磷酸钙盐法回收剩余污泥超声波处理上清液中磷的研究

在污泥减量化处理中,细胞微生物中的碳氮磷等会释放到上清液中。为了对上清液中的磷进行有效回收,在前期研究的基础上,以生物厌氧好氧除磷(An/O)工艺的剩余污泥超声波处理上清液为研究对象,考察了磷酸钙盐(HAP)法的磷回收效果。结果表明:HAP法反应较快,5 min时反应基本完成;初始pH值在8.5～10.0时,回收率均可保持在较高水平;最佳钙磷比(Ca2+/PO34--P)为3.87。在以上最佳工艺条件下,总磷(TP)、正磷酸盐(PO34--P)的回收率分别达到88.4%、94.0%,同时对上清液中的有机物、氮也有一定的去除。     

村镇生活垃圾重金属含量及其来源分析

对全国12个省份72个典型村镇的生活垃圾进行采样调查,系统分析我国村镇生活垃圾中重金属污染特征及其可能来源.结果表明,我国北方典型村镇生活垃圾中重金属As、Hg、Pb、Cd、Cr、Cu、Zn和Ni的含量分别为(7.51±8.89)、(0.64±0.42)、(21.91±12.29)、(4.82±8.37)、(86.36±59.99)、(36.43±15.98)、(62.19±36.61)和(46.07±25.22)mg·kg-1,南方典型村镇生活垃圾中重金属As、Hg、Pb、Cd、Cr、Cu、Zn和Ni的含量分别为(7.43±8.82)、(0.83±0.74)、(21.62±13.76)、(1.84±4.55)、(131.06±74.96)、(37.20±16.80)、(98.04±63.71)和(46.75±25.75)mg·kg-1.与《城镇垃圾农用控制标准》(GB 8172-87)和《土壤环境质量标准》(GB 15618-1995)二级标准相比,重金属Cd和Hg超标较严重.通过聚类分析、Pearson相关分析和主成分分析解析垃圾中重金属污染物的来源,结果表明我国典型村镇生活垃圾中Pb和Cd主要来源于厨余、灰土、橡塑类和纸质等印刷品,Hg主要来源于厨余和灰土,Zn和Cr主要来源于灰土,Cu主要来源于电子、电池类废弃物和尘土、橡塑、纸质等印刷品,Ni主要来源于废弃的电子、电池类产品,As主要来源于杀虫剂等农药和肥料.     

生物法净化挥发性有机废气的吸附-生物膜理论模型与模拟研究

针对挥发性有机废气的生物法净化过程,进行了吸附-生物膜新型理论的相关动力学模型研究.经采用实验室数据和工业应用试验结果的对比验证表明,该模型对描述实际过程有很好的适用性.应用该模型对人口气体甲苯浓度、气体流量及生物膜填料层高度等主要因素的影响进行模拟研究,模拟计算值与实验值之间有较好的相关性,相关系数r为0.80～0.97.     

生物滴滤池净化二氯甲烷废气的实验研究

在φ50mm生物滴滤池内进行了二氯甲烷废气净化的实验研究.由工厂活性污泥经驯化培养得到菌种,进一步接种、在填料表面挂膜,接种和挂膜约需30d.滴滤池内装填聚丙烯散堆填料,废气和循环液在滴滤池内逆流操作,循环液pH值为7.0±0.5,温度维持在28.5±2℃的条件下,生物膜系统能较好地适应进口浓度的变化.在气体空床停留时间为15.7s、二氯甲烷进口浓度为0.7～3.12g/m³的范围内,去除效率为72.0%～99.1%.滴滤池中的酸性环境对二氯甲烷的降解具有明显抑制作用.     

Perceived importance of sustainability dimensions in the Portuguese metal industry

The growing interest of stakeholders regarding the contribution of organizations to Sustainable Development is influencing organizational behavior and strategic planning. The purpose of the present paper is to analyze the perception of the importance of organizational sustainability dimensions in a relevant economic sector: the metal industry. Survey data was collected from a sample of 211 Portuguese industries, and non-parametric statistical tests were used to validate five research hypotheses regarding the importance of the economic, environmental, social and cultural dimensions of sustainability. The results obtained demonstrate awareness of the sampled industries regarding all sustainability dimensions, recognizing that their importance has been increasing over the years, and prospecting that this importance will continue to increase in the future. The industries in this sample revealed different degrees of perceived importance for the different sustainability dimensions: the highest importance was given to the economic dimension, and culture was considered the least important sustainability dimension. However, the perception of the respondents is that these differences will be less relevant in the future. The results also show that companies with certified management systems reveal a higher perceived importance regarding sustainability dimensions. Also, industries with higher values of annual turnover, number of employees and export sales tend to give higher degrees of importance to sustainability dimensions. Considering the economic, environmental and social impacts of metal industries at an international level, the awareness of this industrial sector regarding the importance of sustainability is a relevant step to the commitment towards Sustainable Development.     

