Does the Temporal Resolution of Precipitation Input Influence the Simulated Hydrological Components Employing the SWAT Model?

This study aimed to evaluate the influence of sub‐daily precipitation time steps on model performance and hydrological components by applying the Green and Ampt infiltration method using the Soil and Water Assessment Tool (SWAT). Precipitation was measured at a resolution of 0.1 mm and aggregated to 5‐, 15‐, 30‐, and 60‐min time steps. Daily discharge data over a 10‐year period were used to calibrate and validate the model. Following a global sensitivity analysis, relevant parameters were optimized through an automatic calibration procedure using SWAT‐CUP for each time step. Daily performance statistics were almost equal among all four time steps (NSE ≈ 0.47). Discharge mainly consisted of groundwater flow (55%) and tile flow (42%), in reasonable proportions for the investigated catchment. In conclusion, model outputs were almost identical, showing simulations responded nearly independently of the chosen precipitation time step. This held true for (1) the selection of sensitive parameters, (2) performance statistics, (3) the shape of the hydrographs, and (4) flow components. However, a scenario analysis revealed that the precipitation time step becomes important when saturated hydraulic conductivities are low and curve numbers are high. The study suggests that there is no need in using precipitation time steps <1 h for lowland catchments dominated by soils with a low surface runoff potential if daily flow values are being considered. Editor's note : This paper is part of the featured series on SWAT Applications for Emerging Hydrologic and Water Quality Challenges. See the February 2017 issue for the introduction and background to the series.     

The multifunctionality of urban farming: perceived benefits for neighbourhood improvement

Urban farming – a type of urban agriculture focused on entrepreneurial food production – serves multiple functions in neighbourhoods; yet these are not well delineated. Expectations for urban farming often centre on traditional measures of economic development, potentially overlooking other benefits. Through a qualitative case study conducted in Baltimore, Maryland, we sought to understand community perceptions regarding the ways in which urban farms can benefit cities. Interviews with residents, neighbourhood leaders, and urban farmers in three residential neighbourhoods with urban farms revealed the pathways by which community members view farms as improving neighbourhoods. Benefits stemmed from four primary changes urban farms made to study neighbourhoods: creation of public projects welcoming involvement, physical improvement of degraded space, production of local food, and creation of new businesses. These changes led to multiple perceived benefits including increased social connectedness, a transformed physical landscape, improved neighbourhood reputation, increased access to fresh produce, and educational, youth development, and employment opportunities. Our findings demonstrate the importance of a multifunctional paradigm that accounts for social and educational functions in assessing the value of urban farming and bring empirical evidence to the concept of multifunctional agriculture. Urban farms with strong social aims may appear to contribute little to economic development if measured using traditional indicators of success such as job creation or fiscal impacts, but provide numerous other benefits for community development.     

乌鲁木齐市不同区域大气降尘中重金属污染及来源分析

为进一步了解城市不同区域间大气降尘中重金属含量及其差异性,沿城市走向梯度布设降尘采样点采集样品。采用电感耦合等离子体原子发射光谱(ICP-AES)仪测定样品中Cu、Cr、Mn、Fe、Ni、Zn、Cd、Pb和As等重金属含量,并计算富集因子来判断不同区域间的污染源类型,通过因子分析方法探讨污染的来源。结果显示,所测重金属元素中除Mn外,均受到人为源的影响,且十分严重。从贡献率来看,不同区域间第一因子的贡献率虽有差异,但均为来自土壤的风沙扬尘造成;第二因子的贡献率也不尽相同,主要是燃煤产生的污染;第三因子出现了差异,市南区和市北区主要是受金属冶炼的影响,而市中区的影响可能来自垃圾焚烧;市南区未出现第四因子,而市中区和市北区的污染源也不相同。分析表明,城市大气降尘污染依然严重,做好防控风沙和建筑扬尘,减少煤炭消耗,调整能源结构和产业布局是整体减少大气降尘的关键。     

A2O-MBR工艺处理城市污Z作农业灌溉用水中试研究

为开发一种污水再生利用于农田灌溉领域的新型技术,本实验以城市污水为研究对象,采用A2O—MBR工艺进行中试研究,并将系统出水水质与《农田灌溉水质标准（GB5084—2005）》的主要水质指标进行对比分析。结果表明,系统COD和BOD,出水浓度范围分别为3．2～59．6mg／L、1．0～7．6mg／L,系统出水pH为7．16～7．54,悬浮物浓度几乎为0,上述指标均符合标准;TP、TN和氨氮的出水范围分别为0．03～0．79mg／L、1．6～17．7mg／L和0．8～10．3mg／L。《农田灌溉水质标准》没有对上述3个指标提出具体要求,且少量的氮磷是植物生长的营养元素。该系统出水的主要水质指标符合标准兽求．     

高效脱硫菌的筛选及其性能研究

从高硫污染的活性污泥中富集培养,分离纯化得到一株可以降解噻吩的菌株s_4,并对该菌株的形态特征进行观察。应用Design—Expert8．0．5b软件进行响应面优化实验,研究了反应时间、噻吩浓度、微生物浓度3个因素的组合对菌株s_4脱硫效果的影响,并拟合得到多元二次回归方程,得出最佳实验条件。拟合结果表明,当反应时间27．46h,噻吩浓度为1．04％,微生物浓度4．04％时,预测噻吩降解率为14．8％,通过验证得最佳条件下的降解率为14．3％,与预测值相符。     

