纺织废水臭味产生的原因和机理探讨

针对高硫酸盐、高色度纺织废水处理站恶臭气体所造成的环境污染,及对职工和居民的健康造成损害等一系列问题,进行了实验研究,分析了高硫酸盐、高色度纺织废水恶臭气体形成的原因和机理.     

偶氮类染料脱色率的定量构效关系

偶氮类染料的生产和使用过程中存在着三废多、难脱色和污染严重等问题,该染料是印染工业的主要污染物。选取偶氮类染料的分子结构参数和其光催化氧化脱色率之间建立定量结构活性关系(QSAR),进而得到回归方程,为印染废水处理和染料环境行为评价提供理论预测。结果表明,偶氮类染料的光催化氧化脱色率与其结构之间存在着线性相关性,线性方程为:D=0.647μ+66.277,(D为脱色率、μ为偶极矩)R=0.989方程具有预测能力。     

A study on genotoxicity of textile dyeing industry effluents from Rajshahi,Bangladesh, by the Allium cepa test

Textile dye effluents are believed to be toxic as they might exert various harmful effects on living organisms including genotoxicity. These effluents are the main source of direct and continuous input of pollutants into the aquatic ecosystems. In this study, dye effluents from a local silk dyeing industry were analysed for their genotoxic potential by the Allium cepa genotoxicity test. The A. cepa test is characterised as a genotoxicity test where the roots of A. cepa are grown in different concentrations of the test material. The macroscopic results clearly showed that the toxicity of the dye effluents prompted A. cepa root growth inhibition, and this effect increased with higher concentrations of the effluents. At the cellular level, no dividing cells were found at higher concentrations such as 60%, 80% and 100% of the effluents. However, at a lower concentration of 20%, dividing cells were identified, although the mitotic index was much lower than that of the control. Microscopic analysis showed that the dye effluents induced chromosomal aberrations at significant levels. Taken together, these results revealed that the textile dyeing industry effluents are toxic to eukaryotic cells and these dyes have genotoxic properties that can potentially lead to cancer development and adverse health conditions.     

灵芝漆酶对直接蓝86的催化脱色性能

利用灵芝菌Ganoderma lucidum U-281漆酶对直接蓝86进行酶促氧化脱色,并对其降解机理进行了探讨。结果表明,染料-漆酶共反应体系在20～50℃及pH小于5.0范围内,直接蓝86均可脱色50%以上;漆酶对直接蓝86具有宽泛的浓度适应性,对300 mg/L的该染料仍具有耐受性。最优脱色工艺参数为温度40℃、pH 5.0、染料初始浓度200 mg/L、漆酶用量1 U/mL。在优化条件下,直接蓝863 h的脱色率达到54.54%,48 h脱色率达到91.54%。紫外-可见吸收光谱分析表明,漆酶的酶促氧化导致染料的分子结构产生了变化,是造成直接蓝86脱色的主要发生机制。     

厌氧滤池处理纺织印染废水的中试研究

对厌氧滤池反应器处理难降解印染废水进行中试研究。结果表明,厌氧滤池反应器水力停留时间(HRT)在8.1～14.6 h之间,进水COD浓度波动较大(500～1 000 mg/L)时,对COD平均去除率为20%。印染废水的BOD5/COD由0.23提高到0.35,废水可生化性明显改善。印染废水中硫酸根浓度略有下降,去除浓度为70 mg/L左右。厌氧滤池进出水颜色明显变化,由紫红色变为蓝黑色,紫外可见光谱分析表明废水中的有机物结构发生变化。     

活性艳橙K-7R分子印迹聚合物微球的制备及结合特性研究

以微米级聚苯乙烯微球为种球,活性艳橙K-7R为模板分子,甲基丙烯酸为功能单体,乙二醇二甲基丙烯酸酯为交联剂,采用单步溶胀聚合法在水相中制得了分子印迹聚合物微球(MIPs),并用平衡吸附实验研究了其吸附性能。通过Scatchard分析,结果表明,MIPs在识别K-7R过程中存在两类结合位点,高亲和力结合位点的平衡离解常数Kd1=14.855μmol/L,最大结合量Qmax1=1.282μmol/g;低亲和力结合位点的平衡离解常数Kd2=70.939μmol/L,最大结合量Qmax2=3.930μmol/g。该MIPs对K-7R有较高的亲和性和选择性。     

