好氧亚硝化颗粒污泥特性的研究

对在小试曝气上流式污泥床反应器中成功培养出的好氧亚硝化颗粒污泥的特性进行了研究.工艺稳定运行时,亚硝化颗粒污泥的VSS/SS稳定在80%左右,粒径大于1.0 mm的颗粒污泥约占总数的70%,粒径大于0.8 mm的颗粒污泥的湿密度约为1?022 kg/m³.荧光原位杂交结果表明,亚硝化细菌主要分布在颗粒污泥的表层,而硝化细菌则分布在表层之下;最大可能数结果显示,亚硝化工艺稳定运行时亚硝化细菌的数量远多于硝化细菌,甚至可高于硝化细菌4个数量级以上.上述结果表明,硝化细菌（AOB和NOB）以接种的产甲烷颗粒污泥或其碎片为载体,通过在其表层附着生长,最终形成好氧亚硝化颗粒污泥.     

基于视频分析的人群密集场所客流监控预警研究

为实现人群密集场所客流安全隐患早发现,辅助管理人员早决策,人群聚集风险区早疏散,提升对灾难的预见性和主动性。在国内外人群异常聚集监测预警现状分析基础上,对比分析得出监控视频分析技术是解决人群密集场所精准预警难题较为理想的解决方案;构建以视频智能分析的人群计数、密度估计、行人追踪、活动烈度识别为核心技术的人群密集场所风险预警技术框架;将该技术框架应用到某大型商圈的商业街区,获得监控区域内的人群总数、密度分布、行人轨迹和异常活动等特征。结果表明:提出的基于视频分析的人群密集场所风险预警技术框架可为城市大型商圈、交通枢纽、大型活动场所等城市公共场所的安全管理提供参考和借鉴。     

二氧化碳水合物储气特性的实验研究

利用二氧化碳水合物小型实验装置分别在恒容和恒压条件下,研究了机械搅拌对二氧化碳气体溶解的影响以及温度与水-气比对二氧化碳水合物形成和储气密度的影响。通过实验结果发现,机械搅拌对二氧化碳的溶解有非常明显的促进作用,可以在3 min内完成溶解过程,促进溶解作用好于添加剂SDS。研究还发现,反应温度越低,二氧化碳水合物的生成速率越快,总的储气量越大,而水-气比越大,储气密度越小。在实验压力3 MPa、反应温度273.55 K的条件下,1体积的水生成水合物后可储存157体积的二氧化碳。     

中国城镇建设用地经济密度的区位差异及影响因素——基于273个地级及以上城市的分析

以全国地级及以上城市中的273个样本城市为研究对象,分别从全国、沿海地区、内陆地区三个层次考察了样本城市城镇建设用地经济密度的区位差异。根据柯布-道格拉斯生产函数的理论与分析方法建立模型,分析了资本、劳动力、土地三大投入要素和城市全要素生产率等对城镇建设用地的影响,并在控制以上变量的条件下侧重考察了城市区位差异的影响。发现我国城镇建设用地经济密度的区位差异明显,具有区位优势的城市土地效益平均高于缺乏区位优势的城市;沿海水陆口岸的区位优势十分显著,建设用地经济密度相对较高,而内陆地区水陆口岸的区位优势有待发掘;航空口岸对提高城镇建设用地经济密度未发挥积极作用。分析结果表明,生产要素投入、科技水平、市场环境和城市发展阶段是影响土地效益的主要因素,但不同区位条件下城镇建设用地经济密度的影响因素有所不同,为提高城镇建设用地经济密度,不同区位条件的城市着力点应各有侧重。     

Inverse modeling of Asian Rn flux using surface air Rn concentration

When used with an atmospheric transport model, the ²²²Rn flux distribution estimated in our previous study using soil transport theory caused underestimation of atmospheric ²²²Rn concentrations as compared with measurements in East Asia. In this study, we applied a Bayesian synthesis inverse method to produce revised estimates of the annual ²²²Rn flux density in Asia by using atmospheric ²²²Rn concentrations measured at seven sites in East Asia. The Bayesian synthesis inverse method requires a prior estimate of the flux distribution and its uncertainties. The atmospheric transport model MM5/HIRAT and our previous estimate of the ²²²Rn flux distribution as the prior value were used to generate new flux estimates for the eastern half of the Eurasian continent dividing into 10 regions.The ²²²Rn flux densities estimated using the Bayesian inversion technique were generally higher than the prior flux densities. The area-weighted average ²²²Rn flux density for Asia was estimated to be 33.0 mBq m⁻² s⁻¹, which is substantially higher than the prior value (16.7 mBq m⁻² s⁻¹). The estimated ²²²Rn flux densities decrease with increasing latitude as follows: Southeast Asia (36.7 mBq m⁻² s⁻¹); East Asia (28.6 mBq m⁻² s⁻¹) including China, Korean Peninsula and Japan; and Siberia (14.1 mBq m⁻² s⁻¹). Increase of the newly estimated fluxes in Southeast Asia, China, Japan, and the southern part of Eastern Siberia from the prior ones contributed most significantly to improved agreement of the model-calculated concentrations with the atmospheric measurements. The sensitivity analysis of prior flux errors and effects of locally exhaled ²²²Rn showed that the estimated fluxes in Northern and Central China, Korea, Japan, and the southern part of Eastern Siberia were robust, but that in Central Asia had a large uncertainty.     

