GdFeO3上CO氧化的Redox机理动力学

ＧｄＦｅＯ３用柠檬酸络合制备。用ＸＲＤ测定ＧｄＦｅＯ３为钙钛矿结构。用ＣＯ还原脉冲及用Ｏ２再氧化脉冲证实在ＧｄＦｅＯ３上ＣＯ氧化为Ｒｅｄｏｘ机理。用外循环流动无梯度反应顺研究了ＣＯ氧化稳态动力学。用正交设计法估计动力学方程中的参数。还原催化剂再氧化为控制步骤。     

超临界水氧化技术处理有机废水的研究

超临界水是处理难氧化有机污染物的一种很好媒介,因为在超临界状态下有机污染物和氧化剂能够互溶而加快反应速度,具有去除率高,反应时间短且无污染等特点,因而受到了越来越多的关注。本文主要概述了超临界水氧化的特点、机理、工艺流程和存在的问题,介绍了当前超临界水氧化处理难降解污染物的效果、动力学、催化剂研究等情况,并展望了其应用前景。     

Application of tracer ratio and inverse dispersion methods with boat-based plume measurements to estimate ammonia emissions from seabird colonies

Ammonia emissions from two contrasting seabird colonies in Scotland were measured, based on the determination of atmospheric concentrations downwind of the colonies. Atmospheric concentrations of ammonia (NH₃) across the downwind plume were compared with the inverse application of a Gaussian dispersion model (ID) to calculate the modelled NH₃ emission that would generate the measured cross-wind-integrated plume concentration. In parallel, a tracer gas (sulphur hexafluoride, SF₆) was released from the colonies with air samples taken to allow determination of SF₆ concentrations. On the basis of the known emission rate of SF₆, the magnitude of ammonia emissions was estimated by the cross-wind-integrated tracer ratio (TR) of NH₃/SF₆ concentrations. Coupled with data on annual bird attendance, the measurements indicate annual emissions from the Isle of May and the Bass Rock of 18 and 132 tonnes NH₃-N year^–1, respectively. The measured NH₃ emissions were compared with estimates of seabird nitrogen excretion to estimate the proportion of excreted N that is volatilised as NH₃ (F_Nr). The emission estimates of the two methods compared favourably, giving 4 and 6 kg NH₃-N h^–1 (F_Nr = 15%) for the Isle of May for the ID and TR methods, respectively, and 21 and 25 kg NH₃-N h^–1 (F_Nr = 50%) for the Bass Rock for the ID and TR methods, respectively. The results provide the first measurement-based estimates to allow regional up scaling of ammonia emissions from seabirds.     

活性污泥中硝化螺菌(Nitrospira)的富集及其动力学参数

采用连续进水的进水方式对污水处理厂活性污泥系统中的Nitrospira富集培养并对其相关动力学参数进行研究.结果表明,在控制反应器亚硝酸盐浓度不高于2 mg·L~(-1)的条件下可以成功富集出以Nitrospira为优势种属的活性污泥,其最大比亚硝酸盐氧化速率(以N/VSS计)为48.72 mg·(g·h)~(-1).荧光原位杂交结果显示Nitrospira占活性污泥总微生物量的75%左右,而Nitrobacter仅占总微生物的0.1%.此外通过对Nitrospira在20℃时的动力学参数进行测定,结果表明Nitrospira的最适生长温度为30~35℃,温度修正系数τN为1.046,其基质半饱和常数KS和氧半饱和常数KO分别为(0.32±0.03)mg·L~(-1)和(1.52±0.09)mg·L~(-1).Nitrospira动力学参数的研究为污水处理厂的设计运行及工艺优化提供理论参考.     

Removal of perfluorinated surfactants from wastewater by adsorption and ion exchange——Influence of material properties,sorption mechanism and modeling

Perfluorooctane sulfonate(PFOS) has attracted increasing concern in recent years due to its world-wide distribution, persistence, bioaccumulation and potential toxicity. The influence of sorbent properties on the adsorptive elimination of PFOS from wastewater by activated carbons, polymer adsorbents and anion exchange resins was investigated with regard to their isotherms and kinetics. The batch and column tests were combined with physicochemical characterization methods, e.g., N_2 physisorption, mercury porosimetry, infrared spectroscopy, differential scanning calorimetry, titrations, as well as modeling. Sorption kinetics was successfully modelled applying the linear driving force(LDF) approach for surface diffusion after introducing a load dependency of the mass transfer coefficient βs.The big difference in the initial mass transfer coefficient βs,0, when non-functionalized adsorbents and ion-exchange resins are compared, suggests that the presence of functional groups impedes the intraparticle mass transport. The more functional groups a resin possesses and the longer the alkyl moieties are the bigger is the decrease in sorption rate.But the selectivity for PFOS sorption is increasing when the character of the functional groups becomes more hydrophobic. Accordingly, ion exchange and hydrophobic interaction were found to be involved in the sorption processes on resins, while PFOS is only physisorptively bound to activated carbons and polymer adsorbents. In agreement with the different adsorption mechanisms, resins possess higher total sorption capacities than adsorbents. Hence, the latter ones are rendered more effective in PFOS elimination at concentrations in the low μg/L range, due to a less pronounced convex curvature of the sorption isotherm in this concentration range.     

