衡水市空气主要污染物体积质量的时间分布特征

利用衡水市环境监测站2005—2007年度大气例行检测的数据,对衡水市大气中主要污染物SO^2、NO^2、PM10体积质量值的逐日数据进行统计分析,得出了衡水市空气污染的现状和时间变化规律：（1）污染物体积质量值的月变化曲线呈槽型分布,非取暖期的空气状况明显好于取暖期,取暖期SO^2平均体积质量是非取暖期的2．45倍;（2）污染物体积质量值的日变化曲线基本为两高两低型,其中取暖期污染指数早晨出现极高值的时间比非取暖期明显偏晚;（3）污染物体积质量值的年变化表明了SO^2的体积质量在降低,而NO^2的体积质量却有了小幅增长。     

自动喷水灭火系统喷水强度概率分布特性及其控火性能研究

喷水强度是体现自动喷水灭火系统控火能力的重要参数,具有不均匀性和不确定性.传统的喷水强度设计主要考虑喷头的流量和保护面积,没有考虑其分布特性,对系统控火性能的影响.因此本文将喷水强度分布特性引入自动喷水灭火系统的控火性能研究.以公称口径为15 mm的传统下垂型玻璃球洒水喷头的喷水强度分布实验为基础,建立了包含径向距离和喷头工作压力等参数的喷水强度分布模型,采用蒙特卡罗方法获得了喷水强度的概率分布特性.参照不同危险等级场控火所需的喷水强度参数和不同喷头开启个数下的有效控火百分比,分析了喷水强度概率分布特性对控火性能的影响.研究结果表明,喷水强度概率分布特性对控火性能有重要影响,随径向距离的增加,喷水强度出现较小值的概率增大,控火性能下降,在某些危险较大的场所不能达到控火作用.对于同一危险等级场所,控火性能随着喷头安装间距减小而增强.研究方法可为合理评估喷头适用范围、优化喷头布置提供参考.     

吸收液pH值对锌合金白烟处理效果的影响

为了治理同时含有气态和粒状污染物的锌合金白烟,采用填料塔对其进行洗涤和吸收,考察了吸收液的pH值以及喷淋密度对锌合金白烟处理效果的影响,并根据碱洗和酸洗的特点,考察了碱酸两级处理的效果.结果显示,吸收液的喷淋密度与氯化铵烟尘、氯化氢和氨的处理效率成正比.吸收液的pH值也会影响白烟的处理效果,主要是通过吸收液与污染物之间的化学反应来进行,碱洗时氯化铵烟尘和氯化氢获得了较高的处理效率,但碱洗过程有氨生成,限制其应用;酸洗对氨的处理效率较高,但氯化铵烟尘和氯化氢的处理效率都比较低,达不到国家排放标准.尽管对锌白烟的处理效果还不理想,但试验结果对于锌白烟的治理具有重要的参考价值和指导意义.     

Processing and Properties of Mixtures of PHB-V with Post-consumer LDPE

Mixtures of poly-β-(hydroxybutyrate-co-valerate) PHB-V with virgin and post-consumer low density polyethylene (LDPE) were prepared by melt mixing in proportions of 100/0, 90/10, 80/20, 70/30 and 0/100 (wt/wt%). The mixtures were analysed by infrared spectroscopy, differential scanning calorimetry (DSC), dynamic mechanical thermal analysis (DMTA), melting flow index (MFI), tensile tests, scanning electron microscopy (SEM) and biodegradation in simulated soil. The DMTA and DSC curves of post-consumer LDPE suggested that this polymer was a mixture of LDPE and linear low density polyethylene (LLDPE). Virgin and post-consumer LDPE had lower MFI than PHB-V, but the blends showed higher index as the content of LDPE increased. The addition of LDPE reduced the tensile strength and Young’s modulus of the mixtures compared with PHB-V. SEM indicated poor interfacial adhesion between PHB-V and LDPE. PHB-V degraded slow and gradually, while both LDPE showed virtually no degradation under the conditions studied. The biodegradability of the blends depended on their composition and of the type of LDPE. LDPE improved the biodegradability of the mixtures.     

