SCR脱硝系统烟道内流场优化

为了改善选择性催化还原法(SCR)催化剂上游烟气的流场、温度场和浓度场分布,基于CFD仿真分析技术,建立了整个脱硝系统三维模型,并通过优化导流板及整流格栅,使得速度标准偏差、浓度标准偏差、温度偏差、速度偏转角以及压降等性能指标都满足设计要求,在满足脱硝效率和氨逃逸率前提下,大大降低了烟气对催化剂层的冲刷,保证催化剂的使用寿命。最后,为了合理布置吹灰器,对优化结构下粉尘颗粒在烟道内的运动情况进行了仿真分析研究,为设计提供了依据。     

CS/PEG/PFT膜制备及对含铜废水的处理

实验将溶胶凝胶法和高分子辅助倒相法结合,制备出一种新型的壳聚糖/聚乙二醇/亚铁氰化钾钛(CS/PEG/PFT)复合膜,通过FT-IR和SEM对膜进行表征后,将其用于模拟铜废水的吸附和脱附实验,并探究出膜吸附的最佳工艺条件为:pH 5.50、实验温度55℃、实验时间2 h,该条件下,膜对铜离子最大吸附量为9.85 mg/g,去除率达到95%以上。CS/PEG/PFT膜的除铜过程符合Langmuir等温吸附方程(y=0.0597x+0.0168),线性相关度达到0.9917。     

电弧流溶胞技术促进污泥厌氧消化

为提高污水厂处理污泥时的厌氧消化速率,利用电弧流溶胞技术处理剩余污泥,研究电弧流溶胞技术对污泥破解预处理效果的影响.实验结果表明,与未经预处理的污泥相比,电弧流溶胞处理能够明显提高污泥厌氧消化效率,增加有机物含量和沼气产量.其中,经处理后的污泥TS、VS剩余量分别降低了8.3%和6.3%,COD增加了11.9%.厌氧系统平均产气量平均增加79.76 L/d,增加率45.82%,甲烷含量增加1.03 L/d,增加率102%.由此说明,电弧流溶胞技术可以提高厌氧消化反应中有机物的去除率,有效促进厌氧消化中污泥的水解过程,显著增加甲烷气体的产生量.在综合考虑运行费用和污泥消化效果的前提下,采取适宜的电弧流强化处理措施有一定的积极意义.     

密相塔半干法烟气脱硫塔内加湿降温及其对脱硫效率的影响

为了实现密相塔半干法脱硫工艺的精确加湿进一步提高系统脱硫效率,利用推导出的传热传质计算方法,得到烟气温度降低和加水量的关系.结合3组密相塔半干法工程实际数据,发现理论计算值和实测值误差区间仅为2.9%~5.4%.通过选取河北某钢厂210 m2烧结烟气密相塔半干法脱硫项目实际在线检测数据,发现循环脱硫灰含湿量为3%的系统脱硫效率整体高于含湿量为5%和4%的样品,最大值达93.56%.通过粒度分析、扫描电镜、X射线衍射及差热-热重对2种不同含湿量的循环脱硫灰进行表征,结果表明,含湿量为3%的循环脱硫灰较含湿量为5%的样品粒径小、比表面积大,无团聚现象,物相分析还证实相对于含湿量为5%样品,其Ca(OH)2和结晶水含量少,几乎都是CaSO4和CaSO3干态物质,因此脱硫反应进行彻底,脱硫效率较高.     

Thermodynamic investigation and hydrate inhibition of real gas flow through orifice during depressurization

A thermodynamic procedure has been proposed which can be used to predict the gas pressure, temperature and flow rate through orifice upon chock flow condition, using equation of state (EOS). The procedure applied for emergency depressurization operation incorporating the Peng-Robinson EOS and validated by comparing flow rates of a multi-component hydrocarbon gas mixture for thirteen experimental cases. The average absolute deviations of the predicted flow rates for orifice discharge coefficients of 0.85 and 0.9, are 7.36% and 2.03%, respectively. The corresponding error for API 520 (American Petroleum Institute Recommendation Practice 520) method is 6.91%. In this work, the hydrate formation temperature and hydrate inhibitor type and its required weight fraction for preventing the hydrate formation upon orifice and its upstream conditions are evaluated by the EZ-Thermo software using the Moshfeghian–Maddox method. The results qualitatively show that the hydrate prevention is essential for the safety of the operation due to low temperature condition.     

