加压活性污泥法处理有机中间体废水的研究

对加压活性污泥法处理有机中间体废水进行了研究,主要考察了停留时间(HRT)、污泥浓度(MLSS)和反应压力等条件对COD去除率的影响.有机中间体废水经铁炭预处理后,COD从原来的8 000 mg/L降到5 000 mg/L左右,BOD5/COD由原来的0.20升高到0.40左右.当反应器内废水混合后COD 2 000 mg/L时,在反应压力0.10 MPa、污泥质量浓度3～5 g/L、停留时间8～10 h条件下,出水COD小于600 mg/L,COD去除率大于70%;出水经混凝沉淀处理后COD小于400 mg/L,可以达到<污水综合排放标准>(GB 8978-1996)三级标准.与常规的活性污泥处理方法相比,加压活性污泥法具有处理速度快、降解效率高和容积负荷大等优点.     

多环芳烃在全土及其碱提残余物上的吸附行为

以菲和芘为代表性化合物,采用8种有机质含量不同的天然全土样品及其碱提残余物进行吸附实验,并利用不同吸附模型进行数据拟合,藉以探讨有机质含量对土壤吸附行为的影响.结果表明,Freundlich吸附模型的非线性指数n都小于1,显示全土和碱提残余物在多环芳烃的吸附过程中表现出非线性特征.菲和芘的吸附行为随土壤有机质含量不同而变化,碱提残余物的吸附能力强于全土,两者吸附行为的差异主要归因于土壤有机质含量和性状的区别.     

利用电石渣制备多种晶形碳酸钙的研究

为了有效地利用电石渣资源,研究用电石渣为原料制备球形、板状形、针叶形碳酸钙.利用DTA-TG、SEM等研究了电石渣的预处理方式对碳酸钙纯度的影响和碳化反应温度、CO₂流量等对多晶型碳酸钙形成的影响.结果表明:电石渣可直接与氯化铵反应,当pH>7时,合成的碳酸钙的纯度大于97%,白度大于98.电石渣经过处理后,在不同的碳化反应温度及合适的CO₂流量的条件下分别可以得到球形、板状形、针叶形的碳酸钙.     

低温低浊微污染水源水的生物净化技术研究

针对低温低落景污染水源,采用生物预处理的手段进行现场试验研究。结果发现：以陶粒为载体的生物预处理工艺,能去除水中有机物（ＯＣ或ＣＯＤ）２０－３０％,ＳＳ６０－７０％,氨氮８０％,低温时去除率受到一定影响。但仍有一定和去除有机物及氨氮的。水库的低浊度和有机物含量较多的性质有利于生物预处理工艺对水中有机污染物的控制。     

Air Pollution Zones and Harmful Pollution Levels of Alkaline Dust for Plants

For characterisation of landscapes in north-eastern Estoniaaffected by alkaline oil shale fly ash and cement dust the zonation-method based on average annual (C _y) and short-termconcentrations of pollutants in the air was used, as well as on deposition loads of dust and Ca²⁺. In the overground layer of atmosphere the zones with different air pollution loads were distinguished. A comparative analysis of pollution zones characteristics and biomonitoring data revealed that for sensitive lichen the dangerous level of alkaline dust in the air, introducingthe degradation of Sphagnum sp. at the level of C _y of dust 10–20 g m^-3 and at 0.5–1 hr maximums 100–150 g m^-3. For Scots pine (Pinus sylvestris L.) and Norway spruce (Picea abies (L.) Karst.) this limited concentration (decline of growth parameters) of cement dust is correspondingly following: 30–50 g m^-3 and 150–500 g m^-3, in case of fly ash the limit level of C _y amounting 100 g m^-3. Daily deposition load of Ca²⁺ should not exceed approximately 4.5–15 mg m^-2 for lichen; for conifers the harmful pollution load is higher – >22 mg m^-2.     

Optimized determination of airborne tetracycline resistance genes in laboratory atmosphere