Determination of specific gravity of municipal solid waste

This investigation was conducted to evaluate experimental determination of specific gravity (G_s) of municipal solid waste (MSW). Water pycnometry, typically used for testing soils was adapted for testing MSW using a large flask with 2000 mL capacity and specimens with 100–350 g masses. Tests were conducted on manufactured waste samples prepared using US waste constituent components; fresh wastes obtained prior and subsequent to compaction at an MSW landfill; and wastes obtained from various depths at the same landfill. Factors that influence specific gravity were investigated including waste particle size, compaction, and combined decomposition and stress history. The measured average specific gravities were 1.377 and 1.530 for as-prepared/uncompacted and compacted manufactured wastes, respectively; 1.072 and 1.258 for uncompacted and compacted fresh wastes, respectively; and 2.201 for old wastes. The average organic content and degree of decomposition were 77.2% and 0%, respectively for fresh wastes and 22.8% and 88.3%, respectively for old wastes. The G_s increased with decreasing particle size, compaction, and increasing waste age. For fresh wastes, reductions in particle size and compaction caused occluded intraparticle pores to be exposed and waste particles to be deformed resulting in increases in specific gravity. For old wastes, the high G_s resulted from loss of biodegradable components that have low G_s as well as potential access to previously occluded pores and deformation of particles due to both degradation processes and applied mechanical stresses. The G_s was correlated to the degree of decomposition with a linear relationship. Unlike soils, the G_s for MSW was not unique, but varied in a landfill environment due both to physical/mechanical processes and biochemical processes. Specific gravity testing is recommended to be conducted not only using representative waste composition, but also using representative compaction, stress, and degradation states.     

基于网格划分的宜兴市区滨水区可达性评价

城市滨水区可达性不仅仅是空间距离的阻隔,还包括人们对滨水空间的需求及滨水区自身对公众的吸引力。依据潜能模型的概念,选取人口密度、滨水区综合质量和以土地利用表达的交通作为评价因子,借助ArcGIS93软件,建立了基于网格划分的滨水区可达性计算模型。该模型通过对研究区域进行等距网格划分以及定量计算网格内的人口密度、最小阻力成本和滨水区综合质量来进行滨水区可达性的定量评价。运用该模型评价了宜兴市中心城区居民至各滨水区的可达性水平,发现各滨水区平均可达性水平存在明显差异,最高的是团氿,最低的是蠡河;对每个滨水区而言,可达性从空间上均呈现出以滨水区为中心由内向外递减的趋势。评价结果可为城市滨水区合理建设格局的制定和居民享用滨水区的公平性提供决策参考     

江苏阳澄湖螺类群落的空间分布格局

2008年1月～2009年10月对江苏阳澄湖螺类群落结构进行了季节调查研究。共采集到螺类4科5属6种,优势种为铜锈环棱螺,次优种为长角涵螺。阳澄湖螺类平均密度为220±47 ind./m2,平均生物量为2331±469 g/m2,螺类密度和生物量在年际和季节间均无明显差异,但群落结构存在显著的空间变化,密度在东湖区和中华绒螯蟹围网养殖区较大、西湖区最小,生物量围网养殖区最高、西湖区最低;铜锈环棱螺密度围网养殖区最高、西湖区最低,长角涵螺密度东湖区最高、围网养殖区次之、入湖河流及其它湖区极低。中华绒螯蟹养殖未导致围网养殖区螺类数量下降,螺类（主要是铜锈环棱螺）的投放可能是该区螺类密度、生物量及铜锈环棱螺所占比例较高的主要原因之一。逐步回归分析表明,水深是影响螺类群落整体密度和生物量空间分布差异的主要因子;典型对应分析（CCA）表明,铜锈环棱螺主要分布在叶绿素a较高的水域,而长角涵螺和纹沼螺则主要分布在透明度较大的地方     

生物滴滤塔处理模拟甲硫醚废气

在常温条件下,采用生物滴滤塔处理模拟甲硫醚废气,考察了气体空床停留时间(EBRT)、容积负荷、喷淋密度及营养液pH对生物滴滤塔性能的影响。实验结果表明:当EBRT为90 s、进气甲硫醚质量浓度为150 mg/m~3、喷淋密度为0.65 m~3/(m~2·h),营养液pH为6.8时,甲硫醚去除率为90%;容积负荷高于15 g/(m~3·h)时,对生物滴滤塔的性能产生抑制作用;EBRT为90 s及60 s时,最佳喷淋密度分别为0.56~0.65 m~3/(m~2·h)及0.65~0.75 m~3/(m~2·h);降解甲硫醚的微生物对pH的变化较敏感,最适营养液pH为6~7。     

Microbial fuel cells: Advances in electrode modifications for improvement of system performance

There is an increasing trend to conduct the researches related to Microbial Fuel Cells (MFCs) in the recent years. Limited power output has been the major obstacle for the practical application and upscaling of MFCs. Attempts have been made on electrode modifications such as anode treatments, cathode modifications with catalysts and bio cathodes developments to produce varying degrees of improved output current depending upon the types of modifications. Power density and Coulombic efficiency have been considered as the important parameters to analyze the system performances. This paper overviews on the advances made in MFCs’ researches focusing on different types of electrodes modifications along with the involved methodology. Furthermore, the system performances of different modified MFCs are compared in terms of the power density and the Coulombic efficiency.