填埋场中亚硝酸还原酶测定条件的优化

填埋垃圾中的含氮化合物经一系列生物脱氮作用,最终使得填埋场中的氮素得以消减,在这一过程中亚硝酸还原酶起着十分重要的作用。以填埋场中的填埋垃圾为研究对象,在土壤亚硝酸还原酶测定方法的基础上,对亚硝酸还原酶活性测定条件进行了优化。结果表明,填埋垃圾中的亚硝酸还原酶活性测定的最优条件为:垃圾样品风干温度25℃,2mL的1%NaNO2溶液和2.5 mL的1%葡萄糖溶液,抽气5 min,置于25℃的培养箱中培养24 h。优化后的测定条件相对标准偏差(RSD)小于1.27%,表明该方法具有较高的灵敏度和精密度。     

人工浮床对汾江河水质净化的研究

对佛山市汾江河内布置浮床的水域的7个断面进行采样监测,分析了布置浮床侧与未布置浮床侧各水质指标的差异,以考察人工浮床对汾江河水质的净化效果。同时比较了圆币草、水罂粟、梭鱼草、狐尾草、美人蕉和鸢尾6种浮床植物的生物量和氮磷吸收量。结果表明,布置人工浮床一侧的水质TN、TP、COD和NH4＋-N含量均显著低于未布置浮床一侧的水质,表明人工浮床对水体水质的有净化效果。总面积约4 900 m2的浮床植物经过3个月的生长,从水体中共吸收了192.5 kg的氮和76.1 kg的磷。6种浮床植物中,狐尾草的净增生物量最高,达到64.2 kg/m2;圆币草次之,为62.2 kg/m2。狐尾草和圆币草对氮磷的吸收能力在6种植物中处于较高水平,每平方米狐尾草和圆币草从水体中分别吸收了51.61g氮、19.79 g磷和46.90 g氮、22.93 g磷。综合比较得出,狐尾草和圆币草在生物量和氮磷吸收量上均保持在较高水平,是较好的浮床植物。本研究为人工浮床在南方类似河流中的应用及植物选择提供了参考依据。     

含锰废渣的氧化-活化再生回用工艺

为实现紫苏醛生产过程中二氧化锰（氧化剂）的循环利用,采用一种新型的氧化-活化工艺再生得到活性二氧化锰,即以紫苏醇合成紫苏醛过程中产生的含锰废渣为原料,首先采用氯酸钠氧化含锰废渣得到初级二氧化锰,然后使用高锰酸钾对初级二氧化锰进一步活化得到活性二氧化锰。实验表明,制取初级二氧化锰的最佳工艺条件为：反应时间为4h,反应温度为90～95℃,硫酸摩尔浓度为1.5 mol/L,氯酸钠加量为理论量的130%。制取活性二氧化锰的合适条件为：反应温度在60℃时,反应时间为1.5 h;反应温度在50℃时,反应时间为2.5 h。采用氧化-活化法再生的活性二氧化锰氧化紫苏醇,紫苏醛的产率可达52.8%,与使用电解二氧化锰氧化得到的紫苏醛的产率53.1%相当,而使用初级二氧化锰,紫苏醛的产率仅为14.9%。     

Long-range atmospheric transport of three toxaphene congeners across Europe. Modeling by chained single-box FATEMOD program

Background, aims, and scope  Since toxaphene (polychlorocamphene, polychloropinene, or strobane) mixtures were applied for massive insecticide use in the 1960s to replace the use of DDT, some of their congeners have been found at high latitudes far away from the usage areas. Especially polychlorinated bornanes have demonstrated dominating congeners transported by air up to the Arctic areas. Environmental fate modeling has been applied to monitor this phenomenon using parallel zones of atmosphere around the globe as interconnected environments. These zones, shown in many meteorological maps, however, may not be the best way to configure atmospheric transport in air trajectories. The latter could also be covered by connecting a chain of simple model boxes. We aim to study this alternative approach by modeling the trajectory chain using catchment boxes of our FATEMOD model. Polychlorobornanes analyzed in biota of the Barents Sea offered one case to study this modeling alternative, while toxaphene has been and partly still is used massively at southern East Europe and around rivers flowing to the Aral Sea. Materials and methods  Pure model substances of three polychlorobornanes (toxaphene congeners P26, P50, and P62) were synthesized, their environmentally important thermal properties measured by differential scanning calorimetry, as evaluated from literature data, and their temperature dependences estimated by the QSPR programs VPLEST, WATSOLU, and TDLKOW. The evaluated property parameters were used to model their atmospheric long-range transport from toxaphene heavy usage areas in Ukraine and Aral/SyrDarja/AmuDarja region areas, through East Europe and Northern Norway (Finnmarken) to the Barents Sea. The time period used for the emission model was June 1997. Usual weather conditions in June were applied in the model, which was constructed by chaining FATEMOD model boxes of the catchment’s areas along assumed maximal air flow trajectories. Analysis of the three chlorobornanes in toxaphene mixtures function as a basis for the estimates of emission levels caused by its usage. High estimate (A) was taken from contents in a Western product chlorocamphene and low estimate (B) from mean contents in Russian polychloroterpene products to achieve modeled water concentrations. Bioaccumulation to analyzed lipid of aquatic biota at the target region was estimated by using statistical calculation for persistent organic pollutants in literature. Results  The results from model runs A and B (high and low emission estimate) for levels in sea biota were compared to analysis results of samples taken in August 1997 at Barents Sea. The model results (ng g⁻¹ lw): 4–95 in lipid of planktovores and 7–150 in lipid of piscivores, were in fair agreement with the analysis results from August 1997: 21–31 in Themisto libellula (chatka), 26–42 in Boreocadus saida (Polar cod), and 5–27 in Gadus morhua (cod) liver. Discussion  The modeling results indicate that the application of chained simple multimedia catchment boxes on predicted trajectory is a useful method for estimation of volatile airborne persistent chemical exposures to biota in remote areas. For hazard assessment of these pollutants, their properties, especially temperature dependences, must be estimated by a reasonable accuracy. That can be achieved by using measurements in laboratory with pure model compounds and estimation of properties by thermodynamic QSPR methods. The property parameters can be validated by comparing their values at an environmental temperature range with measured or QSPR-estimated values derived by independent methods. The chained box method used for long-range air transport modeling can be more suitable than global parallel zones modeling used earlier, provided that the main airflow trajectories and properties of transported pollutants are predictable enough. Conclusions  Long-range air transport modeling of persistent, especially photo-resistant organic compounds using a chain of joint simple boxes of catchment’s environments is a feasible method to predict concentrations of pollutants at the target area. This is justified from model results compared with analytical measurements in Barents Sea biota in August 1997: three of six modeled values were high and the other three low compared to the analysis results. The order of magnitude level was similar in both modeled (planktovore and piscivore) and observed (chatka and polar cod) values of lipid samples. The obtained results were too limited to firm validation but are sufficient to justify feasibility of the method, which prompts one to perform more studies on this modeling system. Recommendations and perspectives  For assessment of the risk of environmental damages, chemical fate determination is an essential tool for chemical control, e.g., for EU following the REACH rules. The present conclusion of applicability of the chained single-box multimedia modeling can be validated by further studies using analyses of emissions and target biota in various other cases. To achieve useful results, fate models built with databases having automatic steps for most calculations and outputs accessible to all chemical control professionals are essential. Our FATEMOD program catchments at environments and compound properties listed in the database represent a feasible tool for local, regional, and, according our present test results, for global exposure predictions. As an extended use of model, emission estimates can be achieved by reversed modeling from analysis results of samples corresponding to the target area. This article is dedicated to the memory of Professor Alexander B Terentiev (who passed away in November 2006), our true friend. With his Institute of Organo-Element Compounds, Russian Academy of Science, Moscow, he was an important main organizer of the six joint Finnish–Russian seminars (every third year since 1989) on the field (‘Chemistry and Ecology of Organo-Element Compounds’). He prompted us especially to search properties and environmental fates for various polyhalogen compounds. We remember him for his friendly character and great sense of humor.     

