硫素对氧化还原条件下水稻土氧化铁和砷形态影响

通过充N2和充O2的氧化还原反应装置,在添加外源砷污染的水稻土中,施用不同形态的无机硫(不施硫S0,单质硫S1和硫酸盐S2),模拟水稻田的氧化还原状况.结果表明,通N2时,土壤溶液氧化还原电位(Eh)在-100~-200 mV之间,溶液pH在7.0~8.0之间,pe+pH为4~7之间;通O2时,溶液Eh在200mV左右,溶液pH在6.5~7.5之间,pe+pH为9~12之间.无论通N2还是通O2,土壤溶出铁的浓度在1.2~1.6 mg·L-1,均有处理S0>S1>S2和AsS0>AsS1>AsS2.在通N2时,各处理HCl提取土壤氧化铁的含量比原土[(21.4±0.3)g·kg-1]低5 g·kg-1,有利于结晶态氧化铁向无定形氧化铁转化和形成Fe2+,无定形氧化铁活化度比原土活化度46.8%有所增加,且处理AsS2(49.4%)AsS2(36.1%).通N2时,土壤溶液中砷浓度变化为AsS0[(1.13±0.04)mg·L-1]>AsS1[(0.89±0.01)mg·L-1]>AsS2[(0.77±0.04)mg·L-1];通O2时,土壤溶液中砷浓度变化AsS1[(0.77±0.01)mg·L-1]>AsS0[(0.20±0.09)mg·L-1]>AsS2[(0.09±0.01)mg·L-1].通N2时,不同处理各形态砷占总砷比例变化为残渣态(34.9%~41.4%)≈专性吸附态(37.4%~39.5%)>晶态铁锰结合态(23.3%~25.6%)>非专性吸附态(2.4%~3.3%)>无定形铁锰结合态(0.5%~0.8%).通O2时,各处理形态砷占总砷比例变化为残渣态(30.8%~39.3%)≈专性吸附态(30.3%~34.7%)>晶态铁锰结合态(26.0%~28.7%)>无定形铁锰结合态(9.3%~10.7%)>非专性吸附态(0.5%~1.6%),其中,无定形铁锰氧化物结合态砷比通N2时提高了约9%,也就是无定形铁锰的老化作用对砷形态转化的影响.这表明还原条件能够使氧化铁的活化度升高,砷的移动性增强,但硫酸盐体系降低氧化铁的活化度,单质硫体系的砷移动性要大于硫酸盐体系的砷移动性.     

Photoassisted Fenton degradation of phthalocyanine dyes from wastewater of printing industry using Fe(Ⅱ)/γ-Al2O3 catalyst in up-flow fluidized-bed

Fe(II)/γ-Al2O3 powders synthesized using the dipping method were produced from a mixed aqueous solution containing aluminium oxide(γ-Al2O3) and iron(II)-precursor(FeSO4), and used for photoFenton degradation of phthalocyanine dyes(PCS) under ultraviolet(UV) irradiation in an up-flow fluidized bed. The catalysts were characterized by XRD, ESCA, BET, EDS and SEM. The results showed that Fe2+ion was compounded on the γ-Al2O3 carrier. The effects of different reaction parameters such as catalyst activity, dosage and solution pH on the decolorization of PCS were assessed. Results indicated that maximum decolorization(more than 95%) of PCS occurred with20 wt% Fe(II)/γ-Al2O3 catalyst(dosage of 60 g/L) using a combination of UV irradiation and heterogeneous Fenton system. The degradation efficiency of PCSincreases as pH decreases, exhibiting a maximum efficiency at pH 3.5. The recycled catalyst was capable of repeating three runs without a significant decrease in treatment efficiency, and this demonstrated the stability and reusability of catalyst.     

Atmospheric sulfur hexafluoride in-situ measurements at the Shangdianzi regional background station in China

We present in-situ measurements of atmospheric sulfur hexafluoride（SF6） conducted by an automated gas chromatograph–electron capture detector system and a gas chromatography/mass spectrometry system at a regional background site, Shangdianzi,in China, from June 2009 to May 2011, using the System for Observation of Greenhouse gases in Europe and Asia and Advanced Global Atmospheric Gases Experiment（AGAGE）techniques. The mean background and polluted mixing ratios for SF6 during the study period were 7.22 × 10-12（mol/mol, hereinafter） and 8.66 × 10-12, respectively. The averaged SF6 background mixing ratios at Shangdianzi were consistent with those obtained at other AGAGE stations located at similar latitudes（Trinidad Head and Mace Head）, but larger than AGAGE stations in the Southern Hemisphere（Cape Grim and Cape Matatula）. SF6 background mixing ratios increased rapidly during our study period, with a positive growth rate at 0.30 × 10-12year-1. The peak to peak amplitude of the seasonal cycle for SF6 background conditions was 0.07 × 10-12, while the seasonal fluctuation of polluted conditions was 2.16 × 10-12. During the study period, peak values of SF6 mixing ratios occurred in autumn when local surface horizontal winds originated from W/WSW/SW/SWS/S sectors, while lower levels of SF6 mixing ratios appeared as winds originated from N/NNE/NE/ENE/E sectors.     