飞播马尾松林生物产量及生产力研究

湘乡市16年生不同密度的马尾松(Pinus massoniana)飞播林林分单株生物量随密度的增加而明显减小,低密度林分是高密度林分的2 42倍,高出18.33kg;当林分密度一定后,林分生物量同样随密度的增加而减小,低密度林分比高密度林分高出21.81t/hm2。林分各组生物量随密度增大而减小,并出现W>W根>W枝>W皮>W叶的规律。年均净生长量低密度林分是高密度林分的1.40倍。     

典型湖泊水华特征及相关影响因素分析

通过2011-2015年对太湖、巢湖和滇池水华高发季节的连续监测,以藻类密度和水华面积为判据评价了3个湖体的水华情况及变化趋势,探讨了水华发生的主要影响因素。结果表明：太湖水华程度以"轻度水华"为主,巢湖水华程度以"轻微水华"为主,滇池水华程度以"中度水华"为主;太湖、巢湖和滇池水华规模均以"零星性水华"为主;太湖和巢湖藻类密度与水温、pH、溶解氧、总氮、总磷和高锰酸盐指数均呈显著正相关,与透明度呈显著负相关,与氨氮无显著相关性;滇池藻类密度与水温、总磷和高锰酸盐指数均呈显著正相关,与透明度和氨氮呈显著负相关,与pH、溶解氧和总氮无显著相关性。     

生物滴滤塔处理模拟甲硫醚废气

在常温条件下,采用生物滴滤塔处理模拟甲硫醚废气,考察了气体空床停留时间(EBRT)、容积负荷、喷淋密度及营养液pH对生物滴滤塔性能的影响。实验结果表明:当EBRT为90 s、进气甲硫醚质量浓度为150 mg/m~3、喷淋密度为0.65 m~3/(m~2·h),营养液pH为6.8时,甲硫醚去除率为90%;容积负荷高于15 g/(m~3·h)时,对生物滴滤塔的性能产生抑制作用;EBRT为90 s及60 s时,最佳喷淋密度分别为0.56~0.65 m~3/(m~2·h)及0.65~0.75 m~3/(m~2·h);降解甲硫醚的微生物对pH的变化较敏感,最适营养液pH为6~7。     

Microbial fuel cells: Advances in electrode modifications for improvement of system performance

There is an increasing trend to conduct the researches related to Microbial Fuel Cells (MFCs) in the recent years. Limited power output has been the major obstacle for the practical application and upscaling of MFCs. Attempts have been made on electrode modifications such as anode treatments, cathode modifications with catalysts and bio cathodes developments to produce varying degrees of improved output current depending upon the types of modifications. Power density and Coulombic efficiency have been considered as the important parameters to analyze the system performances. This paper overviews on the advances made in MFCs’ researches focusing on different types of electrodes modifications along with the involved methodology. Furthermore, the system performances of different modified MFCs are compared in terms of the power density and the Coulombic efficiency.     

光/电法氨氮降解过程中协同作用的研究

为了研究光/电法在氨氮降解过程中的协同作用,采用光/电法降解模拟工业循环冷却水中的氨氮,并对氨氮降解过程中的各影响因素进行了研究,考察了氯离子浓度和溶液p H对降解效率的影响。结果表明,与传统的光催化法和电化学法相比,光/电法在氨氮降解过程中存在良好的协同效应,因而具有更高的氨氮去除率,这主要归功于溶液氯离子的促进作用。另外,在酸性条件下,氨氮降解效率得到进一步加强。当p H在4~5之间,电流密度为10 m A/cm2,Na Cl浓度为100 mg/L时,在经过90 min光/电法处理后氨氮去除率高达95%,且N2占总氨氮降解产物的84.2%。     

Determination of specific gravity of municipal solid waste

This investigation was conducted to evaluate experimental determination of specific gravity (G_s) of municipal solid waste (MSW). Water pycnometry, typically used for testing soils was adapted for testing MSW using a large flask with 2000 mL capacity and specimens with 100–350 g masses. Tests were conducted on manufactured waste samples prepared using US waste constituent components; fresh wastes obtained prior and subsequent to compaction at an MSW landfill; and wastes obtained from various depths at the same landfill. Factors that influence specific gravity were investigated including waste particle size, compaction, and combined decomposition and stress history. The measured average specific gravities were 1.377 and 1.530 for as-prepared/uncompacted and compacted manufactured wastes, respectively; 1.072 and 1.258 for uncompacted and compacted fresh wastes, respectively; and 2.201 for old wastes. The average organic content and degree of decomposition were 77.2% and 0%, respectively for fresh wastes and 22.8% and 88.3%, respectively for old wastes. The G_s increased with decreasing particle size, compaction, and increasing waste age. For fresh wastes, reductions in particle size and compaction caused occluded intraparticle pores to be exposed and waste particles to be deformed resulting in increases in specific gravity. For old wastes, the high G_s resulted from loss of biodegradable components that have low G_s as well as potential access to previously occluded pores and deformation of particles due to both degradation processes and applied mechanical stresses. The G_s was correlated to the degree of decomposition with a linear relationship. Unlike soils, the G_s for MSW was not unique, but varied in a landfill environment due both to physical/mechanical processes and biochemical processes. Specific gravity testing is recommended to be conducted not only using representative waste composition, but also using representative compaction, stress, and degradation states.