职业接触苯乙烯工人静脉血中血红蛋白—环氧苯乙烯加合物的分析测定

人的静脉血中血红蛋白（Ｈｂ）－环氧苯乙烯（ＳＯ）加合物的分析测定过程是：从人的静脉血中提取的血红蛋白在一定条件下酶解,蛋白质中半胱氨酸残留加合物再以Ｒａｎｅｙ Ｎｉｃｋｅｌ催化反应生成两种加合物的异构体：α－苯己醇（２－ＰＥ）,β－苯乙醇（１－ＰＥ）,再用五氟苯酰氯衍生化,最后用ＧＣ／ＭＳ测定这两种加合物（ｉｎ ｖｉｔｒｏ和ｉｎ ｖｉｖｏ）。实验结果表明：在动物实验中,所测的血红蛋白－环氧苯乙烯两     

生物滴滤法去除低浓度苯乙烯

通过装载改性聚乙烯填料的生物滴滤塔进行废气中的苯乙烯生物降解实验。结果表明,通过快速排泥法挂膜,该反应器可在较短周期内实现微生物的驯化。苯乙烯入口浓度和空床停留时间(EBRT)是影响反应器性能的重要因素,当EBRT分别为60、45、30和15 s以及对应的入口浓度分别为950、430、350和200 mg/m3时,可实现达标排放。循环喷淋液中的硝酸盐(亚硝酸盐)对生物滴滤池的影响十分明显,在初始阶段,亚硝酸根很快被耗尽,硝酸根则相对缓慢。当循环液中的TN从102.63 mg/L下降到24.24 mg/L时,滴滤池的去除效率由94.48%下降到43.16%,部分原因是降低NOx-的浓度减弱了反硝化作用对VOC碳源的利用。     

WSH-2型催化剂在环氧丙烷/苯乙烯装置废气处理中的工业应用

介绍了WSH-2型催化剂在环氧丙烷（PO）/苯乙烯（SM）装置废气处理中的应用。工业化装置的运行结果表明,在废气处理量86 000 Nm³/h、设定反应器进口温度250~300 ℃、设定进口非甲烷总烃（NMHC）质量浓度1 000~2 200 mg/m³的条件下,无论单系列还是双系列运转,采用WSH-2型催化剂均可对废气进行有效处理。处理后气体中的NMHC、苯、甲苯、乙醛、SM等的含量均符合GB 16297—1996《大气污染物综合排放标准》和GB 14554—1993《恶臭污染物排放标准》中的相关规定。NMHC去除率达到92.9%以上,装置运行稳定。按照目前的废气排放工况推算,预计催化剂的使用寿命可达5 a。     

臭氧氧化苯乙烯有机气体性能及机制

采用臭氧高级氧化处理高浓度苯乙烯有机废气,研究了进气苯乙烯浓度、臭氧浓度、停留时间、O₃/C₈H₈摩尔比对苯乙烯去除效率的影响。研究结果表明,臭氧氧化能有效净化苯乙烯有机废气,苯乙烯去除效率可达66.6%。适宜运行条件为：停留时间为3.6 s,O₃/C₈H₈摩尔比为0.46。采用GC-MS分析臭氧氧化苯乙烯出口气样,研究结果表明,苯甲醛（C₆H₅CHO）和苯甲酸（C₆H₅COOH）为臭氧氧化苯乙烯的中间产物。臭氧高级氧化苯乙烯机制为苯乙烯气体被臭氧氧化为苯甲醛和苯甲酸,然后继续臭氧氧化为最终产物二氧化碳和水。     

Sorption of 1-naphthol by plant cuticular fractions

The contribution of aliphatic-rich plant biopolymer to sorption of hydrophobic organic compounds is significantly important because of their preservation and accumulation in the soil environment,but sorption mechanism is still not fully understood.In this study, sorption of 1-naphthol by plant cuticular fractions was examined to better understand the contributions of respective fraction.Toward this end,cuticular materials were isolated from the fruits of tomato by chemical method.The tomato cuticle sheet consisted of waxes (6.5 wt%),cuticular monomer (69.5 wt%),and polysaccharide (24.0 wt%).Isotherms of l-naphthol to the cuticular fractions were nonlinear (N value (0.82-0.90)) at the whole tested concentration ranges.The KodKow ratios for bulk cuticle (TC1),dewaxed cuticle (TC2),cutin (TC4),and desugared cuticle (TC5) were larger than unity,suggested that tomato bulk cuticle and cutin are much powerful solption medium.Sorption capability of cutin (TC4) was 2.4 times higher than the nonsaponifiable fraction (TC3).The 1-naphthol interactions with tomato cuticular materials were governed by both hydrophobic-type interactions and polar (H-bonding) interactions. Removal of the wax and polysaccharide materials from the bulk tomato cuticle caused a significant increase in the sorption ability of the cuticular material.There was a linear negative trend between K_(oc) values and the amount of polysaccharides or fraction's polarities ((N O)/C);while a linear positive relationship between K_(oc) values and the content of cutin monomer (linear R~2=0.993) was observed for present in the cuticular fractions.Predominant sorbent of the hydrophobic organic compounds (HOCs) in the plant cuticular fraction was the cutin monomer,contributing to 91.7% of the total sorption of tomato bulk cuticle.     

