Catalytic dechlorination of o-chlorophenol by nanoscale Pd/Fe

IntroductionTheuseofzerovalentironforthetreatmentofchlorinatedorganiccompounds (COCs )inwaterandgroundwaterhasbeenthefocusofmuchrecentresearch .Thestudieswereconcernedwithcompoundssuchascarbontetrachloride(Bradley ,1995 ) ,trichloroethene(Orth ,1996 ;Chen ,2 0 0 1)andpesticidesandrelatedcompounds(Sayles,1997;Monson ,1998;Eykholt,2 0 0 1;Dombek ,2 0 0 1) .Whenironisincontactwithalessreductivemetal,themetalcouplecanformgalvaniccells.ThishasledtothediscoveryofPd Febimetalliccomplexinwhichpal…     

关于脲醛树脂胶粘剂安全问题的探讨

从原料的危害,有机物的挥发量,人员的个人防护等方面对脲醛树脂胶粘剂的职业安全问题进行了探讨,并指出了其安全环保的发展方向。     

调度自动化系统实时信息分层分流构建

火灾作用下混凝土构件的承载能力总体不断下降且具有明显随机性,采用抗火可靠指标可较好地评估构件的火灾安全性。本文针对混凝土轴压柱的高温承载能力极限状态,考虑材料强度变异性导致的柱高温极限承栽力的随机性,以及高温下柱荷栽效应组合的随机性,采用JC法计算给出了ISO834标准升温曲线作用下不同受火时间对应的柱抗火可靠指标,讨论了主要参数对该可靠指标的影响规律;并根据我国现行建筑防火规范,通过分析和参照对比,初步提出了混凝土轴压柱抗火可靠指标的目标建议值。研究认为:(1)截面尺寸越小,柱抗火可靠指标随受火时间增加而下降的速率越快;(2)现行规范给出的截面(200×200)mm、(240×240)mm、(300×300)mm 3种柱在各自耐火极限时刻的抗火可靠指标较为接近,但截面(370×370)mm柱的抗火可靠指标却明显偏低;(3)混凝土轴压柱的目标抗火可靠指标建议取为1.6。     

表面铜螯合磁性二氧化硅固定化漆酶及其催化降解水中2，4-二氯酚

利用磁性二氧化硅表面接枝的聚丙烯酰胺络合Cu2＋离子,制备了表面铜螯合磁性SiO：材料,采用傅立叶红外光谱（FT．IR）,X射线衍射（XRD）对该磁性材料进行了表征,并通过配位作用固定化漆酶,考察了其对水中2,4-二氯酚（2,4-DCP）的催化降解效能及主要影响因素。结果表明,表面铜螯合磁性SiO：固定化漆酶对2,4-DCP具有较好的催化降解效能,利用8g／L固定化漆酶催化降解50mL初始浓度为24．25mg／L的2,4-DCP,反应12h2,4-DCP去除率达91％;当pH值在3．0～6．0范围内时,2,4-DCP的去除率随反应pH值的增加而升高;2,4-DCP初始浓度在14．39～257．6mg／L范围内时,反应12h,2,4-DCP的去除率均达85％以上;给酶量增加促进2,4-DCP的去除,但过多的给酶量导致单位质量固定化漆酶催化降解2,4-DCP的速率下降;水中硫酸根离子对固定化漆酶催化降解2,4-DCP具有明显的促进作用,而碳酸氢根离子明显抑制反应的进行。     

Pd/C气体扩散电极用于电生成H2O2降解苯酚的研究

采用自制的Pd/C气体扩散阴极和Ti/IrO2/RuO2阳极,在无隔膜电解槽中对苯酚模拟废水降解效果及机制进行了研究,采用电子自旋共振法(ESR)对电解体系中产生的羟自由基(·OH)进行了检测.结果表明,在Pd/C气体扩散体系中掺杂Pd催化剂可以促进H2 O2的生成(H2 O2的稳定浓度是7.5 mg/L),有利于·OH的产生.经电化学氧化处理120 min后,苯酚和COD的去除率分别达到97.2%和50%,表明在电催化氧化过程中苯酚被氧化生成了大量低分子量中间产物.废水的BOD5/COD值达到0.73是处理前的9.1倍,苯酚废水的可生化降解性通过电化学氧化处理后显著提高.在该电化学体系中苯酚的降解是在阳极直接、间接氧化及阴极产生的H2 O2、·OH的氧化共同作用下完成的.通过对紫外扫描光谱图的分析推断出苯酚在电解过程中有醌类物质生成;由GC-MS检测到了邻苯二酚、对苯二酚、苯醌等芳香族化合物和己二酸、顺丁烯二酸、反丁烯二酸、丁二酸、丙二酸、乙二酸等短链羧酸,据此提出了苯酚降解的可能历程.     