Investigation of biocatalytic potential of garbage enzyme and its influence on stabilization of industrial waste activated sludge

The decomposable waste thrown into the environment can be used to produce value added bio-product which in turn reduces the production of greenhouse gas. Garbage enzyme is one such value added product produced by fermentation of organic solid waste. In the present study enzyme activity and disinfectant potential of garbage enzyme was evaluated and its influence on reduction of total solids, suspended solids and pathogens in dairy waste activated sludge were studied. The result showed the garbage enzyme possesses protease, amylase and lipase activity and reduced 37.2% of total solids, 38.6% of suspended solids and 99% of pathogens in dairy waste activated sludge. This significant result may be helpful for researchers to compare the effectiveness of earth-friendly garbage enzyme treatment of industrial sludge with various physical and chemical pre-treatment methods to improve the biogas production from the sludge digestion unit.     

Usage of polystyrene disposable food dishes in the lightweight concrete making

The increasing use and subsequent accumulation of polystyrene containers has triggered a substantial environmental problem. This study investigated using varied percentages of solid waste polystyrene disposable food dishes in the production of lightweight concrete samples with 350 kilograms per cubic meter (kg/m³) of cement and a density of 1,300 kg/m³. The polystyrene disposable dishes were ground into beads of 0–3 millimeters (mm) and 3–6 mm in size. First, the characteristics of Type II Portland cement, polystyrene, and aggregates were examined. The following characteristics of concrete using ASTM International and British Standards Institution standards were tested: slump, compressive strength, ability to resist chloride ion penetration, and resistance of concrete to rapid freezing and thawing cycles. Scanning electron microscopy (SEM) and energy dispersive X‐ray spectroscopy analytical techniques were also used. The slump of samples varied between 40 and 70 mm and was not dependent on either the polystyrene percentage or the size of the polystyrene beads in the concrete samples (p‐value > .05). The compressive strength of the concrete samples after 90 days of curing, and using different percentages of polystyrene, varied between 96 and 113 kilograms per square centimeter (kg/cm²). The resistance of the samples to the freezing and thawing cycle and chloride ion penetration were affected unfavorably by the presence of the polystyrene. The SEM technique indicated that concrete samples containing 15% and 25% polystyrene had denser crystals and less void than concrete samples with 40% and 55% polystyrene.     

Exploration of relationships between safety performance and unsafe behavior in the Chinese oil industry

Safety performance is comprised of two components, safety compliance and safety participation. However, relationships between safety performance and unsafe behavior have not been thoroughly investigated. In this work, scales for safety compliance and safety participation were revised for use in the oil industry, and job burnout scale was developed on the basis of the Maslach Burnout Inventory-General Survey (MBI-GS). A structural equation model was then employed to investigate the interactions of these factors for 238 front-line oil workers from the PetroChina Huabei Oilfield Company in China. From the results, it was determined that workers' unsafe behavior could not be reduced significantly solely from these two dimensions of safety performance. Compared with safety participation, safety compliance was found to have a greater influence on unsafe behavior. However, job burnout was found to be a significant moderator between these two components and unsafe behavior. Furthermore, it was determined that oil workers' occupational psychological health conditions must be taken into account to improve organizational safety management and reduce workers’ unsafe behavior.     

Interactive mechanism of working environments and construction behaviors with cognitive work analysis: an elevator installation case study

Unsafe behavior is a leading factor in accidents, and the working environment significantly affects behaviors. However, few studies have focused on detailed mechanisms for addressing unsafe behaviors resulting from environmental constraints. This study aims to delineate these mechanisms using cognitive work analysis (CWA) for an elevator installation case study. Elevator installation was selected for study because it involves operations at heights: falls from heights remain a major cause of construction worker mortality. This study adopts a mixed research approach based on three research methodology stages. This research deconstructs the details of the working environment, the workers’ decision-making processes, the strategies chosen given environmental conditions and the conceptual model for workers’ behaviors, which jointly depict environment–behavior mechanisms at length. By applying CWA to the construction industry, environmental constraints can easily be identified, and targeted engineering suggestions can be generated.     

跨区域应急协作视角下化工园区空间布局的失衡与应对策略分析

随着工业化进程加快,我国化工园区呈现出数量逐年递增且集中分布的态势,增加了跨区域重大突发事件的风险,如何实现跨区域的应急协作成为化工园区安全规划所面临的重点与难点问题之一。基于此,搜集近15 a全国化工园区的安全事故,采用自组织特征映射神经网络分类方法与多元回归模型研究全国范围内化工园区安全事故的空间分布规律及影响因素,进而从风险分布与应急协作需求的匹配性角度讨论我国现有应急协作机制存在的潜在问题。研究结果表明:我国化工园区整体空间布局呈现出以区域优势为导向的趋势,其选址大多忽略了化工园区集中区域的高风险与应急能力不足的问题,这种布局的失衡使得政府无法形成高效的跨区域应急协作体制;化工园区数量上的增加并非是导致危机事故的主要原因,强调了化工园区自身特征与危机事故严重程度的相关性,区域间应急联动协作在化工园区危机应对过程中的重要作用;最后,从空间布局、跨区域协作角度提出化工园区区域应急协作的相应政策建议。