Performances of mesophilic anaerobic digestion systems treating poultry mortalities

Abstract

A closed‐loop anaerobic digestion system consisting of a leachbed (LB) and an upflow anaerobic sludge blanket (UASB) was tested as an alternative for the disposal of poultry mortalities. This paper compares the performances of three LB‐UASB treatment systems with different initial moisture contents in the LBs. Each LB was loaded with one chicken and 5, 10 or 18 liters of water. The LBs initially carried out the hydrolysis/acidification phase while the UASBs the methanogenesis phase. Due to repeated inoculation by the UASBs, the LBs with 10 and 18 liters of water started producing methane on day 5, while the one with 5 liters of water on day 19. However, methane production rates were low before day 40 for the LB with 10 liters of water and day 60 for the other LBs. Methane production gradually improved as the LBs continued to receive ungranulated sludge from the UASBs. The LBs eventually became balanced methane reactors. Continued balanced fermentation in the LBs resulted in leachates with very low substrate concentrations that could no longer support high‐rate methanogenesis in the UASBs. Consequently, methane production rates from the UASBs decreased quickly while that from the LBs reached peak levels. Cumulative methane production from each LB eventually exceeded that from its connecting UASB. After 118 days of digestion, 414, 437 and 470 liters of methane were produced from the three systems, respectively. Cumulative methane production from the LBs with 5 and 18 liters of water accounted for 63% of the total methane produced from their respective systems. The LB with 10 liters of water produced 75% of the total methane from that system. Methane yields ranged from 0.485 to 0.554 m³ (Kg TS) ¹. About 86% of the initial dry weight was biodegraded. All three systems performed very well with little operational problems. Overall, the system that started with 10 liters of water in the LB performed the best. Strategy for enhancing system performances and implementing farm applications are discussed.     

废活性炭微波再生新工艺的研究

提出用微波加热一二氧化碳活化法再生乙酸乙烯合成用触媒载体废活性炭工艺。采用条件实验法研究了活化时间、二氧化碳流量和微波功率对活性炭碘吸附值，亚甲基蓝吸附值和再生得率的影响，得到微波辐射加热二氧化碳活化再生乙酸乙烯用触媒载体废活性炭的最佳工艺条件为活化时间25min，二氧化碳流量0．2L／min，微波功率700w。在此条件下制得的活性炭碘吸附值为1158．02mg／g、亚甲基蓝吸附值为240mv,／g、得率为74．19％。并对活性炭进行了比表面积的测定和孔结构的分析，活性炭的比表面积为1308．13m^2／g，总孔容为0．76mL／g。     

城市废物的回收处理与利用

当前世界各国均面临着“废弃物”所造成的环境污染问题。本文列举了一些国家“废弃物”的排放以及回收利用情况,并举例说明对变废为宝的技术路线和应该采取的措施。     

Flame Propagation Across Gelled Alkane-In-Water Emulsions

Flame propagation rates were measured for flames spreading across surfaces of gel-like alkane-in-water emulsions. A long, slender, water-cooled trough was used to contain the mixtures. Abrupt changes in the flame propagation velocities - of nearly two orders of magnitude - were observed to occur near ‘critical’ concentrations of certain alkane/water mixtures. Four alkanes were used - pentane, hexane, heptane, and octane - and fuel rich emulsions (in which water was the continuous phase) were employed. The ability of the aqueous phase of the emulsion to inhibit the release of fuel into the vapor phase plays an important role in the observed behavior. That is, the rate at which fuel can diffuse through both the emulsion and the thin liquid layers that reside on it, is an essential kinetic aspect of the phenomena which determine the flame propagation rate across gelled alkane-in-water emulsions.     

活性污泥对四环素的吸附性能研究

通过批量平衡法研究了四环素在活性污泥上的吸附行为.结果表明,污泥混合液浓度和四环素初始浓度对吸附平衡时间、污泥吸附量和污泥吸附率均有较大影响.伪二级反应动力学模型较伪一级反应动力学模型更符合本吸附实验.在10、25℃条件下,四环素在活性污泥上的吸附行为较符合Langmuir模型,最大吸附量分别是31.14、70.95 mg.g-1;在40℃下,符合Henry模型.应用D-R模型判定吸附类型,10℃(平均吸附能为9.13 kJ.mol-1)下,化学吸附占主导;40℃(平均吸附能为7.07 kJ.mol-1)下,物理吸附占主导.温度升高,污泥对四环素的吸附能力增大.离子交换是四环素在活性污泥上吸附的一种机制.四环素的初始浓度为5、10、20 mg.L-1,钠离子浓度由0 mol.L-1增加到0.1 mol.L-1时,吸附量分别下降15.32%、15.00%、20.12%.当pH在5～10之间时,pH为6的条件下污泥对四环素的吸附量最大.     

