Dyella ginsengisoli LA-4吸附Cu2+特性及其动力学研究

研究一种新型吸附菌剂Dyella ginsengisoli LA-4(以下简称菌株LA-4)对Cu2+的吸附特性及其动力学,并利用表面响应法优化菌株LA-4对Cu2+的吸附条件.结果表明:(1)菌株LA-4的接种量、pH对Cu2+的吸附有重要的影响.(2)根据表面响应法 优化模型预测出菌株LA-4吸附Cu2+的最...     

Robustness testing of a free-fall triboelectric separation process for plastic waste recovery

Among the separation techniques used in industries, the triboelectric separation of insulating particles using a rotary tube is an effective way employed in the waste recovery of plastic and mineral products. This process, also called free-fall triboelectric separation, is widely used for the sorting of granular mixtures resulting from industrial plastic wastes. Given that the robustness of such a separation process is an important issue, a standard procedure is used for determining the set point and for minimising the process sensitivity of sorting mixed particles of different polymers to changes in the values of some critical factors. The aim of this paper was to analyse the efficiency of the triboelectric separation process of polymers with respect to any slight variation in the values of the most significant factors. Experiments with a sample of high-density polyethylene and polyvinyl chloride plastic granules were carried out on a laboratory experimental bench. Several one-factor-at-a-time experiments, followed by two factorial designs (one composite and the other fractional), were performed based on the following experimental procedure: (1) determination of the variation limits of the input variables; (2) identification of the set point and (3) robustness testing of the process, i.e. testing whether the performance of the system remains high even when the factors vary slightly around the set point.     

高效液相色谱-串联质谱法同时检测地表水中13种药物及个人护理品

采用高效液相色谱-串联质谱(HPLC-MS/MS)检测,建立了地表水中13种药物及个人护理品的测定方法。水样用盐酸与氢氧化钠溶液调p H值至7.0左右,过固相萃取小柱进行富集,用14 m L甲醇洗脱。以C18柱为分离柱,0.01%甲酸的甲醇-0.01%甲酸水溶液为流动相,目标物在10 min内分离,在0.50~250μg/L范围内,13种化合物峰面积与内标物质峰面积之比与质量浓度的线性关系良好(0.99),检出限在0.05~0.5 ng/L范围内。基质加标实验结果表明,13种化合物在水中的回收率分别在56.2%~123.2%之间(加标水平5 ng/m L)和58.0%~107.8%(加标水平50 ng/m L),相对标准偏差在1.60%~19.9%(n=6)之间。应用该方法测定了从2条纳污河流采集的10份水样,结果表明,除美托诺尔和普洛萘尔未被检出外,其余11药物的检出频率在30%~100%之间。在13种目标物质中,咖啡因的检测浓度最高达287.5ng/L,舒必利次之,为277.5 ng/L。本方法快速、准确,适用于地表水中PPCPs类的快速测定。     

300MW燃煤锅炉机组超细颗粒聚并器的实验研究

为了解决燃煤锅炉烟气中超细颗粒难以脱除的问题,基于流体动力学原理设计了一种超细颗粒聚并器,并在300 MW燃煤锅炉机组电除尘器的前置烟道中进行了实验研究。结果表明,聚并器内部存在超细颗粒之间以及超细颗粒与大颗粒之间的相互聚集行为,从而使超细颗粒数量显著减少。例如,对于粒径在2.65和10.48μm以下的颗粒,其体积比例在聚并器出口分别减少了56.7%和62.3%,在电除尘器出口的粉尘浓度减少了26.34 mg/Nm3,这表明,基于流体动力学原理的聚并器对超细颗粒的聚并作用明显,具有良好的应用前景。     

响应面法优化黄粉虫幼虫处理餐厨垃圾饲养条件的研究

研究了黄粉虫幼虫处理餐厨垃圾的方法.首先在饲养温度、饲料含水量和饲养密度等条件下进行单因素实验,然后,以利用率为指标,运用响应面法优化了黄粉虫幼虫处理餐厨垃圾的饲养条件,结果表明,最佳饲养条件为饲养温度26.7℃、饲料含水量14.5％、饲养密度4.1头/cm2.在此饲养条件下,黄粉虫对餐厨垃圾利用率理论值为38.72％,实际餐厨垃圾利用率为38.88％,相对误差为0.41％,说明利用黄粉虫幼虫处理餐厨垃圾具有较好的效果.     

