Sorption of 3,4-dichloroaniline on four contrasting Greek agricultural soils and the effect of liming

Sorption of 3,4-dichloroaniline (3,4-DCA) on four typical Greek agricultural soils, with distinct texture, organic matter content and cation exchange capacities, was compared by using sorption isotherms and the parameters calculated from the fitted Freundlich equations. The sorption process of 3,4-DCA to the soil was completed within 48–72 h. The 3,4-DCA sorption on all soils was well described by the Freundlich equation and all sorption isotherms were of the L-type. The sandy clay loam soil with the highest organic matter content and a slightly acidic pH was the most sorptive, whereas the two other soil types, a high organic matter and neutral pH clay and a low organic matter and acidic loam, had an intermediate sorption capacity. A typical calcareous soil with low organic matter had the lowest sorption capacity which was only slightly higher than that of river sand. The 3,4-DCA sorption correlated best to soil organic matter content and not to clay content or cation exchange capacity, indicating the primary role of organic matter. The distribution coefficient (K _d) decreased with increasing initial 3,4-DCA concentration and the reduction was most pronounced with the highly sorptive sandy clay loam soil, suggesting that the available sorption sites of the soils are not unlimited. Liming of the two acidic soils (the sandy clay loam and the loam) raised their pH (from 6.2 and 5.3, respectively) to 7.8 and reduced their sorption capacity by about 50 %, indicating that soil pH may be the second in importance factor (after organic matter) determining 3,4-DCA sorption.     

外源硅对不同pH水田土壤吸附铅的影响

通过等温吸附实验,研究了加硅对2种不同pH水田土壤吸附铅特性的影响。实验中用硝酸中和硅酸钠的碱性,各处理间钠离子和硝酸根离子的差异以硝酸钠补齐,消除了因硅酸盐的加入改变体系pH及伴随离子对土壤吸附铅可能产生的影响。结果表明,在本实验条件下,Langmuir方程、Freundlich方程和Temkin方程都能较好地描述不同硅浓度条件下两种土壤对铅的吸附特征,但以Freundlich模型为最优;加硅促进了酸性土壤对铅的吸附,抑制了碱性土壤对铅的吸附。     

HAN阻隔防爆模型研究

通过合理简化,利用多方气体状态方程,分别建立油品储运容器内可燃混合气体定容爆炸模型和装设阻隔防爆材料的油品储运容器内可燃混合气体爆炸模型,获得了阻隔防爆性能测试装置的燃爆容器抗爆设计限值,以及其在HAN阻隔防爆测试中燃爆容器试爆压力量级的控制下限值,同时,还给出HAN工程应用中容器留空率的计算方法,具有实际指导意义。     

Vertical migration of radionuclides in undisturbed grassland soils

Literature data on numerical values obtained for the parameters of the two most popular models for simulating the migration of radionuclides in undisturbed soils have been compiled and evaluated statistically. Due to restrictions on the applicability of compartmental models, the convection–dispersion equation and its parameter values should be preferred. For radiocaesium, recommended values are derived for its effective convection velocity and dispersion coefficient. Data deficiencies still exist for radionuclides other than caesium and for soils of non-temperate environments.     

HYDROLOGIC MODELING OF A BIOINFILTRATION BEST MANAGEMENT PRACTICE1

ABSTRACT: The goal of this research was to develop a methodology for modeling a bioinfiltration best management practice (BMP) built in a dormitory area on the campus of Villanova University in Pennsylvania. The objectives were to quantify the behavior of the BMP through the different seasons and rainfall events; better understand the physical processes governing the system's behavior; and develop design criteria. The BMP was constructed in 2001 by excavating within an existing traffic island, backfilling with a sand/soil mixture, and planting with salt tolerant grasses and shrubs native to the Atlantic shore. It receives runoff from the asphalt (0.26 hectare) and turf (0.27 hectare) surfaces of the watershed. Monitoring supported by the hydrologic model shows that the facility infiltrates a significant fraction of the annual precipitation, substantially reducing the delivery of nonpoint source pollution and erosive surges downstream. A hydrologic model was developed using HEC‐HMS to represent the site and the BMP using Green‐Ampt and kinematic wave methods. Instruments allow comparison of the modeled and measured water budget parameters. The model, incorporating seasonally variable parameters, predicts the volumes infiltrated and bypassed by the BMP, confirming the applicability of the selected methods for the analysis of bioinfiltration BMPs.     

