喷涂车间卫生防护距离计算方法探讨

无组织废气排放对环境危害较大,目前,无组织废气排放的卫生防护距离的计算主要以国家标准方法(GB/T 13201-91)为主,但该方法存在一定的缺陷。以机械加工企业中常见的涂装车间无组织废气排放为研究对象,分别研究国家标准计算模式、线源扩散模式、面源扩散模式等三种不同的卫生防护距离计算方法,讨论不同卫生防护距离计算公式的差异,为企业选址和总图布置提供科学依据。     

离子色谱法测定无组织废气中溴化氢浓度

探讨无组织废气中溴化氢的测定方法。采样方法参照环境空气中氯化氢的采样方法,用淋洗液做吸收液,用大型气泡吸收管作收集器,点位设置按照《大气污染物综合排放标准(》GB16297-1996)附录C给出的无组织排放监控点设置方法进行;分析方法使用离子色谱法测定,分离度较高,相对标准偏差为1.7%～1.9%,加标回收率为93.8%～97.6%,溴离子的检测限为0.02μg/ml,当采样体积为60 L时,无组织废气中溴化氢的检出限为0.003 mg/m3。     

臭气浓度无组织排放现场监测中常见问题的探讨

目前恶臭污染源排气及环境空气样品臭气浓度的测定一般采用三点比较式臭袋法。该方法侧重于臭气样品的实验室分析,对样品的现场采集部分未作具体要求。本文针对臭气浓度无组织排放现场监测中的常见问题,尤其是现有标准和规范中未明确的内容,从排放源的确认、生产工况的监督、气象条件的选择、监控点位的设置、监测频次的选择以及现场原始记录等方面进行了探讨,结合多年现场监测工作实践,提出了一些解决办法,使现场监测工作更具规范性和有效性。     

Reversibly enhanced aqueous solubilization of volatile organic compounds using a redox-reversible surfactant

Surfactant-enhanced remediation (SER) is an effective method for the removal of volatile organic compounds (VOCs) from contaminated soils and groundwater. To reuse the surfactant the VOCs must be separated from the surfactant solutions. The water solubility of VOCs can be enhanced using reversible surfactants with a redox-acive group, (ferrocenylmethyl)dodecyldimethylammonium bromide (Fcl2) and (ferrocenylmethyl)tetradecanedimethylammonium bromide (Fcl4), above and below their critical micelle concentrations (CMC) under reducing (I⁺) and oxidative (I²⁺) conditions. The CMC values of Fcl2 and Fcl4 in I⁺ are 0.94 and 0.56 mmol/L and the solubilization of toluene by Fcl2 and Fcl4 in I⁺ for toluene is higher than the solubilization achieved with sodium dodecyl sulfate, cetyltrimethylammonium bromide and Trition X-114. The solubilization capacity of the ferrocenyl surfactants for each tested VOCs ranked as follows: ethylbenzene > toluene > benzene. The solubilities of VOCs by reversible surfactant in I⁺ were 30% higher than those in I²⁺ at comparable surfactant concentrations. The effects of Fcl4 concentrations on VOCs removal efficiency were as follows: benzene > toluene > ethylbenzene. However, an improved removal efficiency was achieved at low ferrocenyl surfactant concentrations. Furthermore, the reversible surfactant could be recycled through chemical approaches to remove organic pollutants, which could significantly reduce the operating costs of SER technology.     

低温等离子体-催化协同降解挥发性有机废气

低温等离子体-催化协同技术适合于各类挥发性有机物的治理,特别是大气量低浓度的有机废气的处理.高效催化剂的加入可 以显著提高等离子体反应中有机废气的降解效率,减少有害副产物的生成以及提高反应器的能量利用率.从反应器、催化剂以及背景气体等方面探讨了该技术实现产业化需要解决的问题,结合低温等离子体与催化剂的相互作用、等离子体...     

Effects of metal and acidic sites on the reaction by-products of butyl acetate oxidation over palladium-based catalysts

Catalytic oxidation is widely used in pollution control technology to remove volatile organic compounds. In this study, Pd/ZSM-5 catalysts with different Pd contents and acidic sites were prepared via the impregnation method. All the catalysts were characterized by means of N2 adsorption- desorption, X-ray fluorescence （XRF）, HE temperature programmed reduction （H2-TPR）, and NH3 temperature programmed desorption （NH3-TPD）. Their catalytic performance was investigated in the oxidation of butyl acetate experiments. The by-products of the reaction were collected in thermal desorption tubes and identified by gas chromatography/mass spectrometry. It was found that the increase of Pd content slightly changed the catalytic activity of butyl acetate oxidation according to the yield of CO2 achieved at 90%, but decreased the cracking by-products, whereas the enhancement of strong acidity over Pd-based catalysts enriched the by-product species. The butyl acetate oxidation process involves a series of reaction steps including protolysis, dehydrogenation, dehydration, cracking, and isomerization. Generally, butyl acetate was cracked to acetic acid and 2- methylpropene and the latter was an intermediate of the other by-products, and the oxidation routes of typical by-products were proposed. Trace amounts of 3-methylpentane, hexane, 2-methylpentane, pentane, and 2-methylbutane originated from iso4merization and protolysis reactions.     