Pd/g-C3N4对水中2,4-二氯酚的催化加氢脱氯研究

分别采用光沉积法和浸渍法制备了载钯石墨相氮化碳催化剂(Pd/g-C3N4-PD和Pd/g-C3N4-IMP),并对其进行了电感耦合等离子体发射光谱(ICP-AES)、X射线衍射(XRD)、透射电镜(TEM)和Zeta电位的表征.结果表明,不同载钯量Pd/g-C3N4-PD的等电点均在pH 2.3左右;Pd/g-C3N4-PD表面Pd粒子分散均匀,且Pd粒径小于Pd/g-C3N4-IMP.分别将Pd/g-C3N4-PD和Pd/g-C3N4-IMP用于2,4-二氯酚的催化加氢脱氯研究,Pd/g-C3N4-PD的催化脱氯效果明显优于Pd/g-C3N4-IMP.低pH值利于2,4-二氯酚的催化加氢脱氯过程,但不利于保持催化剂的稳定性.     

Formic acid as an alternative reducing agent for the catalytic nitrate reduction in aqueous media

Formic acid was used for the nitrate reduction as a reductant in the presence of Pd:Cu/γ-alumina catalysts. The surface characteristics of the bimetallic catalyst synthesized by wet impregnation were investigated by SEM, TEM-EDS. The metals were not distributed homogeneously on the surface of catalyst, although the total contents of both metals in particles agreed well with the theoretical values. Formic acid decomposition on the catalyst surface, its influence on solution pH and nitrate removal efficacy was investigated. The best removal of nitrate (50 ppm) was obtained under the condition of 0.75 g/L catalyst with Pd:Cu ratio (4:1) and two fold excess of formic acid. Formic acid decay patterns resembled those of nitrate removal, showing a linear relationship between kf (formic acid decay) and k (nitrate removal). Negligible amount of ammonia was detected, and no nitrite was detected, possibly due to buffering effect of bicarbonate that is in situ produced by the decomposition of formic acid, and due to the sustained release of H2 gas.     

Effects of metal and acidic sites on the reaction by-products of butyl acetate oxidation over palladium-based catalysts

Catalytic oxidation is widely used in pollution control technology to remove volatile organic compounds. In this study, Pd/ZSM-5 catalysts with different Pd contents and acidic sites were prepared via the impregnation method. All the catalysts were characterized by means of N2 adsorption- desorption, X-ray fluorescence （XRF）, HE temperature programmed reduction （H2-TPR）, and NH3 temperature programmed desorption （NH3-TPD）. Their catalytic performance was investigated in the oxidation of butyl acetate experiments. The by-products of the reaction were collected in thermal desorption tubes and identified by gas chromatography/mass spectrometry. It was found that the increase of Pd content slightly changed the catalytic activity of butyl acetate oxidation according to the yield of CO2 achieved at 90%, but decreased the cracking by-products, whereas the enhancement of strong acidity over Pd-based catalysts enriched the by-product species. The butyl acetate oxidation process involves a series of reaction steps including protolysis, dehydrogenation, dehydration, cracking, and isomerization. Generally, butyl acetate was cracked to acetic acid and 2- methylpropene and the latter was an intermediate of the other by-products, and the oxidation routes of typical by-products were proposed. Trace amounts of 3-methylpentane, hexane, 2-methylpentane, pentane, and 2-methylbutane originated from iso4merization and protolysis reactions.     

EDTA优化纳米Pd/Fe对2,4-D的催化脱氯研究

采用EDTA优化纳米Pd/Fe催化脱氯水中2,4-二氯苯氧乙酸(2,4-D),并考察了EDTA投加浓度、pH、钯化率、温度等因素对2,4-D还原的影响.结果表明,EDTA的加入络合了纳米Pd/Fe在催化脱氯过程中生成的铁离子,抑制纳米Pd/Fe颗粒表面钝化层的形成,提高了体系的反应活性.适宜的EDTA浓度、低pH、高钯化率、低温等有利于2,4-D的还原脱氯.当EDTA浓度为25.0 mmol·L-1,纳米铁含量为1.0 g·L-1,初始pH=4.3、钯化率为0.5%,温度为25.0℃,搅拌速率为200 r·min~(-1)时,反应50 min,10.0 mg·L-1的2,4-D去除率及苯氧乙酸(PA)生成率均达到100%.     

Degradation of pentachlorobiphenyl by a sequential treatment using Pd coated iron and an aerobic bacterium (H1)

The reductive dechlorination and biodegradation of 2,2^′4,5,5^′-pentachlorobiphenyl (PCB#101) was investigated in a laboratory-scale. Palladium coated iron (Pd/Fe) was used as a catalytic reductant for the chemical degradation of 2,2^′4,5,5^′-pentachlorobiphenyl, and an aerobic bacteria was used for biodegradation following the chemical reaction in this study. Dechlorination was affected by several factors such as Pd loading, initial soil pH and the amount of Pd/Fe used. The results showed that higher Pd loading, higher dosage of Pd/Fe and slightly acid condition were beneficial to the catalytic dechlorination of 2,2^′,4,5,5^′-pentachlorobiphenyl. In laboratory batch experiments, 2,2^′4,5,5^′-pentachlorobiphenyl was reduced in the presence of Pd/Fe bimetal, which was not further degraded by aerobic bacteria. 2,2^′,4-trichlorobiphenyl (PCB#17), a reduction product from 2,2^′4,5,5^′-pentachlorobiphenyl, was readily biodegraded in the presence of a aerobic bacterial strain. It is suggested that an integrated Pd/Fe catalytic reduction-aerobic biodegradation process may be a feasible option for treating PCB-contaminated soil.