Connecting sources, fractions and algal availability of sediment phosphorus in shallow lakes: An approach to the criteria for sediment phosphorus concentrations

Although point and nonpoint sources contribute roughly equal nutrient loads to lakes, their relative role in supporting algae growth has not been clarified. In this research, we have established a quantitative relationship between algae-available phosphorus (P) and P chemical fractions in sediments; the latter indicates the relative contribution of point versus nonpoint sources. Surface sediments from three large shallow lakes in eastern China, namely, the Chaohu, Taihu and Hongzehu Lakes, were sampled to assess their algae-available P and chemically extracted P fractions. The algae-available P primarily comes from iron/aluminium (hydr)oxide-bound P (Fe/Al-bound P), 45% of which is algae-available P. The ratio of Fe/Al-bound P to calcium compound-bound P (Ca-bound P) indicated the relative contribution of point to nonpoint sources, with the point sources contributing the majority of increased Fe/Al-bound P in sediments. Therefore, the reduction of point sources from urbanized areas, rather than nonpoint sources from agricultural areas that primarily contribute to the Ca-bound P fraction, should be prioritized to alleviate cyanobacterial algal blooms (CyanoHABs) in shallow lakes with sediment P as a potential source to support algae growth. With these important results, we proposed a conceptual model for “P-pumping suction” from sediments to algae to aid in the development of the criteria for sediment P concentrations in shallow lakes.     

两种奥氏体不锈钢酸性盐雾腐蚀行为研究

目的研究0Cr18Ni9(钝化)不锈钢与0Cr18Ni10Ti(钝化)不锈钢在酸性盐雾条件下的腐蚀行为,为发动机零件选材及防护措施的改进提供依据。方法按GJB150.11A—2009《军用装备环境试验方法盐雾试验》进行,调节溶液p H到3.5±0.5,以24 h喷雾润湿+24 h干燥为一个循环,分别开展2(96 h)、4(192 h)、5(240 h)个循环的酸性盐雾试验。采用目视、称量、X射线衍射(XRD)、扫描电子显微镜(SEM)及能谱仪(EDS)对盐雾腐蚀后试样进行观察及分析。结果 0Cr18Ni9(钝化)与0Cr18Ni10Ti(钝化)两种奥氏体不锈钢均发生了轻微的腐蚀,主要为局部腐蚀及均匀腐蚀。结论两种金属在酸性盐雾条件下耐蚀性良好,且可满足目前海军型发动机对材料耐酸性盐雾腐蚀的要求,0Cr18Ni9(钝化)略优于0Cr18Ni10Ti(钝化)。     

活性硅酸聚合硫酸铁的研究

以硅酸钠，硫酸和聚合硫酸铁为原料制备活性硅酸合硫酸铁，测定了ＡＳＰＦＳ红外光谱，了Ｆｅ／Ｓｉ摩尔比和水样ＰＨ值等因素对产品和除浊效果的影响当Ｆｅ／Ｓｉ摩尔比为１．５时产品稳定性和除浊效果均较好。     

用废催化剂作原料制CIM油脂氢化催化剂

介绍用废油脂氢化催化剂作原料,回收Cu2+-Ni2+液,再用此液作原料制CIM油脂氢化催化剂的工艺流程和制作方法。结果表明:其所制成的CIM催化剂的性能与用工业硫酸铜和硫酸镍为原料制的CIM催化剂的性能相同。     

利用废渣废碱液年产3000t粒状五水偏硅酸钠工艺初步设计

介绍以铝矾土提取硫酸铝废渣和氧氯化锆副产废碱液为原料生产泡花碱 ,然后利用一次造粒法生产五水偏硅酸钠新工艺确定影响产品质量指标工艺因素。小试试验产品质量指标达到HG/T2 5 6 8- 94要求 ,工艺成本低 ,避免废碱液及废渣排放对环境的污染。     

合成盐酸中酸性废水的综合治理

对合成盐酸中的酸性废水循环利用,并用此酸性水作为生产普通盐酸的吸收水.实践证明,该方法是一种行之有效的治理途径,有较好的环境和经济效益.     

城市污水处理厂工艺和自控系统

归纳了城市生化污水处理厂工艺、自控系统的构成和作用，具体分析了沈阳市北部污水处理厂自控系统     

硫精砂尾矿还原硫酸烧渣的研究

利用硫精砂尾矿还原硫酸烧渣，从而提高烧渣中的铁的浸出率，达到综合利用尾矿及烧渣，减轻污染的目的。结果表明，把烧渣和尾矿按４－６比１的比例混合，在７００－８００℃处理３０ｍｉｎ，铁的浸出率比处理前增加３倍。文中还讨论了还原机理。     

环烷酸脱油工艺的实验研究

以锦州化工二厂生产的２＃环烷酸为原料，采用减压蒸馏──初馏分皂化萃取脱油工艺，可制得中性油含量分别低于１０％和５％的一级品环烷酸．该工艺具有流程简单、物料消耗少、产品收率高等优点．通过实验，初步探讨了蒸馏真空度、氢氧化钠浓度及用量、乙醇用量、萃取剂用量等工艺条件对脱油效果及产品质量的影响。