炼油厂"三泥"离心脱水处理研究

通过对目前炼油厂“三泥”性状的调查，利用已有污泥处理设施进行了炼油厂“三泥”离心分离的现场试验，并分析了影响“三泥”离心分离处理工艺的主要因素，发现了离心机转速和絮凝剂投加量对“三泥”离心分离的有关规律和最佳操作条件，在此基础上，提出了适合炼油厂“三泥”处理系统的优化方案。     

活性污泥吸附重金属Cr6+的研究

以活性污泥为材料，采用不同时间、温度、pH进行吸附重金属Cr^6 的研究。实验结果表明，当吸附时间为15min，吸附温度为28℃，吸附pH=7时具有较好吸附效果。在此条件下，当重金属Cr^6 浓度为50mg/L，其吸附率可达97．2％。     

河津发电厂废水零排放实施及建议

介绍了河津发电厂目前的用水、排水情况及工业废水零排放实施方案，对方案实施后的效果进行了预测，同时对废水零排放实施后运行中可能出现的问题进行了分析并提出了建议。     

含油污泥固化处理后油的迁移研究

利用紫外分光光度计和索氏抽提器,研究了温度、土壤含水率以及水泥与污泥的不同比例等因素在不同时间对含油污泥固化后油迁移的影响。试验结果表明:对于强度为3.84MPa的污泥固化块,油的迁移量从240h迁移6.8mg变为480h迁移178mg,之后变化较小。在20℃～30℃时,随着温度的增加,迁移量从6.8mg增加到20.6mg,超过30℃以后迁移量的增幅变小。水泥与污泥的比例从1∶0.8增加到1∶1.4,油的迁移量从256mg降到27.2mg,之后未检测到。960h后,迁移量达到348mg,此时土壤中油含量为1.16%,在环境的自净作用下,土壤能完全容纳;强度大于9.56MPa时未检测到油。这表明用固化法处理油田含油污泥是安全可靠的。     

废纸造纸工业节水零排放技术

本文介绍了废纸造纸零排放技术的意义、零排放循环水处理需要解决的问题及工程实践情况。     

环评中锅炉房大气污染源强的确定

在环境评价中,污染源强的确定对环境影响因素评价的分析结果有重要作用。对锅炉房污染物排放的分析表明,影响锅炉房大气污染物的主要因素有燃料的构成、发热量和燃烧方式等。确定锅炉房大气污染物的方法主要有物料衡算法、实测法和经验系数法。在这三种方法中,物料衡算法被普遍采用。在确定锅炉房大气污染物的排放量时,也可以采用物料衡算法和实测法相结合的方法。     

改进型石灰混凝法去除城市污水二级出水中有机物的研究

将石灰混凝处理后的沉淀泥渣进行回流，对石灰混凝法进行改进，研究改进后的石灰混凝法对城市污水二级出水中有机物的去除效果。结果表明，活性泥渣回流有利于提高石灰混凝法对城市污水二级出水中有机物的去除。回流位置在石灰投加前、复合絮凝剂投加后，最佳回流量为新泥渣产生量的100％～200％，活性泥渣回流的最佳pH为11．0～11．5；活性泥渣中CaCO3、Mg(OH)2、Fe(OH)3等沉淀物以及有机高分子絮体均有助于提高其对有机物的去除效果，其中Mg(OH)2沉淀物起主导作用；含循环泥渣的活性污泥回流，对有机物的去除效果无明显影响。     

Environmental assessment of supercritical water oxidation of sewage sludge

Environmental aspects of using supercritical water oxidation (SCWO) to treat sewage sludge were studied using a life cycle assessment (LCA) methodology. The system studied is the first commercial scale SCWO plant for sewage sludge in the world, treating sludge from the municipal wastewater treatment facility in Harlingen, TX, USA. The environmental impacts were evaluated using three specific environmental attributes: global warming potential (GWP), photo-oxidant creation potential (POCP) and resource depletion; as well as two single point indicators: EPS2000 and EcoIndicator99. The LCA results show that for the described process, gas-fired preheating of the sludge is the major contributor to environmental impacts, and emissions from generating electricity for pumping and for oxygen production are also important. Overall, SCWO processing of undigested sewage sludge is an environmentally attractive technology, particularly when heat is recovered from the process. Energy-conserving measures and recovery of excess oxygen from the SCWO process should be considered for improving the sustainability potential.     

CHEMISTRY OF COALBED METHANE DISCHARGE WATER INTERACTING WITH SEMI‐ARID EPHEMERAL STREAM CHANNELS1

ABSTRACT: The objective of this study was to examine the chemistry of Coalbed Methane (CBM) discharge water reacting with semi‐arid ephemeral stream channels in the Powder River Basin, Wyoming. The study area consisted of two ephemeral streams: Burger Draw and Sue Draw. These streams are tributaries to the perennial Powder River. Samples were collected bimonthly from three CBM discharge points and seven channel locations in Burger Draw and Sue Draw. Samples were also collected bimonthly from the Powder River above and below the confluence of Burger Draw. Before sample collection, the pH and electrical conductivity (EC) were measured in the field. Samples were transported to the laboratory and analyzed for alkalinity, major cations, and anions. From the measurement of sodium (Na), calcium (Ca), and magnesium (Mg), practical sodium adsorption ratio (SARp) and true sodium adsorption ratio (SARt) were calculated. Results suggest pH and EC of CBM discharge water was 7.1 and 4.3 dS/m, respectively. The CBM discharge water consisted of higher concentrations of sodium and alkalinity compared to other components. The pH of CBM discharge water increased significantly (p = 0.000) in the downstream channel of Burger Draw from 7.1 to 8.84 before it joined with the Powder River. Dissolved calcium concentration of CBM discharge water decreased significantly (p = 0.000) in the downstream channel water. Subsequently, SARp increased approximately from 24 to 29. The SARt also increased significantly (p = 0.001) in the downstream channel water. For instance, SARt of CBM discharge water increased from 32.93 to 45.5 downstream channels after the confluence of Sue Draw with the Burger Draw. The only significant difference in water chemistry above and below the confluence of Burger Draw with the Powder River was pH, which increased from 8.36 to 8.52. The significant increase in SAR values of CBM discharge water in Burger Draw and Sue Draw tributaries suggest a careful monitoring of salinity and sodicity is needed if CBM discharge water is used for irrigation in semi‐arid environments. Results discussed in this study will be useful to downstream water users who depend on water for irrigation.     

气田污泥脱水工艺研究

在对气田废水处理中产生的污泥进行处理时,普遍存在着干化周期长、含水率高等问题,严重影响了废水处理装置的处理能力。脱水剂优化选择实验以及污泥脱水性能实验结果表明:先加入聚合氯化铝并搅拌15 s,再加入阴离子聚丙烯酰胺并搅拌混合30 s,最后加入FO4190SH搅拌,混合凝聚30 s后静止分层,其凝聚效果较好。在污泥脱水性能的各项指标中,真空脱水均好于重力脱水,特别是对于新鲜污泥滤层,真空(45 kPa)脱水速度比重力脱水速度约高8倍。