石英砂负载氧化铁的表征及其除锑吸附性能研究

通过SEM/EDAX以及Nova-1000表面分析仪对石英砂负载的氧化铁颗粒进行了表征,发现负载氧化铁的粒径为200 nm左右,其表面孔径及孔隙率分别为2×10-9～9×10-9m及0.11%,负载氧化铁的石英砂的比表面积为原砂的5倍.考察了石英砂负载氧化铁(IOCS)在不同的实验条件下(吸附时间,pH值,温度等)对水溶液中锑的去除效果,在pH为3～9范围内,其去除率均超过了98%.吸附动力学及吸附等温线实验数据分别符合二级反应动力学模型及Langmuir等温吸附模型.热动力学实验结果进一步表明:IOCS吸附锑的过程是自发的、吸热的化学吸附反应.     

好氧颗粒污泥负载纳米二氧化钛强化磺胺嘧啶降解的机制及性能

抗生素在传统污水处理厂的去除效果有限,基于此,制备了一种将纳米二氧化钛(TiO₂)吸附在好氧颗粒污泥上的生物纳米材料,该材料可以在不影响其他污染物去除性能的情况下提高废水中磺胺嘧啶(SDZ)类抗生素的降解,并强化中间产物的进一步转化。结果表明,AGS对TiO₂的吸附满足伪二级吸附动力学,得到的生物纳米材料结构稳定;在TiO₂为20 mg·L⁻¹时吸附速率最快、对污泥内细胞和胞外聚合物影响较小;用该材料降解含SDZ的模拟废水时,紫外光照会促进生物纳米材料中异养菌的活性,提高耗氧有机污染物、SDZ及其中间产物对氨基苯磺酸的去除率,10 h内SDZ平均降解速率可达0.97 mg·(L·h)⁻¹。以上获得的新型生物纳米材料可为抗生素废水的处理提供新的技术选择。     

不锈钢纤维毡改性材料的制备及在微生物燃料电池中的应用

为制备一种导电性高、生物相容性良好且耐腐蚀的阳极材料,提高微生物燃料电池(MFC)的产电性能,以不锈钢纤维毡(SSFF)为基底,采用水热反应法制备了还原氧化石墨烯/不锈钢纤维毡(RGO/SSFF),并进一步采用粉体烧结法将纳米二氧化钛(TiO₂)负载至RGO/SSFF,制备了二氧化钛/还原氧化石墨烯/不锈钢纤维毡(TiO₂/RGO/SSFF),将SSFF(对照)、RGO/SSFF和TiO₂/RGO/SSFF分别作为MFC的阳极(对应的MFC分别命名为MFC-CK、MFC-RG和MFC-TRG)以探究改性材料对MFC去除水体中耗氧有机物和产电性能的影响。结果表明：与SSFF相比,RGO/SSFF和TiO₂/RGO/SSFF具有更大的电容(Q为413.9 mF和446.9 mF),更小的界面转移电阻(R_ct为19.65 Ω和18.16 Ω),更高的交换电流密度(i₀为1.56×10⁻⁵ mA和2.07×10⁻⁴ mA);MFC-TRG对水体COD去除速率最高可达929.62 mg·(L·d)⁻¹;MFC-RG和MFC-TRG稳定输出电压分别为245 mV和280 mV,比MFC-CK提高了88.5%和115.4%;MFC-RG和MFC-TRG的功率密度输出分别为 337.50 mW·m⁻²和472.03 mW·m⁻²,比MFC-CK提高了163.9%和233.9%。由此可知,改性后的RGO/SSFF和TiO₂/RGO/SSFF阳极成功提高了MFC的产电性能。该研究结果可为后续MFC阳极改性研究提供参考。     

基于响应曲面法优化的臭氧/过硫酸盐/四氧化三铁工艺对结晶紫的降解

为有效去除水中结晶紫,利用臭氧/过硫酸盐/四氧化三铁工艺对结晶紫的氧化效果进行研究,设计单因素实验探索臭氧流量、过硫酸盐浓度、四氧化三铁浓度和pH对结晶紫降解的影响,依据响应曲面法的Box-Behnken Design(BBD)实验设计原理,探究臭氧流量、过硫酸盐浓度、四氧化三铁浓度和反应时间对降解效果的影响,并优化工艺参数;使用SEM-EDS、FT-IR和Raman表征了反应前后的四氧化三铁,并用EPR技术直接鉴定出工艺过程中的活性氧。结果表明：此工艺在较宽的pH区间(3~11)都具有较高的结晶紫降解能力,臭氧流量、过硫酸盐浓度和四氧化三铁浓度与结晶紫的降解率成正比;臭氧流量1.000 L·min⁻¹,过硫酸盐浓度0.968 mmol·L⁻¹,四氧化三铁浓度2.158 mmol·L⁻¹,反应时间41.702 min为预测的最佳工艺条件;在最佳工艺条件下得到的实际降解率与预测降解率相对偏差仅为−1.12%;催化反应后Fe₃O₄粒径减小,表面变得更加光滑;反应后的Fe₃O₄的铁元素质量分数由48.24％降至35.31%,而氧和硫元素质量分数由34.05%和0.39%分别增至37.59%和1.09%;臭氧/过硫酸盐/四氧化三铁工艺过程中存在SO₄^·–和·OH。由此可知,BBD优化模型预测与实际处理效果基本一致。该研究成果为可为难降解的结晶紫废水的深度处理提供参考。     

