Chlorinated solvents in a petrochemical wastewater treatment plant: an assessment of their removal using self-organising maps

The self-organising map approach was used to assess the efficiency of chlorinated solvent removal from petrochemical wastewater in a refinery wastewater treatment plant. Chlorinated solvents and inorganic anions (11 variables) were determined in 72 wastewater samples, collected from three different purification streams. The classification of variables identified technical solvents, brine from oil desalting and runoff sulphates as pollution sources in the refinery, affecting the quality of wastewater treatment plant influent. The classification of samples revealed the formation of five clusters: the first three clusters contained samples collected from the drainage water, process water and oiled rainwater treatment streams. The fourth cluster consisted mainly of samples collected after biological treatment, and the fifth one of samples collected after an unusual event. SOM analysis showed that the biological treatment step significantly reduced concentrations of chlorinated solvents in wastewater.     

Ozonation as an advanced oxidant in treatment of bamboo industry wastewater

The present study employed ozonation process to treat the bamboo industry wastewater (BIWW). The impact of ozone dosage and initial organic concentration on color, COD and TOC removal rates were studied along with characterization of the major organics in raw and treated wastewater. The results suggested the ozone dosage of 3.15 g h⁻¹ (concentration 52.5 mg L⁻¹) was suitable for the treatment. After 25 min ozonation of 1 L raw wastewater, the color, COD and TOC removal efficiencies were 95%, 56% and 40%, respectively, with an influent COD concentration of 835 mg L⁻¹. The ratio of kg O₃ kg⁻¹ COD at 3.15 g h⁻¹ was 2.8 (<3), revealing that ozonation was a cost effective process for tertiary treatment of BIWW. Longer oxidization time was required to achieve similar results for raw wastewater with higher COD concentration. The chromatogram from gel permeation chromatography revealed that ozonation resulted in the breakdown of high molecular weight compounds into lower molecular weight components but could not completely mineralize the organic matter. The majority of these compounds were identified in both raw and ozonated samples via GC-MS analysis. In addition to ester derivatives as the main intermediates of ozonation, 1-chloroctadecane, methyl stearate, benzophenone and α-cyperone were identified as the by-products of ozonation.     

采油废水中多环芳烃的生态风险评价

先利用C-18固相萃取小柱富集大港油田港东联合处理站污水处理站的采油废水中16种多环芳烃(PAHs,即萘、苊烯、苊、芴、菲、蒽、荧蒽、芘、、苯并[a]蒽、苯并[b]荧蒽、苯并[k]荧蒽、苯并[a]芘、茚并[1,2,3-cd]芘、二苯并[a,h]蒽和苯并[g,h,i]苝),再用气相色谱/质谱(GC/MS)分析测定其浓度,以评价PAHs的去除率和生态风险。结果表明:(1)采油废水经处理后,COD、石油类去除率分别达到82.27%、91.06%;外排水COD、石油类达到《污水综合排放标准》(GB 8978—1996)一级标准要求,优于中国采油废水处理的一般水平。(2)采油废水主要以2、3环的PAHs为主,约占总量的93%以上。(3)苯并[a]芘超过《地表水环境质量标准》(GB 3838—2002)中限值。(4)处理前的采油废水中蒽、菲和苯并[a]芘具有一定的生态风险;处理后的外排水中萘、蒽、菲、荧蒽、苯并[a]芘的暴露浓度(PEC)/预测无效应浓度(PNEC)均小于1,目前尚未对环境造成威胁。但是8种PAHs(苊烯和苯并类PAHs除外)总和表现出较大的毒性,需要引起重视。     

