侧向风速作用下聚氨酯泡沫双火源火蔓延研究

为探究环境风作用下逆向双点火源聚氨酯泡沫火蔓延及融合行为,开展多组对照实验并从材料传热机理角度分析侧向风速对火蔓延行为中火羽流形态、质量损失和辐射热流场等特征参数的影响。结果表明:风速与上述参数之间存在非线性关系。环境风效应使火焰被拉长且敷贴于预热区表面,增大预热区面积和热反馈;侧向风速的增加对FPU板材质量损失的影响逐渐弱化,且板材的熔滴率与风速呈正相关;无论侧向风是否存在,两侧逆向火焰融合后均达到整个蔓延过程中的峰值温度;风速的存在限制了火焰温度与辐射热通量峰值,也缩短了温度和辐射峰值出现的时间。     

活化后钾改性正硅酸锂吸附CO2的性能评价及动力学研究

制备了钾改性正硅酸锂(K-Li4SiO4),并对其进行了自活化,考察了活化后K-Li4SiO4吸附剂在不同温度和CO2浓度气氛中吸附CO2的性能及动力学行为。总体而言,吸附剂的CO2吸附能力随着温度的升高、CO2浓度的增加而提升。在700℃、100%体积分数CO2气氛中吸附剂的吸附量最大,可达7.9 mmol/g,吸附剂的利用率为95.2%。利用双指数模型能够很好地描述吸附剂在各个温度以及各个CO2浓度气氛下的CO2吸附过程。吸附活化能随着CO2气氛浓度的升高而降低,CO2体积分数为20%,50%,100%时的吸附活化能分别为26448,14035,6178 J/mol。     

Effect of pyrolysis and oxidation characteristics on lauric acid and stearic acid dust explosion hazards

The effect of pyrolysis and oxidation characteristics on the explosion sensitivity and severity parameters, including the minimum ignition energy MIE, minimum ignition temperature MIT, minimum explosion concentration MEC, maximum explosion pressure P_max, maximum rate of pressure rise (dP/dt)_max and deflagration index K_st, of lauric acid and stearic acid dust clouds was experimentally investigated. A synchronous thermal analyser was used to test the particle thermal characteristics. The functional test apparatuses including the 1.2 L Hartmann-tube apparatus, modified Godbert-Greenwald furnace, and 20 L explosion apparatus were used to test the explosion parameters. The results indicated that the rapid and slow weight loss processes of lauric acid dust followed a one-dimensional diffusion model (D1 model) and a 1.5 order chemical reaction model (F1.5 model), respectively. In addition, the rapid and slow weight loss processes of stearic acid followed a 1.5 order chemical reaction model (F1.5 model) and a three-dimensional diffusion model (D3 model), respectively, and the corresponding average apparent activation energy E and pre-exponential factor A were larger than those of lauric acid. The stearic acid dust explosion had higher values of MIE and MIT, which were mainly dependent on the higher pyrolysis and oxidation temperatures and the larger apparent activation energy E determining the slower rate of chemical bond breakage during pyrolysis and oxidation. In contrast, the lauric acid dust explosion had a higher MEC related to a smaller pre-exponential factor A with a lower amount of released reaction heat and a lower heat release rate during pyrolysis and oxidation. Additionally, due to the competition regime of the higher oxidation reaction heat release and greater consumption of oxygen during explosion, the explosion pressure P_m of the stearic acid dust was larger in low concentration ranges and decayed to an even smaller pressure than with lauric acid when the concentration exceeded 500 g/m³. The rate of explosion pressure rise (dP/dt)_m of the stearic acid dust was always larger in the experimental concentration range. The stearic acid dust explosion possessed a higher P_max, (dP/dt)_max and K_st mainly because of a larger pre-exponential factor A related to more active sites participating in the pyrolysis and oxidation reaction. Consequently, the active chemical reaction occurred more violently, and the temperature and overpressure rose faster, indicating a higher explosion hazard class for stearic acid dust.     