铁盐和铝盐混凝对印染废水生化出水中溶解性有机污染物的去除特性

以三氯化铁和硫酸铝为混凝剂,印染废水二级生化出水为研究对象,并利用XAD-8/XAD-4吸附树脂联用技术将印染废水生化出水中溶解性有机物分为疏水酸、非酸疏水物质、弱疏水物质及亲水物质4类有机物,通过小试实验探讨了2种混凝剂对生化出水中各类溶解性有机物的去除效果及特点。实验结果表明,对于该印染废水的生化出水,溶解性有机物的主要成分是疏水性物质,以DOC表征时占总DOC的75%,其中疏水酸约占41%,疏水性物质也是引起色度的主要物质,所占比例以ADMI7.6表征时为89%,其中以非酸疏水物质的贡献最大,达到52%,并且非酸疏水物质中不饱和双键或芳香环有机物的含量较高。在三氯化铁和硫酸铝各自最佳的混凝条件下,均能够有效去除由疏水性物质（疏水酸和非酸疏水物质）引起的色度,但三氯化铁对弱疏水性物质以及亲水物质的去除率高于硫酸铝,这使得三氯化铁对印染废水生化出水中的溶解性有机物的去除效果优于硫酸铝。并且三氯化铁和硫酸铝混凝工艺均能明显降低生化出水的毒性。     

七种染料对鲤鱼肝微粒体芳烃羟化酶的诱导

以鲤鱼肝微粒体为实验体系,研究了七种染料化合物对其芳烃羟化酶（AHH）的诱导,发现七种染料都可诱导AHH的活性,随染料浓度增大AHH的活性升高。七种染料对AHH活性诱导能力大小为：酸性红B＞派拉丁蓝RRN＞普拉红B＞活性艳红K－2BP＞活性艳红K－2G,媒介大红S－80＞分散红E－4B,与其毒性大小相关。     

二氧化氯对有机染料脱色效果的研究

本文对二氧化氯二两种直接染料和两种活性染料脱色效果的影响因素－ClO2的投加量、染料的初始浓度、pH值、温度以及反应时间等进行了研究。结果表明,在适当的条件下,二氧化氯对这几种有机染料均具有很好的脱色效果。     

Ionic dye adsorption by zinc oxide nanoparticles

The adsorption behaviour of Basic Red 12, Acid Orange 7 and Acid Blue 1 on zinc oxide nanoparticles (ZNP) has been investigated to understand the physicochemical process involved and to explore the possible use of nanoparticles in the treatment and management of textile waste matter. The dye removal capacity of ZNP towards Basic Red 12, Acid Orange 7 and Acid Blue 1 was found to be 15.64, 6.78 and 6.38 mg g^?1, respectively. The adsorption process was pH dependent and optimum pH values of 9.0, 2.0 and 4.0 were obtained for Basic Red 12, Acid Orange 7 and Acid Blue 1, respectively. Equilibrium was established after 1.0 h for all dyes. Langmuir, Freundlich and Temkin isotherm models were applied to the system. The adsorbent ZNP was characterised using scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffraction (XRD), Brunauer–Emmett–Teller (BET) and Fourier transform infrared (FTIR) techniques. SEM analysis revealed the noticeable nanoporous morphology of the material. The results of FTIR spectroscopy showed that the process is driven by an electrostatic complexation mechanism. XRD studies revealed the nanocrystalline structure of ZNP. BET surface area measurement suggested a high pore volume and large surface area for the adsorbent. The kinetic measurements suggested pseudo-second-order kinetic processes with high regression coefficients and smaller standard error of estimate values and lower residual sum of squares. The thermodynamic measurements suggested that all processes were exothermic and accompanied by negative values for Δ G⁰, Δ S⁰ and Δ H⁰.