• Sampling parameters with high efficiency was determined. • Operational process to detect airborne ARGs was optimized. • Providing research basis to control airborne ARGs of a laboratory atmosphere Antibiotic resistance genes (ARGs) have been detected in various atmospheric environments. Airborne ARGs transmission presents the public health threat. However, it is very difficult to quantify airborne ARGs because of the limited availability of collectable airborne particulate matter and the low biological content of samples. In this study, an optimized protocol for collecting and detecting airborne ARGs was presented. Experimental results showed that recovery efficiency tended to increase initially and then declined over time, and a range of 550–780 copies/mm² of capture loading was recommended to ensure that the recovery efficiency is greater than 75%. As the cell walls were mechanically disrupted and nucleic acids were released, the buffer wash protects ARGs dissolution. Three ratios of buffer volume to membrane area in buffer wash were compared. The highest concentrations of airborne ARGs were detected with 1.4 µL/mm² buffer wash. Furthermore, the majority of the cells were disrupted by an ultrasonication pretreatment (5 min), allowing the efficiency ARGs detection of airborne samples. While, extending the ultrasonication can disrupt cell structures and gene sequence was broken down into fragments. Therefore, this study could provide a theoretical basis for the efficient filter collection of airborne ARGs in different environments. An optimized sampling method was proposed that the buffer wash was 1.4 µL/mm² and the ultrasonication duration was 5 min. The indoor airborne ARGs were examined in accordance with the improved protocol in two laboratories. The result demonstrated that airborne ARGs in an indoor laboratory atmosphere could pose the considerable health risk to inhabitants and we should pay attention to some complicated indoor air environment.     

化学絮凝-吸附预处理垃圾填埋场渗滤液试验研究

为改进现有二滩库区垃圾处理填埋场垃圾渗滤液处理工艺,研究絮凝—吸附法预处理工艺,试验以聚合氯化铝作为絮凝剂,最佳投放量为600mg/L,以粉煤灰作为吸附剂,最佳投放量为200g/L。结果表明:CODcr去除率达到79.64%;NH3-N去除率达到83.23%;悬浮物去除率达到58.75%;色度去除率达到92.56%;重金属离子去除率为60.37%～96.33%;研究证明:渗滤液经预处理后可以与城市生活污水合并处理。     

稻草经超声波辅助预处理后酶解过程的动力学研究

在功率为120 W、处理时间为30 min的条件下,分别对稻草进行超声波辅助酸碱预处理,与传统化学预处理(碱-预处理、酸-预处理)后稻草的主要化学组成相比较,结果表明超声波技术辅助酸碱预处理可以更为有效地去除半纤维素和木质素,从而提高了稻草基质中纤维素的相对含量,有利于缩短稻草水解时间。在一系列实验研究的基础上,建立了稻草酶水解动力学模型。结果表明,分别经碱、超声波-碱、酸、超声波-酸预处理的稻草在糖化过程中的模型参数(米氏常数KM,速率常数k和抑制常数KI)均不相同,KM分别为17.55、14.14、15.29和15.08 g/L;k分别为15.30、21.32、13.40和15.42 h-1;抑制常数KI变化不明显分别为2.31、2.08、1.81和1.85 g/L。模型及实验方法简便可靠,有较好的拟合性,对稻草酶水解过程工程放大及过程控制都具有一定的参考价值。     

改进型生物质阴离子交换纤维制备及吸附性能

用氢氧化钠水溶液预处理,以乙二胺作交联剂,采用环氧氯丙烷和二甲胺对网状植物丝瓜络纤维进行化学改性,制备出改性丝瓜络阴离子交换纤维(LS-AEF),重点探讨了LS-AEF的形态特征并对其形态特征进行了表征分析,还考察了碱预处理对产品吸附水体中的NO-3的影响。研究结果表明,(1)LS-AEF引入带正电的胺基基团,可以提高对NO-3的吸附性能;(2)乙二胺剂量对产品吸附性能影响比较大,最佳剂量为9 mL,吸附率达到75%;(3)碱性预处理能够显著提高产品的吸附性能,碱处理前后的产品吸附率分别为76%和85%;(4)吸附过程符合伪二级动力学方程。     

高铁酸钾预处理垃圾渗滤液

采用自制高纯度高铁酸钾预处理危废填埋场和垃圾焚烧厂的垃圾渗滤液,探讨和分析了处理效果。正交实验表明,高铁酸钾预处理危废填埋场渗滤液COD的最佳条件为:高铁酸钾与COD的初始质量浓度比为0.5、渗滤液初始pH值4.00、反应温度30℃、反应时间40 min,此时COD去除率达71.51%。此最佳条件下高铁酸钾对不同类型垃圾渗滤液的色度、SS、COD、BOD5、氨氮、总磷、重金属离子等污染因子都具有良好的去除效果,危废填埋场渗滤液经高铁酸钾预处理后可以直接进入后续生化处理系统;垃圾焚烧厂渗滤液预处理后其COD为2 861.0 mg/L,经二次预处理也可进入生化处理系统。实验结果表明,高铁酸钾对不同类型垃圾渗滤液都具有良好的预处理效果。