四海龙湾表层沉积物中有机质的组成特征及其源解析

为研究玛珥湖四海龙湾表层沉积物中有机质的组成特征及来源,采集四海龙湾表层沉积物样品,并对其中的有机质进行了分析. 结果表明,四海龙湾表层沉积物中w(TOC)(TOC为总有机碳)为6.7%、w(TN)为0.6%、δ13C_org(TOC同位素丰度)为-28.0‰、δ15N_total(TN同位素丰度)为2.2‰. 可溶性有机质主要包括脂肪烃、脂肪醇、脂肪酸和GDGTs(甘油二烷基甘油四醚脂)等,其中脂肪酸是可溶性有机质的主要组分,约占可溶性有机质总量的68.8%,主要来源于内源性的藻类和厌氧菌; 脂肪烃主要来源于陆源的C3木本植物;结合态脂肪醇具有明显的内源来源特征,而游离态脂肪醇却呈现陆源来源特征. 四海龙湾沉积物中含有丰富的GDGTs,主要来源于陆源土壤,包括支链类GDGTs和类异戊二烯类GDGTs,其中类异戊二烯类GDGTs以GDGTⅣ和GDGTⅤ为主,但其在四海龙湾沉积物中的含量相对较小. 研究显示,四海龙湾流域陆源是沉积物中可溶性有机质的主要来源,陆源有机质的大量流入改变了四海龙湾的营养水平;不同种类可溶性有机质表现出不同的来源特征,这主要是由于微生物对不同种类有机质降解速率的不同所致,并且导致降解所产生的二次有机质数量也不同.      

活性炭对非离子型表面活性剂中菲的吸附效能

为研究表面活性物质与疏水有机物的分离效能,以TX100(曲拉通100)为代表性的非离子型表面活性剂,以PHE(菲)为代表性的多环芳烃,使用活性炭对二者共存体系进行静态吸附和固定床吸附. 静态吸附结果表明,活性炭对TX100和PHE的吸附均满足Langmuir等温吸附模型和准二阶动力学模型,吸附量分别为437.31和58.86 mg/g. 固定床吸附时,对应于14.7 cm的活性炭柱高,PHE穿透10%和TX100穿透90%的时间分别是420和270 min,从BDST(bed depth service time)模型中可以得到TX100传质区长度小于PHE,这为二者分离提供了条件. 通过活性炭固定床吸附可以在回收90%TX100的同时去除90%PHE,说明吸附法是一种回收表面活性剂的有效方法. 利用微波法再生活性炭,可使购置活性炭的成本降低4/5,进一步提高了回收法的经济性和可行性. 研究表明,活性炭吸附是一种可用于土壤洗涤工艺中回收表面活性剂的有效方法.      

Investigation on sampling artifacts of particle associated PAHs using ozone denuder systems

Polycyclic aromatic hydrocarbons （PAHs） are complex organic compounds which are identified as significant carcinogenic to human health. PAHs （mainly in particle phase） are susceptible to atmospheric oxidant gases, especially ozone, nitrogen oxides （NOx）, hydroxyl radical （OH）, and could be degraded on filters during sampling process, leading to an underestimation of ambient PAH concentrations. The goal of this work was to investigate particle associated PAHs sampling artifacts caused by ozone in summer of Beijing. Comparative sampling systems were operated simultaneously during the whole campaign, one with activated carbon ozone denuder, the other being set as conventional sampling system. Activated carbon denuder was testified to be highly efficient to eliminate ozone from air stream. In general, nine particle-bound PAHs observed from conventional sampler were all lower than those from ozone denuder system. The total PAHs （particle phase） concentration was averagely underestimated by 35.9% in conventional sampling procedure. Benzo[a]pyrene （BaP） had the highest percentage of mass loss. founded to have influences Ambient temperature was on PAHs sampling artifacts. High temperature can increase loss of particle associated PAHs during sampling.     

Ecological selection of bacterial taxa with larger genome sizes in response to polycyclic aromatic hydrocarbons stress

Polycyclic aromatic hydrocarbons(PAHs) are ubiquitous priority pollutants that cause great damage to the natural environment and health. Average genome size in a community is critical for shedding light on microbiome’s functional response to pollution stress within an environment. Here, microcosms under different concentrations were performed to evaluate the selection of PAHs stress on the average genome size in a community. We found the distinct communities of significantly larger genome size w...     

