EVALUATION OF COPPER ACCUMULATION IN PART OF THE CALIFORNIA AQUEDUCT1

ABSTRACT: Copper sulfate has been used extensively in the California Aqueduct to control phytoplankton and the alga Cladophora. Since 1969 more than 250,000 pounds of copper sulfate has been added to a part of the aqueduct. Although copper sulfate is effective in controlling algae, copper tends to accumulate in the system in which it is applied. Samples of water, biota including plants, clams, and snails, as well as sediment were analyzed for copper. Results of these analyses showed that copper concentrations in the water, with three exceptions, were less than 10 micrograms per litre. Samples of plant tissue showed a 198 percent increase in copper concentration in the treated reach of the aqueduct, and clam tissue showed a 68 percent increase. Snails in the treated reach had 77 percent more copper than in the untreated reach whereas copper concentrations in the sediment doubled. None of the concentrations found are considered to be harmful to the biota.     

THE IMPACT OF URBANIZATION ON THE DISTRIBUTION OF HEAVY METALS IN BOTTOM SEDIMENTS OF THE SADDLE RIVER1

ABSTRACT: A three-year study has been conducted on a 4.6 mile stretch of the Saddle River near Lodi, New Jersey. The primary objectives of this investigation were (1) to provide baseline information on the concentration and distribution of heavy metals in bottom sediments of the Saddle River; (2) to qualitatively evaluate which parameters affect this distribution; and (3) to determine the effect of urbanization on the concentration and distribution of these materials. Significant enrichments of several heavy metals were observed in bottom sediments of the lower Saddle River near Lodi, New Jersey, as compared to the upper Saddle River. Attempts to correlate metal concentrations in bottom sediments with chemical-oxygen demand were not successful in demonstrating a relationship between these two factors. Metal concentrations were found to be strongly dependent upon particle size. In general, metal concentrations in bottom sediments increased with decreasing partical diameter. However, metals enrichment was observed to be considerably greater in the larger sediment fractions studied (>420μ) than the smaller sediment fractions as one proceeded downstream through the urban area. Since the larger sediment fractions are least effected by scour and transport they may best reflect the effect of urbanization on the distribution of heavy metals over an extended period of time at a given location.     

WATER USE AND WATER CONSERVATION BY THE COPPER MINING INDUSTRY1

ABSTRACT: This paper examines the use of water by copper mines for treating low grade ores. The froth flotation process for treating sulphide ore and the heap leaching process for treating oxide ore are described, and ways of reducing the amount of water used in these processes are discussed. Estimates of the costs reducing water consumption are given. Finally, the circumstances in which it would be desirable for a copper mine to reduce its level of water consumption are considered.     

CALCULATION OF CUMULATIVE PERCENTAGE AT SELECTED PARTICLE SIZES FROM BOTTOM WITHDRAWAL TUBE ANALYSIS

ABSTRACT: A new computation method is developed for the bottom withdrawal tube particle size analysis. A transformation on time scale is introduced so that the cumulative percentage of a selected particle size can be determined from a single continuous Oden cum.     

SC菌剂对废水中Cu~(2 )去除的初步研究

用研制的SC菌剂作生物吸附剂 ,研究了其在不同菌铜比 ,pH、温度及作用时间条件下对Cu2 的去除效果。结果表明 ,在获得的最佳条件下 ,对不同Cu2 浓度的印刷电路板废水中Cu2 的去除效果明显 ,达 95 48%和 86 74%。     

Electrochemical remediation of copper (II) from an industrial effluent Part II: three-dimensional foam electrodes

A batch recycle removal of copper ions from an industrial effluent by means of copper foam cathodes was tested. A constant current of 750 A was applied to the cell in order to perform the reduction. Copper depletion was investigated at different solution flow rates and a removal greater than 98% was obtained with a flow rate of 1000 l/h. The influence of initial metal concentration on copper deposition and current efficiency is also discussed.     