Unregulated emissions from diesel engine with particulate filter using Fe-based fuel borne catalyst

The alteration and formation of toxic compounds and potential changes in the toxicity of emissions when using after-treatment technologies have gained wide attention. Volatile organic compound（VOC）, carbonyl compound and particle-phase polycyclic aromatic hydrocarbon（PAH） emissions were tested at European Steady State Cycle（ESC） to study unregulated emissions from a diesel engine with a fuel-borne catalyst and diesel particulate filter（FBC–DPF）. An Fe-based fuel-borne catalyst was used for this study. According to the results, brake specific emissions of total VOCs without and with DPF were 4.7 and4.9 mg/kWh, respectively, showing a 4.3% increase. Benzene and n-undecane emissions increased and toluene emission decreased, while other individual VOC emissions basically had no change. When retrofitted with the FBC–DPF, total carbonyl compound emission decreased 15.7%, from 25.8 to 21.8 mg/kWh. The two highest carbonyls, formaldehyde and acetaldehyde, were reduced from 20.0 and 3.7 to 16.5 and 3.3 mg/kWh respectively. The specific reactivity（SR） with DPF was reduced from 6.68 to 6.64 mg/kWh. Total particle-phase PAH emissions decreased 66.4% with DPF compared to that without DPF. However, the Benzo[a]pyrene equivalent（BaPeq） with DPF had increased from 0.016 to 0.030 mg/kWh.Fluoranthene and Pyrene had the greatest decrease, 91.1% and 88.4% respectively. The increase of two- and three-ring PAHs with DPF indicates that the fuel-borne catalyst caused some gas-phase PAHs to adsorb on particles. The results of this study expand the knowledge of the effects of using a particulate filter and a Fe-based fuel-borne catalyst on diesel engine unregulated emissions.     

化学合成类制药行业工艺废气VOCs排放特征与危害评估分析

以浙江台州6家典型化学合成类制药企业为代表,对其排放工艺废气中的18项挥发性有机物(VOCs)特征污染物(如甲苯、甲醛、二氯甲烷等)进行监测和分析,并采用臭氧产生潜力(OFP)和健康风险评价指标对VOCs所产生的环境与健康危害进行初步的评价.结果表明,化学合成类制药企业排放的总VOCs浓度为14.9~308.6 mg·m-3,其产生环境危害的OFP值为3.1~315.1 mg·m-3,主要贡献物质为甲苯、四氢呋喃、乙酸乙酯等6种物质,存在较大的潜在环境危害.另外,健康危害中的非致癌风险指数和总致癌风险指数介于9.48×10-7~4.98×10-4a-1和3.17×10-5~6.33×10-3之间,主要是苯、甲醛和二氯甲烷这3种致癌物.     

大连星海地区环境空气中挥发性有机物的臭氧生成潜势研究

以该实验的观测资料为基础,通过数据分析表明,对大连星海地区OH自由基消耗的主要环境VOCs组分是烯烃类物质,对O3生成潜势贡献最高的环境VOCs组分是芳香烃类物质;综合LiOH及OFP值评价,识别影响大连星海地区O3生成的关键环境VOCs反应活性物种为丙烯、甲苯、间对二甲苯等物质。     

Field monitoring of volatile organic compounds using passive air samplers in an industrial city in Japan

Highly portable, sensitive, and selective passive air samplers were used to investigate ambient volatile organic compound (VOC) levels at multiple sampling sites in an industrial city, Fuji, Japan. We determined the spatial distributions of 27 species of VOCs in three campaigns: Mar (cold season), May (warm season), and Nov (mild season) of 2004. In all campaigns, toluene (geometric mean concentration, 14.0microg/m3) was the most abundant VOC, followed by acetaldehyde (4.76microg/m3), and formaldehyde (2.58microg/m3). The spatial distributions for certain VOCs showed characteristic patterns: high concentrations of benzene and formaldehyde were typically found along major roads, whereas high concentrations of toluene and tetrachloroethylene (PCE) were usually found near factories. The spatial distribution of PCE observed was extremely consistent with the diffusion pattern calculated from Pollutant Release and Transfer Register data and meteorological data, indicated that passive air samplers are useful for determining the sources and distributions of ambient VOCs.