CRITICAL EVALUATION OF CERTAIN METHODS OF UNSTEADY GROUNDWATER HYDRAULICS1

The basic theories and fundamental assumptions usually employed in the solution of unsteady groundwater flow problems are reviewed critically. The best known method of analysis for such problems is based on the Dupuit-Forchheimer approximation and leads to a nonlinear parabolic differential equation which is generally solved by linearization or numerical methods. The accuracy of the solution to this equation can be improved by use of a different approach which does not employ the Dupuit Forchheimer assumption, but rather is based on a semi-numerical solution of the Laplace equation for quasi-steady conditions. The actual unsteady process is replaced by a sequence of steady-state conditions, and it is assumed that the actual unsteady flow characteristics during a short time interval can be approximated by those associated with “average” steady state flow. The Laplace equation is solved by a semi-discretization method according to which the horizontal coordinate is divided into subintervals, while the vertical coordinate is maintained continuous. The proposed method is applied to a typical tile drainage problem, and, based on a comparison of calculated results with experimental data, the method is evaluated and practical conclusions regarding its applicability are advanced.     

DIGITAL SIMULATION OF THE EFFECT OF THERMAL DISCHARGE ON STREAM WATER QUALITY1

A modified transient version of the Streeter-Phelps model along with the energy balance equation is employed to analyze the effects of waste heat discharge from power plants on stream water quality. Analysis is also made to examine the effects of the upstream water quality and stream velocity on the downstream DO concentration level. The resulting coupled nonlinear hyperbolic partial differential equations representing the energy, BOD and DO concentrations are solved by the method of characteristics and simulated on a digital computer. Final numerical results indicate that the allowable quantity of thermal discharge does heavily depend on the upstream quality.     

STABILITY AND REACH LENGTH IN WATER SURFACE PROFILE DETERMINATION1

ABSTRACT: Extension of basic step methods of backwater computation to reaches of finite length is examined. Accuracies of commonly accepted hydraulic loss equations under particular water surface profile conditions are compared. Simulation of energy lines within a reach by parabolic curves is found to minimize error provided orientation of the axis of the parabola is selected in accordance with prevailing hydraulic conditions. Theoretical basis for an index reach length beyond which single-step computation from end to end of the reach must be in error is developed. Reduction of this reach length by suitable factors tailored to hydraulic conditions yields a mathematically defined allowable reach length for backwater computation. When reach length does not exceed this allowable reach length, no significant error may be detected. Automatic insertion of synthetic cross sections interpolated between surveyed cross sections when these are inadvertently spaced too far apart enables computation to proceed. This device is error-free for prismatic channls but may introduce error for irregular natural channels. Preliminary trials indicate that results so obtained may be accepted provided the fall in the original reach does not exceed from one to two feet. When this is exceeded, additional cross sections should be surveyed.     

SEDIMENT ROUTING FOR AGRICULTURAL WATERSHEDS1

ABSTRACT: A sediment routing technique was developed to route sediment yield from small watersheds through streams and valleys to the outlet of large watersheds. The technique is based on the modified universal sol loss equation and a first order decay function of travel time and particle size. Deposition is dependent upon settling velocities of sediment particles, travel time, and the amount of sediment in suspension. Sediment routing increases sediment yield prediction accuracy and allows determination of subwatershed contributions to the total sediment yield. Also, the locations and amounts of floodplain scour and deposition can be predicted. Another advantage of sediment routing is that measured sediment yield data are not required. The procedure performed satisfactorily in test routings on two Texas blackland watersheds Sediment routing will be useful in flood control evaluation, reservoir and channel design, water quality calculations, environmental impact assessment, and land-use planning.     

COMPARISON OF METHODS TO ESTIMATE DEEP PERCOLATION RATES1

ABSTRACT: Deep percolation rates are normally estimated from a water balance. Results are presented of a study undertaken to evaluate three alternative methods of estimating percolation below the root zone when knowledge about the history of applied water and evapotranspiration are not available. The alternative methods are: 1) use of Darcy's equation to calculate deep percolation rate; 2) measurement of the soil temperature prof and calculation of the deep percolation rate from the shape of the temperature depth curve; and 3) measurement of the tritium concentration in the soil water and its relationship to the history of the tritium concentration in rainfall. At the principal study site, the Darcy velocity of flow ranged from 9 cm per year determined by the temperature method, to 40 cm per year determined by the tritium method. Darcy's equation to calculate seepage rates resulted in an estimation of deep seepage of 18 cm per year. An average deep percolation rate at the principal study site of 22 cm per year was determined using the average of all three methods. Results for other sites based on the temperature method indicated a lower seepage rate.