热水锅炉水冷壁管爆管事故综合分析

对在同一单位的三台热水锅炉发生多起水冷壁管爆管事故进行了综合分析,提出了相应的改进措施。     

L型钢管混凝土芯柱耐火极限研究

火灾高温对结构安全有显著影响,为研究等肢L形钢管混凝土芯柱的耐火极限及其影响因素,利用ABAQUS软件建立合理的高温反应分析模型,在验证模型可靠性基础上,分析了荷载比、截面边长、长细比、荷载偏心率、含钢率等对L形钢管混凝土芯柱耐火极限的影响。研究结果表明:在一定参数范围内,荷载比和截面边长是构件耐火极限的主要影响参数,荷载比越小,截面边长越大,构件的耐火极限越高;长细比和荷载偏心率对其影响较大,长细比和荷载偏心率越小,构件的耐火极限越高;含钢率对其影响不显著。结果可为异形钢管混凝土芯柱的抗火安全设计提供参考。     

Application of CFD on the sensitivity analyses of some parameters of the modified Hartmann tube

The aim of this work is to determine the influence of operating parameters such as the dispersion pressure, the ignition delay and height on the dust flammability. A Computational Fluid Dynamics (CFD) simulation, based on an Euler–Lagrange approach, was developed with Ansys Fluent™ and validated experimentally. Such analysis will facilitate the choice of the most conservative conditions for a flammability test. This paper is focused on a case study performed on wheat starch with the modified Hartmann tube. The dispersion process of the powder was studied with granulometric analyses performed in situ and high speed videos. Tests were performed with injections at gas pressure ranging from 3 to 6 bars and the evolution of the particle size distribution (PSD) was recorded at different ignition heights (5, 10 and 15 cm over the dispersion nozzle). The observations highlighted the presence of agglomeration/deagglomeration processes and dust segregation. Besides, a CFD simulation analysis was aimed at evaluating the impact of a set of parameters on the PSD and the local turbulence, which are closely linked to some flammability parameters. For this computational analysis, the CFD simulation was coupled with a collision treatment based on a Discrete Element Method (DEM) in order to consider the cohesive behavior of the combustible dust. Thus the results suggest performing the injection of the gases at approximately 5 bars for the flammability tests of wheat starch in order to obtain the finest PSD at a given ignition height. It is also shown that the finest PSD are obtained at 5 cm over the dispersion nozzle. However, the local instabilities and turbulence levels are so high during the first stages of the dispersion that the flame growth can be disturbed for short ignition delays. Moreover, the stabilization of the bulk of the dust cloud requires longer periods of time when the ignition sources are located at 15 cm. As a result, the recommended height to perform a flammability test is 10 cm in this case. Finally, this study proposes some tools that might improve the procedure of dust flammability testing.     

四环素类抗生素和铜复合污染对猪粪厌氧消化的影响

兽用抗生素和矿物元素添加剂可起到预防动物疾病、促进动物生长、提高饲料转化率等作用,因此被广泛应用于畜禽养殖业。本研究以猪粪中温厌氧消化为研究目标,采用全自动甲烷潜势测试系统,考察了一定浓度的四环素(TC:30 mg·kg~(-1)dry weight,DW)、土霉素(OTC:50 mg·kg~(-1)DW)和金霉素(CTC:15 mg·kg~(-1)DW)对厌氧累积产甲烷量和日产甲烷速率的影响。结果表明,TC、OTC和CTC对猪粪中温厌氧消化累积产甲烷量和日产甲烷速率均有促进作用(累积产甲烷总量提高比例分别为7.9%、0.4%和5.4%)。另外,采用超高效液相色谱-四极杆串联质谱对猪粪厌氧消化前后样品中四环素类抗生素及其代谢产物进行了分析。结果表明,液相中的四环素类抗生素在猪粪厌氧消化过程中得到了明显的去除,去除率达到90%~100%;而固相中只有金霉素和差向异构金霉素有明显的去除效果,去除率分别为41.69%和41.58%。采用Tessier连续提取法对猪粪厌氧消化前后样品中5种形态的铜包括可交换态、碳酸盐结合态、铁锰氧化结合态、有机物结合态、残渣态进行了分析,结果表明,猪粪厌氧消化后,可交换态、碳酸盐结合态和铁锰结合态的铜浓度比厌氧消化前分别降低了1%~9%、0.1%~3%、12%~19%,而有机态和残渣态的铜浓度却在厌氧消化后分别增加了15%~35%、1%~2%。厌氧消化后,70%~80%的铜都是以有机铜的形态存在。铜逐渐从不稳定态转化为相对稳定的有机态和残渣态铜,因此,厌氧消化过程使铜从可生物利用态转变为不可生物利用态,趋于稳定化。