VFAs、TOC及COD作为生物除磷能力指标的探讨

在实际生活污水的处理中,研究了通过A/O运行模式对生物除磷过程中磷的变化情况及在厌氧释磷过程中COD、TOC与VFAs变化之间的关系。结果表明,在厌氧释磷过程中VFAs的变化更能准确地反映系统内释磷进程,实际生活污水中能直接用于磷释放的有机物含量占COD的13.33%,并且释放1 mg P所需VFAs为1.401 mg,此值明显低于前期研究结果。通过对COD、TOC和VFAs 3种组分的分析,可将实际生活污水中的有机底物分为3类:易生物降解含碳有机物、难降解的含碳有机物和水中存在的无机性还原物质,含量分别占COD的13.33%、31.7%和54.97%,其中只有13.33%的含量对生物释磷有直接作用,并可对实际生活污水除磷有指导意义。     

铁炭微电解工艺处理采油废水的研究

随着采油废水产生量的逐渐增大以及排放标准的日益严格,寻找一种经济、高效的处理方法显得十分必要。采用铁炭微电解技术对冀东油田采油废水进行了处理。考察了铁屑粒径、pH值、Fe/C质量比和反应时间对COD去除率的影响并设计了正交实验,结果表明,影响微电解工艺的因素主次关系为:pH>Fe/C质量比>反应时间,在最佳条件pH=5,Fe/C质量比为7∶1,反应时间50 min下,原水COD由170 mg/L降至95.6 mg/L,去除率达43.85%,出水满足国家二级排放标准。     

UV-Fenton体系预处理四氢呋喃废水实验研究

采用UV-Fenton体系预处理四氢呋喃废水,实验结果表明,pH值、反应时间、Fe2+和H2O2投加量等因素对处理效果有较大的影响。实验确定的最佳反应条件为:原水pH=5,Fe2+投加量2.5 mmol/L,H2O2投加量12 mmol/L,反应时间90 min,连续曝气,在此条件下,COD去除率可达85%左右。经UV-Fenton体系处理后,废水的B/C值由0.16增至0.47,可生化性提高,可满足后续生化处理的要求。     

C/N和pH值对高温好氧反硝化菌产N2O的影响研究

以50℃高温、好氧条件下能进行高效好氧反硝化的菌株TAD1为研究对象,在不同C/N和pH值培养条件下,对其24 h的反硝化效率和反硝化过程中N2O的逸出量进行了研究。结果显示,C/N和pH值对菌株TAD1的反硝化效率和N2O产生量有明显影响.菌株TAD1最适宜的C/N为9,pH值为7,此时反硝化效率达到99.12%,N2O产生量仅为3.35×10-2 mg/L,N2 O转化率为0.045%,反硝化产物以氮气为主。另外,菌株TAD1不适宜在酸性条件下生长,pH值为6时反硝化效率为83.18%,N2O产生量为13.88×10-2 mg/L,是pH值为7时的4.14倍,是pH值为8时的5.07倍。     

厌氧滤池处理纺织印染废水的中试研究

对厌氧滤池反应器处理难降解印染废水进行中试研究。结果表明,厌氧滤池反应器水力停留时间(HRT)在8.1～14.6 h之间,进水COD浓度波动较大(500～1 000 mg/L)时,对COD平均去除率为20%。印染废水的BOD5/COD由0.23提高到0.35,废水可生化性明显改善。印染废水中硫酸根浓度略有下降,去除浓度为70 mg/L左右。厌氧滤池进出水颜色明显变化,由紫红色变为蓝黑色,紫外可见光谱分析表明废水中的有机物结构发生变化。     

活性艳橙K-7R分子印迹聚合物微球的制备及结合特性研究

以微米级聚苯乙烯微球为种球,活性艳橙K-7R为模板分子,甲基丙烯酸为功能单体,乙二醇二甲基丙烯酸酯为交联剂,采用单步溶胀聚合法在水相中制得了分子印迹聚合物微球(MIPs),并用平衡吸附实验研究了其吸附性能。通过Scatchard分析,结果表明,MIPs在识别K-7R过程中存在两类结合位点,高亲和力结合位点的平衡离解常数Kd1=14.855μmol/L,最大结合量Qmax1=1.282μmol/g;低亲和力结合位点的平衡离解常数Kd2=70.939μmol/L,最大结合量Qmax2=3.930μmol/g。该MIPs对K-7R有较高的亲和性和选择性。