Uncertainty Models for Estimates of Physical Characteristics of River Segments Over Large Areas

Spatially comprehensive estimates of the physical characteristics of river segments over large areas are required in many large‐scale analyses of river systems and for the management of multiple basins. Remote sensing and modeling are often used to estimate river characteristics over large areas, but the uncertainties associated with these estimates and their dependence on the physical characteristics of the segments and their catchments are seldom quantified. Using test data with varying degrees of independence, we derived analytical models of the uncertainty associated with estimates of upstream catchment area (CA), segment slope, and mean annual discharge for all river segments of a digital representation of the hydrographic network of France. Although there were strong relationships between our test data and estimates at the scale of France, there were also large relative local uncertainties, which varied with the physical characteristics of the segments and their catchments. Discharge and CA were relatively uncertain where discharge was low and catchments were small. Discharge uncertainty also increased in catchments with large rainfall events and low minimum temperature. The uncertainty of segment slope was strongly related to segment length. Our uncertainty models were consistent across large regions of France, suggesting some degree of generality. Their analytical formulation should facilitate their use in large‐scale ecological studies and simulation models.     

多层频率选择表面复合吸波结构的研究

文中采用一种快速求解方法——半解析半数值法计算多层频率选择表面(Frequency Selective Surface,简称FSS)复合结构的反射系数,然后结合具体两层复合结构的实例通过测试验证了半解析半数值法的正确性,并基于复合结构吸波材料吸波频带窄的缺点,在此基础上,设计出一种新的圆形FSS复合结构吸波材料。计算和测试结果都表明,这种新的复合结构在较宽带宽内具有低反射系数。     

捕集阱顶空-气相色谱/质谱法检测地表水中25种挥发性有机物

建立了捕集阱顶空-气相色谱/质谱法检测地表水中25种挥发性有机物的分析方法。采用正交实验设计对捕集阱顶空条件进行了优化,该方法相关系数0.995,加标回收率为90%~110%,方法检出限为0.08~0.39μg/L,相对标准偏差(n=7)为0.7%~4.8%,仪器检出限低于0.04μg/L。方法准确度和灵敏度较好,可以满足对地表水中25种挥发性有机物的检测要求。     

汶川地震映秀镇地质条件与地表破裂特征调查

2008年5月12日14时28分04秒,四川省汶川县发生了MS 8.0地震.根据地震部门测定,本次地震是从映秀开始破裂,震中位于四川汶川县映秀镇附近(北纬31.015°,东经103.365°).在中国地震局组织的汶川地震科学考察成果基础上,本文分析了映秀地质条件:主要发育的地层为二叠系的石英闪长岩,震旦系的砂岩;通过研究区的主要构造为龙门山中央断裂-映秀-北川断裂;主要的地貌类型为河流地貌.调查了研究区的地表破裂特征,根据研究区的地貌类型将其划分为A、B、C三段,A段为河床沉积地貌,垂直断距最大;B段为丘陵地貌,断距中等,但诱发崩塌地质灾害;C段为河流边滩地貌,断距较小,但震害严重.     

Interactions Among the Copper Species and Forms in Sea Water/Sediments and Copper Bioaccumulation in Oysters

Abstract

Earlier papers indicated that the first incident of green discoloration in oysters (Crassostrea gigas) and the mass mortality observed in 1986 along the Taiwan Erhjin Chi coastal area were caused by the higher contents of total copper and copper species (mainly bioavailable and free ion) in sea water. the copper in sea water would be sorbed by suspended matter and transferred to sediments, and the copper in the sediments would also be desorbed to sea water. Processes of copper adsorption and desorption are the major factors influencing the contents of total copper and copper species in sea water and sediments. in this study, the Erhjin Chi sediments were mixed with sea water by a shaker technique. When the mixture was shaken for one hour, analogous to tidal mixing in estuaries, only copper desorption from sediments was observed. If the shaking time is increased for more than 3 hours, the copper released from the sediments was resorbed to the remaining solid phases. the higher the contents of mud (91.71%) and total copper (701 mg kg^?1) in sediments, the higher the copper desorption rate (1.86 ppm hr^?1) and copper adsorption rate (0.50 ppm hr^?1) were observed. in sediments containing lower mud (0.80%) and lower copper (43.5 mg kg^?1), the copper desorption and adsorption rates were 0.83 ppm hr^?1 and 0.22 ppm hr^?1, respectively. the interactions among the total copper and copper species in sea water and sediments, chemical and ecological parameters, and copper bioaccumulation in oysters in the Erhjin Chi estuarine and coastal area are also discussed.     

