Measurements of surface contamination of spray equipment with pesticides after various methods of application

Abstract

A traditional method to determine operator dermal exposure is to quantify the amount of pesticide coming into contact with specific body regions and then to integrate the deposition density values with the total body surface. It is known that extremely high deposition values may occur in the hand region; however, the source of contamination is generally assumed to be direct splash or contact with the pesticide container. One of the parameters affecting operator/pilot exposure could be the transfer of pesticide residue, particularly in the case of pesticides with a longer half‐life, from contaminated surfaces of spray equipment by direct contact over extended periods. If the rate of skin absorption of pesticide is readily known, the expected values of daily dose for an operator or pilot may significantly rise due to the extended contact period. This study produced field data on the surface contamination of spray equipment used for ground and aerial applications. If field data on precise work practice (time‐motion) observations are incorporated, it may be possible to estimate the potential exposure of operator/pilot due to hand contact with contaminated surfaces.     

Assessment of environmental quality of water bodies next to agricultural areas of Buenos Aires province (Argentina) by means of ecotoxicological studies with Rhinella arenarum

Over the last decade, oysters in the Bay of Veys (Northwest France) have sporadically experienced significant summer mortality events which appear to be due to a combination of extrinsic and intrinsic factors. In the present work, the involvement of pesticides (as additional stressors) was investigated using both artificial exposure and field studies (at two sites). Six herbicides were detected in seawater following tests for a total of 15 herbicides. The most estuarine site was the most contaminated, showing relatively high values compared with those recorded in a neighboring river. No pesticides were detected in the flesh of oysters in the field but exposure experiments led to an accumulation of two substituted ureas (diuron and isoproturon, from 0.5 μ g/L and 1 μ gL^{? 1} respectively). Some physiological effects were observed in terms of reproduction (partial spawning) and histopathology (atrophy of the digestive tubule epithelium) but results related to other tissue alterations and to neutral red retention (NRR) assays were not conclusive and require further investigation.     

响应面法和神经网络优化Acinetobactersp．DNS32发酵基质

为了提高阿特拉津降解菌Acinetobactersp．DNS32的产量,分别采用响应曲面法和基于人工神经网络的遗传算法对阿特拉津降解菌DNS32发酵培养基中3个重要基质成分（玉米粉、豆饼粉、K：HPO。）进行优化研究。响应曲面法确定3种成分的含量为玉米粉39．494g／L,豆饼粉25．638g／L和K。HPO。3．265g／L时,预测发酵活菌最大生物量为7．079×10^8CFU／mL,实测量为7．194×10^8CFU／mL;人工神经网络结合遗传算法优化确定3种主要成分含量为玉米粉为39．650g／L,豆饼粉为25．500g／L,K2HPO4为2．624g／L时,预测最大值为7．199×10^8CFU／mL,实测量为7．244×10。CFU／mL;最终确定培养基配方：玉米粉为39．650g／L,豆饼粉为25．500g／L,K2HPO4为2．624g／L,CaCO3为3．000g／L,MgSO4·7H2O和NaCl均为0．200g／L;优化后阿特拉津降解菌DNS32发酵生物量比优化前提高了36．6％。结果表明,在阿特拉津降解菌DNS32发酵培养基组分优化方面,响应面法和基于人工神经网络的遗传算法都是可行的,基于人工神经网络的遗传算法具有更好的拟合度和预测准确度。     

基于BP人工神经网络的城市PM2.5浓度空间预测

针对PM2.5日均质量浓度,采用BP人工神经网络模型,预测研究区空气中PM2.5浓度的空间变异,通过与普通克里格(Ordinary Kriging)插值方法对比验证BP人工神经网络预测模型的精度.结果表明:BP人工神经网络预测模型下研究区检验样本点位置的PM2.5仿真浓度与观测浓度之间的均方差、平均绝对误差、平均相对偏差和相关系数分别为0.296 μg2/m6、0.412 μg/m3、1.650％和0.851;而与此同时,普通克里格插值方法下的对应结果分别为1.041 μg2/m6、0.689 μg/m3、11.910％、0.638.研究成果在肯定BP人工神经网络预测模型可用于揭示PM2.5浓度空间变异特征的同时,也证实了其相对于普通克里格插值方法在固定空间点位准确预测PM2.5浓度方面的优势.     

诱导结晶工艺中诱品载体的选择与改性

以含铜废水为处理对象,重点考察了诱晶载体的表面性质及表面负荷对诱导结晶过程的影响。结果表明,在工艺启动初期,白云石以及碱式碳酸铜为诱晶载体时,铜的去除率在90％以上,石英砂对铜的去除率较低,但石英砂经表面改性后对铜的去除效率亦可达90％以上。在运行稳定后,几类诱导载体对铜的去除率皆能稳定在95％,说明诱晶载体的表面性质对诱导结晶工艺的影响主要在于反应启动初期,选择与目标结晶产物结构、成分相同或相似的诱晶载体有利于诱导结晶过程的进行。此外,研究结果还表明,诱晶载体表面负荷对结晶过程影响较大,诱导结晶除铜工艺中载体表面负荷不宜高于0．054gCu／（m2·d）。     

