凹凸棒石粘土固定辣根过氧化物酶处理含酚废水

采用凹凸棒石粘土、可溶性淀粉和工业水玻璃作为制备凹凸棒石粘土基颗粒的材料,并将制备的凹凸棒石粘土基颗粒进行改性,得到了改性后的凹凸棒石基多孔材料,并将其作为固定辣根过氧化物酶的载体,再应用于含酚废水的处理研究,取得了良好的效果。实验结果表明,辣根过氧化物酶的最佳固定化条件为:单位酶活载体量1 mg、固定化时间1.5小时、固定pH值5。并且在固定化酶循环使用6次后,苯酚去除率仍能达到62.3%。     

纳米二氧化钛复合石墨烯催化剂的制备及处理染料废水

以硫酸钛为原料,采用共沉淀法,制备了一系列纳米二氧化钛复合石墨烯催化剂,采用XRD和FTIR对样品进行表征。通过紫外光照射亚甲基蓝溶液光催化降解实验,研究石墨烯的加入量对TiO2光催化性能的影响,结果表明,TiO2-GO-5具有最佳的光催化性能。在pH=6.00、TiO2-GO-5的投加量为0.070 g/50 mL、光照3 h条件下,100 mg/L亚甲基蓝溶液的脱色率达到最大值为90.52%。     

模拟阳光下Ag／I-TiO2光催化预处理山核桃加工废水

研究了在模拟太阳光下,采用银修饰的碘掺杂二氧化钛光催化剂（Ag／I—TiO2）对某食品厂山核桃加工废水进行光催化预处理的效果。结合x射线衍射（XRD）、比表面积分析（BET）、紫外-可见漫反射光谱（uV—Vis）的表征结果,来分析催化剂结构对于废水处理效果的影响。探讨了Ag含量、废水初始pH（pHi）和光照时间等因素对化学需氧量（COD）去除及水质可生化性（B／C）提高的影响。并得出适宜的反应参数为：3％Ag含量;pHi为6;光照时间为240min。在最佳条件下,COD去除率45％,废水B／C比由0．17上升到0．31。光催化氧化法能够有效降低山核桃加工废水的COD含量,并达到显著提高废水可生化性的目的。     

循环式超声强化光催化降解双酚A

设计了一种循环式超声强化光催化反应器,以TiO2作为光催化剂,研究了超声功率、TiO2加入量、循环液流速和空气流量对双酚A(BPA)降解效果的影响。实验结果表明:超声与光催化过程在循环式超声强化光催化反应器中实现了较好的协同效应;在初始BPA质量浓度为20.0mg/L、超声功率为600W、TiO2加入量为7g/L、循环液流速为4.05×10-2m/s、空气流量为200mL/min的条件下,反应150min后,BPA降解率可达90.5%,溶液中剩余BPA质量浓度仅为1.8mg/L,反应240min后TOC去除率可达84.5%。     

Sorption–desorption of imidacloprid onto a lacustrine Egyptian soil and its clay and humic acid fractions

Sorption–desorption of the insecticide imidacloprid 1-[(6-chloro-3-pyridinyl)-methyl]-N-nitro-2-imidazolidinimine onto a lacustrine sandy clay loam Egyptian soil and its clay and humic acid (HA) fractions was investigated in 24-h batch equilibrium experiments. Imidacloprid (IMDA) sorption–desorption isotherms onto the three sorbents were found to belong to a non-linear L-type and were best described by the Freundlich model. The value of the IMDA adsorption distribution coefficient, Kd_ads, varied according to its initial concentration and was ranged 40–84 for HA, 14–58 for clay and 1.85–4.15 for bulk soil. Freundlich sorption coefficient, Kf_ads, values were 63.0, 39.7 and 4.0 for HA, clay and bulk soil, respectively. The normalized soil Koc value for imidacloprid sorption was ～800 indicating its slight mobility in soils. Nonlinear sorption isotherms were indicated by 1/n_ads values <1 for all sorbents. Values of the hysteresis index (H) were <1, indicating the irreversibility of imidacloprid sorption process with all tested sorbents. Gibbs free energy (ΔG) values indicated a spontaneous and physicosorption process for IMDA and a more favorable sorption to HA than clay and soil. In conclusion, although the humic acid fraction showed the highest capacity and affinity for imidacloprid sorption, the clay fraction contributed to approximately 95% of soil-sorbed insecticide. Clay and humic acid fractions were found to be the major two factors controlling IMDA sorption in soils. The slight mobility of IMDA in soils and the hysteresis phenomenon associated with the irreversibility of its sorption onto, mainly, clay and organic matter of soils make its leachability unlikely to occur.     