Comparison of different disinfection processes in the effective removal of antibiotic-resistant bacteria and genes

This study compared three different disinfection processes(chlorination, E-beam, and ozone) and the efficacy of three oxidants(H2O2, S2O-8, and peroxymonosulfate(MPS)) in removing antibiotic resistant bacteria(ARB) and antibiotic resistance genes(ARGs) in a synthetic wastewater. More than30 mg/L of chlorine was needed to remove over 90% of ARB and ARG. For the E-beam method, only1 dose(kGy) was needed to remove ARB and ARG, and ozone could reduce ARB and ARG by more than 90% even at 3 mg/L ozone concentration. In the ozone process, CT values(concentration × time)were compared for ozone alone and combined with different catalysts based on the 2-log removal of ARB and ARG. Ozone treatment yielded a value of 31 and 33(mg·min)/L for ARB and ARGs respectively. On the other hand, ozone with persulfate yielded 15.9 and 18.5(mg·min)/L while ozone with monopersulfate yielded a value of 12 and 14.5(mg·min)/L. This implies that the addition of these catalysts significantly reduces the contact time to achieve a 2-log removal, thus enhancing the process in terms of its kinetics.     

气相中乙酸乙酯光解的光子效率:波长和催化剂的影响

采用4种不同波长的准分子光源(Xe Cl*、Kr Cl*、Xe Br*和Kr Br*)降解气相的乙酸乙酯.对比了外加3种负载型光催化剂(有机膜负载Ti O2、有机膜负载石墨烯和纱网负载Ti O2)条件下乙酸乙酯的去除率,考察了光源类型、辐射功率和气体初始浓度对去除率的影响.同时,测定了不同光源的辐射光谱和辐射功率,计算了不同反应条件下的光子效率.结果表明,乙酸乙酯去除率按Kr Br*Kr Cl*Xe Cl*Xe Br*依次降低,而Xe Cl*和Kr Br*光源降解乙酸乙酯气体可以得到较高的光子效率;有机膜负载Ti O2比不加催化剂时乙酸乙酯去除率和光子效率都有所提高,但提高幅度不大.气体流速和乙酸乙酯初始浓度升高,光子效率升高.采用Kr Br*准分子灯直接光解乙酸乙酯,实验条件为:辐射功率0.76 W,乙酸乙酯初始浓度946mg·m-3,气体流速600 m L·min-1,光子效率为5.63%.     

高硫酸盐难降解废水高温厌氧处理中限量曝气的应用及影响

由于硫酸盐还原的影响,普通高温UASB反应器处理亚硫酸盐纸浆厂排出的高硫酸盐难降解废水过程中甲烷菌活性受到了严重抑制.考虑到空气对硫化氢的吹脱和对硫化物的氧化作用可能减轻硫化物对甲烷菌的抑制,本研究在厌氧反应器中引入限量曝气措施.试验结果表明,反应器的运行稳定性和处理能力均得到大幅提高.在有机负荷提高到原来2倍的情况下,曝气后COD去除率仍有提高,从40%～50%提高到60%～70%.试验证明部分甲烷菌可以耐氧,而某些种类的水解酸化细菌则对不完全厌氧环境比较敏感.     

改性贵金属催化剂催化还原脱除NO

含有NO的工业废气直接排放会严重污染空气,须对含有NO的工业废气进行净化处理.采用NH3为还原剂贵金属铂催化剂进行了低温还原NO脱除烟气中氮氧化物性能的研究.结果表明:实验室制备的贵金属铂催化剂具有高的低温活性和选择性催化还原脱除NO的性能,但该催化剂易被原料气中少量的硫化物(SO₂)中毒而影响其稳定性;用稀土元素La和Ce对贵金属铂催化剂进行改性,改性后贵金属铂催化剂的稳定性得到了大幅度提高,出口气体中氮氧化物浓度大幅度降低.本实验Pt∶La∶Ce最佳摩尔比为1∶3.78∶3.56.     

Preparation and characterization of Fe2O3-CeO2-TiO2/γ-Al2O3 catalyst for degradation dye wastewater

In order to develop a catalyst with high activity for catalytic wet oxidation （CWO） process at room temperature and atmospheric pressure, Fe2O3-CeO2-TiO2/γ-Al2O3 catalyst was prepared by consecutive impregnation method and the prepared parameters were optimized. The structure of the catalyst was characterized by BET, XRF, SEM and XPS technologies, and the actual wastewater was used to investigate the catalytic activity of Fe2O3-CeO2-TiO2/γ-Al2O3 in CWO process. The experimental results showed that the prepared catalyst exhibited good catalytic activity when the doping amount of Ti was 1.0 wt% （the weight ratio of Ti to carriers）, and the middle product, Fe2O3-CeO2-TiO2/γ-Al2O3, was calcined in 450℃ for 2 h. The CWO experiment for treating actual dye wastewater indicated that the COD, color and TOC of actual wastewater were decreased by 62.23%, 50.12% and 41.26% in 3 h, respectively, and the ratio of BOD5/COD was increased from 0.19 to 0.30.     

气态硫闪爆事故原因分析及对策

对处理硫磺回收装置高温掺合阀故障时发生的硫闪爆事故进行了分析,提出了相应的对策.     

沼渣生物炭基Fenton催化剂的制备及其高效降解吡虫啉农药废水的研究

以废弃物沼渣和含铁剩余污泥为原料,采用一步热解法制备沼渣生物炭基Fenton催化剂(以下简称催化剂),构建了非均相Fenton反应体系处理含吡虫啉模拟废水,考察了H2 O2和催化剂用量对吡虫啉去除率的影响.结果表明,非均相Fenton反应体系中,H2 O2最佳投加量为0.50 g/L,催化剂最佳投加量为1.00 g/L...