidans ATCC23270 and Acidithiobacillus thiooxidans TM-32 were used for bioleaching of spent refractories of aluminium and copper melting furnaces for their recycling.Firstly,penetration of elements into aluminium melting furnace refractory was investigated and it was found that up to 7 cm from surface was contaminated.Comparison on leaching efficiency by the strains ATCC23270 and TM-32 found that the strain ATCC23270 could treat larger amount of the refractories than the strain TM-32 could do.In the experiment of bioleaching of spent refractory aluminium melting furnace by the strain ATCC23270,high leaching efficiency were obtained on Al,Si,and Ca,and extremely low leaching performance was,however,shown on the rest of elements i.e.,Na,Mn,and Zn.Under the strain TM-32 use,relatively high leaching performance was recognized on Al,Si,Ca,Na,Mn,and Zn.In the experiment of bioleaching for spent refractory copper melting furnace,almost the same leaching trends were shown on Cu,Zn,Al,and Si under the strains ACTT23270 and TM-32 uses.     

废弃SCR催化剂中钒和钨的浸出及回收

采用NaOH溶液一次性浸出废弃SCR催化剂中的钒和钨,并用硫酸对浸出液进行除杂,再利用NH4Cl和硫酸分步对浸出液中的钒和钨进行沉淀回收。在NaOH质量分数40%、液固比8、浸出时间4 h、浸出温度90℃的最佳碱浸条件下,钒和钨的浸出率分别达到90.44%和84.49%。除杂过程的铝去除率达到100%,硅去除率达到77.56%。在沉钒pH为8.0、n(NH_4~+)∶n(V)为4的最佳沉钒条件下,钒回收率达到82.79%。在n(SO_4~(2-))∶n(W)为2的最佳沉钨条件下,钨回收率达到76.41%。     

氨基磺酸溶液浸出废锂离子电池负极活性材料中的锂

随着锂离子电池的广泛应用,产生了大量废锂离子电池,其负极活性材料中积累了高品位的锂。锂作为一种稀有金属,对其进行回收利用很有意义。选取了无毒、稳定性好的氨基磺酸作为浸出剂,浸取废锂离子电池负极活性材料中的锂,考察了预处理方式对负极活性材料成分和结构的影响以及浸出条件对锂浸出率的影响。结果表明:600℃下煅烧4 h,可完全去除附着在负极活性材料表面的有机物;在氨基磺酸浓度0.75 mol/L、固液比5 g/L、浸出温度40℃、浸出时间45 min的最佳浸出条件下,负极活性材料中锂浸出率达97.2%。     

Earthworms to assess the innocuousness of spent biomixtures employed for glyphosate degradation

In this study, the innocuousness of different biomixtures employed for glyphosate degradation was tested through Eisenia fetida earthworms. Eight biomixtures were prepared with local materials: alfalfa straw (AS), wheat stubble (WS), river waste (RW) and two different soils (A and B). Each biomixture was divided into two equal portions: one without glyphosate application (control substrate) and the other was sprayed with a commercial glyphosate formulation of 1,000 mg glyphosate a.i. kg^?1 biomixture (applied substrate). The bioassay started when all sprayed biomixtures reached high percentages of glyphosate degradation (spent biomixtures). Three parameters were studied: survival, adults and juveniles biomass and reproduction. The results allowed the identification of three biomixtures (AWS, BWS and BWSRW) for good maintenance and development of E. fetida. In addition, at the end of the bioassay two of the viable biomixtures (AWS and BWS) showed the highest performance of juvenile earthworms compared to a reference soil. The Principal Component Analysis (PCA) indicated that the biomixtures containing high silt and clay percentages and minor density renders higher values of earthworm growth and reproduction. Therefore, these innocuous biomixtures can be used as organic amendments or recycled materials for new treatments on biobeds.     

废无汞碱性电池极性材料制备锰锌铁氧体磁性纳米颗粒

以硝酸浸取废无汞碱性电池极性材料,再加入硝酸铁及蔗糖生成前驱体,最后通过焙烧制得锰锌铁氧体磁性纳米颗粒。优化了酸浸和焙烧条件,采用FTIR和DTA-TG技术研究了前驱体的形成和热解过程,采用XRD、FTIR、TEM技术和振动样品磁强计对锰锌铁氧体进行了表征。结果表明:废无汞碱性电池极性材料酸浸的最佳条件为H_2O_2加入量3%(w)、液固比10 mL/g、稀硝酸浓度4 mol/L、浸取温度40℃,该条件下浸取10 min锰和锌的浸出率均可达100%;所得前驱体为葡萄糖酸盐,其最佳焙烧条件为焙烧温度450℃、焙烧时间2 h;最佳条件下所得锰锌铁氧体为尖晶石型Mn_(0.5)Zn_(0.5)Fe_2O_4,其颗粒为球形、大小均匀,且磁性能优良。     

微波焙烧法与马弗炉焙烧法处理废脱硝催化剂的效果比较

用Na_2CO_3作为助溶剂、Na_2O_2作为消解剂,采用微波焙烧法和马弗炉焙烧法消解处理废钒钨钛脱硝催化剂。通过XRF、BET、XRD和NH_3-TPD技术对两种消解方法制得的钛钨粉样品进行了表征。表征结果显示,与马弗炉焙烧法相比,微波焙烧法得到的钛钨粉纯度更高,TiO_2与WO_3含量之和大于96.7%(w),且该钛钨粉还具有更高的比表面积和酸性,可以作为钒钨钛脱硝催化剂的生产原料再利用。     

乙烯废碱液的再生

开发了除油-苛化-脱硫组合技术处理乙烯废碱液工艺,考察了影响各级处理效果的主要因素.实验结果表明:经石英砂-聚丙烯腈纤维膜-强碱性阴离子交换树脂组合装置除油后,碱液中油类物质质量浓度小于2 mg/L,NaOH,Na_2CO_3,Na_2S等无机组分含量基本不变;经苛化-脱硫处理后碱液中Na_2CO_3和Na_2S质量浓度分别小于4 430 mg/L和4 480 mg/L;再生碱液的流体力学性质及对酸性气体的吸收性能均可满足乙烯裂解气碱洗要求.     

溶剂萃取法提取废旧碱性电池中的有价成分

为回收利用废旧电池，进行了溶剂萃取法提取碱性废弃电池中锌、锰金属的试验研究。选择南孚（AA）碱性废电池为处理样品，通过粉碎、水浸、酸浸等步骤，获得含锌、锰离子的稀溶液，并利用模拟体系得到的萃取结果进行浸出液的萃取性能试验研究。结果表明，每个废电池填充物中含锌和锰分别为0.25g和0.36g，具有可观的回收价值；采用完全皂化的二（2－乙基己基）磷酸（D2EHPA）／煤油为萃取剂提取含锌锰的酸浸出液，一级萃取就可获得60％以上的提取率。