Ti（Ⅳ）催化臭氧／过氧化氢预处理酸性难降解废水

在Ti（Ⅳ）和过氧化氢存在条件下,考察了臭氧化酸性苯乙酮溶液、硝基苯溶液和垃圾渗滤液（浙江衢州某垃圾填埋场）的预处理效能。结果表明,在pH2．86条件下,单独臭氧化处理对苯乙酮、硝基苯和垃圾渗滤液的COD去除率分别为10．1％、44％和28．6％。BOD,／COD值分别从原来的0．039、0．060和0．085提高到了0．130、0．158和0．174,仍属生化难降解废水。当体系加入Ti（Ⅳ）后,臭氧化苯乙酮和硝基苯的COD去除率分别达到了75．5％和65％,BOD;／COD则提高到了0．679和0．314,可生化性提升明显。对于垃圾渗滤液,只有当体系加入Ti（Ⅳ）和H22后,臭氧化COD的去除率达到66．6％,BOD、／COD提高至0．425。上述结果对酸性难降解废水的处理实际意义非常突出。     

云母钛珠光颜料的应用研究

介绍了一种不使用有机溶剂获得云母钛珠光颜料、水性金属效果云母钛珠光浆、珠光涂料的环保型制备工艺和性能.采用液相沉积法获得了不同厚度的纳米TiO2薄膜包覆层而显示银白、金、红、紫、蓝、绿等各种色彩的系列珠光云母颜料;应用珠光云母颜料与分散剂等水性助剂混合,获得了水性金属效果云母钛珠光浆的制备工艺;应用云母钛珠光浆与乳液配合,获得了云母钛珠光涂料的制备工艺.制备的云母钛珠光涂料系列多彩,白度高、反射率大、珠光效果好,硬度、附着力、耐候性等指标优异.     

村庄下倾斜煤层条带开采方法研究

针对我国"三下"(建筑物下、水体下、铁路下)压煤条带开采的实际情况,根据国内外有关条带开采的实践经验和技术要求,采用极限强度理论和压力拱理论对村庄下倾斜煤层条带开采进行了分开采深度设计,计算得出了条带开采的采出宽度和保留宽度;应用条带开采地表移动参数的模糊优化理论对概率积分法预计参数进行了选取,按照不同的开采深度,对村庄范围内的地表移动和变形值进行预计;根据预计的结果,对计算得出的条带开采尺寸进行检验和优化。研究表明,村庄下分采深条带开采尺寸设计和分采深地表沉陷预计,不仅可以提高地下煤炭资源的采出率,实现村庄在不搬迁情况下安全开采,也可最大限度地减小地下开采对地表建筑物的损害。     

TiO2-PTFE光催化膜的制备及性能

以聚四氟乙烯（PTFE）乳液和纳米TiO2粉末为原料,采用无水乙醇为溶剂,经辊压后与不锈钢网结合,制备了多孔固定化TiO2-PTFE光催化膜。膜性能研究结果表明,m（TiO2）：m（PTFE）=4时,光催化反应处理质量浓度为20mg／L的苯甲酸溶液,2h内TOC去除率高达81．3％。通过扫描电子显微镜观察,TiO2-PTFE光催化膜表面平整,且孔隙分布均匀。TiO2最佳负载量为15mg／cm2。在优化反应条件下同悬浮态TiO2光催化反应体系相比,TiO2-PTFE光催化膜对光源有更高的利用率,表现出更佳的催化活性。     

Leaching,mobility and persistence of tebufenozide in columns packed with forest litter and soil

Abstract

Leaching, downward mobility and persistence of tebufenozide was investigated under laboratory conditions in columns packed with forest litter and soil, after fortification with the analytical grade material (purity > 99.6%) and with two commercial formulations, RH‐5992 2F (aqueous flowable) and RH‐5992 ES (emulsion suspension). Two types of litter and soil were used: one type with relatively high amounts of sand and the other with high amounts of clay.

The concentrations eluted in the leachates were lower when the analytical material (dissolved in acetone) was used for fortification, than when the two formulations (diluted with water) were used. The amount leached was higher for RH‐5992 2F than for RH‐5992 ES. The type of substrate, i.e., sandy or clay type, had only marginal influence on the amounts eluted in the leachates. Downward movement of tebufenozide from the top 2‐cm layer to the untreated middle and bottom layers (3‐cm segments) was consistently lower when the analytical material was used for fortification, than when the two formulations were used. Downward movement was higher for RH‐5992 2F than for RH‐5992 ES. Persistence of tebufenozide in substrates, maintained under submerged conditions for 70 days after leaching, indicated an initial 2‐week lag period prior to the onset of degradation. Formulation‐related differences were observed in the half‐life (DT₅₀) values. When the analytical material was used for fortification, the DT₅₀ ranged from ca 54 to 59 d. However, when the formulations were used for fortification, the DT₅₀ showed a higher range, i.e., from ca 62 to 67 d for RH‐5992 2F and ca 70 to 80 d for RH‐5992 ES. Formulation ingredients appear to have caused enhanced adsorption of tebufenozide onto the substrates, thus delaying degradation.