Diffusive gradients in thin films using molecularly imprinted polymer binding gels for in situ measurements of antibiotics in urban wastewaters

• Selective molecularly imprinted polymer (MIP) binding gel was prepared. • MIP-DGT showed excellent uptake performance for antibiotics. • In situ measurement of antibiotics in wastewaters via MIP-DGT was developed. • The MIP-DGT method was robust, reliable, and highly sensitive. Urban wastewater is one of main sources for the introduction of antibiotics into the environment. Monitoring the concentrations of antibiotics in wastewater is necessary for estimating the amount of antibiotics discharged into the environment through urban wastewater treatment systems. In this study, we report a novel diffusive gradient in thin films (DGT) method based on molecularly imprinted polymers (MIPs) for in situ measurement of two typical antibiotics, fluoroquinolones (FQs) and sulfonamides (SAs) in urban wastewater. MIPs show specific adsorption toward their templates and their structural analogs, resulting in the selective uptake of the two target antibiotics during MIP-DGT deployment. The uptake performance of the MIP-DGTs was evaluated in the laboratory and was relatively independent of solution pH (4.0–9.0), ionic strength (1–750 mmol/L), and dissolved organic matter (DOM, 0–20 mg/L). MIP-DGT samplers were tested in the effluent of an urban wastewater treatment plant for field trials, where three SA (sulfamethoxazole, sulfapyridine, and trimethoprim) and one FQ (ofloxacin) antibiotics were detected, with concentrations ranging from 25.50 to 117.58 ng/L, which are consistent with the results measured by grab sampling. The total removal efficiency of the antibiotics was 80.1% by the treatment plant. This study demonstrates that MIP-DGT is an effective tool for in situ monitoring of trace antibiotics in complex urban wastewaters.     

武汉市一次污染过程的局地流场和边界层结构的数值模拟

利用2013年11月武汉市逐日空气质量资料、地面气象观测资料、NCEP/NCAR再分析资料和L波段雷达探空资料,通过WRF模式模拟空气污染生消过程中的局地气象条件变化,探讨特殊地形条件下边界层结构变化和局地环流在污染物生消过程中的作用和影响。结果表明：（1）武汉地区当背景环流场强的时候,由地形引起的局地流场对污染物扩散的影响就弱,反之当背景环流场弱的时候, 地形对流场影响明显:夜间为山风,白天为谷风。夜间山风与偏西北气流及偏东气流在武汉及周边地区辐合,形成气流汇聚带,在武汉地区形成一个反复污染带,即由地形引起的局地流场对污染物扩散的贡献就大;（2）武汉地区发生空气污染时,地面湿度较高,边界层呈上干下湿状态,其特征为暖而干且有偏东小风,这导致污染物不断堆积和重污染过程的形成。     

Soil type affects migration pattern of airborne Pb and Cd under a spruce-beech forest of the UN-ECE integrated monitoring site Zöbelboden, Austria

Anthropogenic trace element emissions have declined. However, top soils all over the world remain enriched in trace elements. We investigated Pb and Cd migration in forest soils of a remote monitoring site in the Austrian limestone Alps between 1992 and 2004. Large spatial variability masked temporal changes in the mineral soil of Lithic Leptosols (Skeltic), whereas a significant reduction of Pb concentrations in their forest floors occurred. Reductions of concentrations in the less heterogeneous Cambisols (Chromic) were significant. In contrast, virtually no migration of Pb and Cd were found in Stagnosols due to their impeded drainage. Very low element concentrations (<1 μg l⁻¹) in field-collected soil solutions using tension lysimeters (0.2 μm nylon filters) imply that migration largely occurred by preferential flow as particulate-bound species during intensive rainfall events. Our results indicate that the extent of Pb and Cd migration in soils is largely influenced by soil type.     

水体中常见无机阳离子对TiO2薄膜光催化还原Cr（Ⅵ）的影响

选择了6种水体中常见的阳离子（Na^＋、Mg^2＋、Ca^2＋、Al^3＋、Cu^2＋、Ni^2＋）,分别考查了其对TiO2薄膜光催化还原Cr（Ⅵ）的影响;从光吸收、无机离子本身的性质对光生电子的捕获及传递等讨论了上述离子影响TiO2薄膜光催化还原Cr（Ⅵ）的反应速率的原因。结果表明：由于其不能捕获光生电子,Na^＋、Mg^2＋、Ca^2＋本身对TiO2薄膜光催化还原Cr（Ⅵ）的反应速率影响不大;Al^3＋吸引电子能力较强,成为光生电子和Cr（Ⅵ）之间的桥梁,促进了Cr（Ⅵ）的还原;浓度为1 mmmol/L时,Cu^2＋显著地促进了Cr（Ⅵ）的光催化还原,其主要原因是Cu^2＋捕获光生电子的能力很强,起到了催化剂的作用,而浓度大于10 mmol/L时,Cu^2＋形成单质Cu以及对紫外光的吸收都使促进作用降低;Ni^2＋未充满的d轨道具有获得并传递光生电子的能力,也促进了Cr（Ⅵ）的还原;在浓度同为1mmol/L时,对Cr（Ⅵ）光催化还原的促进作用依次为：Cu^2＋〉Al^3＋〉Ni^2＋〉Na^＋、Ca^2＋、Mg^2＋。     

