上海世博规划区交通干道污染物对流扩散研究

采用计算流体动力学(CFD)技术,对不同来流风速大小、风向条件下的上海世博规划区内四条主要交通干道上的交通污染物对流扩散进行了三维数值仿真。获得了不同工况下交通污染物浓度的空间分布。通过数值仿真结果分析,探明了交通干道上的机动车尾气排放对世博规划区内空气质量的影响(各工况下世博规划区内的CO最大浓度为0.25～0.59mg/m3;东南、东北和南风向下规划区内的NO2最大浓度分别为0.037mg/m3、0.03mg/m3和0.03mg/m3,而北风和西风下规划区建筑群内NO2最大浓度分别为0.068mg/m3和0.12mg/m)3,并揭示出应该重视靠近交通干道的建筑物附近的空气质量改善,特别是要重视靠近卢浦大桥两侧的建筑群周围空气质量改善(卢浦大桥两侧的建筑群周围NO2最大浓度已稍大于《环境空气质量标准》规定的一级标准浓度限值)。     

Rh-Al-MCM-41上NO选择性催化还原的原位红外研究

利用气-固相固定床反应装置考察了Rh交换的Al-MCM-41在高气体空速条件下对贫燃NOx的选择性催化还原活性,考察了氧含量对其的影响。结果表明,在200000h~(-1)的气体空速、O_2/C_3H_6=20、603K时,NO转化率为74.3％。利用原位FTIR技术研究了该催化剂的表面吸附物种及表面程序升温反应行为,并结合实验观察探讨了贫燃条件下Rh-Al-MCM-41催化剂上NO的选择性催化还原机理。     

某大型钢结构项目喷涂废气污染防治措施可行性分析研究

钢结构建筑是一种新型的节能环保的建筑体系,大多数大型钢结构产品在生产过程中均需要进行抛丸除锈、喷涂处理,使用油漆进行喷涂过程中将不可避免地产生含TVOC(主要为甲苯、二甲苯和非甲烷总烃)的有机废气。大型钢构类生产项目喷涂废气的收集和处理尤为困难。文章结合某大型钢结构生产企业实际采取的喷涂废气治理方法进行喷涂废气污染防治可行性分析,旨在为同类项目喷涂废气污染治理及进一步改良涂装废气治理工艺和技术提供参考依据。     

2006—2012年广东省机动车尾气排放特征及变化规律

利用广东省年鉴及实地调查资料,基于COPERT Ⅳ模型计算并分析了2006─2012年广东省珠三角和非珠三角地区的机动车尾气排放清单. 结果表明:研究地区2006─2012年机动车保有量上升,国Ⅲ、国Ⅳ车辆所占比例提高,其中珠三角地区优化程度大于非珠三角地区;2006─2012年2个地区污染物(CO、VOC、NO_x、PM_2.5)排放因子均有降低,降幅在24.54%~57.89%之间. 机动车污染物排放量上升趋势及贡献特征地区性差异明显,2006─2012年非珠三角地区CO、VOC排放量分别上升了37.20%、26.93%,增幅高于珠三角地区,而珠三角地区2012年的NO_x、PM_2.5排放量增幅(分别为21.65%、14.60%)高于非珠三角地区. 轻型客车是2个地区CO和VOC的主要贡献车型,贡献率均达46.96%以上,并且处于上升状态,但珠三角地区增幅小于非珠三角地区;重型客车和重型货车是2个地区NO_x、PM_2.5的主要来源,贡献率均在40.78%以上.      

一次环境污染司法鉴定的测试与分析

受人民法院的委托,环境监测部门对一起汽车尾气致人死亡案件的现场进行大气污染物和空气质量的模拟测试。测试表明,在密闭的车库内,汽车外和汽车内CO浓度都会迅速增加,达到致人死亡的浓度,O2浓度迅速减少,最终使汽车发动机熄火。测试为司法部门提供案件审理现场空气质量数据,也提醒人们不要在密闭的车库内开启汽车空调取暖或纳凉休息。     

