船舶塑料垃圾热解特性及动力学分析

利用热重分析(TGA)研究船舶塑料垃圾在不同升温速率和不同气氛下的热解特性,并得到了热解动力学参数。结果表明,船舶塑料垃圾的热解过程主要有3个阶段,比一般塑料热解复杂;随着升温速率增大,最大热解速率和最大热解速率温度等热解特性参数也增大,反应变得更剧烈;N2/CO2比为4∶1时,热解反应进行得最完全,固体残留率最少。动力学分析表明,采用3个连续一级反应模型能很好地拟合实验数据;不同的升温速率和气氛比对反应各阶段活化能均有不同程度的影响。     

膜电解技术处理含氯及重金属的废酸

采用离子交换膜电解技术处理铜冶炼过程产生的含氯及重金属的废酸。考察了废酸处理工艺、电解温度、电解时间、电流密度和催化剂的添加等条件对处理效果的影响。实验结果表明：采用先沉淀重金属后脱氯的废酸处理工艺,氯离子和铜离子的去除效果均较好;当以钛盐为催化剂时,在电解温度为40 ℃、电解时间为2.0 h、电流密度为825 A/m²的最佳工艺条件下,处理后废酸中的氯离子质量浓度为0.22 g/L,氯离子去除率为98.59%,铜离子质量浓度为0.45 g/L,铜离子去除率为95.08%,其他重金属大部分也得到有效去除。净化后的废酸可回用至铜冶炼的生产过程中。     

Determination of specific gravity of municipal solid waste

This investigation was conducted to evaluate experimental determination of specific gravity (G_s) of municipal solid waste (MSW). Water pycnometry, typically used for testing soils was adapted for testing MSW using a large flask with 2000 mL capacity and specimens with 100–350 g masses. Tests were conducted on manufactured waste samples prepared using US waste constituent components; fresh wastes obtained prior and subsequent to compaction at an MSW landfill; and wastes obtained from various depths at the same landfill. Factors that influence specific gravity were investigated including waste particle size, compaction, and combined decomposition and stress history. The measured average specific gravities were 1.377 and 1.530 for as-prepared/uncompacted and compacted manufactured wastes, respectively; 1.072 and 1.258 for uncompacted and compacted fresh wastes, respectively; and 2.201 for old wastes. The average organic content and degree of decomposition were 77.2% and 0%, respectively for fresh wastes and 22.8% and 88.3%, respectively for old wastes. The G_s increased with decreasing particle size, compaction, and increasing waste age. For fresh wastes, reductions in particle size and compaction caused occluded intraparticle pores to be exposed and waste particles to be deformed resulting in increases in specific gravity. For old wastes, the high G_s resulted from loss of biodegradable components that have low G_s as well as potential access to previously occluded pores and deformation of particles due to both degradation processes and applied mechanical stresses. The G_s was correlated to the degree of decomposition with a linear relationship. Unlike soils, the G_s for MSW was not unique, but varied in a landfill environment due both to physical/mechanical processes and biochemical processes. Specific gravity testing is recommended to be conducted not only using representative waste composition, but also using representative compaction, stress, and degradation states.     

Using multivariate regression modeling for sampling and predicting chemical characteristics of mixed waste in old landfills

Municipal solid waste landfills pose a threat on environment and human health, especially old landfills which lack facilities for collection and treatment of landfill gas and leachate. Consequently, missing information about emission flows prevent site-specific environmental risk assessments. To overcome this gap, the combination of waste sampling and analysis with statistical modeling is one option for estimating present and future emission potentials. Optimizing the tradeoff between investigation costs and reliable results requires knowledge about both: the number of samples to be taken and variables to be analyzed.This article aims to identify the optimized number of waste samples and variables in order to predict a larger set of variables. Therefore, we introduce a multivariate linear regression model and tested the applicability by usage of two case studies. Landfill A was used to set up and calibrate the model based on 50 waste samples and twelve variables. The calibrated model was applied to Landfill B including 36 waste samples and twelve variables with four predictor variables.The case study results are twofold: first, the reliable and accurate prediction of the twelve variables can be achieved with the knowledge of four predictor variables (Loi, EC, pH and Cl). For the second Landfill B, only ten full measurements would be needed for a reliable prediction of most response variables. The four predictor variables would exhibit comparably low analytical costs in comparison to the full set of measurements. This cost reduction could be used to increase the number of samples yielding an improved understanding of the spatial waste heterogeneity in landfills.Concluding, the future application of the developed model potentially improves the reliability of predicted emission potentials. The model could become a standard screening tool for old landfills if its applicability and reliability would be tested in additional case studies.     