层燃螺旋炉排焚烧技术处理含油污泥研究

通过对几种含油污泥无害化处理技术的比选,分析不同处理技术物耗、能耗情况,优选出经济有效的含油污泥焚烧技术,结合新疆油田含油污泥的特点,采用层燃螺旋炉排焚烧技术,利用其燃烧热能生产蒸汽用于原油生产,采用余热吸收急冷与碱液半干法除酸技术,有效控制了二次污染;采用布袋除尘与烟尘固化技术确保了烟气达标排放。年节省成本支出3095.88万元。     

柴油机微粒中可溶性有机成分的真空干燥条件

柴油机碳烟颗粒(PM)中可溶性有机组分(SOF)含量是其重要的特性参数,而真空干燥法可方便、高效、可靠地分析颗粒SOF含量,对其干燥条件的探索具有重要的研究意义和应用价值。首先采用模拟的柴油机颗粒,分析不同的干燥条件对模拟SOF(柴油、润滑油)挥发率的影响规律,得出模拟的SOF分析的最佳干燥条件;在此基础上,探索了真实柴油机颗粒SOF分析的最佳干燥条件为:干燥温度220℃、干燥时间3 h、真空度98 kPa,得知SOF组分干燥的难易程度介于柴油和润滑油之间;同时,根据此干燥条件,分析了排气管末端采集的真实碳烟颗粒的SOF含量特性。     

电渗透脱水对污泥热干燥特性的影响

以污水厂机械脱水后的污泥作为研究对象,提出了采用电渗透-热干燥结合进行深度脱水的方法。通过对原泥以及电渗透脱水至不同含水率(67%、71%和76%)的污泥在热干燥过程中含水率和干燥速率的测定,分析电渗透脱水对污泥热干燥特性的改善规律。结果表明,经电渗透脱水至含水率为67%和71%的污泥在热干燥过程中的传热传质速率及干燥速率有明显提高,且干燥温度越高,电渗透后污泥的干燥速率与原泥的干燥速率差距越大。相同电压梯度及相同温度下电渗透至67%后进行热干燥耗能最少。实际应用中应结合能耗分析选择合适的电渗透程度及干燥温度,以达到最优效果。     

黄河中上游能源化工区大气污染跨界环境影响分析

对黄河中上游能源化工区近地面和边界层顶气象流场及该区域大气污染长距离输送产生的跨界环境影响趋势特征进行了分析。结果表明,该区域近地面和边界层顶的流场总体上为西北向东南流动,大气污染物长距离输送可能影响的区域主要为华中地区;区域冷空气的活动对其大气污染物的清除起重要作用;通过CALPUFF模型的模拟结果表明,该区域SO2的影响程度和范围明显大于NO2,在区域内部存在污染物浓度较高的区域,但未对区外造成显著跨界环境影响。     

Investigation of titanium liquid/gas diffusion layers in proton exchange membrane electrolyzer cells

In a proton exchange membrane electrolyzer cell (PEMEC), liquid/gas diffusion layer (LGDL) is expected to transport electrons, heat, and reactants/products to and from the catalyst layer with minimum voltage, current, thermal, interfacial, and fluidic losses. In addition, carbon materials, which are typically used in PEM fuel cells (PEMFCs), are unsuitable in PEMECs due to the high ohmic potential and highly oxidative environment of the oxygen electrode. In this study, a set of titanium gas diffusion layers with different thicknesses and porosities are designed and examined coupled with the development of a robust titanium bipolar plate. It has been found that the performance of electrolyzer improves along with a decrease in thickness or porosity of the anode LGDL of titanium woven meshes. The ohmic resistance of anode LGDL and contact resistance between anode LGDL and the anode catalyst play dominant roles in electrolyzer performance, and better performance can be obtained by reducing ohmic resistance. Thin titanium LGDLs with straight-through pores and optimal pore morphologies are recommended for the future developments of low-cost LGDLs with minimum ohmic/transport losses.     

Experimental investigation of a solar water distillation-cum-drying unit

In this communication, a new design of solar-energy-based water distillation cum drying unit with parabolic reflector has been designed, fabricated, and tested. Bitter gourd and potato slices are chosen as a drying commodity. Thermal performance of the developed system has been evaluated based on the experimental results and using linear regression analysis. Heat transfer coefficients (convective, evaporative, and radiative) for solar distillation system have been observed to be 2.48–4.09, 13.25–52.38, and 8.75–9.66 W/m²°C, respectively. Overall thermal efficiency and exergy efficiency for the distillation system has been found to be 18.77% and 1.2%, respectively. The convective heat transfer coefficient for potato slices are observed higher for initial hours and decreases as the day progresses. The average convective heat transfer coefficients for bitter gourd and potato slices have been observed as 2.18 and 5.04 W/m²°C, respectively. Experimental error in terms of percent uncertainty for bitter gourd and potato slices are found to be 42.93% and 37.06%, respectively. The present design of solar distillation and drying in a single unit could be beneficial for the development of remote, arid, and rural areas.