深圳市大气中多环芳烃的污染特征与来源识别

利用大流量主动采样器于2009年12月~2010年1月及2010年6月,分冬季与夏季两批次对深圳市13个点位进行大气样品采集,检测其气相及颗粒相中总的多环芳烃(PAHs)浓度.结果表明,冬季深圳市大气中总PAHs的浓度为17.9~92.3ng/m3,平均值为45.3ng/m3;夏季总PAHs浓度范围为8.64~96.3ng/m3,平均值为32.2ng/m3.两个季节PAHs单体中均以3~4环为主,占总浓度的75%以上;单个组分与总量的相关性分析表明,夏季明显优于冬季.来源分析表明,冬季大气中PAHs来源比夏季更为复杂,通过特征分子比值法推断冬季PAHs主要来源于石油源、燃煤、机动车尾气排放;夏季主要来源于机动车尾气排放.利用毒性当量因子法和致癌风险评价其污染水平和毒性风险,结果表明深圳市大气中PAHs污染与国内部分城市相比,处于较低水平.     

长江武汉段沉积物再悬浮过程中PAHs释放的预测模型

为研究长江武汉段沉积物再悬浮过程中多环芳烃的释放,采用回归方法建立了剪应力与再悬浮颗粒物浓度、有机碳含量及PAHs浓度之间的定量关系模型,并结合PAHs在悬浮颗粒物-水体分配系数,建立了不同剪应力条件下再悬浮过程中上覆水体PAHs浓度预测模型,通过模型预测结果与实验结果的比较,表明模型具有良好的预测效果,可用来进行不同剪应力条件下沉积物再悬浮过程PAHs释放的预测.     

Polycyclic aromatic hydrocarbons in medicinal plants from Syria

The levels of 16 US Environmental Protection Agency polycyclic aromatic hydrocarbons (EPA PAHs) in 10 medicinal plants in different used parts of plant (leaves and flowers) have been determined. The analytical method consists of sample preparation by ultrasonic extraction with dichloromethane followed by silica gel clean-up. Subsequently, the analysis was carried out by reversed-phase high-performance liquid chromatography (HPLC) coupled to both ultraviolet and fluorescence detections in series to insure the detection of all 16 EPA PAHs. It was observed that the sum of the 16 PAHs (ΣPAHs) in the investigated medicinal plants ranged from 47 to 890 μg kg^–1 where the highest ΣPAHs was found in Sage plant sample. Light PAHs were dominants in all studied medicinal plants. The sum of eight genotoxic PAHs (ΣPAH8) have shown a better indicator of the degree of contamination with carcinogenic PAHs compared to benzo[a]pyrene in these products.     

Possibilities and limitations of ecotoxicological testing of chemicals

This study concerns the polycyclic aromatic hydrocarbons (PAH's) emission from gasoline and diesel automobile engines.

The sampling procedure, the extraction and the analytical method are presented. Using the gas chromatography‐mass spectrometry technique it is possible to detect and quantify easily about 15 PAH's. Data obtained on exhaust particles collected from gasoline and diesel automobile engines are presented and discussed.     

Project tocoen. The fate of selected organic pollutants in the environment—iv. soil,earthworms and vegetation 1988

The samples of soils, earthworms and vegetation (needles, lichens, mosses) were collected for the realization of Project TOCOEN (Toxic Organic Compounds in the ENvironment). The samples were collected from three TOCOEN model areas in Czechoslovakia—one city and two rural areas. The samples were analyzed for polycyclic aromatic hydrocarbons (PAHs), chlorinated pesticides (C1‐PEST) and polychlorinated biphenyls (PCBs).     

Pah characteristics in ambient air within a steel industrial complex

Ambient air samples at ten sites in an iron and steel industrial complex were collected from June to December for analyzing polycyclic aromatic hydrocarbons (PAHs). Sixteen species of PAH components in air samples were identified. The results indicate that both gaseous phase and particle‐bound PAHs at the top of the cokemaking plants are unusually high. The profiles of particle‐bound PAHs indicate that the predominant species at the top of, the coke oven batteries are those of high molecular weight components. The major components of particle‐bound PAHs at sampling sites near the fenceline, however, include the medium molecular weight components. The PAH profiles of air samples within the industrial complex show a strong similarity to those of cokemaking plant samples. The concentrations and the specific content of benzo(a)pyrene in the iron and steel industrial complex are higher than those values measured in urban area, petrochemical industry park, and open‐air burning area.