微氧环境下无色硫细菌和硫酸盐还原菌脱硫

通过间歇曝气形成微氧环境让SRB和CSB实现共生,使含硫酸盐有机废水中硫酸根最终转化成单质硫达到脱硫目的.研究考察了曝气量对SRB还原和CSB氧化的影响,确定了合适的曝气强度和水力停留时间,使得单质硫占系统内总硫比值最大.实验结果显示,在进水COD/SO42-=2000/1500 mg/L、曝气开关时间为2 s/2 min、生化时间为10 h时,单质硫产率最大,为89.53％,SO42-浓度降至最低值72.7 mg/L,还原率达95.1％,此时脱硫效果较好.     

硫化法制备废水处理用光催化剂La3NbS2O5

采用高温硫化法制备了具有可见光活性的La3 NbS2 O5光催化剂,运用X射线衍射谱图、扫描电子显微镜照片、比表面积和紫外-可见漫反射光谱对La3 NbS2 O5的结构、物理性质和光吸收性能进行了表征.以亚甲基蓝为目标降解物,考察了硫化温度、催化剂加入量和制备方法对亚甲基蓝降解率的影响.实验结果表明,当硫化温度为800...     

Air Pollution Effects on Forest Trees in Balikesir,Turkey

Air pollution has become an actual problem in Balikesir because of rapid urbanisation and increasing of the polluting sources. Air pollutionproblems occur under the unfavorable meteorological conditions which increase in frequency of occurrence in winter due to use of low quality lignite coals for heating. The `Protection of Air Quality' in Turkey dated 1986 is based on the human health criteria. But the critical limit values are lethal for the forest trees as far as SO₂ is concerned. The field observations showed that leaves of the trees have yellow spots indicating acid burns in Balikesir. This study aims at determining the relationships between the SO₂ concentrationsin the air under selected climatic conditions, and the effects of air pollution on forest trees in Balikesir. Samples of leaves were collected from the City Parks in Balikesir, Deirmenboaz forested area located 10 km far fromBalikesiron the Balikesir-Bursa highway, and from the forestation areas near the Balikesir-Edremit highway. Sulfur contents of the leaves were very high especially in the city (2650–5300 g m^-3).Samples from other areas had values lower than this range but above the usual values (850–3612 g m^-3). The diameter increments of the trees were found to be lower and these results clearly showed the adverse impacts. Negative correlations were found between these sulfur concentrations and the daily mean temperatures and wind speeds. Positive correlation was seen between these concentrations and pressures, humidities. Emission sources must be controlled in order to safeguard the forests which protects the soil, facilitate water production, assimilate carbon dioxide in air and produce oxygen. It must be considered that the problems are not only regional but have a global identity.     

Sulfur Metabolism in Polluted Sphagnum Peat Bogs: A Combined 34S–35S–210Pb Study

The size and isotopic behavior of sulfur pools in²¹⁰Pb-dated peat cores were investigated to obtain aninsight into retention mechanisms of pollutant S in twomountain-top peatlands of the Northern Czech Republic, CentralEurope. The bogs were situated 40 km apart in an area whichbetween the years 1985 and 1995 received as much as 130 kg Sha^-1 yr^-1 from the atmosphere. Vertical peataccretion was faster at Pod Jelení horou (JH) than atVelký moál (VM). Organic carbon-bonded S was themost abundant sulfur pool, constituting 77 and 65 wt. % at JHand VM, respectively. At JH both the S concentration maximumand the highest annual S deposition rate were displaceddownward by more than 20 years (from 1987 to the 1960s)indicating that the buried S is vertically mobile. At VM the Sconcentration was the highest in the topmost 2-cm section eventhough atmospheric S deposition peaked in 1987. Differentmechanisms of S isotope redistribution prevailed in thetopmost peat layers at JH, where a negative ³⁴Sshift occurred, and at VM, where a positive ³⁴Sshift occurred. Bacterial sulfate reduction was responsiblefor the negative ³⁴S shift at JH. One possibleexplanation of the positive ³⁴S shift at VM isrelease of ³²S-enriched products of mineralization duringpeat diagenesis. There was a strong positive correlationbetween the abundance of total and pyrite S along the profiles.The presence of pyrite S at VM (526 ± 60 ppm) suggestedthat even at VM bacterial sulfate reduction occurred. Ananaerobic incubation of JH peat indicated sulfate reductionrate of 600 nmol g^-1 day^-1. The turnover times forinorganic S pools were shorter than for the organic S pools.Cumulative S contents in the Czech peat bogs were found to besignificantly lower than in similar sites in the NortheasternU.S., even though the atmospheric S inputs were more thanthree times higher at the Czech sites. Possible causes of suchdiscrepancy are discussed.     

