山梨酸废水在ABR中的基质降解行为

稳态条件下,采用厌氧折流板反应器(anaerobic baffled reactor,ABR)处理山梨酸废水并进行基质降解动力学研究.实验表明,在污泥负荷为0.54～1.63 kg COD/(kg VSS·d)的范围内,COD去除率随着负荷的增加从85%降到55%.各隔室出水COD沿程递减,前3个隔室承担了去除COD的重要作用,但随着污泥负荷的增加,后部承担的COD去除率比例增大.基于各串联隔室完全混合的假定,推导ABR中山梨酸废水的基质降解动力学方程,并通过实验确定相关动力学参数及相应的动力学方程.实测值与预测值基本吻合.     

不同条件下高炉渣吸附水中无机磷的研究

高炉渣(BFS)是在冶炼生铁过程中产生的固体废弃物,开展高炉渣的资源化研究具有重要意义.为了对水淬高炉渣净化含磷污水的应用提供理论依据,采取等温吸附的实验方法,比较了不同水淬炉渣的吸附磷效果,研究了不同pH和不同温度下水淬炉渣吸附磷的特点,结果如下:利用Langmuir等温吸附方程炉渣吸附磷的过程进行拟合,其相关系数均能达到显著水平.炉渣的碱度越高,吸附磷的效果越好;炉渣对磷的吸附能力随溶液pH的增加而降低,且初始为酸性(pH=2、4)的溶液在吸附达到平衡后pH有所上升,而初始为碱性的溶液(pH=10、12)在吸附达到平衡后pH有所下降;炉渣对磷的吸附是一个自发放热过程.     

固定化解脂耶氏酵母处理油脂废水研究

利用海藻酸钙包埋固定的解脂耶氏酵母(Yarrowia lipolytica)分别降解以色拉油为惟一碳源和以葡萄糖为惟一碳源的污水,结果表明,在最佳处理条件下,固定化细胞在50 h内,能较好地降解废水中浓度为2 000 mg/L的色拉油和浓度为2 000 mg/L 的COD,降解率都在80%以上;固定化细胞对色拉油、COD降解效率随着时间的延长而增加、随着底物浓度的增加而下降;与未固定菌株相比,固定化细胞有着更好的储存稳定性和可重复使用性,结果进一步提示固定化解脂耶氏酵母适于含油废水以及高COD含量的生活污水处理。     

类Fenton氧化技术去除榨菜生产废水COD的研究

研究了紫外光照射下类Fenton试剂对榨菜生产废水COD的去除,考察了光照时间、初始pH值、过氧化氢用量、FeCl₃·6H₂O用量等因素对榨菜废水中COD去除率的影响。结果表明,光照时间60 min,初始pH值3,H₂O₂（30%）的用量为理论值的120%,c₀(H₂O₂)∶c₀［Fe(Ⅲ)］=11.6∶1.0时,COD去除率效果为最佳,达到79%。当H₂O₂投加总量不变时,去除率随着投加次数的增多而增大。     

聚硅酸氯化铝处理皂素废水的研究

制备了聚硅酸氯化铝(PASC)絮凝剂,并用其进行了皂素废水处理实验。考察了絮凝剂投加量、pH值、搅拌速度对COD和浊度去除率的影响。结果表明,当絮凝剂投加量为9～13.5 mg/L、pH值5～7、搅拌速度150～250 r/min时,COD和浊度去除效果较好。最佳工艺条件为：絮凝剂投加量11.25 mg/L、pH值6、搅拌速度200 r/min。此时,COD去除率为93.7％,浊度去除率为97.5％。PASC的絮凝性能明显优于PAC。     

Monitoring air quality with lichens: a comparison between mapping in forest sites and in open areas

Four different methods of epiphytic lichen mapping were used for the assessment of air quality in the region under the influence of the Sostanj Thermal Power Plant (Salek Valley, Slovenia). Three methods were based on the presence of different lichen species (VDI, EU and ICP-Forest), the fourth on a frequency and coverage assessment of different growth forms of epiphytic lichens, e.g. crustose, foliose and fruticose (SI). A comparison of the results from the assessment of air quality between forest sites (ICP-Forest, SI) and open areas (VDI, EU and SI), obtained by the different methods of epiphytic lichen mapping, is presented in the contribution. Data showed that lichen species richness is worse in forest sites in comparison with open areas. From the data obtained it can be concluded that epiphytic lichen mapping in open areas is a better method for the assessment of air pollution in a given area than mapping in forest sites. The species-based methods in open areas are more powerful and useful for air quality assessment in polluted research areas than the SI and ICP-Forest methods.     

