季铵盐离子液体改性活性炭及其热安全性研究*

为进一步提高活性炭对VOCs的吸附性能和热安全性,采用铵盐类离子液体改性原始活性炭,优化其理化性质。结果表明:改性活性炭表面生成新的无机盐化合物,C=O、-OH、C-O、-COOH和C-S基团增加;孔隙结构增多且分布均匀,比表面积及微孔体积增大;改性后活性炭对甲苯的吸附量提高3.14倍,吸附效率明显提升;在固定碳的燃烧阶段,改性活性炭活化能为54.44 kJ·mol-1,是改性前活性炭的1.38倍,活化能增大,物质稳定性增强;当粒径为120~150目及200目以上时,改性前后活性炭的自燃温度分别从328.4 ℃、319.3 ℃增长至355.1 ℃、345.7 ℃。因此,负载季铵盐离子液体可有效提高活性炭吸附性能和热安全性,研究结果可为优化VOCs处理工艺提供参考。     

相对干燥条件下甲苯,苯和氯仿的光催化降解

研究了甲苯,苯和氯仿3种挥发性有机物在相对干燥条件下的动态气相光催化降解,考察了进口浓度,流量(停留时间),催化剂,光源等因素的影响.研究表明,在较低污染物浓度,流量小于0.2L/min(停留时间大于3.825min)时,甲苯,苯和氯仿的光催化去除率均大于90%,遵循一级反应动力学,甲苯和苯的半衰期分别在1.0～1.34min和0.65～1.1min;在研究的负荷范围内,甲苯和苯的去除量随负荷增加达到一个最大值,而氯仿则一直随之增大;催化剂的光催化性能与污染物种类有关,同样功率的杀菌灯效果好于黑光灯.     

废水中甲苯的臭氧氧化动力学的研究

采用臭氧氧化降解含甲苯的废水,实验研究了在温度为298K时,不同pH值、反应物的初始浓度对甲苯降解反应过程及其动力学的影响,初步探讨了甲苯液相臭氧氧化降解过程机理。      

气-固流化床光催化氧化甲苯的研究

在自制的流化床光催化反应装置中研究了中低浓度(28~140mg/m3)甲苯的气相光催化降解过程,考察了光照时间、初始浓度、表观气速和催化剂负载量等因素对甲苯光催化降解率的影响规律。结果表明,紫外灯照射约1·5h,甲苯的转化率达最大值,甲苯初始浓度越低,维持此最大值的时间越久;在一定低浓度范围内(28~55mg/m3),甲苯的转化率不随浓度变化,符合一级反应动力学,浓度进一步增加,则甲苯的转化率下降;表观气速和催化剂负载量的最佳值分别为3·3Umf和0·19gTiO2/gSiO2。     

甲苯降解菌的分离、鉴定及其对甲苯的降解特性

从重庆钢铁集团焦化厂脱酚池车间污泥中分离纯化得到一株能以甲苯为惟一碳源和能源的革兰氏阴性菌。根据生理生化实验结果、菌落特征、菌体形态,初步鉴定为假单孢菌属。菌株的最佳生长条件为：pH7、温度35℃、加入量100mL培养基中加入60μL甲苯、接种量5．0％。考察了菌株对甲苯的降解特性,在甲苯质量浓度为150mg/L时,比降解速率达到0．211h^-1。     

高流量负荷下低浓度VOCs废气的生物法处理

高流量负荷下生物膜填料塔净化低浓度甲苯废气的实验结果表明,当气体流量在0.8m/h,入口气体甲苯浓度为105mg/m,停留时间18.3s时,甲苯的净化效率可达到61.9%,出口气体甲苯浓度低于国家对现有企业的排放标准(≤60mg/m³).适宜的操作温度应控制在20～25℃之间,氮磷营养添加量的配比应控制为C:N:P=200:5:1.依据实验结果数据,对相关的机理问题进行了分析探讨.     

Leaching of styrene and other aromatic compounds in drinking water from PS bottles

Bottled water may not be safer, or healthier, than tap water. The present studies have proved that styrene and some other aromatic compounds leach continuously from polystyrene （PS） bottles used locally for packaging. Water sapmles in contact with PS were extracted by a preconcentration technique called as ＂purge and trap＂ and analysed by gas chromatograph-mass spectrometer （GC/MS）. Eleven aromatic compounds were identified in these studies. Maximum concentration of styrene in PS bottles was 29.5 μg/L. Apart from styrene, ethyl benzene, toluene and benzene were also quantified but their concentrations were much less than WHO guide line values. All other compounds were in traces. Quality of plastic and storage time were the major factor in leaching of styrene. Concentration of styrene was increased to 69.53 μg/L after one-year storage. In Styrofoam and PS cups studies, hot water was found to be contaminated with styrene and other aromatic compounds. It was observed that temperature played a major role in the leaching of styrene monomer from Styrofoam cups. Paper cups were found to be safe for hot drinks.     

Effects of seed aerosols on the growth of secondary organic aerosols from the photooxidation of toluene

Hydroxyl radical （.OH）-initiated photooxidation reaction of toluene was carried out in a self-made smog chamber. Four individual seed aerosols such as ammonium sulfate, ammonium nitrate, sodium silicate and calcium chloride, were introduced into the chamber to assess their influence on the growth of secondary organic aerosols （SOA）. It was found that the low concentration of seed aerosols might lead to high concentration of SOA particles. Seed aerosols would promote rates of SOA formation at the start of the reaction and inhibit its formation rate with prolonging the reaction time. In the case of ca. 9000 pt/cm^3 seed aerosol load, the addition of sodium silicate induced a same effect on the SOA formation as ammonium nitrate. The influence of the four individual seed aerosols on the generation of SOA decreased in the order of calcium chloride〉sodium silicate and ammonium nitrate〉ammonium sulfate.     

活性炭纤维处理甲苯废气试验研究

采用动态吸附试验,研究了进气温度、废气浓度对粘胶基活性炭纤维吸附甲苯过程的影响,分析了活性炭纤维(ACF)的穿透时间、平衡饱和吸附量的变化情况,并用Y-N模型对穿透曲线进行拟合.研究了吸附饱和ACF采用氮气热再生法,确定了温度、流量、再生时间等最佳操作参数,并进行了相关机理的探讨.     

乙氰菊酯对草履虫的毒性

乙氰菊酯是一种新型菊酯类杀虫剂．以甲苯为助溶剂的水溶液，对草履虫的半致死浓度为１６．３ｍｇ／ｌ；以丙酮为助溶剂的水溶液对草履虫的半致死浓度为２４．０ｍＧ／ｌ。建议在实际应用乙氰菊酯农药时以丙酮代替甲苯做助溶剂为好。