BASE FLOW TRENDS IN URBANIZING WATERSHEDS OF THE DELAWARE RIVER BASIN1

Rapid land development is raising concern regarding the ability of urbanizing watersheds to sustain adequate base flow during periods of drought. Long term streamflow records from unregulated watersheds of the lower to middle Delaware River basin are examined to evaluate the impact of urbanization and imperviousness on base flow. Trends in annual base flow volumes, seven‐day low flows, and runoff ratios are determined for six urbanizing watersheds and four reference watersheds across three distinct physiographic regions. Hydrograph separation is used to determine annual base flow and stormflow volumes, and nonparametric trend tests are conducted on the resulting time series. Of the watersheds examined, the expected effects of declining base flow volumes and seven‐day low flows and increasing stormflows are seen in only one watershed that is approximately 20 percent impervious and has been subject to a net water export over the past 15 years. Both interbasin transfers and hydrologic mechanisms are invoked to explain these results. The results show that increases in impervious area may not result in measurable reductions in base flow at the watershed scale.     

高压输电系统对通信局(站)危险影响中地电流系数的确定

高压输电系统发生接地短路故障时,会产生一个地电位升,对通信局(站)会危险影响,为了计算这个危险影响的大小,首先能够准确的计算出高压输电系统的地电流系数。本文论述了高压输电系统对通信局(站)危险影响中地电流系数的确定,介绍了地电流系数的定义,并分析了不同危险情况下地电流系数的计算。     

Development of heat transfer and evaporation model of LNG covered by Hi-Ex foam

Natural gas is a kind of clean, efficient green energy source, which is used widely. Liquefied natural gas (LNG) is produced by cooling natural gas to −161 °C, at which it becomes the liquid. Once LNG was released, fire or explosion would happen when ignition source existed nearby. The high expansion foam (Hi-Ex foam) is believed to quickly blanket on the top of LNG spillage pool and warm the LNG vapor to lower the vapor cloud density at the ground level and raising vapor buoyancy. To identify the physical structure after it contacted with LN₂ and to develop heat transfer model, the small-scale field test with liquid nitrogen (LN₂) was designed. In experiment, three layers including frozen ice layer, frozen Hi-Ex layer and soft layer of Hi-Ex foam were observed at the steady state. By characterizing physical structure of the foam, formulas for calculating the surface of single foam bubble and counting foam film thickness were deduced. The micro heat transfer and evaporation model between cryogenic liquid and Hi-Ex foam was established. Indicating the physical structure of the frozen ice layer, there were a certain number of icicles below it. The heat transfer and evaporation mathematical model between the frozen ice layer and LNG was derived. Combining models above with the heat transfer between LNG, ground and cofferdam, the heat transfer and evaporation mathematical model of LNG covered by Hi-Ex foam was developed eventually. Finally, LN₂ evaporation rate calculated by this model was compared with the measured evaporation rate. The calculated results are 1.2–2.1 times of experimental results, which were acceptable in engineering and proved the model was reliable.     

供水管网铁释放的影响因素相对重要性分析

供水管网的铁释放问题近年来日益受到关注.影响供水管网铁释放的因素众多,本研究选取了pH、溶解氧(DO)、碱度(Alk)、硬度、氯离子(Cl~-)、硫酸根(SO_4~(2-))、温度(T)和水力停留时间(HRT)这8个影响因素,利用逐步回归和偏相关分析,建立了铁释放的非线性幂指数模型,并用标准化回归系数和偏相关系数比较了这些因素的相对重要性.结果表明,铁释放模型拟合效果良好;用标准化回归系数衡量影响因素相对重要性时,SO_4~(2-)、HRT、Cl~-和T是相对重要的因素,相对重要性排序为SO_4~(2-)≈HRTCl~-T;用偏相关系数衡量时,HRT、SO_4~(2-)、Alk、Cl~-和T是相对重要的因素,排序为HRTSO_4~(2-)AlkCl~-T.综合两种系数的分析结果,HRT、SO_4~(2-)和Cl~-是本研究条件下相对重要的因素,T和Alk的相对重要性视实际情况变动.     

成都市污染边界层高度的演变特征分析

基于2014年1月21日至2月5日成都市人民南路四段逐时PM_(2.5)质量浓度、大气能见度资料以及同期Mie散射激光雷达探测数据,遵循消光系数与细颗粒物质量浓度之间的关系,探讨污染边界层高度的演变特征。结果表明:污染时段内的污染边界层高度偏低,平均为221m;污染边界层高度与地面PM_(2.5)浓度的变化具有明显相关性,但污染边界层高度改变在前,地面PM_(2.5)浓度响应在后;污染边界层高度的日变化表现为单峰单谷型,峰值和谷值分别出现在08:00时和14:00时前后。     