沿面放电氧化液相亚硫酸铵

为了解决湿式氨法烟气脱硫生成不稳定亚硫酸铵（（NH4）2SO3）副产物的问题,设计了以不锈钢弹簧和溶液分别作为高压和低压电极的沿面放电系统,对液相（NH4）2SO3的氧化进行了研究。空气从反应器上方进入后经放电区域形成活性物质,再由底部的曝气头鼓入溶液并与（NH4）2SO3发生反应。比较了沿面放电处理与传统曝气处理的氧化效率,考察了放电电压、载气气量和初始浓度等因素对（NH4）2SO3氧化的影响。结果表明,沿面放电对（NH4）2SO3有显著的氧化效果;优化条件下的（NH4）2SO3氧化率接近100%;溶液中（NH4）2SO4与（NH4）2SO3的浓度比小于1时有利于（NH4）2SO3的氧化。     

A-O工艺污泥疏水比率与污泥活性的关系

通过A-O工艺对印染废水的降解处理,研究了不同污泥活性下微生物疏水比率和COD去除率的变化规律.结果表明,污泥活性指标ATP浓度与微生物疏水性之间存在一定关系,并对COD去除率产生一定的影响.缺氧污泥的活性指标ATP浓度在0.38～0.77 mg/L范围时,污泥微生物的疏水性最好且疏水比率最高值为84％,COD的去除率最高,为70.01％;好氧污泥的活性指标ATP浓度在0.86～2.17 mg/L范围时,污泥微生物的疏水性最好,疏水比率最高值为75％,COD的去除率最高为96.2％.     

响应面法和神经网络优化Acinetobacter sp. DNS32发酵基质

为了提高阿特拉津降解菌Acinetobacter sp.DNS32的产量,分别采用响应曲面法和基于人工神经网络的遗传算法对阿特拉津降解菌DNS32发酵培养基中3个重要基质成分(玉米粉、豆饼粉、K2HPO4)进行优化研究。响应曲面法确定3种成分的含量为玉米粉39.494 g/L,豆饼粉25.638 g/L和K2HPO43.265 g/L时,预测发酵活菌最大生物量为7.079×108CFU/mL,实测量为7.194×108CFU/mL;人工神经网络结合遗传算法优化确定3种主要成分含量为玉米粉为39.650 g/L,豆饼粉为25.500 g/L,K2HPO4为2.624 g/L时,预测最大值为7.199×108CFU/mL,实测量为7.244×108CFU/mL;最终确定培养基配方:玉米粉为39.650 g/L,豆饼粉为25.500 g/L,K2HPO4为2.624 g/L,CaCO3为3.000 g/L,MgSO4.7H2O和NaCl均为0.200 g/L;优化后阿特拉津降解菌DNS32发酵生物量比优化前提高了36.6%。结果表明,在阿特拉津降解菌DNS32发酵培养基组分优化方面,响应面法和基于人工神经网络的遗传算法都是可行的,基于人工神经网络的遗传算法具有更好的拟合度和预测准确度。     

响应面法优化聚丙烯酸/腐殖酸/累托石吸附剂的制备条件

以累托石、丙烯酸及腐殖酸为原料制备出能同时吸附重金属和多环芳烃的吸附剂聚丙烯酸/腐殖酸/累托石,采用响应面试验设计法优化吸附剂的制备条件。利用Design Expert软件,建立了预测吸附剂对Cd2+、菲吸附量的二次回归模型,对回归模型进行了方差分析,并确定了吸附剂的最佳制备条件。结果表明,二次回归模型能较好地模拟Cd2+、菲的吸附量与影响因子丙烯酸中和度、引发剂量和交联剂量之间的关系。各因子对Cd2+吸附量的影响次序为:交联剂量>引发剂量>丙烯酸中和度;对菲吸附量的影响次序为引发剂量>交联剂量>丙烯酸中和度。吸附剂的最佳制备条件为:累托石、丙烯酸和腐殖酸三者的质量比为65∶30∶5,丙烯酸中和度、引发剂量和交联剂量分别为75.16%、2.57%和0.44%。在此优化条件下制备的吸附剂对Cd2+和菲的吸附量分别为170.19 mg/g和7.36 mg/g。     

一种新型活性半焦吸附剂的制备及其表面特征分析

对一种原料半焦进行粉碎、筛分,取其中10～20目的颗粒;用去离子水冲洗后高温下烘干至恒重;依次进行HNO3活化、KOH活化和加压水热化学活化,制备出活性半焦吸附剂。经实验证明,该活性半焦吸附剂对甲苯的吸附等温线符合Langmuir模型,其甲苯吸附容量可达207 mg/g,穿透时间由80 min延长至235 min。该活性半焦吸附剂的比表面积为555.56 m2/g,碘值为811.38 mg/g,表面酸碱总量为0.8649 mmol/g,并通过SEM扫描进行了表面微观形态分析。数据表明,经改性后制备出的新型活性半焦对甲苯的去除率明显增加,其表面物化性质也有明显改变,是一种优良的有机废气吸附剂。