Estimation of building-related construction and demolition waste in Shanghai

One methodology is proposed to estimate the quantification and composition of building-related construction and demolition (C&D) waste in a fast developing region like Shanghai, PR China. The varieties of structure types and building waste intensities due to the requirement of progressive building design and structure codes in different decades are considered in this regional C&D waste estimation study. It is concluded that approximately 13.71 million tons of C&D waste was generated in 2012 in Shanghai, of which more than 80% of this C&D waste was concrete, bricks and blocks. Analysis from this study can be applied to facilitate C&D waste governors and researchers the duty of formulating precise policies and specifications. As a matter of fact, at least a half of the enormous amount of C&D waste could be recycled if implementing proper recycling technologies and measures. The appropriate managements would be economically and environmentally beneficial to Shanghai where the per capita per year output of C&D waste has been as high as 842 kg in 2010.     

炼油恶臭污染治理技术在中国石化天津分公司的应用实例

简述了炼油装置区恶臭污染源的主要分布、恶臭气体组成和排放规律,介绍了恶臭治理的基本方法。通过治理实例,重点分析了目前常用的吸收法、燃烧法、生物法和吸附法等恶臭治理技术的优势和相对不足,并对恶臭治理应用技术方案的选择提出建议。     

生物滴滤塔处理氯苯废气的工艺性能

将活性污泥培养及驯化后接种于生物滴滤塔中,挂膜启动后处理模拟氯苯废气（简称氯苯废气）,考察了生物滴滤塔在挂膜启动阶段及稳定运行阶段的性能。实验结果表明：接种41 d后生物滴滤塔成功挂膜,此时氯苯去除率稳定在90%以上;生物滴滤塔稳定运行阶段,随着进气中氯苯质量浓度由303.82 mg/m³逐渐增至1 489.05 mg/m³,氯苯去除率从85.1%降至70.1%。处理氯苯废气适宜的工艺条件为：空塔停留时间超过45 s,喷淋液流量31.8 mL/min,氯苯负荷23.97~128.01 g/（m³·h）。生物滴滤塔对喷淋液的酸性环境有较好的适应性,喷淋液pH的变化对氯苯去除率无显著影响。     

表面活性剂改性4A分子筛对Cr(VI)的吸附行为

采用浸渍法对4A分子筛进行表面改性,通过引入阳离子表面活性剂,使4A分子筛表面附着季铵型阳离子,并与反离子Br-形成"阴离子交换膜",从而促使更多的Cr(VI)阴离子通过离子交换吸附到改性4A分子筛上,通过X-射线衍射(XRD)和傅里叶变换红外光谱(FTIR)对样品的物相结构和组成进行表征分析。研究表明,表面活性剂的类型和疏水碳氢链结构会影响4A分子筛的吸附能力,十八烷基三甲基溴化铵(OTAB)碳氢链长,在分子筛表面形成的双分子层密,对Cr(VI)的吸附量最大。采用准一级、准二级、Elovich和Bangham动力学模型对六价铬的吸附数据进行拟合,其中准一级动力学方程最符合十八烷基三甲基溴化铵改性分子筛的吸附行为。同时,分别从Langmuir和Redlich-Peterson等温吸附模型获得六价铬的最大吸附量为13.98 mg/g,且改性分子筛以均一表面吸附为主。     

Photoinduced reduction of divalent mercury in ice by organic matter

Reduction of divalent mercury and subsequent emission to the atmosphere has been identified as loss process from surface snow, but its mechanism and importance are still unclear. The amount of mercury that stays in the snow pack until spring is of significance, because during snow melt it may be released to the aquatic environment and enter the food web. Better knowledge of its fate in snow might further assist the interpretation of ice core data as paleo-archive. Experiments were performed under well-controlled laboratory conditions in a coated wall flow tube at atmospheric pressure and irradiated with light between 300 nm and 420 nm. Our results show that the presence of benzophenone and of oxalic acid significantly enhances the release of mercury from the ice film during irradiation, whereas humic acid is less potent to promote the reduction. Further it was found that oxygen or chloride, and acidic conditions lowered the photolytically induced mercury release in the presence of benzophenone, while the release got larger with increasing temperatures.     

基于博弈论的非点源污染控制模型探讨

随着对工业和城市生活污水等点源污染治理能力的不断增强,农业非点源污染对水质环境的影响日益凸现.相对于点源污染,非点源污染发生的不确定时间、不确定途径、不确定量等特点给治理政策的制定带来很大难度.本文从著名的公地悲剧现象出发,着力从市场博弈及政府监督博弈两个模型分析非点源污染制造者之间的博弈格局,并提出以“集体表现”的形式对非点源污染进行管理和控制.市场博弈模型中以一定的排污削减目标为前提,确定以成本最优的原则进行点源-非点源排污权交易是可行且有效率的;而政府监督博弈模型的结果显示:合理的环境补贴和惩罚机制、政府对自身声誉及公众形象的重视及维护对非点源污染治理起正向促进作用.