污泥厌氧消化技术的研究与进展

厌氧消化是目前国际上应用最为广泛的污泥稳定化和资源化的方法,随着全球性的能源危机以及各国可持续发展和环保法规的相继出台,该技术将有更加广阔的发展前景。阐述了厌氧消化的基本原理和应用情况,讨论了近年国外针对厌氧消化预处理技术和不同运行条件对厌氧消化反应效果的影响以及不同污泥处理工艺产能效果等方面研究成果及最新进展。     

有机废物厌氧消化工艺应用现状及前景展望

与其他常规处理方法相比,利用厌氧消化技术处理有机废物更具有优嚏,因为它不仅可以有效减少污省染,还可以产生很好的经济效益和巨大的环境效益。简要介绍了厌氧消化技术的机理、影响因素、类型,以及在有机废物处理领域的应用现状,并重点介绍了国外近年来发展形成的典型厌氧消化工艺,同时分析了厌氧消化技术在有机废物资源化处理领域的广阔应用前景。     

厌氧反应器系统动力学模型构建方法学研究

以系统动力学的基本概念、方法为基础提出了存在于变量之间的3种基本关系模式,并在此基础上提出针对复杂系统的分块建模理论.将以葡萄糖为进水基质的厌氧反应器划分为3个子系统.确定了该系统的系统结构图,在此基础上构建厌氧消化系统的SD模型.根据分块建模的优势及特点,对模型中的3个子系统采用不同的计算方式,通过对比模拟结果表明,SD模型静态模拟结果与实验数据、传统结构模型模拟结果之间的误差<10%,动态模拟结果与实际趋势一致,说明SD模型的模拟结果是可信的.根据其特性,对取消物化子系统的简化模犁的模拟结果进行分析,表明根据不同的研究目的,选择合适的模型结构是必要的,采用系统动力学的分块建模方法有利于模型的简化与升级、减少计算量、提高模型的计算速度.     

Structure and activity of thermophilic methanogenic microbial communities exposed to quaternary ammonium sanitizer

Food processing facilities often use antimicrobial quaternary ammonium compound (QAC) sanitizers to maintain cleanliness. These QACs can end up in wastewaters used as feedstock for anaerobic digestion. The aim of this study was to measure the effect of QAC contamination on biogas production and structure of microbial communities in thermophilic digester sludge. Methane production and biogas quality data were analyzed in batch anaerobic digesters containing QAC at 0, 15, 50, 100 and 150 mg/L. Increasing sanitizer concentration in the bioreactors negatively impacted methane production rate and biogas quality. Microbial community composition data was obtained through 16S rRNA gene sequencing from the QAC-contaminated sludges. Sequencing data showed no significant restructuring of the bacterial communities. However, significant restructuring was observed within the archaeal communities as QAC concentration increased. Further studies to confirm these effects on a larger scale and with a longer retention time are necessary.     

餐厨垃圾厌氧消化运行试验研究

采用猪粪厌氧消化的消化污泥为接种物,在中温(37℃)条件下,以连续进料的方式对餐厨垃圾的湿式厌氧消化进行了启动以及运行试验,监测整个实验过程中产气量、pH、VFA、碱度等能够反映厌氧消化的系统指标。结果表明:本实验中系统最佳有机负荷为2.8 kg/(m~3·d)(以VS计),超过此负荷后,依靠系统自身恢复和人工调节,pH很难恢复正常运行状态。正常运行过程中,pH稳定在7.5~8.0,VFA稳定在2 000 mg/L左右,碱度在6 000~9 000 mg/L,氨氮在1 500~2 000 mg/L,底物含水率为96%~98%。系统超负荷运行后,产气量和pH下降,VFA浓度上升,碱度、氨氮、含水率基本保持稳定。     

Effects of free ammonia on volatile fatty acid accumulation and process performance in the anaerobic digestion of two typical bio-wastes

The effect of free ammonia on volatile fatty acid(VFA)accumulation and process instability was studied using a lab-scale anaerobic digester fed by two typical bio-wastes:fruit and vegetable waste(FVW)and food waste(FW)at 35°C with an organic loading rate(OLR)of 3.0 kg VS/(m~3·day). The inhibitory effects of free ammonia on methanogenesis were observed due to the low C/N ratio of each substrate(15.6 and 17.2,respectively). A high concentration of free ammonia inhibited methanogenesis resulting in the accumulation of VFAs and a low methane yield. In the inhibited state,acetate accumulated more quickly than propionate and was the main type of accumulated VFA. The co-accumulation of ammonia and VFAs led to an "inhibited steady state" and the ammonia was the main inhibitory substance that triggered the process perturbation. By statistical significance test and VFA fluctuation ratio analysis,the free ammonia inhibition threshold was identified as 45 mg/L. Moreover,propionate,iso-butyrate and valerate were determined to be the three most sensitive VFA parameters that were subject to ammonia inhibition.     

生活垃圾生物处理的研究与展望

综述了国内外生活垃圾生物处理的研究进展和目前生活垃圾微生物研究水平，以及生活垃圾处理发展趋势与新动向，在此基础上提出了生活垃圾处理的建议和展望。     

有机固体废物固态厌氧消化处理的研究现状与进展

有机固体废物的固态厌氧消化处理是一种在固体含量很高的条件下进行厌氧发酵,同时产生沼气的处理方法,该方法能够实现废弃物污染防治和综合利用的目标.文中介绍了有机固体废物固态厌氧消化的研究状况,并且展望了其固态厌氧消化的研究前景.      

微波及其组合工艺强化污泥厌氧消化研究

为提高剩余污泥的厌氧消化效能和脱水性能,考察了微波及其组合污泥预处理工艺的强化污泥厌氧消化效果,同时考察了预处理-厌氧消化过程的污泥理化特征及其脱水性能.结果表明,微波及其组合工艺可以强化污泥厌氧消化产甲烷,其中微波-过氧化氢-碱(0.2)的强化效果最为显著,不仅30 d累计产甲烷量比对照组增加了13.34%,而且产甲烷速率也得到了提升.与单独微波处理相比,过氧化氢、碱的投加显著提高了溶解性COD的释放量,这表明微波、过氧化氢、碱之间的协同作用能有效破碎污泥,进而强化厌氧消化效果;微波-酸预处理后的污泥具有良好的脱水性能,毛细吸水时间(CST)只有9.85 s,污泥脱水性能的改善与其表面电性、粒径分布的变化密切相关;不同预处理条件下的污泥经过厌氧消化后,污泥脱水性能较为接近.     

微波消解-火焰原子吸收分光光度法测定固体废物中的钡

采用微波消解法对固体废物浸出液样品进行前处理,采用乙炔-空气火焰原子吸收法测定钡的含量,检出限为2．04mg／L,加标回收率为94．5％,精密度为4．85％-6．81％。