芦苇碳源-表面流人工湿地对农田退水脱氮的长期效能研究

针对农田退水NO₃^--N占比高、C/N低,氮污染难以去除的问题,将经济易得的芦苇(Phragmites australis)茎叶碎段装填在表面流人工湿地(packed surface flow construct wetland,PSFW)的表层作为外加碳源,以研究其长期运行情况下的脱氮效能。结果表明：第29~149天,外加芦苇茎叶碎段的PSFW的脱氮效能明显高于无芦苇茎叶碎段的空白PSFW₀;进水NO₃^--N和TN浓度分别为(16.4±1.0)和(17.7±2.0)mg/L,HRT按3、4和2 d运行时,HRT为4 d时脱氮效能最优,PSFW对NO₃^--N和TN去除率分别为(87.4±6.0)%和(74.1±6.0)%,PSFW₀去除率仅为(14.4±4.0)%和(14.4±3.0)%;第150~269天,PSFW的脱氮效能稍高于PSFW₀,在进水NO₃^--N和TN浓度分别为(10.4±1.0)和(10.8±1.0)mg/L,HRT按3、2和1 d运行时,HRT为3 d时脱氮效能最优,PSFW对NO₃^--N和TN的去除率分别为(91.9±7.0)%和(90.2±7.0)%,PSFW₀去除率分别为(91.3±5.0)%和(86.4±6.0)%。第270~334天,PSFW的脱氮效能稍低于PSFW₀;进水NO₃^--N和TN浓度分别为(5.7±0.4)和(7.2±0.8)mg/L,HRT为3 d时,PSFW对NO₃^--N和TN的去除率分别为(88.6±10.0)%和(82.5±7.0)%,PSFW₀去除率分别为(94.0±6.0)%和(87.8±3.0)%。     

采场通风方式与瓦斯运移规律研究

采场是煤矿生产的核心地带,而采场通风系统是确保采场作业安全,创造良好生产环境的重要环节。本文以采场风流流动及瓦斯运移理论为基础,通过现场试验、模型模拟试验及计算机模拟研究等方法,着重研究了中国常用的和有发展前途的走向长壁后退式U型通风方式、U+L型通曲方式、后退式Y型通风方式条件下采场风流流动及瓦斯运移规律。     

双氰胺-甲醛聚合物-聚合氯化铝复合絮凝剂的合成及应用

以双氰胺、甲醛、氯化铝为主要原料,加入添加剂合成了双氰胺-甲醛聚合物（DF）-聚合氯化铝（PAC）复合絮凝剂。采用模拟印染废水考察了各种因素对DF—PAC复合絮凝剂混凝脱色性能的影响。实验结果表明,在双氰胺、甲醛、氯化铝、添加剂加入量分别为29．1,57．8,4．8,12．5g,反应温度（70±1）℃、反应时间2．5h的条件下制得的DF—PAC复合絮凝剂的絮凝脱色性能良好,COD去除率不小于90％,色度去除率不小于99％。与PAC和DF絮凝剂相比,DF—PAC复合絮凝剂对实际印染废水的絮凝脱色效果更好。     

Modeling Parent and Metabolite Fate and Transport in Subsurface Drained Fields With Directly Connected Macropores1

Abstract: Few studies exist that evaluate or apply pesticide transport models based on measured parent and metabolite concentrations in fields with subsurface drainage. Furthermore, recent research suggests pesticide transport through exceedingly efficient direct connections, which occur when macropores are hydrologically connected to subsurface drains, but this connectivity has been simulated at only one field site in Allen County, Indiana. This research evaluates the Root Zone Water Quality Model (RZWQM) in simulating the transport of a parent compound and its metabolite at two subsurface drained field sites. Previous research used one of the field sites to test the original modification of the RZWQM to simulate directly connected macropores for bromide and the parent compound, but not for the metabolite. This research will evaluate RZWQM for parent/metabolite transformation and transport at this first field site, along with evaluating the model at an additional field site to evaluate whether the parameters for direct connectivity are transferable and whether model performance is consistent for the two field sites with unique soil, hydrologic, and environmental conditions. Isoxaflutole, the active ingredient in BALANCE^® herbicide, was applied to both fields. Isoxaflutole rapidly degrades into a metabolite (RPA 202248). This research used calibrated RZWQM models for each field based on observed subsurface drain flow and/or edge of field conservative tracer concentrations in subsurface flow. The calibrated models for both field sites required a portion (approximately 2% but this fraction may require calibration) of the available water and chemical in macropore flow to be routed directly into the subsurface drains to simulate peak concentrations in edge of field subsurface drain flow shortly after chemical applications. Confirming the results from the first field site, the existing modification for directly connected macropores continually failed to predict pesticide concentrations on the recession limbs of drainage hydrographs, suggesting that the current strategy only partially accounts for direct connectivity. Thirty‐year distributions of annual mass (drainage) loss of parent and metabolite in terms of percent of isoxaflutole applied suggested annual simulated percent losses of parent and metabolite (3.04 and 1.31%) no greater in drainage than losses in runoff on nondrained fields as reported in the literature.     

夹点技术--一种有效的清洁生产方法

夹点技术作为一种有效的清洁生产措施可用于能源优化、资源节约、废物减量及污染防治等方面，能收到良好的经济效益和环境效益。本文介绍夹点技术的基本原理、应用研究领域及其发展趋势。