中国西部矿产资源产业集聚度与竞争力研究

促进矿产资源产业集聚是推动我国西部矿产资源产业发展的主要路径之一,开展我国西部矿产资源产业集聚度与产业竞争力相关性的研究可以为西部矿产资源产业竞争力提升提供相关决策指导.为分析矿产资源产业集聚对矿产资源产业竞争力和区域经济的推动作用,本文选取区位熵反映矿产资源产业集聚度,具体地,选择企业数量区位熵反映矿产资源产业区域集聚度.选取产业产值区位熵反映矿产资源产业经济集聚度;矿产资源产业竞争力则选取产值利润率借以反映.通过衡量我国西部9个矿产资源产业的区域集聚度、经济集聚度和产值利润率,得出我国西部大部分矿产资源产业仍停留于企业"扎堆"的区域集聚,经济集聚不足,尤其是下游加工业,这导致我国西部矿产资源产业集聚效应难以充分发挥,产值利润率低下;进一步的相关性分析表明,西部矿产资源产业集聚度与产业竞争力正相关,且经济集聚对产业竞争力的推动作用更强.因而,不仅要发展下游加工业,而且要提高产业集聚度尤其是经济集聚度,以更有效地推动我国西部矿产资源产业竞争力的提升.     

轨道交通运行引起的场地振动试验研究

轨道交通运行引起的环境振动问题,已成为土木工程界关注的一个新的课题。对南京市栖霞镇某场地进行了列车振动现场试验,得到了不同列车车型与车速下的地面振动速度时程曲线,给出了地面振动速度的频谱特性和衰减规律,分析了列车运行引起的环境振动的传递路径,为进一步研究轨道交通振动控制提供了参考。     

昌吉硫磺沟矿区地表沉陷区的土地整治与生态恢复

针对昌吉市硫磺沟矿区煤矿开采引起的地表沉陷及其对矿区地表及环境破坏的影响,以减轻地表沉陷危害程度、恢复矿区所在地的生态功能为目标,按照采矿区塌陷类型、塌陷坑大小及塌陷区地理环境,采用不同的土地整治与生态恢复措施,在防治和控制矿区地表沉陷引起的生态破坏及生态环境保护方面取得很好的成果与经验.     

Multi-response optimization of Fenton process for applicability assessment in landfill leachate treatment

Fenton process, as a pretreatment method, was found to be effective in the primary treatment of mature/medium landfill leachate. However, the main problem of the process is the large amount of produced sludge that requires an accurate feasibility evaluation for operational applications. In this study, the response surface methodology was applied for the modeling and optimization of Fenton process in three target responses, (1) overall COD removal, (2) sludge to iron ratio (SIR) and (3) organics removal to sludge ratio (ORSR), where the latter two were new self-defined responses for prediction of sludge generation and applicability assessment of the process, respectively. The effective variables included the initial pH, [H₂O₂]/[Fe²⁺] ratio and Fe²⁺ dosage. According to the statistical analysis, all the proposed models were adequate (with adjusted R² of 0.9116–0.9512) and had considerable predictive capability (with prediction R² up to 0.9092 and appropriate adequate precision). It was found that all the variables had significant effects on the responses, specifically by their observed role in dominant oxidation mechanism. The optimum operational conditions obtained by overlay plot, were found to be initial pH of 5.7, [H₂O₂]/[Fe²⁺] ratio of 17.72 and [Fe²⁺] of 195 mM, which led to 69% COD removal, 2.4 (l sludge/consumed mole Fe²⁺) of SIR and 16.5 (gCOD removed/l produced sludge) for ORSR in verification test, in accordance with models-predicted values. Finally, it was observed that [H₂O₂]/[Fe²⁺] ratio and Fe²⁺ dosage had significant influence on COD removal, while Fe²⁺ dosage and [H₂O₂]/[Fe²⁺] ratio had remarkable effects on SIR and ORSR responses, respectively.     

Diffusion mechanism of lindane into wood charcoal

Abstract

The wood charcoal treated by 1N HNO₃ (WCT) was used to remove toxic chlorinated pesticide lindane (y‐HCH) residue from water by the sorption process. Using a simple first order reversible kinetics constants and half time equations, the film and pore diffusion coefficients were determined. Film diffusion was found to be rate limiting step in sorbing lindane by WCT. This was further authenticated by kinetics studies at different initial sorbate concentrations, different sorbent sizes, and different agitation speeds besides interruption test. A pore diffusion model was used to fit the data of kinetics in continuously mixed batch reactors (CMBR), and the tortuosity, external resistance, and surface diffusion effects on lindane sorption by WCT were noticed. The tortuosity values of 15 to 28 were obtained for WCT‐lindane system.