Possible Utilization of Silica Gel Sludge for the Removal of Phenol from Aqueous Solutions: Laboratory Studies

This paper discusses the adsorption capacity of silica gel sludge for phenol removal from aqueous solution. Kinetic experiments showed that phenol adsorption was completed after 2 h. Adsorption isotherms were measured for phenol from aqueous solution onto silica gel sludge under various pHs and temperatures. Results showed that the adsorption capacities for phenol was increased as pH decreased from 6.5 to 2. Temperature also was found to affect the adsorption isotherm. As temperature increases from 30 to 50°C, the adsorption capacity increases. The adsorption equilibrium of phenol on silica gel sludge was described by the linear Freundlich and Langmuir models. Furthermore, results showed that the isotherm parameters fit both linearized Langmuir and Freundlich adsorption isotherms. The Freundlich and Langmuir parameters at optimum pH was found as K _f=2.89, 1/n=0.23 and K _d=22.0, q _m=7.98, respectively. Whereas, for those at optimum temperature it was observed as K _f=2.87, 1/n=0.16 and K _d=20.93, q _m=7.91, respectively.     

低浓度臭氧在含钴盐硅胶上的吸附研究

常压下对含钴盐硅胶进行低浓度臭氧的吸附实验，吸附达到饱和后用氮气作为载气加热解吸。结果显示，含钴盐的硅胶对臭氧具有较强的吸附能力；臭氧解吸量随着解吸温度的上升而增加；吸附了臭氧的含钴硅胶粒子在常温(313．15K)下可在60min内不问断解吸出臭氧。     

HAN基ECSP凝胶模型的构建与分子动力学模拟

目的 从微观分子的角度对硝酸羟胺(HAN)基电控固体推进剂(Electrically Controlled Solid Propellants,ECSP)的性能参数进行模拟与计算。方法 利用分子表面静电势(ESP)对HAN分子2种可能的构型进行优化和稳定性分析。通过真空非周期性分子动力学模拟得到聚乙烯醇(PVA)分子稳定构型,并以HAN基ECSP的主要成分按一定比例构建凝胶模型。基于RESP(Restrained Electrostatic Potential)电荷生成更准确的凝胶模型拓扑文件,并进行凝胶模型的分子动力学模拟、模型稳定分析以及模型参数计算。结果 凝胶模型总能量相对平均值的周期性波动不超过7%。由于三维PVA链的包裹,H2O分子的扩散系数被大幅削弱。氢键分析和径向分布函数表明氢键键长主要分布在0.282 6 nm附近,PVA与H2O间的氢键较少,H2O与HAN、H2O与H2O之间的氢键较多。模型密度为1.405 g/cm³,与实验值吻合度高。在283、293、303 K下,HAN基ECSP凝胶模型的拉伸模量依次降低,剪切模量先增后减。在15 K/600 ps冷却速率下,HAN基ECSP凝胶模型的拉伸模量和剪切模量均增大。结论 ECSP制备结束后,冷却过程中的环境温度不宜过高,否则容易造成ECSP力学性能的快速下降,快速冷却可以提高ECSP的力学性能。     

固相萃取-GC/MS法测定地表水中3-甲基吲哚

采用微球硅胶键合C_(18)固相萃取柱萃取水样中的3-甲基吲哚,并用气质联用法测定,方法在0 mg/L~10.0 mg/L范围内线性良好,方法检出限为0.2μg/L。空白水样3个质量浓度水平的加标回收率为89%~94%,7次测定结果的RSD为2.3%~6.9%。用该方法测定7个实际地表水样品,其中4个地表水样品检出3-甲基吲哚,地表水样的加标回收率为81.5%~97.0%。     

Measurements of selected PCBs in open urban ambient air of Madrid (Spain)

The focus of this study was to characterize the concentration levels of selected PCBs and compare them to compiled data in order to contribute to the international database. The sampling site is located in the outskirts of Madrid and can be considered an open urban area. 32 samples of air were taken from February 1998 to June 1998 by using a high volume air sampler. Glass fiber filters and polyurethane foam (PUF) were used to collect the paniculate and gas phase material, respectively. PUF plugs were Soxhlet extracted and filters were ultrasonically extracted by using pesticide-grade hexane and dichloromethane, respectively. The cleanup procedure was carried out on a florisil column with hexane and hexane/dichloromethane as elution solvents. GC/MS in a selected ion monitoring mode was used for quantification and 29 selected PCBs congeners were analyzed.     

