纤维增强气凝胶复合材料高温结构转变及热稳定性研究

目的研究高温受热条件下纳米复合隔热材料的结构转变特征及热稳定性。方法采用扫描电镜、X射线衍射仪、红外光谱仪及热重仪等检测方法。结果纤维增强气凝胶材料从室温到650℃存在连续的质量损失,从室温到放热前,质量损失为1.66%;365℃开始出现放热,温度升至398℃时达到峰值,整个放热过程对应质量损失约为1.3%;从435℃放热结束开始到650℃的质量损失为1.46%。经过400℃热处理后,试样比表面积从268m~2/g增加到437m~2/g;当试样热处理温度达到600℃时,试样的比表面积明显随之降低至198m~2/g。结论 SiO_2气凝胶复合材料以无定形结构为主,存在少量的二氧化钛晶体。在400℃左右,SiO_2气凝胶结构中硅甲基Si—CH_3发生氧化,产生明显的放热峰,之后硅羟基Si—OH之间发生缩聚反应,使600℃热处理后气凝胶中Si—O—Si网络骨架强度有所提高。未处理的纤维增强气凝胶材料试样上气凝胶纳米颗粒构成的块体较为良好地包裹在玻璃纤维表面,而经过600℃的高温热处理1 h后,块体气凝胶脱离了光滑的纤维表面,气凝胶纳米粒子发生收缩,致使材料比表面积下降。     

油气田在役管道高后果区识别与完整性评价方法

根据油气管道建设与管理的相关标准与规范或导则,针对目前油气田在役管道,明确了其高后果区识别的划分及其在不同标准中的差异以及识别的原则和时间间隔,分别介绍了在管道的相关数据采集的基础上开展地质灾害和第三方破坏造成的管道风险评价方法,管道内外腐蚀的直接评价以及包括剩余强度、剩余寿命和材料在内的管道适用性评价方法,同时给出了这些评价工作所涉及到的相关内容项,对油田管道的完整性管理具有重要的指导作用和应用价值。     

Relationship between PM10 and PM2.5 levels in high-traffic area determined using path analysis and linear regression

The objective of this study was to determine the relationship between PM_(10) and PM_(2.5) levels as related to meteorological conditions and traffic flow using both a linear regression analysis and a path analysis. The Particulate matter(PM) samples were collected from Sukhumvit road, Bangkok, Thailand, at both open(104 samples) and covered(92 samples)areas along the road. Fifteen percent of all samples were separated before the statistical models were run and used for model validation. The results from the path analysis were more elaborate than those from the linear regression, thus indicating that meteorological conditions had a direct effect on the particulate levels and that the effects of traffic flow were more variable in open areas. The model also indicated that meteorological conditions had an indirect effect and that traffic flow had a direct effect on particulate levels in covered areas. The model validation results indicated that for open areas, the R~2 values were not very different between the path analysis and the linear regression model, but that the path analysis was more accurate than the linear regression model at very low PM concentrations. At high PM concentrations, the path analysis model also had a better fit than did the linear regression, so the predictions from the path analysis model were more accurate than those from the linear regression.     

储罐用钢在3.5%NaCl溶液中的腐蚀行为研究

目的对比研究三种油气储罐在水压试验时的腐蚀行为特征。方法选用9Ni钢、Q235碳钢、304L不锈钢储罐用材料以及3.5%NaCl模拟海水溶液,采用开路电位、电化学阻抗谱、动电位极化曲线测试方法研究三种储罐用钢在模拟海水中的电化学腐蚀特征,同时结合浸泡质量损失试验和微观腐蚀形貌进行分析。结果 9Ni钢、Q235碳钢、304L不锈钢稳定后的开路电位(vs.SCE)分别为-0.55、-0.64、-0.10m V,Rt值分别为2 792、1 765、125 100,平均腐蚀深度分别为0.070 6、0.160 3、0.002 5 mm/a。微观腐蚀形貌显示,9Ni钢和Q235碳钢表面发生明显的腐蚀,而304L不锈钢只发生轻微的点蚀。结论在3.5%NaCl模拟海水溶液中,304L不锈钢最耐腐蚀,Q235碳钢最易腐蚀,9Ni钢居于两者之间。因此在9Ni钢和Q235碳钢储罐海水试压过程中需要采取临时保护。     