地下水循环井技术处理土壤和地下水中甲基叔丁基醚研究

研究了MTBE在砂土中的静态吸附以及采用地下水循环井技术(GCW)去除砂土和地下水中MTBE的衰减规律。结果表明:MTBE在砂土中的吸附动力学符合准二级动力学方程,相关系数R2为0.99618,在砂土中的吸附平衡时间为24 h;吸附热力学符合Linear平衡吸附,吸附系数为0.00306 m3/kg。GCW运行30 h后,地下水饱和含水层中MTBE浓度由500 mg/L降至72.5 mg/L,去除率为85.5%;砂土中MTBE的吸附量由0.93 mg/g降至0.03 mg/g,去除率达96.4%。水平方向距GCW越近,MTBE的去除效率越快,垂直方向位于GCW上部的MTBE优先会被去除,最佳修复时间为运行15 h。GCW对砂土和地下水中高浓度MTBE具有良好的修复效果。     

Pb(II) removal from water using Fe-coated bamboo charcoal with the assistance of microwaves

Bamboo charcoal(BC) was used as starting material to prepare iron-modified bamboo charcoal(Fe-MBC) by its impregnation in FeCl 3 and HNO 3 solutions simultaneously,followed by microwave heating.The material can be used as an adsorbent for Pb(Ⅱ) contaminants removal in water.The composites were prepared with Fe molar concentration of 0.5,1.0 and 2.0 mol/L and characterized by means of N 2 adsorption-desorption isotherms,X-ray diffraction spectroscopy(XRD),scanning electron microscopy coupled with energy dispersive X-ray spectrometry(SEM-EDS),Fourier transform infrared(FT-IR) and point of zero charge(pH pzc) measurements.Nitrogen adsorption analyses showed that the BET specific surface area and total pore volume increased with iron impregnation.The adsorbent with Fe molar concentration of 2 mol/L(2Fe-MBC) exhibited the highest surface area and produced the best pore structure.The Pb(Ⅱ) adsorption process of 2Fe-MBC and BC were evaluated in batch experiments and 2Fe-MBC showed an excellent adsorption capability for removal Pb(Ⅱ).The adsorption of Pb(Ⅱ) strongly depended on solution pH,with maximum values at pH 5.0.The ionic strength had a significant effect on the adsorption at pH < 6.0.The adsorption isotherms followed the Langmuir isotherm model well,and the maximum adsorption capacity for Pb(Ⅱ) was 200.38 mg/g for 2Fe-MBC.The adsorption processes were well fitted by a pseudo second-order kinetic model.Thermodynamic parameters showed that the adsorption of Pb(Ⅱ) onto Fe-MBC was feasible,spontaneous,and exothermic under the studied conditions,and the ion exchange mechanism played an significant role.These results have important implications for the design of low-cost and effective adsorbents in the removal of Pb(Ⅱ) from wastewater.     

Photocatalytic degradation of carbofuran in TiO2 aqueous solution：Kinetics using design of experiments and mechanism by HPLC/MS/MS

The photocatalytic degradation kinetics of carbofuran was optimized by central composite design based on response surface methodology for the first time. Three variables, TiO2 concentration, initial pH value and the concentration of carbofuran, were selected to determine the dependence of degradation efficiencies on independent variables. Response surface methodology modeling results indicated that the degradation efficiency of carbofuran was highly affected by the initial pH value and the concentration of carbofuran. Then nine degradation intermediates were detected by HPLC/MS/MS. The Frontier Electron Densities of carbofuran were calculated to predict the active sites on carbofuran attacked by hydroxyl radicals and photoholes. Point charges were used to elucidate the chemisorption pattern on TiO2 catalysts during the photocatalytic process. By combining the experimental results and calculation data, the photocatalytic degradation pathways of carbofuran were proposed, including the addition of hydroxyl radicals and the cleavage of the carbamate side chain.     

低C/N条件下MUCT工艺数学模型的参数校正与验证

基于ASM2d模型建立了稳定运行的MUCT工艺营养物质去除过程的动力学反应模型,比较各种COD、TN、NH 4＋-N、TP的实测值和模拟值,以确定系统在低C/N条件下运行时的动力学和化学计量学参数.模拟结果表明,稳态模型中的动力学参数qPHA、KA、KPP、YPO3-4、μAUT和ηNO-3分别取值2.90 g.（g.d）-1、3.85 g.m-3、1.35 g.（g.d）-1、0.35、1.6和0.8.其他的动力学和化学计量学参数可采用IWA给出的默认值.     

硫酸羟胺的自加速分解温度和稳定性研究

通过快速筛选热分析试验对硫酸羟胺热危险性进行定性分析,对其热分解过程进行初步研究,获得温度、压力变化规律;再运用C80微量热仪对硫酸羟胺进行深入分析,得到硫酸羟胺的化学反应动力学参数,根据Semenov模型计算其自加速分解温度（SADT）。试验结果表明：由RSD初步筛选试验得到硫酸羟胺在164．2℃时即发生分解放热;用C80法得到硫酸羟胺的起始热分解温度为137．1℃,并计算了该物质在3种典型包装下的自加速分解温度。由SADT得到储存、运输过程中硫酸羟胺的控制温度,从而为减少硫酸羟胺事故的发生提供必要的参考数据。