肥煤自燃全过程热动力学特征参数研究

实验测定了林西矿肥煤样品30~900℃煤自燃全过程热动力学特征参数,得出:TG/DTG曲线显示煤样DTG初始临界温度45℃,干裂温度122℃,活性温度195℃,增速温度265℃,质量极大值温度342℃,着火温度465℃,最大热失重速率温度515℃和燃尽温度690℃;DSC曲线显示,煤样初始放热温度60℃、最大热释放速率温度511℃。结合TG-DTG-DSC曲线综合分析可知,煤温达到510℃左右时煤样反应最剧烈。由煤自燃标志气体测定实验系统得出:煤温130℃后CO,CO 2释放量迅速增加,210℃增加速度下降;CH 4,C 2 H 6含量变化具有规律性且两者变化相近;C 2 H 4出现温度为130℃;C 2 H 4/C 2 H 6比值在190~350℃有较强的规律性,呈上升趋势且上升速度较快;350℃之后,CH 4,C 2 H 6,C 2 H 4体积分数均开始急剧增大;C 2 H 4/CO与C 2 H 4/CO 2变化趋势大致相同,在130~350℃时缓慢增长,达到350℃后比值呈指数形式上升。经拟合曲线,得到活化能的3个突变点温度:70,180,220℃,其中180℃与交叉点温度相吻合。通过以上研究,得到了肥煤自燃全过程的热力学特征参数,为实际生产中防治煤自燃提供了理论依据。     

矿井热宽温度环境人体热健康分区热调节模型*

为评价矿井热环境中工人职业健康安全状况,提出矿井热宽温度环境人体热健康状态的基本特征与生理要求,分析热宽温度环境人体分区热调节规律与热健康状态的对应关系。基于生物控制论的观点,提出热宽温度范围内不同热应力作用下人体分区热调节机制,建立人体分区热调节模型。结果表明:模型能实现对环境热应力作用下人体物理热平衡状态与生理状态的参数化描述,揭示多因素作用下人体热健康状态的热应力边界与变化规律。分区热调节模型提供了人体热健康状态定量模拟平台,通过参数调整可使模型适应研究需求,模型为井下热环境工人职业健康安全状况分析与评价提供了可参考的思路与方法。     

屏蔽服冷却系统对人体表面温度影响的研究*

为科学有效地论证多种方式组合的冷却屏蔽服在不同环境条件下对人体表面温度控制的效果,需要对冷却系统及人体敏感部位发热量进行客观评估。通过对5名健康男性的高温测试,探究人体在不同环境温度下体表温度的变化,得出胸部、背部及额头为热量最高部位,并构建以“人体-降温屏蔽服-外界环境”为主体的冷却系统数值模型,对不同环境中的屏蔽服冷却效果展开研究,分析穿戴冷却屏蔽服时人体躯干部分的温度分布及影响。结果表明:在屏蔽服中靠近胸部、背部部位引入相变材料和风扇,均可帮助人体降低体温,提高舒适度。     

简述排污许可制下火电行业现状及发展

实施排污许可制度,是强化排污者责任、提高固定污染源环境管理效能、改善环境质量的重要制度保障。火电行业作为典型的高架固定源,先行试点实施排污许可制度。通过分析火电行业发展和环保现状,结合排污许可管理要点,简述排污许可制对火电行业发展的影响。     

硫化废气污泥活性炭净化处理技术研究

以污泥厂剩余活性污泥作为原料,采用KOH为活化剂制备污泥活性炭,探讨了活化温度及时间、热解温度、洗涤温度及方式在污泥活性炭制备过程中的最佳工艺条件。以品红吸附量及产率作为污泥活性炭的考察指标,采用单因素实验筛选出了制备污泥活性炭的最佳工艺条件,并对污泥活性炭脱硫剂的脱硫性能进行了实验研究。实验研究结果显示,烟气中O2、水蒸气含量的多少及脱硫温度的高低会影响污泥活性炭脱硫剂的脱硫性能。     

基于火探管式的锂离子电池灭火技术研究

为研究锂离子电池灭火方案,基于火探管灭火技术同时利用新型清洁灭火剂Novec 1230,组装成火探管灭火系统。在灭火测试平台上以功率为200 W的电热管作为外热源引发单电池或电池模组热失控,通过改变火探管的布置位置,记录相应的灭火行为以及灭火效率,并对实验结果进行了分析。研究结果表明,当火探管灭火系统直接布置在电池正上方时,在起火后的5.6s内控制火情;随着灭火剂用量增加可以显著降低体系温度,防止电池复燃以及连锁热失控现象发生;火探管有效覆盖区域外的失控电池作为热源将继续加热临近电池,引发连锁热失控,造成灭火系统失效;根据电池热失控后的燃烧行为以及传热行为,提出相应的火探管灭火系统复合方案。