西北干旱区中小城市水价探析

为了促进西北干旱区中小城市的快速、稳定的发展,解决该地区中小城市的水资源短缺问题,以水价作为出发点,充分利用水价格的经济杠杆作用,制定出该地区中小城市的水价。以西北干旱区中具有代表性的城市石河子为例,通过实地调研,得到石河子居民、居民生活用水情况、现行水价、居民家庭节水情况、居民的心理承受水价以及平时生活的节水意识等情况,通过分析,得出居民的心理承受偏低,现行水价仍有一定的上调空间,调价范围为1.58~2.31元/m3,最高可调至4.11元/m3。结合石河子的水价,为西北干旱区的中小城镇的水价改革、提高水资源的利用率等提出一些切实可行的建议。     

低温A/O-MBR工艺启动试验研究

研究了A/O-MBR工艺低温(水温在5~12℃)启动效能,结果表明,低温下A/O-MBR工艺启动迅速,活性污泥的培养驯化时间较短。启动过程中根据出水水质情况,逐渐提高负荷,运行34 d,系统对COD的去除率能达到90%以上,系统对氨氮的去除率能达到96%以上,至稳定运行后氨氮的负荷平均可达到0.419kg/(m3.d),反硝化效果系统去除率基本能稳定在60%左右。     

加压气浮法处理含油废水中溶气压力对出水水质的影响与应用研究

以实际工作中的含油废水为研究对象,采用加压气浮处理工艺,通过多年的实际应用与对监测数据的分析,总结出气浮压力对气浮处理效果的影响,通过对溶气罐压力的调整,可得到最佳的出水水质。该项研究结果操作方便、处理效率高、易于控制、对今后的工作具有指导意义,有很好的推广价值。     

硫酸系统水平衡分析计算和生产实践

在硫酸系统中,通过水平衡分析计算烟气带入净化工序的SO2体积分数和含水量,确定净化工序的能力,控制干燥塔进口烟气温度,使干吸工序生产出合格产品;通过计算,烟气带入净化工序的水量小于产品带出的水量,制酸净化污水经过污水处理工序处理后返回到净化工序重复使用,实现净化污水零排放,消除对环境的污染.     

四川某中小城镇污水处理厂进水水质统计分析

生活污水水质对处理工艺的选择、设计参数的选取以及稳定运行十分重要。运用SPSS软件,对四川某中小城镇污水处理厂为期一年的进水指标(水量、COD、氨氮、总磷、pH、SS)进行方差和相关性分析。方差分析结果显示进水量、氨氮和SS在月份和季节之间存在显著性差异,而总磷和pH仅在月份之间存在显著差异,COD在季度和月份之间无显著性差异;指标相关性分析表明,进水量和氨氮之间呈负相关,氨氮和总磷、COD和总磷之间呈正相关,且相关性显著。在此分析的基础上对污水处理厂设计、工艺选择及运行管理提出了一些建议。     

A numerical study of summer ozone concentration over the Kanto area of Japan using the MM5/CMAQ model

We assessed the ability of the MM5/CMAQ model to predict ozone (O3) air quality over the Kanto area and to investigate the factors that a ect simulation of O3. We find that the coupled MM5/CMAQ model is a useful tool for the analysis of urban environmental problems. The simulation results were compared with observational data and were found to accurately replicate most of the important observed characteristics. The initial and boundary conditions were found to have a significant e ect on simulated O3 concentrations. The results show that on hot and dry days with high O3 concentration, the CMAQ model provides a poor simulation of O3 maxima when using initial and boundary conditions derived from the CMAQ default data. The simulation of peak O3 concentrations is improved with the JCAP initial and boundary conditions. On mild days, the default CMAQ initial and boundary conditions provide a more realistic simulation. Meteorological conditions also have a strong impact on the simulated distribution and accumulation of O3 concentrations in this area. Low O3 concentrations are simulated during mild weather conditions, and high concentrations are predicted during hot and dry weather. By investigating the e ects of di erent meteorological conditions on each model process, we find that advection and di usion di er the most between the two meteorological regimes. Thus, di erences in the winds that govern the transport of O3 and its precursors are likely the most important meteorological drivers of ozone concentration over the central Kanto area.     

Chemical cleaning of fouled PVC membrane during ultrafiltration of algal-rich water

Cleaning of hollow-fibre polyvinyl chloride (PVC) membrane with di erent chemical reagents after ultrafiltration of algal-rich water was investigated. Among the tested cleaning reagents (NaOH, HCl, EDTA, and NaClO), 100 mg/L NaClO exhibited the best performance (88.4% 1.1%) in removing the irreversible fouling resistance. This might be attributed to the fact that NaClO could eliminate almost all the major foulants such as carbohydrate-like and protein-like materials on the membrane surface, as confirmed by Fourier transform infrared spectroscopy analysis. However, negligible irreversible resistance (1.5% 1.0%) was obtained when the membrane was cleaning by 500 mg/L NaOH for 1.0 hr, although the NaOH solution could also desorb a portion of the major foulants from the fouled PVC membrane. Scanning electronic microscopy and atomic force microscopy analyses demonstrated that 500 mg/L NaOH could change the structure of the residual foulants on the membrane, making them more tightly attached to the membrane surface. This phenomenon might be responsible for the negligible membrane permeability restoration after NaOH cleaning. On the other hand, the microscopic analyses reflected that NaClO could e ectively remove the foulants accumulated on the membrane surface.     

中心组合设计优化S-Cr-TiO2催化剂光降解工艺条件

在确定的温度和光照条件下,采用中心组合设计法研究了固相反应法合成的硫与铬共掺杂二氧化钛(S-Cr-TiO2)光催化剂与水溶苯胺蓝(ANB)可见光降解过程中的三个作用因子:催化剂的浓度、水溶苯胺蓝水溶液的pH值及其初始浓度之间的相互作用关系,得到了影响因子与降解速率之间的回归方程及因素之间相互作用的响应面图.结果表明,S...     

连续流动氢化物发生原子荧光法测定水中硒

文章介绍连续流动一氢化物发生一原子荧光测定水中硒的方法,研究了盐酸浓度、硼氢化钾浓度、灯电流、光电倍增管负高压、泵速、载气和屏蔽气流量等对测定硒的影响,找出测定水中硒最佳条件,在最佳条件下,校准曲线相关系数为0.9999.方法检出限为0.0095μg/L,方法的测量范围为0.038-300μg/L,回收率在91.8%-...     

吹扫捕集-气相色谱法测定水中的乙醛和丙烯醛

建立了吹扫捕集-气相色谱法测定水样中乙醛和丙烯醛的方法,并对吹扫捕集测试条件进行优化,考察了吹扫温度和吹扫时间对吹扫捕集效率和方法检出限的影响。在50℃下,吹扫时间为20 min时,该方法乙醛和丙烯醛的检出限分别为0.001 2 mg/L、0.000 6 mg/L,相对标准偏差分别为3.5%～6.9%、2.9%～5.8%,加标回收率分别为91.6%～108%、92.0%～105%。与GB3838-2002推荐使用的分析方法相比较,该方法具有操作简便、灵敏度高、重复性好、基本上不消耗有机溶剂等特点,可满足地表水和废水中乙醛和丙烯醛的测定要求。