Ecotoxicity of nanoparticles of CuO and ZnO in natural water

The acute toxicity of CuO and ZnO nanoparticles in artificial freshwater (AFW) and in natural waters to crustaceans Daphnia magna and Thamnocephalus platyurus and protozoan Tetrahymena thermophila was compared. The L(E)C₅₀ values of nanoCuO for both crustaceans in natural water ranged from 90 to 224 mg Cu/l and were about 10-fold lower than L(E)C₅₀ values of bulk CuO. In all test media, the L(E)C₅₀ values for both bulk and nanoZnO (1.1-16 mg Zn/l) were considerably lower than those of nanoCuO. The natural waters remarkably (up to 140-fold) decreased the toxicity of nanoCuO (but not that of nanoZnO) to crustaceans depending mainly on the concentration of dissolved organic carbon (DOC). The toxicity of both nanoCuO and nanoZnO was mostly due to the solubilised ions as determined by specific metal-sensing bacteria.     

CaH_2对Cu-Ce-La-ZSM-5催化分解NO性能的影响

实验采用一步离子交换法制备Cu-Ce-La-ZSM-5催化剂,然后采用共混法制得Cu-Ce-La-ZSM-5/CaH2催化剂。采用扫描电镜(SEM),电感耦合等离子体发射光谱(ICP-AES),X射线衍射(XRD),红外(FTIR)以及NO吸脱附(NO-TPD)对催化剂进行表征。结果显示CaH2的加入使得催化剂中铜离子存在形式发生变化,催化剂表面变光滑洁净,并且吸附NO能力增强。NO催化分解实验的结果表明CaH2提高了催化剂活性和抗氧性。CaH2助催性是由于其受热分解过程中产生的H2能将Cu2+还原为具有催化活性的Cu+,同时使催化剂表面洁净光滑更容易吸附NO。     

氧化镁烟气脱硫反应特性研究

利用实验室规模的鼓泡式反应装置,对比了碳酸钙、氧化镁和氧化镁/硫酸镁脱硫剂的反应活性,证实脱硫液中高浓度硫酸镁的存在是保证镁法脱硫效率高于钙法的重要因素,并考察了硫酸镁浓度、脱硫剂(氧化镁)浓度、烟气量、SO2浓度和吸收液温度等因素对脱硫效率的影响。结果表明,脱硫反应可以根据pH分为2个不同阶段;反应过程中脱硫效率随着硫酸镁浓度的增加而显著升高;烟气量增加将会导致脱硫效率有所下降;入口SO2浓度升高,脱硫效率下降;氧化镁浓度、温度对脱硫效率影响不显著。结合实验现象进行推断,氧化镁脱硫的反应过程受SO2在气液两相界面的传质扩散和其水解产物在液相的扩散控制。     

二氧化钛载银抗菌剂的研究进展

介绍了二氧化钛系和银系无机抗菌剂在国内外的研究现状、杀菌机理以及存在的问题,论述了二氧化钛载银改性杀菌材料的最新进展,并就其研究开发亟需解决的关键问题提出了可行性建议。     

Spatial variability of arsenic concentration in soils and plants, and its relationship with iron, manganese and phosphorus

Spatial distribution of arsenic (As) concentrations of irrigation water, soil and plant (rice) in a shallow tube-well (STW) command area (8 ha), and their relationship with Fe, Mn and P were studied. Arsenic concentrations of water in the 110 m long irrigation channel clearly decreased with distance from the STW point, the range being 68-136 μg L⁻¹. Such decreasing trend was also noticed with Fe and P concentrations, but the trend for Mn concentrations was not remarkable. Concerning soil As, the concentration showed a decreasing tendency with distance from the pump. The NH₄-oxalate extractable As contributed 36% of total As and this amount of As was associated with poorly crystalline Fe-oxides. Furthermore only 22% of total As was phosphate extractable so that most of the As was tightly retained by soil constituents and was not readily exchangeable by phosphate. Soil As (both total and extractable As) was significantly and positively correlated with rice grain As (0.296 ± 0.063 μg g⁻¹, n = 56). Next to drinking water, rice could be a potential source of As exposure of the people living in the As affected areas of Bangladesh.     

Novel application of the CORAL software to model cytotoxicity of metal oxide nanoparticles to bacteria Escherichia coli

Convenient to apply and available on the Internet software CORAL (http://www.insilico.eu/CORAL) has been used to build up quantitative structure-activity relationships (QSAR) for prediction of cytotoxicity of metal oxide nanoparticles to bacteria Escherichia coli (minus logarithm of concentration for 50% effect pEC50). In this study six random splits of the data into the training and test set were examined. It has been shown that the CORAL provides a reliable tool that could be used to build up a QSAR of the pEC50.