长输管道泄漏检测技术进展浅析

简述了长输管道泄漏检测技术的进展情况,介绍了4种泄漏检测技术原理,并对比分析了各种技术的特点和应用范围,为管道的安全运行管理和维护决策提供了技术参考。     

装修噪声污染及防治

对住宅装修噪声与振动的污染进行了调查监测分析,弄清住宅装修噪声源的特点,及其对周围声环境和居民的污染状况。提出住宅装修噪声的有关防治措施。     

Evaluation of mercury speciation and removal through air pollution control devices of a 190 MW boiler

Air pollution control devices (APCDs) are installed at coal-fired power plants for air pollutant regulation. Selective catalytic reduction (SCR) and wet flue gas desulfurization (FGD) systems have the co-benefits of air pollutant and mercury removal. Configuration and operational conditions of APCDs and mercury speciation a ect mercury removal e ciently at coal-fired utilities. The Ontario Hydro Method (OHM) recommended by the U.S. Environmental Protection Agency (EPA) was used to determine mercury speciation simultaneously at five sampling locations through SCR-ESP-FGD at a 190 MW unit. Chlorine in coal had been suggested as a factor a ecting the mercury speciation in flue gas; and low-chlorine coal was purported to produce less oxidized mercury (Hg2+) and more elemental mercury (Hg0) at the SCR inlet compared to higher chlorine coal. SCR could oxidize elemental mercury into oxidized mercury when SCR was in service, and oxidation e ciency reached 71.0%. Therefore, oxidized mercury removal e ciency was enhanced through a wet FGD system. In the non-ozone season, about 89.5%–96.8% of oxidized mercury was controlled, but only 54.9%–68.8% of the total mercury was captured through wet FGD. Oxidized mercury removal e ciency was 95.9%–98.0%, and there was a big di erence in the total mercury removal e ciencies from 78.0% to 90.2% in the ozone season. Mercury mass balance was evaluated to validate reliability of OHM testing data, and the ratio of mercury input in the coal to mercury output at the stack was from 0.84 to 1.08.     

电子产品环境应力筛选试验

为了使环境应力筛选试验在有效提高电子产品的可靠性方面得以广泛应用,介绍了环境应力筛选试验的概念,针对电子产品,论述了环境应力筛选典型应力参数的确定方法、加电检测的原则、筛选度和故障率的计算、筛选中暴露的典型缺陷等。提出了环境应力筛选试验的一般程序和一些需注意的问题。     

Risk and characteristics analysis of the flow-induced vibration of the dip tube in opposed multi-burner gasifier

The vibration of dip tube in multi-burner gasifier changes the stress at the connection, causing flange seal failures and high temperature gas erosions with heavy economic losses and industrial accidents. This work aims to reveal the dip tube vibration mechanism, with special focus on obtaining the effect of operational parameters on the fatigue damage and long-term stable operation of gasifiers. A three-dimensional numerical simulation of the water-scrubbing cooling chamber was conducted to obtain the excitation source in the flow field. Then a FSI (fluid-structure interaction) transient dynamics simulation was carried out to investigate the vibration characteristics. Two major flow forms were found: a vertical annular flow near the dip tube outlet in the water-scrubbing cooling chamber; and a gas-liquid coupled flow caused by the syngas entrained the liquid. These two unstable multiphase flow forms exerted an energy excitation on the dip tube, resulting in a self-excited flutter. The dip tube vibration was similar to the first mode of a cantilever beam. The peak frequency was less affected by the initial liquid level and the syngas stream inlet velocity, which was close to its own first natural frequency. Note that, the alternating load generated by vibration may cause fatigue damage, which needs to be specifically considered in the design and manufacturing process of opposed multi-burner gasifier.     

排桩几何参数对其隔振半径的影响试验研究

通过室外试验的方法、从二维角度入手并将排桩参数与瑞利波波长建立联系研究了几何参数变化时隔振半径的变化。结果表明:单排桩可取得整体性的隔振特点,并且隔振效果最佳的区域在桩后较近的距离;桩长增加可使其隔振效果提升且隔振半径随桩长与波长比值的增加而增加,当桩长与波长比值小于0.320时,隔振半径为0;随比值增加到0.820左右,隔振半径增加到约0.680 m。桩间距的增加可使其隔振效果变差,隔振半径随桩间距与波长比值增加而降低,当比值达到0.300~0.430时,隔振半径长度降为0。振源距离增加可使得排桩隔振效果增强,而隔振半径随振源距与波长比值增加而增加,当比值在0.165~0.305的范围内时,隔振半径为0;随比值增加到0.808左右,隔振半径的长度增加到约0.512 m。     

小波熵去噪在微差爆破延时精确识别中的应用

在小波熵去噪理论的基础上,对实际隧道爆破工程采集到的爆破振动信号进行了小波熵方法去噪。利用db8小波对去噪后的信号在尺度a=16进行了连续小波变换得到其模极大值,准确识别了隧道多段别微差爆破实际延期时间间隔,并验证了小波熵方法去噪的可靠性。结果表明,小波熵去噪方法能够有效滤除和抑制爆破振动非线性信号所夹杂的高频噪声分量,并且很好地保留了爆破振动信号的突变细节。对滤波后的信号进行模极大值变换,信号局部奇异点的辨识更准确,可以精确识别隧道微差爆破延时间隔。     

声激励锚杆轴力监测传感器的研制

根据现有的锚杆支护方式,提出一种采用声激励来监测锚杆轴力的新方法,该方法属于无损检测。阐述了锚杆轴力监测传感器的基本原理,介绍了传感器的构造及参数的设置,从强度、模态、声学3个方面进行了详细说明,分析了共振板的厚度变化对声学性能的影响。结果表明,该传感器满足设计要求,方法可行、有效。     

基于互联网+的轨道交通动力设备安全管理系统的研究

根据我国轨道交通设备安全管理的需求,提出基于互联网+的轨道交通动力设备安全管理系统平台的框架,运用J2EE开发工具,采用嵌入式高速数据采集技术、故障诊断技术,构建形成集成化、网络化和信息化的轨道交通动力设备安全管理系统。完善智能的设备安全管理系统,能有效提高轨道交通动力设备的安全监管力度,保障设备安全。     

Endurance time,muscular activity and the hand/arm tremor for different exertion forces of holding

This study aimed to examine the effects of exertion force on endurance time, muscular activity and hand/arm tremor during holding. Fifteen healthy young males were recruited as participants. The independent variable was exertion force (20%, 40%, 60% and 80% maximum holding capacity). The dependent variables were endurance time, muscular activity and hand/arm tremor. The results showed that endurance time decreased with exertion force while muscular activity and hand/arm tremor increased with exertion force. Hand/arm tremor increased with holding time. Endurance time of 40%, 60% and 80% maximum holding capacity was approximately 22.7%, 12.0% and 5.6% of that of 20% maximum holding capacity, respectively. The rms (root mean square) acceleration of hand/arm tremor of the final phase of holding was 2.27-, 1.33-, 1.20- and 1.73-fold of that of the initial phase of holding for 20%, 40%, 60% and 80% maximum holding capacity, respectively.