PPP机制在城市污水处理行业中的应用

PPP模式作为公共部门与私人企业合作的一种模式,可以有效地缓解基础设施建设资金紧张的状况,是一种基于双赢或多赢理念基础上而形成的模式,目前已被许多国家广泛采用。在我国推行公用事业市场化改革的背景下,该模式具有广阔的应用前景。本文分析了该模式在我国城市污水处理行业中应用的主要形式,以及该模式在我国现实环境下面临的风险、存在的问题和相应的解决办法,并为政府推进PPP模式的应用提供了相关的建议。     

中国陆上油藏CO2封存潜力评估

CO2捕集与封存是减缓气候变化的一种关键的碳减排选择方案。将CO2注入油藏作为一种碳埋存方式引起广泛关注。作为判断某一国家、某一区域或某一具体储层是否适合CO2地质封存开展的重要依据之一,有必要在规划碳捕集与封存(CCS)项目前,对潜在的封存库进行封存潜力评估。本文在已有可公开的地质资料的基础上,评估了中国陆上216个油田实施CO2地质封存的潜力,并与相关研究结果进行了比较。结果表明:在满足埋存深度大于800 m的筛选条件下,当假设我国陆上油田全部用于CO2-EOR时,CO2封存潜力约3.6 Gt;当陆上油田全部视为废弃油藏处理时,CO2理论封存潜力约4.6 Gt。其中,东北和华北地区油藏封存CO2潜力巨大,占陆上油田CO2封存总量的60%以上;同时这里CO2集中排放源分布密集,排放源和封存地间的匹配性良好,可以减少CO2运输和封存成本。在这两个地区可以优先考虑实施油藏封存CO2项目。     

Effective communication about complex environmental issues: Perceived quality of information about carbon dioxide capture and storage (CCS) depends on stakeholder collaboration

This experimental research addresses the effectiveness of communication about complex environmental issues, depending on whether the same information is provided by multiple collaborating or by individual organizations (i.e., stakeholders). The information provided pertains to carbon dioxide capture and storage (CCS) technology, as an example of a complex environmental issue. In Studies 1 (N = 75) and 2 (N = 66) we found that participants perceived factual information from collaborating stakeholders to be of higher quality than when the same information was provided by individual stakeholders. As predicted, the expectation of diverse perspectives being represented in the collaborative information mediated this effect. In addition, in Study 3 (N = 79) the perceived dissimilarity of collaborating stakeholders was shown to be an important precondition for the collaboration effect observed in Studies 1 and 2. Finally, these studies indicate that occasional collaboration between different stakeholders does not necessarily harm the perceived credibility of each individual stakeholder.     

电磁阀贮存寿命加速试验技术研究

首先陈述了贮存寿命加速试验的基本原理,介绍电磁阀的结构组成,分析了失效模式和失效机理后,采取恒定应力加速试验方法,然后运用极大似然估计和最小二乘法对数据进行处理,最后得出其贮存寿命等结论。     

Petrophysical analysis to investigate the effects of carbon dioxide storage in a subsurface saline aquifer at Ketzin, Germany (CO2SINK)

To test the injection behaviour of CO₂ into brine-saturated rock and to evaluate the dependence of geophysical properties on CO₂ injection, flow and exposure experiments with brine and CO₂ were performed on sandstone samples of the Stuttgart Formation representing potential reservoir rocks for CO₂ storage. The sandstone samples studied are generally fine-grained with porosities between 17 and 32% and permeabilities between 1 and 100 mD.Additional batch experiments were performed to predict the long-term behaviour of geological CO₂ storage. Reservoir rock samples were exposed over a period of several months to CO₂-saturated reservoir fluid in high-pressure vessels under in situ temperature and pressure conditions. Petrophysical parameters, porosity and the pore radius distribution were investigated before and after the experiments by NMR (Nuclear Magnetic Resonance) relaxation and mercury injection. Most of the NMR measurements of the tested samples showed a slight increase of porosity and a higher proportion of large pores.     

二氧化碳水合物储气特性的实验研究

利用二氧化碳水合物小型实验装置分别在恒容和恒压条件下,研究了机械搅拌对二氧化碳气体溶解的影响以及温度与水-气比对二氧化碳水合物形成和储气密度的影响。通过实验结果发现,机械搅拌对二氧化碳的溶解有非常明显的促进作用,可以在3 min内完成溶解过程,促进溶解作用好于添加剂SDS。研究还发现,反应温度越低,二氧化碳水合物的生成速率越快,总的储气量越大,而水-气比越大,储气密度越小。在实验压力3 MPa、反应温度273.55 K的条件下,1体积的水生成水合物后可储存157体积的二氧化碳。     

冲击负荷对厌氧序批式反应器的影响及其恢复重建过程

研究了在厌氧条件下以葡萄糖为基质的厌氧序批式反应器(ASBR)中冲击负荷对基质吸收和储存的影响及其恢复重建过程.结果表明,正常状态下,反应器在进水COD为5 000.0 mg/L,出水COD为188.6 mg/L,当进水负荷提高至正常状态2倍后,反应器中COD大量累积,其中51.13％为挥发性有机酸(VFA),48.87％则被转化为糖原储存在细胞体内,出水COD最高为2 368.9 mg/L,污泥糖原储存量最高为273.55 mg/g(以挥发性固体计),是正常状态的4.2倍.在冲击负荷条件下,反应器的产甲烷能力恢复较快,胞内糖原储存恢复较慢,出水COD和胞内糖原分别经过20、41 d后恢复冲击负荷前水平.     

火电厂环保设施运行状态及性能评价技术研究

介绍了火电厂环保设施运行状态及性能评价技术的创新性研究,包括研究方法、评价方法、评价技术及实际应用情况。该研究是继火电厂工程减排、结构减排后的重要管理技术创新,为进一步促进火电厂环保设施安全、稳定、可靠、经济运行,确保达标排放,推进火电行业管理减排和技术监督提供了技术支持。     

Stand-alone wind power system with battery/supercapacitor hybrid energy storage

This paper presents a stand-alone wind power system with battery/supercapacitor hybrid energy storage. A stand-alone wind power system mainly consists of a wind turbine, a permanent magnet synchronous generator, hybrid energy storage devices based on a vanadium redox flow battery and a supercapacitor, an AC/DC converter, two bidirectional DC/DC converters, a DC/AC converter and a variable load. Several control strategies for the stand-alone wind power system are involved such as a maximum power point tracking (MPPT) control, a vanadium redox flow battery charge/discharge control and a supercapacitor charge/discharge control. The proposed MPPT control combines a sliding mode control with an extreme search control to capture maximum wind energy. This strategy avoids the necessity of measuring wind velocity, obtaining models or parameters of the wind turbine and calculating the differentials of the power generated from the wind power system and from the speed of the generator. The battery charge/discharge control maintains a constant DC bus voltage. When the battery charging/discharging current reaches the setting threshold, the charge/discharge control of the supercapacitor is triggered to limit the charging/discharging current of the battery. The simulation results show that the proposed method can rapidly respond to variations in wind velocity and load power.