Potential of secondary aerosol formation from Chinese gasoline engine exhaust

Light-duty gasoline vehicles have drawn public attention in China due to their significant primary emissions of particulate matter and volatile organic compounds(VOCs). However,little information on secondary aerosol formation from exhaust for Chinese vehicles and fuel conditions is available. In this study, chamber experiments were conducted to quantify the potential of secondary aerosol formation from the exhaust of a port fuel injection gasoline engine. The engine and fuel used are common in the Chinese market, and the fuel satisfies the China V gasoline fuel standard. Substantial secondary aerosol formation was observed during a 4–5 hr simulation, which was estimated to represent more than 10 days of equivalent atmospheric photo-oxidation in Beijing. As a consequence, the extreme case secondary organic aerosol(SOA) production was 426 ± 85 mg/kg-fuel, with high levels of precursors and OH exposure. The low hygroscopicity of the aerosols formed inside the chamber suggests that SOA was the dominant chemical composition. Fourteen percent of SOA measured in the chamber experiments could be explained through the oxidation of speciated single-ring aromatics. Unspeciated precursors, such as intermediate-volatility organic compounds and semi-volatile organic compounds, might be significant for SOA formation from gasoline VOCs. We concluded that reductions of emissions of aerosol precursor gases from vehicles are essential to mediate pollution in China.     

Effect of lubricant sulfur on the morphology and elemental composition of diesel exhaust particles

This work investigates the effects of lubricant sulfur contents on the morphology, nanostructure, size distribution and elemental composition of diesel exhaust particle on a light-duty diesel engine. Three kinds of lubricant (LS-oil, MS-oil and HS-oil, all of which have different sulfur contents: 0.182%, 0.583% and 1.06%, respectively) were used in this study. The morphologies and nanostructures of exhaust particles were analyzed using high-resolution transmission electron microscopy (TEM). Size distributions of primary particles were determined through advanced image-processing software. Elemental compositions of exhaust particles were obtained through X-ray energy dispersive spectroscopy (EDS). Results show that as lubricant sulfur contents increase, the macroscopic structure of diesel exhaust particles turn from chain-like to a more complex agglomerate. The inner cores of the core-shell structure belonging to these primary particles change little; the shell thickness decreases, and the spacing of carbon layer gradually descends, and amorphous materials that attached onto outer carbon layer of primary particles increase. Size distributions of primary particles present a unimodal and normal distribution, and higher sulfur contents lead to larger size primary particles. The sulfur content in lubricants directly affects the chemical composition in the particles. The content of C (carbon) decreases as sulfur increases in the lubricants, while the contents of O (oxygen), S (sulfur) and trace elements (including S, Si (silicon), Fe (ferrum), P (phosphorus), Ca (calcium), Zn (zinc), Mg (magnesium), Cl (chlorine) and Ni (nickel)) all increase in particles.     

包装印刷VOCs废气治理

介绍了应用吸附 催化燃烧法原理 ,采用FCJ型有机废气净化装置进行包装印刷厂挥发性有机化合物 (VOCs)废气治理 ,详细描述了包装印刷车间VOCs废气治理的工艺过程及其治理效果。测试结果表明 ,应用这类工艺和设备可以有效地进行大风量的VOCs废气治理 ,净化治理效果达到了国家二级排放标准。     

上海市大气中非甲烷烃与机动车尾气排放研究

采用特征性化合物法和统计法相结合的方法,对上海市大气中非甲烷烃(NMHC)与作为机动车尾气特征性化合物的CO与Pb进行了相关性分析。结果发现,NMHC与Pb在显著性水平0.01下显著性相关,相关系数达到0.593(n=18);NMHC与CO小时均值相关系数达到0.495(n=2329),日均值相关系数达到0.581(n=114)。从而判断机动车尾气排放已经逐渐成为上海市大气中NMHC的主要贡献者。     

麻石文丘里洗涤吸收器在APV尾气处理上的应用

介绍了ＡＰＶ喷雾干燥尾气的性质，原尾气系统存在的问题，改造中采取的措施、原理、流程和取得的效果。实践证明，用“麻石文丘里一次降温、洗涤—ＸＰ型塔板二次洗涤—旋流除雾器除雾”的改造方案，取代原“换热器降温—喷淋塔洗涤—折流脱水器脱水”的流程，取得了良好的降温、洗气和除雾效果，且工程费用低。