竹制填料生物接触氧化工艺处理污染河水简

针对受污染的湖溪河水质特征,以传统弹性塑料填料做对比,研究以竹球和竹丝为填料的生物接触氧化工艺,考察填料的挂膜时间、生物量和污水处理效果;确定连续曝气和间歇曝气时反应器的最优运行工况：连续曝气时为HRT=7.5 h,DO=3 mg/L;间歇曝气时为厌氧1.2 h、好氧6.3 h交替运行。实验结果表明,与弹性塑料填料相比,竹制填料挂膜速度快,竹球填料的水处理效果最好;连续曝气最优工况下竹球填料反应器中COD、TN、NH₃-N和TP的平均去除率分别为66.7%、47.9%、57.1%和30.6%;间歇曝气最优工况下竹球填料反应器中COD、TN、NH₃-N和TP的平均去除率分别64.08%、39.95%、60.7%和54.68%;竹制填料可替代传统的塑料填料作为生物接触氧化工艺的载体填料。     

浙江省工业烟粉尘总量控制研究

通过对浙江省工业烟粉尘排放总量和排放源现状进行分析,提出工业烟粉尘减排治理对策,对工业烟粉尘4个重点行业(水泥制造行业、火力发电行业、钢铁行业(包括炼钢、钢压延加工和黑色金属铸造行业)、纺织染整行业(包括棉印染精加工、化纤织物染整精加工和棉织造加工行业)排放源的烟粉尘减排途径和潜力进行分析测算,研究提出工业烟粉尘总量控制措施和建议。     

基于生态位理论的京津冀城市生态文明评价

生态文明评价体系是明确生态文明建设现状、定位生态文明建设存在问题的关键。从城市群视角出发引入生态位理论,界定生态文明位内涵,构建涵盖社会子系统生态位—经济子系统生态位—资源环境子系统生态位共29项指标的城市生态文明评价指标体系,并提出相对生态文明位和生态经济指数的二维模型,测算京津冀城市群6个案例城市在2007—2011年的生态文明建设水平、趋势以及地位。结果显示,2011年北京生态文明水平(相对生态文明位)最高,邢台生态文明水平最低,石家庄、秦皇岛、承德、天津生态文明水平分别排名第2、第3、第4、第5。2007—2011年,北京、承德、邢台生态文明水平呈现波动下降趋势,而秦皇岛、石家庄、天津呈现小幅上升趋势;但生态经济指数测算显示,北京的经济社会发展对于生态资源环境的占用消耗大,承德有较好的经济发展潜力。并基于该二维模型,将京津冀城市生态文明建设分为4种类型:发展失衡型、相对和谐型、高质量发展型、资源环境优势型,分别确定城市生态文明建设重点,为京津冀协同发展提供了指导依据。     

微生物絮凝剂M-C11处理高岭土悬浊液的响应曲面优化

采用响应曲面法对微生物絮凝剂M-C11处理高岭土悬浊液的过程参数进行优化,选取中心复合实验设计(CCD),以p H、M-C11投加量和Ca Cl2投加量等因素为自变量,以处理后的高岭土悬浊液絮凝率(Fr)为响应值,并借助扫描电镜对絮凝剂的作用机理进行初步探讨。结果表明,微生物絮凝剂M-C11可显著改善高岭土悬浊液的絮凝性能,且选取的3种单因素水平均可影响絮凝剂活性。经多元回归拟合分析,在M-C11投加量为2.56 m L,Ca Cl2投加量为0.37 g/L的最优条件下,微生物絮凝活性实验值可达92.37%,接近模型预测值(92.30%)。Ca Cl2投加量对絮凝效果的影响高于M-C11投加量(PCa Cl2相似文献   

突变灰盖鬼伞过氧化物酶降解刚果红的响应面法优化分析简

酶法降解偶氮染料刚果红是一个复杂的过程,受温度、pH、酶量、刚果红浓度和双氧水浓度显著影响。为研究各因素及因素间交互作用对刚果红降解影响,提高刚果红的降解率,分别使用单因素法和响应面分析法对刚果红降解条件进行了优化。单因素实验结果显示灰盖鬼伞过氧化物酶降解刚果红的最适条件为：pH 5.0、32℃、酶量4.98 U、双氧水0.1 mmol/L、刚果红20 mg/L,此时刚果红最高降解率为34.84%。然后选双氧水浓度、刚果红浓度和灰盖鬼伞过氧化物酶量作为3个因素,通过中心组合设计实验,用响应面法对刚果红降解进行优化分析,最后得到一个拟合度良好的二次多项方程模型（R²=0.9900）。方差分析结果显示,刚果红浓度和酶量是影响最显著的因素,双氧水与酶以及染料与酶之间的交互作用极显著。响应面分析优化后的反应体系为：双氧水浓度0.15 mmol/L,刚果红浓度为27.21 mg/L,酶为2.0 7 U,在此条件下,刚果红降解率达58.13%。