Mapping of tritium emissions using absorption vapour samplers

Püspökszilágy Radioactive Waste Treatment and Disposal Facility (RWTDF) is a typical near-surface engineered repository designated to store low- and intermediate-level wastes from various institutes, research facilities and hospitals in Hungary. Two automatic combined ¹⁴C–tritium sampling units installed at the facility sample the air 2 m above surface. The one installed near the vaults detects tritium (T) activities two orders of magnitude higher than the far reference sampling unit. To localize the T emissions, 19 small absorption vapour samplers filled with silica gel were settled onto the ground surface. After the saturation of the silica gel, the water was recovered and its T concentration was measured with a low-background liquid scintillation counter. The absorption vapour samplers are cheap, simple and easy-to-use. We present the samplers and the T distribution map constructed from the data, which helps to localize the T emission.     

环境污染物的分子毒理机制研究进展

以分子生物学技术为基础研究污染物的毒理机制．从分子水平揭示了污染物毒作用的本质。综述了国内外分子毒理机制的研究进展。详细阐述了毒理芯片、单细胞凝胶电泳等分子生物学技术应用与毒理学研究中的特点、应用前景以及存在的问题。提出了分子毒理机制今后的研究方向。     

氯化汞对小鼠睾丸生殖细胞的DNA损伤作用

探索氯化汞对雄性小鼠生殖细胞毒性的分子遗传机制。分别以 0 .0 1、0 .10、1.0 0 mmol/L的氯化汞体外处理小鼠睾丸细胞和以 0 .5、1.0、5 .0 μmol/kg的氯化汞体内暴露小鼠 ,应用单细胞凝胶电泳技术检测生殖细胞 DNA的损伤。体外处理 3种剂量组小鼠睾丸生殖细胞 DNA损伤率显著高于阴性对照组 ( 0 mmol/L组 ,P<0 .0 0 1) ;0 .1、1.0 mmol/L剂量组慧星细胞迁移率显著高于阴性对照组 ( P<0 .0 0 1,P<0 .0 5 )。体内暴露 3种浓度氯化汞组小鼠睾丸生殖细胞 DNA损伤率显著高于阴性对照组 ( 0μmol/kg,P<0 .0 0 1) ,5 .0 μmol/kg组慧星迁移率显著高于阴性对照组 ( P<0 .0 5 )。一定剂量的氯化汞处理引起生殖细胞 DNA损伤作用可能是氯化汞细胞毒性的机制之一。     

β-环糊精接枝羧甲基壳聚糖吸附剂的制备及其性能

采用γ-氨丙基三乙氧基硅烷化学修饰活化后的硅胶,以戊二醛为交联剂,接上羧甲基壳聚糖,继而接枝上β-环糊精作为功能单体,制备了一种用于分离富集水样中Cu(Ⅱ)的固相萃取新材料。利用红外光谱(FT-IR)、比表面分析(BET)、X射线衍射光谱(XRD)以及热重分析(TG)等方法对吸附剂进行结构表征。采用火焰原子吸收(FAAS)作为检测手段,考察了溶液pH、振荡时间、吸附剂用量、样品流速、洗脱液浓度和体积等对吸附剂吸附Cu(Ⅱ)的影响。吸附剂饱和吸附容量为9.37 mg/g,最大富集倍数高达350。吸附过程能用准二级动力学模型和Langmuir等温吸附方程进行很好的拟合。应用于环境水样中Cu(Ⅱ)的分离富集与测定,回收率在96.8%~105.2%之间,效果较好。     

沿海钢结构设施的防腐研究

针对沿海钢结构设施的腐蚀情况及目前常用防腐涂料的性能,优选了3种重防腐涂料——环氧富锌底漆、环氧玻璃鳞片中间漆、聚氨酯面漆。讨论了环氧树脂、锌粉、玻璃鳞片、聚氨酯改性树脂的选择方法,并提出了适合涂料涂装的表面处理技术和施工工艺。