UV-生物过滤联合降解苯乙烯废气的研究

实验采用主波长为185 nm的低压汞灯为紫外光源,泥炭、棕纤维、多孔活性炭为填料的UV-生物过滤塔联合装置净化苯乙烯废气.苯乙烯进气浓度控制在320~583 mg·m-3之间,稳定后去除率能维持在95%以上.UV光解苯乙烯形成醇、醛、羧酸等水溶性较好的可生物降解的物质,能改善生物过滤塔的运行性能.稳定运行阶段,当总停留时间(total residence time,TRT)较长时,进气浓度的变化基本不影响去除率,随着TRT减少,进气浓度对去除率的影响逐渐显现.TRT为102 s时,联合装置的去除负荷随进气负荷的增加而线性增加,去除率达95%以上.TRT为68 s时,进气负荷较低时,去除负荷的变化也遵循上述规律,但当进气负荷大于30 g·(m3·h)-1时,去除负荷逐渐偏离直线并趋于某一定值.若仅考虑苯乙烯浓度的增减,UV光解对苯乙烯的去除贡献率高于生物过滤塔,而系统关停10 d后重启,苯乙烯的去除效果在第4 d就能恢复.     

聚丙烯酸钠薄膜/K^＋交换玻璃光波导元件的研制及其对苯乙烯蒸气的气敏性研究

采用低分子量聚丙烯酸钠作为敏感试剂,通过旋转涂胶法固定在钾离子交换玻璃光波导表面做成纳米级的薄膜,研制了低分子量聚丙烯酸钠薄膜/K＋离子交换玻璃光波导气敏元件.将该气敏元件固定在光波导气体检测系统中,对挥发性有机物蒸气进行检测.结果表明,室温下该气敏元件对苯乙烯蒸气具有较高的选择性响应,响应和恢复速度快（分别为6 s和...     

Improvement of Physico-mechanical Properties of Chitosan Films by Photocuring with Acrylic Monomers

Natural polymer, chitosan was obtained from dried prawn shell waste through the preparation of chitin and was characterized. Thin film of chitosan was prepared by casting method from its 2% chitosan solution. Mechanical properties like tensile strength (TS), elongation at break (Eb) of chitosan film were studied. Five formulations were developed with 2-ethyl-2-hydroxy methyl-1,3-propandiol trimethacrylate (EHMPTMA), a trifunctional monomer and 2-ethylhexyl acrylate (EHA), a monofunctional monomer in the presence of photoinitiator Darocur-1664 (2%). The film was soaked in those monomer formulations in dissimilar soaking times and irradiated under UV-radiation at different radiation intensities for the improvement of the properties of chitosan film. The cured films were then subjected to various characterization tests like TS, Eb, polymer loading (PL), water absorbency, gel content etc. The formulation, containing 25% EHMPTMA and 73% EHA showed the best performance at 10th UV passes of UV radiation for 4 min soaking time.     

苯乙烯生物滴滤塔生物膜填料的细菌数量分布

采用培养驯化污泥菌种、陶粒、循环液装置等构建三个生物滴滤塔。测定不同苯乙烯负荷生物滴滤塔装置不同高度生物膜填料的细菌数量分布,认识苯乙烯浓度对填料细菌数量分布的影响。结果表明,生物膜填料柱细菌数量分布依赖于入口气体苯乙烯浓度和停留时间,在低入口气体苯乙烯浓度(Cin<500mg/m3)时细菌数在柱子底部达到最大值而沿柱子自下而上逐渐降低,受气体停留时间的影响不大;当入口气体苯乙烯浓度Cin=800mg/m3时细菌数在整个柱子上的分布变得相对均匀;而当入口气体苯乙烯浓度超过阈限值Cin=1200mg/m3时细菌分布行为出现了和Cin<500mg/m3时相反的情况,细菌数在柱子顶部达到最大值而沿柱子自上而下逐渐降低。     

血红蛋白-环氧苯乙烯加合物的分析

采用环氧苯乙烯和血红蛋白中羧酸基和巯基位的加合物同时测定的方法，对大鼠血红蛋白ＳＯ加的进行了体外实 腹腔注射环氧苯乙烯和苯乙烯的体内实验。结果表明在血红蛋白中所分析的３种加合物（ＳＧ，１－ＰＥ，２－ＰＥ）均随着ＳＯ剂量而增加。