Effect of two TiO2 nanoparticles on the growth of unicellular green algae using the OECD 201 test guideline: influence of the exposure system

This work aimed at assessing the influence of different exposure systems to perform the commonly used OECD 201 freshwater algal growth inhibition test in the context of nanoparticles hazard assessment. Two distinct TiO₂ nanoparticles were considered and three different exposure systems were investigated: Erlenmeyers flasks and 24-well microplates (both using an orbital shake system), and an alternative system using cylindrical vials and magnetic stirring. All three systems are in accordance with the OECD 201 test guideline recommendations. We concluded that the exposure systems applied to achieve the test can substantially affect the ecotoxicological results and the subsequent calculated ECx. The selected systems influenced both the interaction between algal cells and TiO₂ nanoparticles as well as the growth inhibition recorded. Disparities in ecotoxicity relative to the TiO₂ nanoparticles tested were also observed and are finally discussed.     

焦化厂静电与防火防爆技术

从安全生产的角度出发,介绍了焦化厂的生产工序及设备概况;从固体、液体、粉体、气体和人体等五个方面讨论了静电的产生机理以及静电的危害性质;重点探讨了防范静电危害的技术措施,其中分析了静电火灾和爆炸事故发生的条件,并提出了静电危害的防护对策,主要包括:工艺控制法、泄漏法、接地法、中和电荷法、封闭消尖法、防人体静电法。     

BS EN ISO 20345：2011《个体防护装备安全鞋》标准的解析和建议

本文通过对最新的BS EN ISO 20345：2011《个体防护装备安全鞋》标准的列表介绍和概括性分析,找出了新标准检测项目仍存在的遗留问题和未考虑到的缺陷以及需要界定的术语,并提出了今后标准的再修订意见。此再修订意见的给出,为推动今后与安全鞋标准BS EN ISO 20345：2011属于同一体系的我国GB 21148-2007《个体防护装备安全鞋》标准修订提供参考意见。     

基于能位测定和示踪检测法的地下煤火漏风状态研究

应用能位测定法和示踪检测技术联合检测了鸡西老二井火区地下漏风状态。通过测试计算相对总压值得出了火区范围内井巷系统与采空区的风流关系,进而定性确定了火区内老二井与胜利井之间存在的可能漏风路径。在此基础上,利用瞬时释放示踪气体法确定了胜利井和老二井间的漏风方向和漏风速度,计算得出了火区下采空区内平均直线漏风风速为0.13m/s,漏风量为776m3/min。研究结果为矿区采取针对性的防灭火措施提供依据,并为同类问题的解决提供参考。     

车用环向缠绕气瓶原型选型分析与建议

针对业内对车用环向缠绕气瓶设计文件鉴定和型式试验工作中存在选型分歧这一实际问题,通过综合分析气瓶设计规则、型式试验规则和产品标准的要求,对该产品的原型选择进行讨论,提出一个能够符合国家标准、合理体现制造厂家诉求、且能与设计鉴定、型式试验工作相适应的选型建议。     

一起钢质无缝气瓶爆炸事故技术分析

文章简要描述了一起消防气体灭火钢质气瓶爆炸事故,对爆炸气瓶进行了断口分析、金相试验和理化试验,并分析了事故的原因,提醒制造厂家规范制造工艺,对预防类似事故的发生具有一定的参考意义。     

Validation of the UN test method N.5

Many substances react with water in such a way that flammable gases are formed. For transport issues this reaction may possess a considerable hazard especially if the cargo is wetted by rain or by water from other sources. In the UN Recommendations on the Transport of Dangerous Goods these kinds of problems are addressed. The UN test N.5 “Test method for substances which in contact with water emit flammable gases” corresponds to this hazard. Classification according to the test method is done by measurement of the gas evolution rate of the flammable gas by any suitable procedure. At BAM a gravimetric approach is used to measure the gas evolution rate. In this paper we present the evaluation of the apparatus by means of an absolute calibration routine utilizing a reaction where a known amount of gas is produced as well as the evaluation of important parameters influencing the gas evolution rate using different substances. It can be shown that the apparatus is capable of measuring absolute gas volumes as low as 6 mL with an acceptable error of about 17% as determined from the reaction of Mg with demineralized water.     

氧化沟工艺处理火车站废水的运行与调试

以信阳市火车北站污水处理工程为例．介绍了以一体化氧化沟工艺为主的处理工艺及其主要构筑物如：泵井、平流沉砂池、氧化沟以及接触消毒池的结构特点和设计水力负荷条件等。针对火车站废水特有的含油污量高、可生化性差的特点．指出了其运行与调试过程中应注意的问题。     

DMF降解菌MBYD-1的分离、鉴定及降解特性

从农药厂污水处理池的活性污泥中分离得到一株能以二甲基甲酰胺(DMF)为唯一碳、氮源生长的菌株MBYD-1.经形态观察、生理生化实验及16S rRNA基因序列分析,将菌株初步鉴定为假单胞菌属 (Pseudomonas sp.).菌株MBYD-1降解DMF的最适条件为:pH 7.0,30℃.当DMF浓度为400mg/L,接种量为2%时,菌株能在72h内将DMF完全矿化.底物广谱性实验表明,菌株MBYD-1能在甲酸盐和甲醛中很好地生长,在甲酰胺中的生长情况优于二甲胺.     

Leaching characteristics of bisphenol A from epoxy-resin pavement materials

We investigated the leaching characteristics of bisphenol A (BPA) from two kinds of epoxy-resin pavement materials, one containing epoxy resins (EPs) and the other containing epoxy-acrylate resins (EPAs). Both samples contained residual BPA monomer, at levels of 9.0?µg?g^?1 for the EP resin sample and 4.4?µg?g^?1 for the EPA resin sample. These amounts were larger than amounts previously measured for polycarbonate samples. The amount of BPA leached from the samples increased with temperature. The leaching of BPA from EP was more strongly affected by temperature than the leaching from EPA. The pH also affected the amount of leached BPA. The maximum leached amount was observed under alkaline conditions (pH 10.8) for both sample types. The amounts of BPA that might leach from pavement materials during 1?h of heavy rain were estimated to be 0.9?µg?m^?2 for EP and 3.5?µg?m^?2 for EPA. Our results indicate that EPs disposed of in waste landfills without any treatment may be a source of BPA in leachate at landfill sites.