Insights into the mechanism of the deterioration of mainstream partial nitritation/anammox under low residual ammonium

Residual ammonium is a critical parameter affecting the stability of mainstream partial nitritation/anammox (PN/A), but the underlying mechanism remains unclear. In this study, mainstream PN/A was established and operated with progressively decreasing residual ammonium. PN/A deteriorated as the residual ammonium decreased to below 5 mg/L, and this was paralleled by a significant loss in anammox activity in situ and an increasing nitrite oxidation rate. Further analysis revealed that the low-ammonium condition directly decreased anammox activity in situ via two distinct mechanisms. First, anammox bacteria were located in the inner layer of the granular sludge, and thus were disadvantageous when competing for ammonium with ammonium-oxidizing bacteria (AOB) in the outer layer. Second, the complete ammonia oxidizer (comammox) was enriched at low residual ammonium concentrations because of its high ammonium affinity. Both AOB and comammox presented kinetic advantages over anammox bacteria. At high residual ammonium concentrations, nitrite-oxidizing bacteria (NOB) were effectively suppressed, even when their maximum activity was high due to competition for nitrite with anammox bacteria. At low residual ammonium concentrations, the decrease in anammox activity in situ led to an increase in nitrite availability for nitrite oxidation, facilitating the activation of NOB despite the dissolved oxygen limitation (0.15–0.35 mg/L) for NOB persisting throughout the operation. Therefore, the deterioration of mainstream PN/A at low residual ammonium was primarily triggered by a decline in anammox activity in situ. This study provides novel insights into the optimized design of mainstream PN/As in engineering applications.     

ABR工艺预处理木薯酒糟废水的工程应用

木薯酒糟废水有机物浓度高、悬浮物含量大、pH呈酸性、可生化性能较差 ,通常直接采用固液分离—厌氧 (UASB)—好氧曝气生化法处理效果并不理想 ,而采用ABR工艺进行厌氧水解酸化预处理木薯酒糟废水迄今为止未见报道。经绵阳市酒厂废水治理工程证明 ,强化ABR预处理工序是保证后续处理措施能否正常运行的关键     

氧化絮凝复合床预处理印染废水的试验研究

在传统铁屑内电解的基础上,提出了氧化絮凝复合床的新技术,并使用该方法对印染废水预处理进行研究,确定了pH值,反应时间等工艺参数的影响。实验结果显示,在酸性条件下,pH为6左右,停留时间为30～45min,处理效果基本达到稳定。COD的去除率可达30%～90%,色度去除率均可达95%以上,且可提高废水的可生化性,为后续生化处理创造了有利条件。另外还研究了加盐Na2CO3,催化剂MnO2,TiO2对印染废水的处理效果。研究表明加以上添加剂后,处理效果均有所提高。该工艺以其设备简单,成本低,操作方便,预处理效果好,以废治废等优点而广受青睐,具有较好的研究价值和工程使用前景。     

混凝沉淀-酸化水解-接触氧化工艺处理聚苯乙烯生产废水

采用混凝沉淀酸化水解生物接触氧化工艺处理聚苯乙烯生产废水,通过治理工程实际运行,结果表明:当废水CODCr平均浓度为1160mg/L时,CODCr去除率为882%,出水水质稳定,能达到设计要求。     

Petro-chemical wastewater treatment by biological process

Ｉｎｔｈｅｃｏｕｒｓｅｏｆｏｉｌｒｅｆｉｎｉｎｇ,ｏｒｇａｎｉｃｗａｓｔｅｗａｔｅｒｗｉｔｈｈｉｇｈｃｏｎｃｅｎｔｒａｔｉｏｎｏｆｅｍｕｌｓｉｆｉｅｄｏｉｌａｎｄｐｈｅｎｏｌｉｓｐｒｏｄｕｃｅｄ,ｓｏｆａｒ,ｔｈｅｍｅｔｈｏｄｓｏｆｐｈｙｓｉｃｏｃｈｅ?..     

高浓度甲基橙溶液的低压湿式催化氧化处理

以高浓度甲基橙溶液模拟偶氮染料废水,采用低压湿式催化氧化法(LPWCO)进行处理,考察了H2O2投量、温度、FeSO4投量、硫酸浓度、甲基橙浓度等因素对甲基橙脱色率的影响。结果表明,LPWCO法能有效地使高浓度(大于400mg/L)甲基橙溶液脱色,脱色率大于95%,而H2O2投量不到Fenton法的5%。     

水解酸化＋两级生物接触氧化处理高盐度水产品加工废水

介绍了“水解酸化＋两级生物接触氧化”处理水产品加工废水的运行效果和工程实例，结果表明：对C1^-浓度平均6000mg／L的高盐度水产品加工废水，系统对COD、SS、氨氮的去除率分别超过了88％、90％、85％，出水COD、SS、氨氮分别低于100mg／L、70mg／L、15mg／L，出水完全可以达到《污水综合排放标准》（GB8978—1996）一级排放标准。     

Decomplexation of Cu-1-hydroxyethylidene-1,1-diphosphonic acid by a three-dimensional electrolysis system with activated biochar as particle electrodes

The feasibility of decomplexation removal of typical contaminants in electroplating wastewater, complexed Cu(II) with 1-hydroxyethylidene-1,1-diphosphonic acid (Cu-HEDP), was first performed by a three-dimensional electric reactor with activated biochar as particle electrodes. For the case of 50 mg/L Cu-HEDP, Cu(II) removal (90.7%) and PO initial pH 7, acid-treated almond shell biochar (AASB) addition 20 g/L, and reaction time 180 min, with second-order rate constants of 1.10 × 10⁻³ and 1.94 × 10⁻⁵ min⁻¹respectively. The growing chelating effect between Cu(II) and HEDP and the comprehensive actions of adsorptive accumulation, direct and indirect oxidation given by particle electrodes accounted for the enhanced removal of Cu-HEDP, even though the mineralization of HEDP was mainly dependent on anode oxidation. The performance attenuation of AASB particle electrodes was ascribed to the excessive consumption of oxygen-containing functionalities during the reaction, especially acidic carboxylic groups and quinones on particle electrodes, which decreased from 446.74 to 291.48 µmol/g, and 377.55 to 247.71 µmol/g, respectively. Based on the determination of adsorption behavior and indirect electrochemical oxidation mediated by in situ electrogenerated H₂O₂ and reactive oxygen species (e.g., •OH), a possible removal mechanism of Cu-HEDP by three-dimensional electrolysis was further proposed.     

生物氧化塔的应用

介绍了生物氧化培处理含油污水的装置运行情况．大量数据说明该塔具有操作弹性大，适用范围广，能耗低，脱除率高，不外排过剩的活性污泥等特点，具有广阔的推广应用前景。     

Mn-Cu-O负载型催化剂上CO氧化性能的研究

研究了ＺｒＯ２或Ａｌ２Ｏ３负载Ｍｎ－Ｃｕ－Ｏ体系催化剂ＣＯ催化氧化活性，以及物相结构，表面氧性能与活性的关系。结果表明，锆基催化剂的氧化活性明显优于铝基催化剂，起燃温度Ｔ５０低达５０℃，ＺｒＯ２载 利于活性组份形成高活性物相，并促进表面吸附氧的脱附，表现出催化剂表面吸附氧的脱附温度高低次序与其氧化活性有一致的对应关系。