Sewage sludge disintegration by high-pressure homogenization: A sludge disintegration model

High-pressure homogenization (HPH) technology was applied as a pretreatment to disintegrate sewage sludge. The effects of homogenization pressure, homogenization cycle number, and total solid content on sludge disintegration were investigated. The sludge disintegration degree (DDCOD), protein concentration, and polysaccharide concentration increased with the increase of homogenization pressure and homogenization cycle number, and decreased with the increase of sludge total solid (TS) content. The maximum DDCOD of 43.94% was achieved at 80 MPa with four homogenization cycles for a 9.58 g/L TS sludge sample. A HPH sludge disintegration model of DD_COD= kN^aP^b was established by multivariable linear regression to quantify the effects of homogenization parameters. The homogenization cycle exponent a and homogenization pressure exponent b were 0.4763 and 0.7324 respectively, showing that the effect of homogenization pressure (P) was more significant than that of homogenization cycle number (N). The value of the rate constant k decreased with the increase of sludge total solid content. The specific energy consumption increased with the increment of sludge disintegration efficiency. Lower specific energy consumption was required for higher total solid content sludge.     

Mechanism of lead immobilization by oxalic acid-activated phosphate rocks

Lead (Pb) chemical fixation is an important environmental aspect for human health. Phosphate rocks (PRs) were utilized as an adsorbent to remove Pb from aqueous solution. Raw PRs and oxalic acid-activated PRs (APRs) were used to investigate the effect of chemical modification on the Pb-binding capacity in the pH range 2.0-5.0. The Pb adsorption rate of all treatments above pH 3.0 reached 90%. The Pb binding on PRs and APRs was pH-independent, except at pH 2.0 in activated treatments. The X-ray diffraction analysis confirmed that the raw PRs formed cerussite after reacting with the Pb solution, whereas the APRs formed pyromorphite. The Fourier Transform Infrared spectroscopy analysis indicated that carbonate (CO₃^2-) in raw PRs and phosphate (PO₄^3-) groups in APRs played an important role in the Pb-binding process. After adsorption, anomalous block-shaped particles were observed by scanning electron microscopy with energy dispersive spectroscopy. The X-ray photoelectron spectroscopy data further indicated that both chemical and physical reactions occurred during the adsorption process according to the binding energy. Because of lower solubility of pyromorphite compared to cerussite, the APRs are more effective in immobilizing Pb than that of PRs.     

Responses of protists with different feeding habits to the changes of activated sludge conditions: A study based on biomass data

Changes of protists, which were categorized into different functional groups primarily according to their feeding habits, in two full-scale municipal wastewater treatment systems experiencing sludge bulking were investigated over a period of 14 months. Protist biomass represented 3.7% to 5.2% of total biomass on average under normal sludge conditions, and the percentage increased significantly (p < 0.05) under sludge bulking conditions. The biomass of Chilodonella spp., capable of eating filamentous bacteria, tended to decrease in both systems when sludge bulking occurred, showing that the abnormal growth of filamentous bacteria did not lead to a biomass bloom of this group of protists. On the other hand, the bactivorous protists represented more than 96% of total protist biomass, and the biomass of this group, particularly the attached ciliates, increased significantly (p < 0.05) when sludge bulking occurred. The significant increase of the attached ciliates may have possibly facilitated the growth of filamentous bacteria through selectively preying on non-filamentous bacteria and further exacerbated sludge bulking. The redundancy analysis and correlation analysis results showed that the biomass changes of the attached ciliates were primarily related to the sludge volume index and to some extent related to five-day biochemical oxygen demand loading and hydraulic retention time.     

Pb2+对城市污水处理厂污泥中苏云金芽孢杆菌发酵的影响

以城市污水处理厂污泥为培养基,研究了添加Pb2+对Bt(Bacillus thuringiensis,苏云金芽孢杆菌)生长和晶体蛋白合成的影响,同时分析了Bt发酵过程中有效态Pb含量(以ρ计)的变化,并采用FTIR(傅立叶红外光谱)和XPS(X射线光电子能谱),初步探讨了Pb2+在Bt表面的作用机制.结果表明:污泥培养基在支持Bt生长代谢和降低重金属有效态含量方面均优于商用培养基,当初始ρ(Pb2+)高达400 mg/L时,与未添加Pb2+相比,污泥培养基中Bt活菌数与晶体蛋白产量约分别下降48%和54%,而商用培养基中约分别下降82%和75%,证实了污泥作为Bt发酵培养基的可行性;Bt对Pb2+有较好的耐受性,当ρ(有效态Pb)在80 mg/L以下时,Bt生长代谢不会受到显著影响.光谱学分析表明,Bt对Pb2+有少量吸附,从而降低Bt发酵过程中Pb的生物有效性,吸附位点主要为羟基,部分C O和S O也参与了吸附反应.