2000年1月15日姚安6.5级地震余震序列震源机制解与震源区应力场分析

本文利用垂直向的Pg和Sg波的最大振幅比方法,计算2000年1月15日云南姚安6.5级地震后余震序列震源机制解,通过统计和系统聚类分析,再结合震中分布图,综合分析了云南姚安6.5级地震的震源机制解和震源区应力场破裂特征,研究结果表明震源断层的走向为SEE-NWW占主导,其平均解为120°,震区主压应力轴平均解为145°,即SSE向,与震源区现今构造应力场主压应力方向一致,表明余震的应力场主要受区域应力场的控制.     

Ecophysiological constraints associated with aggression,and evolution toward pacifism in Spalax ehrenbergi

Evolution from a solitary way of life to sociality involves changes in the modalities of within-population aggression. This paper is concerned with environmental causes of variation in aggression within the complex of mole-rat species Spalax ehrenbergi. We focus on physiological constraints associated with aggressive behaviour, i.e. those resulting from emotional arousal and thus stress. Aggression, social stress sensitivity and urine osmolarity were studied in males of two chromosomal species of Spalax ehrenbergi, 2n = 52 (occurring in cool humid areas) and 2n = 60 (occurring in warm arid zones). Males with 2n = 52 reached a higher level of within-population aggression during a 3-round tournament (an average, 488 ± 140 acts) than males with 2n = 60 (163 ± 54 acts). The species with 2n = 52 displayed a higher corticosterone response after a social encounter (in average, 5.15 ± 0.54 μg/100 ml) than that with 2n = 60 (3.0 ± 0.3 μg/100 ml) whereas resting levels of this hormone were low and not different between the two species. Urine osmolarity was significantly higher in males with 2n = 60 (331.9 ± 18.6 mmol/kg) than males with 2n = 52 (267.3 ± 10.9 mmol/kg). Considering the overall general trend urine osmolarity tended to be negatively related to the level of aggression, while corticosterone levels tended to vary positively with aggressiveness (Fig. 3). Our results allow further discussion of the hypothesis that high levels of aggression could be selected against in arid habitats due to their physiological correlates (decrease in water economy, increased corticosterone leading to potential energy mobilisation and loss). We propose that behavioural ecophysiology could have contributed to the radiation of the S. ehrenbergi superspecies into increasingly arid environments, and may favour evolution toward social tolerance. Received: 10 June 1995/Accepted after revision: 25 October 1995     

焊点热疲劳失效原因分析

某PCBA样品在使用约半年后出现功能失效,该PCBA在封装后进行整体灌胶,将失效样品剥离,发现部分器件直接脱落,通过表面观察、切片分析、EBSD分析、应力分析、热膨胀系数测试等手段对样品进行分析,结果表明:各封装材料存在热失配,且焊点缺陷较多且存在应力集中区,加速焊点的疲劳失效进程,导致PCBA功能失效。     

探讨ADC芯片引脚与印制板之间的固封方式

通过故障分析,将某产品高温老炼试验过程中发生的性能异常现象定位于ADC芯片部分引脚焊点脱焊。为验证芯片引脚与印制板之间的固封方式对焊点受力的影响,分别对"底部灌封+四角固封"及"底部灌封+四边固封"固封方式进行试验验证及随机振动、热应力分析。根据分析结果,高温浸泡时"底部灌封+四边固封"方式下,焊点受力均匀,最大热应力低于3MPa;而"底部灌封+四角固封"固封方式下的焊点最大热应力约5.1MPa,导致了焊点的蠕变疲劳失效。为减少高温浸泡时焊点的热应力,设计了"底部不灌胶,四边固封但一角不封口"的固封方式,并顺利通过相应的验证试验,证明这是一种较为妥当的固封方式。     

确定压力容器安全系数原则

压力容器安全系数与材料参数紧密相关,确定材料许用应力值时,需要同时考虑材料抗拉强度和屈服强度更为合理;奥氏体不锈钢材料具有非常好的应变强化能力和韧性,为充分发挥奥氏体不锈钢材料优良性能,选取奥氏体不锈钢材料许用应力值时,需要特殊考虑.压力容器安全系数的选取建立在经验基础上,在保障压力容器安全性前提条件下,为节省材料和降低成本,随着理论研究深入和科学实验的进步,压力容器安全系数有所降低,这是科学设计和实用成功经验结合的结果.     

后张梁管道摩阻损失测试技术与数据处理

针对常规测试中存在的问题,改进了管道摩阻损失的测试方法,消除了喇叭口等因素影响,使得管道摩阻测试更加合理和准确.介绍了后张法预应力管道摩阻损失的计算,结合秦沈客运专线双线整孔简支箱梁的管道摩阻损失测试,利用最小二乘原理对测试数据进行处理,得到了摩阻系数μ和k的计算公式,所得参数为施工提供了依据.最后讨论了摩阻系数对张拉控制应力的影响,提出现场测试的一般性原则和要求.     

丁酸胁迫对产氢污泥以厨余为底物的产氢影响

采用丁酸对产氢污泥进行胁迫处理,经胁迫后的污泥接种厨余垃圾进行产氢实验,考察丁酸胁迫对提高产氢性能的影响。结果表明,低浓度胁迫能提高产氢污泥的耐丁酸性,从而提高产氢量,而胁迫浓度过高则抑制产氢污泥活性,胁迫浓度呈\"horm esis\"效应。实验采用的4 g/L胁迫浓度为最佳,反应结束后,丁酸浓度和产氢量分别为8 417.1 mg/L和63.72 mL/g VS,比空白提高了31.3%和114%。产氢过程中SCOD的主要来源是有机酸。对产氢污泥胞外多聚物(EPS)的测定表明,厨余垃圾酸化速率、氢气产生速率和EPS总量成正相关。