Heavy metal contamination in the vicinity of an industrial area near Bucharest

BACKGROUND, AIMS AND SCOPE: Chromium enters into the aquatic environment as a result of effluent discharge from steel works, electroplating, leather tanning industries and chemical industries. As the Cr(VI) is very harmful to living organisms, it should be quickly removed from the environment when it happens to be contaminated. Therefore, the aim of this laboratory research was to develop a rapid, simple and adaptable solvent extraction system to quantitatively remove Cr(VI) from polluted waters. METHODS: Aqueous salt-solutions containing Cr(VI) as CrO4(2-) at ppm level (4-6 ppm) were prepared. Equal volumes (5 ml) of aqueous and organic (2-PrOH) phases were mixed in a 10 ml centrifuge tube for 15 min, centrifuged and separated. Concentrations of Cr(VI), in both the aqueous and organic phases, were determined by atomic absorption spectrometry. The effects of salt and acid concentrations, and phase-contact time on the extraction of Cr(VI) were investigated. In addition, the extraction of Cr(VI) was assessed in the presence of tetramethylammonium chloride (TMAC) in 2-PrOH phase. Effects of some other metals, (Cd(II), Co(II), Cu(II), Ni(II) and Zn(II)), on the extraction of Cr(VI) were also investigated. RESULTS AND DISCUSSION: The Cr(VI) at ppm level was extracted quantitatively by salting-out the homogeneous system of water and 2-propanol(2-PrOH) using chloride salts, namely CaCl2 or NaCl, under acidic chloride media. The extracted chemical species of Cr(VI) was confirmed to be the CrO3Cl-. The ion-pair complex extracted into the organic phase was rationalized as the solvated ion-pair complex of [2-PrOH2+, CrO3Cl-]. The complex was no longer stable. It implied the reaction between extracted species. Studies revealed that salts and acid directly participated in the formation of the above complex. Use of extracting agents (TMAC) didn't show any significant effect on the extraction of Cr(VI) under high salting-out conditions. There is no significant interference effect on the extraction of Cr(VI) by the presence of other metals. The Cr(VI) in the organic phase was back-extracted using an aqueous ammonia solution (1.6 mol dm(-3)) containing 3 mol dm(-3) NaCl. The extraction mechanism of Cr(VI) is also discussed. CONCLUSIONS: Salting-out of homogeneous mixed solvent of 2-propanol can be employed to extract Cr(VI) quantitatively, as an ion-pair of [2-PrOH2+ * CrO3Cl-] solvated by 2-PrOH molecules. Then, the complex becomes 'solvent-like' and is readily separated into the organic phase. The increase of Cl- ion concentration in the aqueous phase favors the extraction. The 2-PrOH, salts and acid play important roles in the extraction process. There is no need to use an extracting agent at a high salting-out condition. RECOMMENDATIONS AND PERSPECTIVES: Chromium(VI) must be quickly removed before it enters into the natural cycle. As the 2-PrOH is water-miscible in any proportion, ion-pairing between 2-PrOH2+ and CrO3Cl- becomes very fast. As a result, Cr(VI) can easily be extracted. Therefore, the method is recommended as a simple, rapid and adaptable method to quickly separate Cr(VI) from aqueous samples.     

超声强化Fe0去除阳离子红GTL的研究

采用US/Fe0系统去除阳离子红GTL,考察了pH值、Fe0用量、超声功率及活性炭、H2O2、盐分添加对阳离子红GTL去除率的影响,利用紫外-可见吸收光谱变化查明阳离子红GTL在不同条件下的去除差异性,利用SEM解析铁的形态与染料去除的相关性。结果表明： pH≥5.0时超声和Fe0具有协同效应,Fe0用量2 g/L,pH=7.0,超声功率135 W,阳离子红GTL去除率达到96.07%;一定量的活性炭、H2O2、盐分添加会加速染料去除,US加速Fe0反应速度,但不改变染料降解机理,添加活性炭能够彻底降解阳离子红GTL,添加H2O2提供的氧化环境抑制苯胺类化合物生成;铁的形态及与染料的接触是影响染料去除效果的重要原因。     

区域规划环境影响跟踪评价的理论研究

随着环境影响评价制度的深入实施,其实施领域已由项目环评向区域环评和规划环评转变,评价内容也由广泛实施的预测评价向后评价和跟踪评价转变。然而,对于区域规划环评的评价层次、评价程序和评价内容,目前还没有明晰的认识;同时,对于促进规划环评有效实施的跟踪评价,其相关的理论和实践研究几乎没有。文中就此问题作了深入探讨。     

混凝-水解-接触氧化-气浮工艺处理印染废水

采用混凝-水解酸化-接触氧化-气浮工艺,处理印染废水,运行结果表明：对CODcr SS、色度的去除率分别为91．5％、92％、90％,出水达到《纺织染整工业水污染排放标准》（GB4287—92）的一级标准。