MDEA水溶液膜法天然气脱硫的试验研究

以新配和含有一定H_2S的MDEA溶液为吸收液,以聚偏氟乙烯(PVDF)膜组件为接触器,通过对操作参数的调节和改变膜孔大小等方法对脱硫率和总传质系数进行研究。结果表明:气液压力差以及膜孔孔径的增加均有利于脱硫率和总传质系数的提升,即均有利于脱硫。降低进气流量和低气液比均对H_2S传质有积极作用。     

金属尖化前缘模型主动式热疏导性能试验研究

目的为了更好地解决高超声速飞行器舵、翼前缘及头锥等气动热环境恶劣区域的热防护问题。方法采用主动式热疏导技术,以高温液态合金为工质,设计并制作具有主动式热疏导功能的尖化前缘金属试验模型(R=5 mm)。根据模型外尺寸设计加工一套石英灯仿形加热器和热流测试模型,开展地面热环境模拟试验。结果试件在前缘中心温度530℃左右时具有瞬态启动特性。前缘中心和大面积中心最大辐射热流密度分别为1000 kw/m^2和580 kw/m^2,试件在该环境中长时间受热状态下仍具有较好的热疏导能力。试验后试件无工质泄漏和结构破坏,具有一定的可重复使用性。结论可以此热疏导方式结合现有成熟热防护技术进一步开展工程设计与应用。     

极低风速条件下水-气界面甲烷气体传输速率分析

薄边界层理论被广为用来计算水-气界面气体通量,而气体传输速率(k600)则是其中的关键性环境因子.为了研究极低风速下小型浅水湿地水-气界面甲烷气体传输速率,以宜昌饮用水水库梅子垭水库和周邻5个富营养化池塘为研究对象,采用静态通量箱进行了为期一年的水-气界面甲烷气体通量观测,同步监测了水环境因子和气象因子.野外监测时的风速(U10)范围为0~0.75 m·s~(-1),平均值约为0.19 m·s~(-1);水温(Tw)变化范围为6.3~30.9℃,平均值约为19.3℃.结果表明,梅子垭水库和周边5个池塘水-气界面甲烷气体传输速率较小,在0.20~1.99 cm·h~(-1)之间变化,平均值约为0.50 cm·h~(-1).本研究利用表层水温和风速指标两个参数的双二次项模型和二次项加幂函数模型,回归得到了气体传输速率的数学公式,回归结果与原始数据和对k600进行深度平均(bin-averaged)后的数据均存在极显著性关系.     

好氧颗粒污泥沉降选择实验研究与定量描述

以序批式反应器培养的成熟好氧颗粒污泥为对象,研究沉淀高度对颗粒数、比重、污泥浓度、粒径分布及选择系数的影响.结果表明,随着沉淀高度的增加,污泥浓度在沉淀时间为30 s时由0.24 mg.L-1明显增加至6.07 mg.L-1,平均粒径从450μm增加到550μm,颗粒圆形度增加12.67%,而复杂度减小13.47%,说明粒径较大、形状较规则的颗粒沉降较快,从而更易在沉降选择过程中得以保留.根据选择压原理,结合颗粒污泥沉降实验结果引入选择系数.实验和计算结果显示,在任意沉淀高度,选择系数随粒径和密度的增大而增加.随着沉淀高度的增加,直径>600～800μm的颗粒选择系数增加,小颗粒趋势与之相反,说明增大排水比有利于大颗粒保留而絮体被筛选出反应器,而低的排水比会使污泥颗粒化过程放缓.该研究结果可望对加速污泥颗粒化过程和提高其稳定性提供科学的理论依据和指导.     

基于转运站满负荷的北京市新东西城区生活垃圾物流优化方案研究

北京市新东城和新西城成立后迫切需要对现有生活垃圾物流方案进行优化,实现生活垃圾资源化处理.以北京市东西城区生活垃圾为研究对象,利用统计预测模型和GIS空间分析技术与方法,在分析了4个老城区生活垃圾产生量及所属密闭清洁站垃圾流向和流量基础上,提出了基于满负荷运行的三大转运站(马家楼、小武基和大屯)生活垃圾等距离收集运输优化物流模式,分析了现状及新物流模式下生活垃圾物料平衡.结果表明,与现状收集模式相比,等距离优化物流模式可使清运距离减少约9.3×105km.a-1,与现状相比减少10%;同时,基于三大转运站满负荷运转的,部分考虑海淀、丰台和朝阳区跨区运行的生活垃圾优化物流模式下,且充分利用现有的处理处置设施,可减少原生垃圾填埋量约28.3%.在优化模式的基础上若北京市正筹建的3座垃圾焚烧厂建成后,可使新东西城区生活垃圾焚烧、生化、填埋比例由现状1∶4.8∶4.2,达到3.8∶4.5∶1.7,可基本接近北京市2015年生活垃圾焚烧、堆肥和填埋比例达到4∶3∶3规划目标.