包装箱用碳纤维增强复合材料贮存寿命研究

目的研究碳纤维增强复合材料贮存条件下的性能变化趋势和寿命评估。方法对碳纤维增强复合材料开展四个不同温度条件下的热氧老化试验,按试验周期定期取样开展冲击性能测试,对试验数据采用寿命预估方法进行处理,对材料性能进行预估。结果通过数据计算分别得到我国热带海洋、干热沙漠等典型气候条件下的碳纤维增强复合材料贮存寿命分别为17.21~35.89年。结论碳纤维增强复合材料具有较好的贮存性能,在较为严酷的热带海洋气候和给定的失效判据条件下,寿命预计为17.21年。试验和数据处理方法可以较好地预计材料的性能变化趋势和开展寿命评估。     

典型铅锌矿化区不同土地利用类型土壤重金属污染特征与评价

选取云南者海典型铅锌矿区周边冶炼区（A）、粮食主产区（B）、保护区（C）三个区域土壤为研究对象,分析三个区域内林地（LD）和耕地（GD）土壤pH、总碳（TC）、总氮（TN）、总磷（TP）和5种重金属（Hg、Cd、Pb、Zn、Cu）含量,利用典范对应分析（CCA）研究不同土地利用类型下它们之间的关系,基于系统熵值与重金属生物毒性改进灰色聚类评价法对研究区重金属污染程度进行评价。结果表明,A、B、C三区土壤的5种重金属均超过云南省土壤背景值,且含量A区 > B区 > C区,所有土壤样品Hg、Cd、Pb、Zn、Cu平均含量分别为7.24、1.53、1 794、2 892、210 mg/kg;LD土壤重金属含量普遍高于GD。研究区土壤pH总体呈弱酸性,但A区土壤受矿业活动影响呈弱碱性。TC、TN含量和C/N值均表现出LD大于GD,但TP含量表现为GD显著大于LD （P<0.05）。CCA分析表明LD和GD土壤pH与Cd和Cu呈负相关,与Zn和Pb呈正相关,且pH对重金属含量的影响最大;TC、TP与重金属Cd和Cu在LD土壤中呈正相关,在GD土壤中呈负相关。改进灰色聚类评价结果表明重金属污染程度均表现为LD大于GD;A区污染最严重且均呈重度污染,B区次之,C区污染程度最轻。经比较本文改进的灰色聚类评价法在准确性和灵敏度方面优于传统方法。     

Assessing protected area effectiveness using surrounding (buffer) areas environmentally similar to the target area

Many studies are based on the assumption that an area and its surrounding (buffer) area present similar environmental conditions and can be compared. For example, in order to assess the effectiveness of a protected area, the land use/cover changes are compared inside the park with its surroundings. However, the heterogeneity in spatial variables can bias this assessment: we have shown that most of the protected areas in Mexico present significant environmental differences between their interior and their surroundings. Therefore, a comparison that aims at assessing the effectiveness of conservation strategies, must be cautioned. In this paper, a simple method which allows the generation of a buffer area that presents similar conditions with respect to a set of environmental variables is presented. The method was used in order to assess the effectiveness of the Calakmul Biosphere Reserve, a protected area located in the south-eastern part of Mexico. The annual rate of deforestation inside the protected area, the standard buffer area (based upon distance from the protected area only) and the similar buffer area (taking into account distance along with some environmental variables) were 0.3, 1.3 and 0.6%, respectively. These results showed that the protected area was effective in preventing land clearing, but that the comparison with the standard buffer area gave an over-optimistic vision of its effectiveness.     

铜陵石炭纪威宁期沉积相及与黄铁矿矿床的关系

铜陵地区石炭纪威宁期存在潮坪相,泻湖相和浅海陆棚相。白云岩有两种,准同生白云岩分布于潮坪,成岩白云岩分布于泻湖内,本区以成岩白云岩为主。白云岩中赋存了层位稳定的黄铁矿矿床,黄铁矿在泻湖相最易富集,成岩作用是黄铁矿矿床形成的一个重要因素。     

大顶子山航电枢纽工程建库后上游水质总量控制研究

松花江大顶子山枢纽工程建设后,库区内水体流线及扩散规律的变化将影响库区内水质,受沿江排污影响,其规划目标的水环境容量将发生改变,因此对建库后上游水质总量控制进行研究很有意义.     

利用脉冲澄清池补充处理生化后废水的运行结果和分析

通过对脉冲澄清池在综合废水处理中运行效果的跟踪分析,确定出利用脉冲澄清池补充处理生化后废水(悬浮物、COD_(cr)、BOD_5等)的影响程度,为其在综合废水处理工艺中的应用及其局限性,提供了必要的参考依据.