Application of biomarkers to assess the condition of European Marine Sites

A series of European Marine Sites has been designated as Special Areas of Conservation (SAC) in England. The aim of this study was to develop a practical methodology to assess the condition of SACs by applying a suite of biomarkers. Biomarkers were applied to the blue mussel Mytilus edulis and the shore crab Carcinus maenas from the Fal and Helford SAC (Cornwall). Individual biomarkers provided useful diagnostic information on the activity of certain classes of contaminants and an integrated Biomarker Response Index (BRI) was used to achieve a more holistic understanding of the condition of the SAC. The BRI indicated that the general health of both organisms was impacted in the upper part of the SAC (Fal Estuary) which correlated well with known chemical hotspots and sources of contamination. The BRI allows a pragmatic way to prioritise SAC sites that may require further investigative studies.     

盐河淮阴段氨氮污染变化分析

在分析盐河淮阴段氨氮污染的特征后，对氨氮的来源进行了研究。结果表明，畜牧业和农业面源都是比较显著的氨氮污染源，但未经集中式污水处理厂处理的生活污水，则成为盐河淮阴段最重要的氨氮污染源。     

总氮测定中的注意事项

碱性过硫酸钾消解紫外分光光度法测定总氮中，对空白值偏高的影响因素进行了实验和分析，提出了几点建议及改进措施。     

区域污染物总量控制绩效评估技术及动态化管理建议与对策研究（二）

首次指出了物元分析隶属函数及运算模型在区域污染物总量控制动态化管理中的应用.研究成果是对扬州市的10年污染物总量控制系统性、宏观性的展开,丰富了区域污染物总量控制的理论体系,且进一步表明：该成果不仅为污染物总量控制进行动态化、规范化管理提供了科学的技术支撑,也为促进区域经济结构调整和增长方式的转变,实施循环经济的决策提供了保障.     

高分子量高纯度阳离子聚丙烯酰胺的合成

以丙烯酰胺与丙烯酰氧乙基三甲基氯化铵为单体,在复合引发剂的作用下,选择水溶液共聚法合成高分子量与高纯度阳离子型聚丙烯酰胺(CPAM)。实验表明,有机偶氮引发剂A用量0.5‰、氧化还原引发剂用量0.45‰、还原剂与氧化剂摩尔比2∶1、反应体系pH为4与反应时间5 h条件下,CPAM分子量为1 042万,且溶解性好。通过对聚合物残单含量影响因素添加剂用量、反应时间的研究,结果表明,添加剂EDTA和增溶剂D对残留AM含量影响小,而苯甲酸钠对聚合物残留AM的含量影响显著;延长反应时间至7 h,残单含量可降低至0.27%,CPAM的纯度高。通过与国内外3种同类型产品进行对比,结果表明,自制产品的分子量明显高于其他产品,且残单含量比国内产品降低了50%～75%。     

MBR在橡胶废水处理中的应用

橡胶废水具有含盐量高、色度高、有机污染成分含量高且难于生化降解等特点。膜生物反应器(MBR)技术的核心是生化处理加微滤膜过滤,通过将MBR技术应用于橡胶废水处理的实践表明,该技术对COD、氨氮、磷酸盐的平均去除率都达到了85%以上,再辅之以药剂处理后,降低了色度和难降解有机物含量,出水水质完全符合排放标准的要求,是一种解决橡胶污水处理难题的有效途径。