EVALUATION OF COPPER ACCUMULATION IN PART OF THE CALIFORNIA AQUEDUCT1

ABSTRACT: Copper sulfate has been used extensively in the California Aqueduct to control phytoplankton and the alga Cladophora. Since 1969 more than 250,000 pounds of copper sulfate has been added to a part of the aqueduct. Although copper sulfate is effective in controlling algae, copper tends to accumulate in the system in which it is applied. Samples of water, biota including plants, clams, and snails, as well as sediment were analyzed for copper. Results of these analyses showed that copper concentrations in the water, with three exceptions, were less than 10 micrograms per litre. Samples of plant tissue showed a 198 percent increase in copper concentration in the treated reach of the aqueduct, and clam tissue showed a 68 percent increase. Snails in the treated reach had 77 percent more copper than in the untreated reach whereas copper concentrations in the sediment doubled. None of the concentrations found are considered to be harmful to the biota.     

生石灰孔结构对高温脱硫性能的影响

喷钙脱硫工艺的炉内脱硫率 ,不仅受工艺参数的影响 ,还与石灰石分解生成的新生CaO或直接喷入的CaO的表面结构有关。本研究用同一石灰石经不同方法 (煅烧、过烧、煅烧 -水合 -脱水等 )制备了四种具有不同比表面积和孔结构的生石灰。高温脱硫研究表明 :这四种不同孔结构的生石灰 ,具有不同的脱硫率。通过对高温脱硫前后吸着剂宏观结构变化的对比 ,发现半径小于 30 的孔易被反应产物堵塞 ,因而脱硫能力有限 ,而半径大于 5 0 的孔对脱硫更有效。本研究将为提高炉内喷钙的脱硫率、研制和开发高效脱硫剂提供新的途径。     

储罐硫腐蚀产物标志性气体的监测

含硫油品储罐内的腐蚀产物与油品中的活性硫反应生成硫化物,而此类硫腐蚀产物氧化自燃是导致储油罐发生火灾、爆炸事故的重要原因.通过试验考察了氧气体积比对硫腐蚀产物氧化自燃过程的影响,探索了铁锈模拟物在氧化过程中SO2气体的释放规律.结果表明:氧气浓度越高,硫腐蚀产物的自燃危险性越大;随着O2浓度增加,氧化反应中SO2的浓度越大,SO2气体析出速度越快,当氧化反应的温度为40℃时,SO2气体浓度达到最大.     

活化改性半焦用于烟气脱硫催化剂制备工艺优化

为研究不同制备工艺条件下的烟气脱硫催化剂吸附去除烟气中硫化物的性能,采用硝酸活化的半焦脱硫剂,通过穿透时间和硫容评价所制备催化剂的脱硫性能.采用固定床反应器考察了催化剂表面基团酸碱性、催化剂成型的制备顺序、黏结剂和催化剂尺寸及负载金属氧化物等制备工艺条件对催化剂脱硫性能的影响.结果表明:原料半焦表面呈碱性,半焦经硝酸氧化改性后,表面呈酸性,高温煅烧可以使半焦表面酸性官能团分解成碱性官能团,催化剂表面净碱量越大,脱硫性能越好;采取先将半焦成型再进行高温煅烧、水气活化的工艺,脱硫活性更高;最适合的黏结剂为煤焦油;最佳的催化剂粒径为3mm;烟气中通入O2能显著提高半焦吸附催化剂的脱硫性能,O2体积分数以5％为宜,烟气中适量H2O是脱硫必不可少的条件,水汽体积分数以8％最佳;在催化剂制备过程中添加质量分数为1％的V2O5,可以明显改善催化剂的脱硫性能.