萘降解菌MQ合成靛蓝的研究

利用萘降解菌(丛毛单胞菌)MQ完整细胞对吲哚进行转化合成靛蓝,结果表明菌株MQ具有较好的靛蓝合成能力,靛蓝产量在4h左右即达到稳定.薄层色谱和高效液相色谱分析结果表明,合成的蓝色产物为靛蓝.考察了反应温度及摇床转速对靛蓝合成的影响,结果表明最适温度和转速分别为25℃和150r·min-1.随后,采用表面响应法确定了菌株MQ合成靛蓝的最优条件:菌株接种量OD6602.16,吲哚浓度200.55mg·L-1,pH=6.91.在最优条件下,菌株MQ合成靛蓝的产量为53.05mg·L-1,比初始条件下的产量提高了179%.     

基于响应曲面法袋式除尘器清灰性能的数值研究

利用计算流体动力学（CFD）方法,采用二维、可压缩、非稳态流动数学模型,对袋式除尘器脉冲喷吹过程中滤袋内的清灰流场进行了数值模拟,比较了滤袋壁面压力峰值的模拟值和试验值.同时,利用该模型,基于响应曲面法并使用统计软件MinitabV15研究了喷嘴直径、喷吹高度、文丘里管喉管直径、文丘里管及布袋长度对袋式除尘器清灰性能的影响,并得出了这5个影响因子的二次多项式预测模型.结果表明,滤袋表面压力峰值的模拟值与试验值变化趋势基本上是一致的,误差在10%左右,从而验证了本文数值计算模型的可靠性.在上述5个影响因素中,喷嘴直径（d）、文丘里管喉管直径（de）及布袋长度（L）对清灰性能影响显著,其中,清灰性能随着喷嘴直径和文丘里管喉管直径的增大而提高,随着布袋长度的增大先提高后降低.在本文所研究的尺寸范围内,当d=20mm、de=60mm及L=3360mm时,清灰效果分别达到最优.所得结论有助于进一步改善袋式除尘器的清灰性能.     

基于地表水源热泵尾水排放的江河热环境容量研究

运用FLUENT软件对重庆市洪崖洞水源热泵系统尾水排入受纳水域的过程进行二维数值模拟,选取FLUENT中非耦合、隐式求解器对模型内的定常流动进行求解,得出受纳水域受水源热泵系统温排水影响后的温度梯度和温升面积。在温排水流量为4 500 m3/h、温差为6℃的条件下,得出受纳水域温升值超过1℃的水域面积约为1 600 m2,为模拟江河水域面积的2.0%。选取1℃温升值作为温升带边界控制值,在热泵系统最大负荷工况下,计算得出受纳水域的热环境容量为312.5(m.3℃)/s,剩余热环境容量为306.25(m.3℃)/s。根据地表水环境质量标准,该工程温排水量小于受纳水域的热承载力,不会对受纳水域生态环境造成热污染。     

响应曲面法优化物理活化制备羊骨基活性炭工艺

为通过物理活化法制备羊骨活性炭,采用响应曲面(Response surface methodology,RSM)实验设计,以活化温度、活化时间、CO2流量为试验因素,以碘吸附值为响应值,建立数学模型,工艺条件进行优化。结果表明:最佳工艺条件为活化温度476.05℃、活化时间9.34 min、CO2流量159.4 mL/min,在此条件下碘吸附值为411 mg/g;通过对碘吸附值曲面方程和二次多项回归方程解逆矩阵得知该方程的预测值与实际值之间具有较好的拟合度。     

硫酸盐还原颗粒污泥对Cr的吸附机理解析

以硫酸盐还原颗粒污泥作为研究对象,进行Cr的吸附容量研究及吸附等温线拟合,测定颗粒污泥中的硫化物含量、对比实验前后颗粒污泥的表面形态和微生物组成并采用傅里叶红外变换光谱(FTIR)分析颗粒污泥的表面基团。结果表明,颗粒污泥对Cr的吸附容量为6.84 mg/g,吸附过程可用Langmuir吸附等温式描述。颗粒污泥中硫化物含量达9.868 mg/g(湿重),对应每克颗粒污泥对Cr的最大吸附量可达10.69 mg;颗粒污泥表面生长大量的微生物,以杆菌为主,颗粒污泥表面丰富的微孔结构及微生物所分泌的胞外物均可有效吸附溶液中的Cr;FTIR分析结果显示,颗粒污泥中包含大量C=O、C-N及-S等基团,这些基团均可通过与C(rⅥ)或C(rⅢ)之间的静电吸附作用吸附溶液中的Cr。研究表明化学与生物吸附作用在硫酸盐还原颗粒污泥吸附溶液中的Cr过程中起到了重要的作用。